纳米TiO2-石墨烯光催化剂的水热合成及其光催化性能

以钛酸四正丁酯和石墨为原料,通过水热法制备了锐钛矿型为主的纳米TiO2复合光催化剂（纳米TiO2-石墨烯）,并采用XRD,FTIR,FESEM,TEM技术对其进行了表征。通过紫外光照射降解溶液中的罗丹明B（RhB）研究了TiO2-石墨烯的光催化活性,分析了初始罗丹明B质量浓度、催化剂加入量、溶液pH和催化剂使用次数等影响降解效果的因素。实验结果表明：在初始RhB质量浓度为20 mg/L、溶液pH为7.10、催化剂加入量为1.000 g/L的条件下,紫外光照射30 min时,纳米TiO2-石墨烯对RhB的降解率高达98.69%,明显高于纳米TiO2的44.69%;纳米TiO2-石墨烯稳定性较强,可多次重复使用。     

高效脱硫菌的筛选及其性能研究

从高硫污染的活性污泥中富集培养,分离纯化得到一株可以降解噻吩的菌株s_4,并对该菌株的形态特征进行观察。应用Design—Expert8．0．5b软件进行响应面优化实验,研究了反应时间、噻吩浓度、微生物浓度3个因素的组合对菌株s_4脱硫效果的影响,并拟合得到多元二次回归方程,得出最佳实验条件。拟合结果表明,当反应时间27．46h,噻吩浓度为1．04％,微生物浓度4．04％时,预测噻吩降解率为14．8％,通过验证得最佳条件下的降解率为14．3％,与预测值相符。     

矸石基X型分子筛对水中Co2+、Cu2+、Cd2+和Cr3+的去除

以煤矸石为原料,采用碱熔后水热合成法制备X型分子筛并进行XRD、SEM、BET和Zeta电位分析。研究其对水中Co2+、Cu2+、Cd2+和Cr3+4种离子的吸附性能,包括吸附等温线、吸附动力学以及初始金属离子浓度、pH值对吸附性能的影响。所合成的矸石基X型分子筛的BET比表面积为676.02 m2/g,微孔孔容为0.263 cm3/g。吸附实验表明,矸石基X型分子筛能有效去除上述4种离子,同时实现煤矸石的资源化和金属离子的去除。4种离子的平衡吸附量均随初始浓度的增大而增大,相同条件下平衡吸附量的大小顺序为Cd2+>Cr3+>Cu2+>Co2+。准二级动力学模型能很好地描述4种离子的吸附动力行为。Langmuir模型对Co2+、Cu2+和Cd2+吸附的拟合较Freundlich模型高,说明其主要表现为物理吸附过程。4种离子的吸附速率均由液膜扩散和颗粒内扩散共同控制。     

表面活性剂改性4A分子筛对Cr(VI)的吸附行为

采用浸渍法对4A分子筛进行表面改性,通过引入阳离子表面活性剂,使4A分子筛表面附着季铵型阳离子,并与反离子Br-形成"阴离子交换膜",从而促使更多的Cr(VI)阴离子通过离子交换吸附到改性4A分子筛上,通过X-射线衍射(XRD)和傅里叶变换红外光谱(FTIR)对样品的物相结构和组成进行表征分析。研究表明,表面活性剂的类型和疏水碳氢链结构会影响4A分子筛的吸附能力,十八烷基三甲基溴化铵(OTAB)碳氢链长,在分子筛表面形成的双分子层密,对Cr(VI)的吸附量最大。采用准一级、准二级、Elovich和Bangham动力学模型对六价铬的吸附数据进行拟合,其中准一级动力学方程最符合十八烷基三甲基溴化铵改性分子筛的吸附行为。同时,分别从Langmuir和Redlich-Peterson等温吸附模型获得六价铬的最大吸附量为13.98 mg/g,且改性分子筛以均一表面吸附为主。     

柴油机微粒中可溶性有机成分的真空干燥条件

柴油机碳烟颗粒(PM)中可溶性有机组分(SOF)含量是其重要的特性参数,而真空干燥法可方便、高效、可靠地分析颗粒SOF含量,对其干燥条件的探索具有重要的研究意义和应用价值。首先采用模拟的柴油机颗粒,分析不同的干燥条件对模拟SOF(柴油、润滑油)挥发率的影响规律,得出模拟的SOF分析的最佳干燥条件;在此基础上,探索了真实柴油机颗粒SOF分析的最佳干燥条件为:干燥温度220℃、干燥时间3 h、真空度98 kPa,得知SOF组分干燥的难易程度介于柴油和润滑油之间;同时,根据此干燥条件,分析了排气管末端采集的真实碳烟颗粒的SOF含量特性。     

The fate and risk of selected pharmaceutical and personal care products in wastewater treatment plants and a pilot-scale multistage constructed wetland system

The removal of 12 pharmaceuticals and personal care products (PPCPs) in two full-scale wastewater treatment plants (WWTPs) and a tertiary treatment system was studied. The ecological risks of effluents from both secondary and tertiary treatment systems as well as excess sludge were evaluated. Primary treatment and ultraviolet light disinfection showed limited ability to remove most selected PPCPs. The combination of an anaerobic process and triple-oxidation ditches can eliminate DEET better than the anaerobic/anoxic/oxic process. Adsorption to sludge played a key role in the removal of triclocarban. Multistage constructed wetlands as a tertiary treatment efficiently removed caffeine and ibuprofen from wastewater and could decrease the risk of partial selected PPCPs. Selected PPCPs residues in excess sludge generally produced higher risks to the ecological environment than effluents from WWTPs.     

Rapid and efficient removal of Ni2+ from aqueous solution by the one-pot synthesized EDTA-modified magnetic nanoparticles

A facile one-pot process has been proposed to prepare the novel ethylenediaminetetraacetic acid (EDTA)-modified magnetite nanoparticles (EDTA-MNPs). The bared Fe₃O₄ magnetite nanoparticles and EDTA-MNPs were characterized using FTIR spectroscopy, TEM, VSM, and X-ray diffraction. The application of the modified magnetite nanoparticles for metal ion uptake was studied using Ni²⁺ as a model. The adsorption was fast and the equilibrium was established within 5 min, and the adsorption kinetics of Ni²⁺ onto EDTA-MNPs followed the pseudo second-order chemisorption mechanism. Maximum adsorption capacity for Ni²⁺ reached as high as 41.3 mg/g at pH 6. The successive adsorption–desorption studies indicated that the EDTA-MNPs kept the adsorption and desorption efficiencies constant over ten cycles. Importantly, EDTA-MNPs were able to remove nearly 100 % of Ni²⁺ from real water.     

Impact assessment of human diet changes with rapid urbanization on regional nitrogen and phosphorus flows—a case study of the megacity Shanghai

Regional material flows are strongly influenced by human diets. To diagnose and prevent environmental problems that threaten urban sustainability, the impact of human diet changes with rapid urbanization on the regional nitrogen (N) and phosphorus (P) flows were quantitatively evaluated. A survey of day-to-day activities was conducted of 450 individuals surveyed (adults over 18 years old) in three representative areas (the central district, the new district, and the suburban/rural areas) of Shanghai, a megacity which has attracted worldwide attention. The lifestyle (eating habits, domestic sanitation, drainage facilities, etc.) pattern was determined and the potential N and P loads from human diets on the environment were calculated. The daily potential nitrogen and phosphorus loads from human diets was 19.36 g-N, 1.80 g-P in the central district, 16.48 g-N, 1.52 g-P in the new district, and 13.04 g-N, 1.20 g-P in the suburban/rural areas of Shanghai. Respondents in all three areas, especially those in the suburban/rural areas reported a preference for increasing the intake of animal-derived as well as processed foods, which means that the potential N and P load from human diets to the environment will increase further. In addition, most respondents consider industrial wastewater discharge as the main cause of eutrophication of waterbodies, though in recent years water pollution caused by domestic wastewater has increased rapidly, but this has received much less attention. Environment-friendly eating habits and improvements in the environmental awareness will be required.     

The influences of pH and ionic strength on the sorption of tylosin on goethite

As one of the widely used antibiotics in the world, the environmental risks of tylosin (TYL) received more and more attention. In order to assess its environmental fate and ecological effects accurately, it is necessary to understand the sorption properties of TYL on the soils/sediments. The sorption of TYL on goethite at different pH and ionic strength conditions were measured through a series of batch experiments and the sorption data of TYL were fitted by Freundlich and dual-mode sorption models. It was obvious that sorption was strongly dependent on pH and ionic strength. Sorption capacity of TYL increased as the pH increased and ionic strength decreased. The pH and ionic strength-dependent trends might be related with complexation between cationic/neutral TYL species and goethite. The sorption affinity of TYL on goethite decreased as ionic strength increased, which only occurred at higher TYL concentrations, suggested that inner complex might have dominated process at low concentrations and outer complex might occur at higher concentrations of TYL. Spectroscopic evidence indicated that tricarbonylamide and hydroxyl functional groups of TYL might be accounted for the sorption on mineral surfaces. The experimental data of TYL sorption could be fitted by surface complexation model (FITEQL), indicating that ≡FeOH with TYL interaction could be reasonably represented as a complex formation of a monoacid with discrete sites on goethite. The sorption mechanism of TYL might be related with surface complexation, electrostatic repulsion, and H-bounding on goethite. It should be noticed that the heterogeneous of sorption affinity of TYL on goethite at various environment to assess its environment risk.     

优化的甘蔗皮渣吸附居室甲醛

为了研究优化后的甘蔗皮渣吸附居室中的甲醛,本研究通过3种方法处理材料进行吸附甲醛对比,得出简便高效的碱热烫处理,并针对其热烫时间(X1)、pH值(X2)、水浴锅温度(X3)和水浴时间(X4)设置正交实验,得出热烫时间30 min、pH=11、水浴锅温度80℃、水浴时间2.5 h,甘蔗皮渣对甲醛吸附率可达27.91%。通过与活性炭、硅藻纯吸附效果比较,经F检验得出优化处理甘蔗皮渣与硅藻纯吸附效果相当,均极显著优于活性炭。电镜观测出优化甘蔗皮渣与活性炭、硅藻纯同具粗糙、皱褶、疏松多孔结构;傅里叶红外光谱分析出C≡C等基团在甲醛吸附中起主要作用。