Treatment of hydrocarbon contamination under flow through conditions by using magnetite catalyzed chemical oxidation

Soil pollution by hydrocarbons (aromatic and aliphatic hydrocarbons) is a major environmental issue. Various treatments have been used to remove them from contaminated soils. In our previous studies, the ability of magnetite has been successfully explored to catalyze chemical oxidation for hydrocarbon remediation in batch slurry system. In the present laboratory study, column experiments were performed to evaluate the efficiency of magnetite catalyzed Fenton-like (FL) and activated persulfate (AP) oxidation for hydrocarbon degradation. Flow-through column experiments are intended to provide a better representation of field conditions. Organic extracts isolated from three different soils (an oil-contaminated soil from petrochemical industrial site and two soils polluted by polycyclic aromatic hydrocarbon (PAH) originating from coking plant sites) were spiked on sand. After solvent evaporation, spiked sand was packed in column and was subjected to oxidation using magnetite as catalyst. Oxidant solution was injected at a flow rate of 0.1 mL min^?1 under water-saturated conditions. Organic analyses were performed by GC–mass spectrometry, GC–flame ionization detector, and micro-Fourier transform infrared spectroscopy. Significant abatement of both types of hydrocarbons (60–70 %) was achieved after chemical oxidation (FL and AP) of organic extracts. No significant by-products were formed during oxidation experiment, underscoring the complete degradation of hydrocarbons. No selective degradation was observed for FL with almost similar efficiency towards all hydrocarbons. However, AP showed less reactivity towards higher molecular weight PAHs and aromatic oxygenated compounds. Results of this study demonstrated that magnetite-catalyzed chemical oxidation can effectively degrade both aromatic and aliphatic hydrocarbons (enhanced available contaminants) under flow-through conditions.     

Observations on the influence of water and soil pH on the persistence of insecticides

Abstract

The pH‐disappearance rate profiles were determined at ca. 25°C for 24 insecticides at 4 or 5 pH values over the range 4.5 to 8.0 in sterile phosphate buffers prepared in water‐ethanol (99: 1 v/v). Half‐lives measured at pH 8 were generally smaller than at lower pH values. Changes in half lives between pH 8.0 and 4.5 were largest (>1000x) for the aryl carbamates, carbofuran and carbaryl, the oxime carbamate, oxamyl, and the organophosphorus insecticide, trichlorfon. In contrast, half lives of phorate, terbufos, heptachlor, fensulfothion and aldicarb were affected only slightly by pH changes. Under the experimental conditions described half lives at pH8 varied from 1–2 days for trichlorfon and oxamyl to >1 year for fensulfothion and cyper‐methrin. Insecticide persistence on alumina (acid, neutral and basic), mineral soils amended with aluminum sulfate or calcium hydroxide to different pH values and four natural soils of different pH was examined. No correlation was observed between the measured pH of these solids and the rate of disappearance of selected insecticides applied to them. These observations demonstrate the difficulty of extrapolating the pH dependent disappearance behaviour observed in homogeneous solution to partially solid heterogeneous systems such as soil.     

Comparison of Three Extraction Methods for 17 β-Estradiol in Sand,Bentonite, and Organic-Rich Silt Loam

Extraction is an important procedure for samples that contain soil because other compounds in soil may affect analysis of estrogens. This study was conducted to evaluate three different extraction methods for 17β-estradiol in soil. Sand, bentonite, and organic-rich silt loam were spiked with 1 mg kg^{? 1} of 17β-estradiol as a model compound of estrogens. 17β-estradiol and its metabolites, estrone and estriol, were extracted using (i) a modified Bligh and Dyer extraction, (ii) a pressurized fluid extraction, and (iii) a diethyl ether extraction, and measured by liquid chromatography tandem mass spectrometry. There were significant differences in the extraction efficiency for 17β-estradiol among the extraction methods and the soils: the efficiencies ranged from 10% to 97%. Overall, the diethyl ether extraction method had the largest efficiency of 17β-estradiol with 45% and 57% for bentonite and silt loam, respectively. Transformation of 17β-estradiol to estrone and estriol in the different extraction methods was less than 3.6% during the extraction procedures. This study underlined the importance of sample preparation for estrogen analysis in soil samples.     

Experimental Verification of Diffusion Battery Theory

The diffusion battery, an assembly of circular tubes or rectangular channels, is one of the best devices available for measuring the size and size distribution of submicron aerosols in the diameter range 0.002 to 0.2 µ m. The performance of these batteries is known from molecular diffusion theory, but until now has not been checked experimentally in this size range because of the lack of the necessary monodisperse aerosols. Experimental measurements on singly charged monodisperse aerosols from 0.01 µm to 0.1 µ m are described using a General Electric and a Pollak condensation nucleus counter to measure the aerosol penetration through the stages of a set of portable diffusion batteries in series. Particle sizes in the range tested could be selected at will by adjusting the voltage of an electric mobility classifier. The fraction of aerosol of a given size passing through each battery stage was found to agree closely with the penetration calculated from molecular diffusion theory for that size. This shows that the theory is correct and confirms that the aerosol produced by the electric mobility classifier was monodisperse. In addition, it was found that the difference in penetration between a charged versus a neutralized aerosol was insignificant except for the smallest aerosols used.     

Interactions Between Potassium and Sulfur Species in a Coal-Fired Magnetohydrodynamics System

The interactions between potassium and sulfur-containing species are unique, yet important, phenomena for a coal-fired magnetohydrodynamics (MHD) system. An in-depth understanding of such phenomena will help in the future design of MHD systems. This paper deals with the modeling of potassium and sulfur interactions in DOE's Coal-Fired Flow Facility (CFFF), located in Tullahoma, Tennessee.