东大别地区重大地震事件深部地壳结构特征

本文应用东大别地区层析成像研究结果,对研究区重大地震事件的深部地壳结构特征进行了研究,结果表明：霍山地区的2次MS≥6.0级地震在深部地壳结构上具有一定的相似性;1970年以来的12次MS≥4.0地震在25 km深度的地壳速度结构特征比较接近。     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

常温下短程硝化实现及稳定性试验研究

以自配模拟氨氮废水为研究对象,在全程硝化污泥的基础上通过控制低曝气量和提高反应器进水pH值,在较低的DO质量浓度和较高pH值条件下完成了短程硝化污泥的驯化,系统中的NO2--N积累率稳定在95%以上;逐渐提高硝化阶段的曝气量、降低进水溶液的pH值,短程硝化过程没有被破坏;稳定的短程硝化系统改为定时控制,过度曝气6 d后,NO2--N的积累率仅剩43.7%,硝化类型由短程硝化转变为全程硝化。     

絮凝-SBR-Fenton氧化处理酶制剂废水的研究

以某酶制品厂的废水为研究对象,确定了絮凝-SBR-Fenton高级氧化的试验方法.结果表明,在絮凝阶段,当聚合氯化铝(PAC)投加量为0.6g/L,搅拌6 min,絮凝70min的条件下,预处理的出水CODCr效果最好,去除率为44.6%;再经过SBR工艺处理,停留时间为14 h时,CODCr去除率达到了89.2%;之后再进行Fenton高级氧化,氧化的最佳条件是:ρ(FeSO4·7H2O)为3 g/L,ρ(H2O2)为0.8g/L,反应时间2 h.最终出水达到了GB 8978-1996<污水综合排放标准>中二级排放标准.     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

地球化学定量预测法在武夷成矿带铜资源潜力评价中的应用

利用地球化学定量预测理论方法技术,建立了武夷成矿带紫金山铜金矿等7个典型矿床的地质-地球化学找矿模型,圈定了54处AB级预测区,并利用地球化学定量预测法分别估算了每类预测区的铜资源量,为科学评估武夷成矿带的铜矿资源潜力和该成矿带地质矿产勘察工作部署提供地球化学依据。     

热强化气相抽提对不同质地土壤中苯去除的影响

研究应用电阻加热强化气相抽提技术对砂土、壤土和黏土中苯去除效果的影响及作用机制.与常规抽提结果相比,在热强化处理作用下气相抽提对砂土和壤土中苯的去除效率提高了13.1%和12.3%,处理时间分别降低75%和14%.热强化处理使得黏土含水率下降,土壤渗透率升高,黏土颗粒表面羧基和乙基的吸收峰消失,有机质含量减少,苯的去除效率与对照相比提高了34%.对于砂土和壤土,热强化主要是通过促进苯在土体中扩散来提高去除效率,从而实现在较短时间内污染物质的大量去除;而对于黏土则是通过降低土壤颗粒表面有机基团的含量,从而降低污染物和土壤颗粒的吸附能力,并通过降低含水率和升高渗透率从而提高土壤中气体的扩散性能,以达到增强气相抽提效果的目的.     

硫黄联合装置停工密闭吹扫的实现

介绍了中国石化济南分公司硫黄回收联合装置安全环保停工的过程,在硫黄回收联合装置停工前,研究讨论各装置停工密闭吹扫的流程及方法,并确定各装置停工吹扫的顺序、注意事项和前期准备工作。在各装置停工吹扫过程中,严格按照停工方案,采取了分装置吹扫,该装置吹扫完毕后立即加盲板隔离,最后放火炬公用系统采取倒吹扫,实现了装置停工密闭吹扫,达到了各装置停工酸性气系统吹扫不放火炬的要求。     

基于相关性分析的PCBA热力学模型修正

目的精确且高效地对印制电路板组件热力学模型进行修正。方法采用基于拉丁超立方抽样试验设计和Speraman等级相关系数计算公式的相关性分析方法,找出电子产品热仿真试验中对元器件表面温度值影响较大的输入参数,然后进一步分析得出输入与输出之间的函数关系。在此基础上给出印制电路板组件(PCBA)热力学模型修正的一般方法流程。最后利用该方法对某航空电子产品中一块PCBA的热力学模型进行修正。结果修正结果较精确且只调用2次有限元软件。结论该热模型修正方法具有较高的精确性和高效性,可推广用于工程实践。     

两种喹诺酮类抗生素对亚心形扁藻的毒性效应研究

研究了恩诺沙星和盐酸环丙沙星两种喹诺酮类抗生素对亚心形扁藻的毒理学效应。经多组不同浓度的两种抗生素处理后,分别对扁藻的96EC50、叶绿素和胞外聚合物（EPS）进行分析。结果表明,两种抗生素在低浓度时对扁藻生长具有促进作用,而在高浓度时体现抑制毒性作用。高浓度时,抗生素浓度越高对扁藻的生长、叶绿素和胞外聚合物抑制效果越明显,但当浓度达到一定高度后,抑制会达到其阈值。恩诺沙星和盐酸环丙沙星对扁藻的半生长抑制率分别为19.8 mg/L和28.7 mg/L。