Emission factors and exposures from ground-level pyrotechnics

Potential exposures from ground-level pyrotechnics were assessed by air monitoring and developing emission factors. Total particulate matter, copper and SO₂ exposures exceeded occupational health guidelines at two outdoor performances using consumer pyrotechnics. Al, Ba, B, Bi, Mg, Sr, Zn, and aldehyde levels were elevated, but did not pose a health hazard based on occupational standards. Emission factors for total particulate matter, metals, inorganic ions, aldehydes, and polyaromatic hydrocarbons (PAHs) were determined for seven ground-supported pyrotechnics through air sampling in an airtight room after combustion. Particle generation ranged from 5 to 13% of the combusted mass. Emission factors (g Kg^?1) for metals common to pyrotechnics were also high: K, 23–45; Mg, 1–7; Cu, 0.05–7; and Ba, 0.03–6. Pb emission rates of 1.6 and 2.7% of the combusted mass for two devices were noteworthy. A high correlation (r² ≥ 0.89) between metal concentrations in pyrotechnic compositions and emission factors were noted for Pb, Cr, Mg, Sb, and Bi, whereas low correlations (r² ≤ 0.1) were observed for Ba, Sr, Fe, and Zn. This may be due to the inherent heterogeneity of multi-effect pyrotechnics. The generation of inorganic nitrogen in both the particulate (NO₂^?, NO₃^?) and gaseous (NO, NO₂) forms varied widely (<0.1–1000 mg Kg^?1). Aldehyde emission factors varied by two orders of magnitude even though the carbon source was carbohydrates and charcoal for all devices: formaldehyde (<7.0–82 mg Kg^?1), acetaldehyde (43–210 mg Kg^?1), and acrolein (1.9–12 mg Kg^?1). Formation of lower molecular weight PAHs such as naphthalene and acenaphthylene were favored, with their emission factors being comparable to that from the combustion of household refuse and agricultural debris. Ba, Sr, Cu, and Pb had emission factors that could produce exposures exceeding occupational exposure guidelines. Sb and unalloyed Mg, which are banned from consumer fireworks in the US, were present in significant amounts.     

Lessons from the 2006 Louisiana health and population survey

The 2005 hurricane season caused extensive damage and induced a mass migration of approximately 1.1 million people from southern Louisiana in the United States. Current and accurate estimates of population size and demographics and an assessment of the critical needs for public services were required to guide recovery efforts. Since forecasts using pre-hurricane data may produce inaccurate estimates of the post-hurricane population, a household survey in 18 hurricane-affected parishes was conducted to provide timely and credible information on the size of these populations, their demographics and their condition. This paper describes the methods used, the challenges encountered, and the key factors for successful implementation. This post-disaster survey was unique because it identified the needs of the people in the affected parishes and quantified the number of people with these needs. Consequently, this survey established new population and health indicator baselines that otherwise would have not been available to guide the relief and recovery efforts in southern Louisiana.     

Integrated approach to PCE‐impacted site characterization,site management,and enhanced bioremediation

Tetrachloroethene (PCE)‐ and trichloroethene (TCE)‐impacted sites pose significant challenges even when site characterization activities indicate that biodegradation has occurred naturally. Although site‐specific, regulatory, and economic factors play roles in the remedy‐selection process, the application of molecular biological tools to the bioremediation field has streamlined the assessment of remedial alternatives and allowed for detailed evaluation of the chosen remedial technology. The case study described here was performed at a PCE‐impacted site at which reductive dechlorination of PCE and TCE had led to accumulation of cis‐dichlorethene (cis‐DCE) with concentrations ranging from approximately 10 to 100 mg/L. Bio‐Trap® samplers and quantitative polymerase chain reaction (qPCR) enumeration of Dehalococcoides spp. were used to evaluate three remedial options: monitored natural attenuation, biostimulation with HRC®, and biostimulation with HRC‐S®. Dehalococcoides populations in HRC‐S‐amended Bio‐Traps deployed in impacted wells were on the order of 10³ to 10⁴ cells/bead but were below detection limits in most unamended and HRC‐amended Bio‐Traps. Thus the in situ Bio‐Trap study identified biostimulation with HRC‐S as the recommended approach, which was further evaluated with a pilot study. After the pilot HRC‐S injection, Dehalococcoides populations increased to 10⁶ to 10⁷ cells/bead, and concentrations of cis‐DCE and vinyl chloride decreased with concurrent ethene production. Based on these results, a full‐scale HRC‐S injection was designed and implemented at the site. As with the pilot study, full‐scale HRC‐S injection promoted growth of Dehalococcoides spp. and stimulated reductive dechlorination of the daughter products cis‐DCE and vinyl chloride. © 2008 Wiley Periodicals, Inc.     

A vehicle emissions system using a car simulator and a geographical information system: Part 1--System description and testing

A methodology for estimating vehicular emissions comprising a car simulator, a basic traffic model, and a geographical information system is capable of estimating vehicle emissions with high time and space resolution. Because of the extent of the work conducted, this article comprises two sections: In Part 1 of this work, we describe the system and its components and use examples for testing it. In Part 2 we will study in more detail the emissions of the sample fleet using the system and will make comparisons with another emission model. The experimental data for the car simulator is obtained using on-board measuring equipment and laboratory Fourier transform IR (FTIR) measurements with a dynamometer following typical driving cycles. The car simulator uses this data to generate emission factors every second. These emission factors, together with information on car activity and velocity profiles of highways and residential and arterial roads in Mexico City in conjunction with a basic traffic model, provide emissions per second of a sample fleet. A geographical information system is used to localize these road emissions.     

Development and implementation of coral reef biocriteria in U.S. jurisdictions

Coral reefs worldwide are declining at an alarming rate and are under continuous threat from both natural and anthropogenic environmental stressors. Warmer sea temperatures attributed to global climate change and numerous human activities at local scales place these valuable ecosystems at risk. Reefs provide numerous services, including shoreline protection, fishing, tourism and biological diversity, which are lost through physical damage, overfishing, and pollution. Pollution can be controlled under provisions of the Clean Water Act, but these options have not been fully employed to protect coral reefs. No U.S. jurisdiction has implemented coral reef biocriteria, which are narrative or quantitative water quality standards based on the condition of a biological resource or assemblage. The President’s Ocean Action Plan directs the U.S. Environmental Protection Agency (EPA) to develop biological assessment methods and biological criteria for evaluating and maintaining the health of coral reef ecosystems. EPA has formed the Coral Reef Biocriteria Working Group (CRBWG) to foster development of coral reef biocriteria through focused research, evaluation and communication among Agency partners and U.S. jurisdictions. Ongoing CRBWG activities include development and evaluation of a rapid bioassessment protocol for application in biocriteria programs; development of a survey design and monitoring strategy for the U.S. Virgin Islands; comprehensive reviews of biocriteria approaches proposed by states and territories; and assembly of data from a variety of monitoring programs for additional metrics. Guidance documents are being prepared to assist U.S. jurisdictions in reaching protective and defensible biocriteria.     

Modelling nutrient loads to Sydney estuary (Australia)

Sydney estuary (Australia) catchment is substantially urbanised (80%) and small (480 km²) with a large population (2.5 million) and is therefore highly sensitive to anthropogenic influence. The Model for Urban Stormwater Improvement Conceptualisation used to model nutrient export to the estuary determined an average annual load of 475 t total nitrogen, 63.5 t total phosphorus and 343,000 t total suspended solids. Model verification included intense, short-term water sampling and analysis undertaken in the current project and use of published data spanning 10 years. Under high-rainfall conditions (>50 mm day^???1), the estuary becomes stratified and nutrients are either removed from the estuary directly in a plume or indirectly by advective/dispersive remobilisation. The majority of the nutrient load is delivered during moderate rainfall (5–50 mm day^???1) conditions and accumulates close to discharge points and remains in the estuary. To significantly reduce nutrient load, management strategies should aim to minimise low and moderate rainfall pollutant loads.     

Equity trade‐offs in conservation decision making

Conservation decisions increasingly involve multiple environmental and social objectives, which result in complex decision contexts with high potential for trade‐offs. Improving social equity is one such objective that is often considered an enabler of successful outcomes and a virtuous ideal in itself. Despite its idealized importance in conservation policy, social equity is often highly simplified or ill‐defined and is applied uncritically. What constitutes equitable outcomes and processes is highly normative and subject to ethical deliberation. Different ethical frameworks may lead to different conceptions of equity through alternative perspectives of what is good or right. This can lead to different and potentially conflicting equity objectives in practice. We promote a more transparent, nuanced, and pluralistic conceptualization of equity in conservation decision making that particularly recognizes where multidimensional equity objectives may conflict. To help identify and mitigate ethical conflicts and avoid cases of good intentions producing bad outcomes, we encourage a more analytical incorporation of equity into conservation decision making particularly during mechanistic integration of equity objectives. We recommend that in conservation planning motivations and objectives for equity be made explicit within the problem context, methods used to incorporate equity objectives be applied with respect to stated objectives, and, should objectives dictate, evaluation of equity outcomes and adaptation of strategies be employed during policy implementation.     

Guiding principles for rewilding

There has been much recent interest in the concept of rewilding as a tool for nature conservation, but also confusion over the idea, which has limited its utility. We developed a unifying definition and 10 guiding principles for rewilding through a survey of 59 rewilding experts, a summary of key organizations’ rewilding visions, and workshops involving over 100 participants from around the world. The guiding principles convey that rewilding exits on a continuum of scale, connectivity, and level of human influence and aims to restore ecosystem structure and functions to achieve a self-sustaining autonomous nature. These principles clarify the concept of rewilding and improve its effectiveness as a tool to achieve global conservation targets, including those of the UN Decade on Ecosystem Restoration and post-2020 Global Biodiversity Framework. Finally, we suggest differences in rewilding perspectives lie largely in the extent to which it is seen as achievable and in specific interventions. An understanding of the context of rewilding projects is the key to success, and careful site-specific interpretations will help achieve the aims of rewilding.     

Mineralogy, morphology, and textural relationships in coatings on quartz grains in sediments in a quartz-sand aquifer

Mineralogical studies of coatings on quartz grains and bulk sediments from an aquifer on Western Cape Cod, Massachusetts, USA were carried out using a variety of transmission electron microscopy (TEM) techniques. Previous studies demonstrated that coatings on quartz grains control the adsorption properties of these sediments. Samples for TEM characterization were made by a gentle mechanical grinding method and focused ion beam (FIB) milling. The former method can make abundant electron-transparent coating assemblages for comprehensive and quantitative X-ray analysis and the latter technique protects the coating texture from being destroyed. Characterization of the samples from both a pristine area and an area heavily impacted by wastewater discharge shows similar coating textures and chemical compositions. Major constituents of the coating include Al-substituted goethite and illite/chlorite clays. Goethite is aggregated into well-crystallized domains through oriented attachment resulting in increased porosity. Illite/chlorite clays with various chemical compositions were observed to be mixed with goethite aggregates and aligned sub-parallel to the associated quartz surface. The uniform spatial distribution of wastewater-derived phosphorus throughout the coating from the wastewater-contaminated site suggests that all of the coating constituents, including those adjacent to the quartz surface, are accessible to groundwater solutes. Both TEM characterization and chemical extraction results indicate there is a significantly greater amount of amorphous iron oxide in samples from wastewater discharge area compared to those from the pristine region, which might reflect the impact of redox cycling of iron under the wastewater-discharge area. Coating compositions are consistent with the moderate metal and oxy-metalloid adsorption capacities, low but significant cation exchange capacities, and control of iron(III) solubility by goethite observed in reactive transport experimental and modeling studies conducted at the site.