Objective and subjective measurements of slipperiness in fast-food restaurants in the USA and their comparison with the previous results obtained in Taiwan

Floor slipperiness is a critical issue in slip and fall incidents which are a major source of occupational injuries. The objectives of the current study were to investigate if the protocols used in a field study conducted in Taiwan could be used in similar environments in the USA and whether consistent results could be obtained. Protocols used in the field study to investigate floor slipperiness in western-style fast-food restaurants in Taiwan included both objective and subjective measurements. Using the same methods as in Taiwan, friction was measured on tiles in six major working areas of 10 fast-food kitchens in the USA as an objective measurement of slipperiness, while the subjective measurement was employees’ ratings of floor slipperiness over the same areas. The Pearson’s and Spearman’s correlation coefficients in the USA between the averaged friction coefficients and subjective ratings for all 60 evaluated areas across 10 restaurants were 0.33 (p = 0.01) and 0.36 (p = 0.005), respectively, which were lower than the correlations of 0.49 and 0.45, respectively, obtained in Taiwan. Cultural differences, the amount of water on the floors in the sink areas and the existence of a slip resistant shoe program in one country might be contributors to the lower correlation coefficients in the USA. However, the current study confirmed the results obtained in Taiwan that average friction coefficient and perception values are in fair agreement, suggesting that both might be reasonably good indicators of slipperiness.     

Deriving a bioavailability-based zinc environmental quality standard for France

Environmental Science and Pollution Research - National Environmental Quality Standards (EQS) for zinc used for the assessment of ecological status in freshwaters have been shown to vary by over...     

Comparing Contaminant Removal Costs for Aquifer Recharge with Wastewater with Water Supply Benefits

The use of waters of impaired quality has been suggested as a means to expand available water resources supply for water‐limited communities. An ongoing concern is the safety of supplies that use wastewater because of the potential for introduction of emerging contaminants such as pharmaceuticals into drinking water supplies. Prior research into contaminants of emerging concerns (CECs) have included a variety of methods, but the only consistent removal is with reverse osmosis (RO) membranes, ultraviolet light (UV), and advanced oxidation processes (AOP). However, few of these prior studies have measurable quantities of these contaminants in the influent wastewater, so determining actual removal percentages is difficult. This project was designed to evaluate the removal of CECs to verify that a 3‐log removal of common constituents was realized. Spike testing was used to compare to prior research and to evaluate whether the project costs were competitive with other forms of reuse or other water supplies. The combination of RO/UV/AOP was effective at obtaining a 3‐log removal of CECs, but the RO and UV/AOP processes alone were not capable of removing all substances. However, despite the extensive treatment, the proposed process was both competitive cost‐wise and met the water quality goals.     

Parasite genotypes identify source populations of migratory fish more accurately than fish genotypes

DNA-based assignment of individuals to their population of origin has many applications such as mixed-stock analysis, identifying individuals from protected populations, and elucidating migration patterns. However, low genetic differentiation among populations will cause misassignments. Thus, an alternative means of determining an individual's population of origin is needed in cases where there is little or no neutral differentiation among source populations. Here, we test the hypothesis that parasite genotypes can be used to identify the origins of hosts more accurately than host genotypes. Using microsatellite markers from steelhead trout and their trematode parasites, we show that the odds of correct assignment are four times greater with the parasite's genotypes than with the host's genotypes. Our analyses show that this result is simply explained by the greater genetic structure among populations of the trematode parasite. Recent studies on the comparative genetic structure of other host and parasite species suggest that our results are not unusual or unique to the host-parasite system we studied. Thus, our work indicates that parasites will be useful for a wide range of applied and basic research that requires the assignment of individuals to source populations.     

Validation of three new methods for determination of metal emissions using a modified Environmental Protection Agency Method 301

Three new methods applicable to the determination of hazardous metal concentrations in stationary source emissions were developed and evaluated for use in U.S. Environmental Protection Agency (EPA) compliance applications. Two of the three independent methods, a continuous emissions monitor-based method (Xact) and an X-ray-based filter method (XFM), are used to measure metal emissions. The third method involves a quantitative aerosol generator (QAG), which produces a reference aerosol used to evaluate the measurement methods. A modification of EPA Method 301 was used to validate the three methods for As, Cd, Cr, Pb, and Hg, representing three hazardous waste combustor Maximum Achievable Control Technology (MACT) metal categories (low volatile, semivolatile, and volatile). The modified procedure tested the methods using more stringent criteria than EPA Method 301; these criteria included accuracy, precision, and linearity. The aerosol generation method was evaluated in the laboratory by comparing actual with theoretical aerosol concentrations. The measurement methods were evaluated at a hazardous waste combustor (HWC) by comparing measured with reference aerosol concentrations. The QAG, Xact, and XFM met the modified Method 301 validation criteria. All three of the methods demonstrated precisions and accuracies on the order of 5%. In addition, correlation coefficients for each method were on the order of 0.99, confirming the methods' linear response and high precision over a wide range of concentrations. The measurement methods should be applicable to emissions from a wide range of sources, and the reference aerosol generator should be applicable to additional analytes. EPA recently approved an alternative monitoring petition for an HWC at Eli Lilly's Tippecanoe site in Lafayette, IN, in which the Xact is used for demonstrating compliance with the HWC MACT metal emissions (low volatile, semivolatile, and volatile). The QAG reference aerosol generator was approved as a method for providing a quantitative reference aerosol, which is required for certification and continuing quality assurance of the Xact.     

Origin of 2-ethylhexanol as a VOC

2-Ethylhexanol has been identified as a volatile organic compound (VOC) that contributes to the deterioration of indoor air quality. Plasticizers are common components of dust and building materials and are shown to be degraded by a variety of bacteria and fungi to produce 2-ethylhexanol and other metabolites. Of these, the 2-ethylhexanol has significant volatility and was observed in appreciable quantities. The degree to which 2-ethylhexanol is observed as a VOC in air samples would be limited by the fact that many of the microorganisms that are capable of producing this compound are also able to oxidize it to 2-ethylhexanoic acid, which is much less volatile. It is argued that an abiotic degradation mechanism of plasticizers that results in the generation of 2-ethylhexanol is unlikely and, if this did occur, other metabolites should have been observed. Thus, the microbial degradation of plasticizers is the most likely source of 2-ethylhexanol in indoor air.     

Can Warmwater Streams Be Rehabilitated Using Watershed-Scale Standard Erosion Control Measures Alone?

Degradation of warmwater streams in agricultural landscapes is a pervasive problem, and reports of restoration effectiveness based on monitoring data are rare. Described is the outcome of rehabilitation of two deeply incised, unstable sand-and-gravel-bed streams. Channel networks of both watersheds were treated using standard erosion control measures, and aquatic habitats within 1-km-long reaches of each stream were further treated by addition of instream structures and planting woody vegetation on banks (“habitat rehabilitation”). Fish and their habitats were sampled semiannually during 1–2 years before rehabilitation, 3–4 years after rehabilitation, and 10–11 years after rehabilitation. Reaches with only erosion control measures located upstream from the habitat measure reaches and in similar streams in adjacent watersheds were sampled concurrently. Sediment concentrations declined steeply throughout both watersheds, with means ≥40% lower during the post-rehabilitation period than before. Physical effects of habitat rehabilitation were persistent through time, with pool habitat availability much higher in rehabilitated reaches than elsewhere. Fish community structure responded with major shifts in relative species abundance: as pool habitats increased after rehabilitation, small-bodied generalists and opportunists declined as certain piscivores and larger-bodied species such as centrarchids and catostomids increased. Reaches without habitat rehabilitation were significantly shallower, and fish populations there were similar to the rehabilitated reaches prior to treatment. These findings are applicable to incised, warmwater streams draining agricultural watersheds similar to those we studied. Rehabilitation of warmwater stream ecosystems is possible with current knowledge, but a major shift in stream corridor management strategies will be needed to reverse ongoing degradation trends. Apparently, conventional channel erosion controls without instream habitat measures are ineffective tools for ecosystem restoration in incised, warmwater streams of the Southeastern U.S., even if applied at the watershed scale and accompanied by significant reductions in suspended sediment concentration.     

Investigation into the effects of ingestion of zinc shot by Mallard Ducks (Anas platyrhynchos)

Lead fishing weights and gun shot have been identified as a widespread cause of poisoning of swans and other wildfowl (order Anseriformes). As part of the efforts to find environmentally acceptable substitutes for lead, this paper describes the results obtained from a trial which involved the feeding of zinc shot to groups of mallard (Anas platyrhynchos). Observations of the mallard during the experimental period, post mortem examination, histo-pathological examination and also chemical analysis of liver, kidney and feathers, revealed no ill effects to the dosed birds and indicated that zinc metal in shot from probably presents no detectable health threat to wild birds if ingested.