A Wind Tunnel Study of Gaseous Pollutants in City Street Canyons

Steady state mean concentrations of tracer gas were measured in a 400:1 scale model of an idealized city with variable geometry placed within a wind tunnel at various orientations to the mean flow for a free stream velocity of 6.8 ft/sec. The tracer gas was released from two parallel line sources to simulate lanes of traffic in an effort to quantify the persistence of pollution as well as the mean values realized at street levels. An aerodynamically rough turbulent boundary layer of neutral thermal stratification was employed to simulate the atmosphere. Values of concentration measured in the model city were converted to prototype concentrations in ppm and compared to National Ambient Air Quality Standards. It was shown that single isolated structures may cause favorable mixing of pollution downwind but very high concentrations exist in the immediate leeward vicinity of the building. Two favorable geometries for city blocks tested were found to reduce pedestrian exposure to pollution both near heavy traffic congestion and downwind. It was concluded that the pollutant dilution was controlled by the mean flow rather than by turbulent diffusion and that the lateral spread of the plume was slight as one proceeded downwind of the line source. The combination of favorable geometry and higher dilution velocities may bring pollution levels down to existing Air Quality Standards. The body of information presented in this paper should interest city planners and air quality monitoring personnel, as well as those researchers attempting to study and model flow in city street canyons. It provides order of magnitude estimates on pedestrian and office worker exposure to pollutants under a wide range of conditions.     

Weekday-Weekend Pollutant Studies of the Los Angeles Basin

Pollutant data from the Los Angeles Basin were analyzed for weekday-weekend differences for the smog months of June through September 1972 and 1973. The pollutants investigated were oxidant, NO, NO₂, total hydrocarbons (HC), CO, and particulates. In order to maintain the diurnal variation, the concentration percentiles were calculated for each weekday and weekend hour.     

Cooling Towers and the Environment

Measurements of natural draft cooling tower plume behavior, as well as meteorological variables, were obtained from aircraft flights near major power plants of the American Electric Power System. Persistence of the visible plume to great distances depends essentially on ambient humidity. Atmospheric stability at plume elevation was also important. Cooling tower-induced fog at ground-level was never observed in any of the tests, and aerodynamic downwash of the visible plume was absent also. The cooling towers did cause modification of natural clouds and they occasionally shadowed some local areas from the sun. Merging of the stack and cooling tower plumes was a common occurrence.     

Theory for Penetration in A Pulse-Jet Cleaned Fabric Filter

Presently, there is no effective way to interpret or predict dust penetration through a pulse-jet cleaned fabric filter. This paper presents a model which considers penetration straight through the filter and penetration by seepage. A considerable number of studies have been devoted to penetration by the straight through process; however, a comparison of data from the literature with the present model indicates that seepage and not straight through penetration accounts for virtually all penetrating dust. Although insufficient information is presently available to use the model to predict penetration, the model does show trends that should occur with changes in filter operating variables such as filtration velocity and pulse pressure, and suggests areas in which further research is necessary.     

The Inadequacy of PSD Increments to Protect Visibility in Class I Areas

This study includes an application of the first two phases of a new three-phased decision-making structure that was developed to overcome the problems related to ecological safety and social justice in site selection applications. It was conducted on a current site selection problem related to the municipal solid waste disposal facilities in Kocaeli, the most industrialized region of Turkey. In order to assess the deficiencies of the legal site selection procedures related to ecological safety, two different decision tree modes were applied separately. The first mode (“Legislation”) concerns the current buffer zone applications given in the regulations, while the second one (“Proposed”) includes the applications of the new decision-making structure proposed in this study. Since it was assumed that the subjective tendencies of the decision makers on the weightings would have a significant effect on the final decision, these two modes were assessed by employing two different weighting models. The results were obtained from all of the scenarios related to selection of suitable sites with three different area requirements (15, 250, and 500 acres) for the solid wastes generated in the Kocaeli region. The results showed that the possible changes in the decision structure could cause significant differences in the final decision related to selection of the most suitable sites. The most highest and lowest differences were at the “Legislation” mode for 15 acres and 500 acres, respectively. Furthermore, the results obtained in the study showed that the possible differentiations in the criteria weightings could also cause significant differences in the suitability ranking. Therefore, to get a reliable final decision, a statistical assessment of these differentiations should be made.

Implications: The results showed that the possible changes in the decision structure could cause significant differences in the final decision related to selection of the most suitable sites. Furthermore, the results obtained in the study showed that the possible differentiations in the criteria weightings could also cause significant differences in the suitability ranking. Therefore, to get a reliable final decision, a statistical assessment of these differentiations should be made.     

Testing and Commercialization of Byproduct Dibasic cids as Buffer Additives for Limestone Flue Gas esulfurization Systems

Pilot plant (0.1 MW) tests and utility boiler full scale demonstration (194 MW) of byproduct organic dibasic acids (DBA) as buffer additives to limestone scrubbers have shown performance improvements equivalent to those achieved by the addition of pure adipic acid. Both SO₂ removal efficiency and limestone utilization increased, and no significant operating problems were observed with three of the four DBA tested. Chemical and biological evaluations of scrubber samples taken during the DBA testing indicated no detectable tOxicity or mutagenicity, and no significant environmental impact is expected as a result of DBA addition. Economic estimates indicate that substitution of DBA for pure adipic acid as a buffer additive will result in additive cost savings of 30 % or greater.     

1987 Joint EPRI/EPA Symposium on Stationary Combustion NOX Control

From March 23rd to 26th, 1987, the city of New Orleans hosted 350 attendees, including representatives from 15 foreign countries, at the 1987 Joint Symposium on Stationary Combustion NO_x Control. Cosponsored by the Electric Power Research Institute (EPRI) and the U.S. Environmental Protection Agency (EPA), the symposium provided attendees the opportunity to hear 49 papers in nine sessions covering technological and regulatory developments on NO_x control in the United States and abroad since the May 1985 symposium in Boston. Session topics included general environmental issues, low-NO_x combustion equipment (i.e., low-NO_x burners, reburning, etc.), flue gas treatment, fundamental combustion research, and special issues for cyclone coal-fueled boilers, oil- and gas-fired boilers, and industrial combustion applications.

Advances to the state-of-the-art presented at this symposium include: improved and/or newly applied combustion modifications for pulverized coal-fired boilers; further analyses of reburning, the leading combustion modification option for cyclone-equipped boilers; initial experiences with catalytic flue gas treatment in Europe; studies of NO_x control retrofit options for oil- and gas-fired utility systems; and new technology developments for coal, oil, and gas fueled utility and industrial combustors.

This paper summarizes those presentations that discussed significant changes since May 1985 in areas of potential interest to EPRI and its utility members. Where appropriate, they include our perspectives on the applicability of these newly disclosed findings to utility systems.     

Predicting and Managing the Health Risks of Sour-Gas Wells

The development of sour-gas resources in Canada and the United States has prompted concerns about the public health risks of accidental releases of gas contaminated with hydrogen sulfide (H₂S) from wells. This paper focuses on methods for improving the prediction and management of those risks. Data associated with the health effects of hydrogen sulfide are examined, and it is suggested that sublethal effects should be addressed in risk assessments of sour-gas wells along with the life-threatening effects normally considered. The demarcation of hazard zones around wells can be improved by using a statistical approach for estimating an upper-bound H₂S release rate; this rate can then be used in an atmospheric dispersion model to estimate maximum distances to downwind concentrations for lethal (300 ppmv) and sublethal (50 ppmv) effects resulting from an accidental release. A vertical release is found to have little impact, especially under stable atmospheric conditions; horizontal releases, on the other hand, result in the greatest downwind distances for health impacts. Management of health risks depends on a mix of safety technologies and contingency actions, such as well-ignition options and provision for post-release monitoring and assessment of ambient H₂S concentrations.     

Use of Energy Scenarios in Addressing the CO2 Question

A reference scenario for CO₂ emissions was developed using a model of world energy supply and demand. In the reference scenario, world GNP and world energy demand increase at average rates of 2.1 percent per year and 1.5 percent per year, respectively during the period 1975-2100. The corresponding annual CO₂ emissions rise to a maximum of 16 gigatons of carbon around 2050 and then decline as a result of a transition to nonfossil fuel energy systems. A modified scenario for high CO₂ emissions was obtained by assuming an abundant supply of low cost coal, thus eliminating the transition. A low case was developed in which the low cost of alternative energy (i.e., solar, nuclear) induces an earlier shift away from fossil fuels.

Annual emissions of the three scenarios were used as input to a global carbon cycle model and the CO₂ buildup in the atmosphere during the period 1980-2100 was determined by the model. All three scenarios showed continuous rises in atmospheric CO₂ concentration. The reference scenario reached 775 ppm by 2100. The high CO₂ case resulted in concentrations of over 1040 ppm, and for the low case the 2100 concentration was just under 700 ppm. If the climate theory is correct, even 700 ppm is sufficient to give significant climate warming, but by experiencing the change gradually over a century, adaptation may not be painful. An early transition to nonfossil fuel supplies makes the problem less severe but does not eliminate it.