Characterization of a limestone in a batch fluidized bed reactor for sulfur retention under oxy-fuel operating conditions

CO₂ and SO₂ are some of the main polluting gases emitted into atmosphere in combustion processes using fossil fuel for energy production. The former is one of the major contributors to build-up the greenhouse effect implicated in global climate change and the latter produces acid rain. Oxy-fuel combustion is a technology, which consists in burning the fuel with a mix of pure O₂ and recirculated CO₂. With this technology the CO₂ concentration in the flue gas may be enriched up to 95%, becoming possible an easy CO₂ recovery. In addition, oxy-fuel combustion in fluidized beds allows in situ desulfurization of combustion gases by supplying calcium based sorbent.In this work, the effect of the principal operation variables affecting the sulfation reaction rate in fluidized bed reactors (temperature, CO₂ partial pressure, SO₂ concentration and particle size) under typical oxy-fuel combustion conditions have been analyzed in a batch fluidized bed reactor using a limestone as sorbent. It has been observed that sulfur retention can be carried out by direct sulfation of the CaCO₃ or by sulfation of the CaO (indirect sulfation) formed by CaCO₃ calcination. Direct sulfation and indirect sulfation operating conditions depended on the temperature and CO₂ partial pressure. The rate of direct sulfation rose with temperature and the rate of indirect sulfation for long reaction times decreased with temperature. An increase in the CO₂ partial pressure had a negative influence on the sulfation conversion reached by the limestone due to a higher temperature was needed to work in conditions of indirect sulfation. Thus, it is expected that the optimum temperature for sulfur retention in oxy-fuel combustion in fluidized bed reactors be about 925–950 °C. Sulfation reaction rate rose with decreasing sorbent particle size and increasing SO₂ concentration.     

Lightning protection scenarios of communication tower sites; human hazards and equipment damage

This paper provides comprehensive analysis on the lightning protection scenarios in 48 communication and broadcasting towers situated in similar isokeraunic contours in Sri Lanka at 79°–81° East and 5°–10° North. The investigation has been conducted to study the hazardous environment created on the tower and in the neighbourhood in the event of a lightning strike to the tower. The results show that a direct strike to an antenna structure in a metallic tower is rare irrespective of the presence of an air-termination or a down conductor. However, side flashing or arcing to antenna structures is highly possible once the air-termination and/or down conductor is installed and attempts are made to insulate the system from the tower. The outcome also shows that equipotential bonding of the grounding system, a distributed grounding network including a ring conductor and a suitable system of surge protective devices play a much vital role in lightning protection of equipment and safety of people compared to the effects of simply achieving a low grounding resistance. However, in the absence of such integrated, distributed and equipotentialized grounding system, a high value of ground resistance will sharply increase the possibility of accidents and damage. Considering the observations of the investigations into account we have designed a concrete embedded grounding system for tower sites at problematic locations. Finally, the scenarios for safety management at telecommunication tower sites have been discussed.     

Zoning a Protected Area: Proposal Based on a Multi-thematic Approach and Final Decision

The Madrid Regional Government (Central Spain) proposes a zone of the Guadarrama Mountains to be declared as a National Park. This paper reports on the zoning method developed to this end. The procedure followed considers compatibility of land uses with landscape characteristics and proposes protecting a part of the zone through declaration of National Park status and declaring another part as a Regional Park. The approach is based upon a multivariate environmental analysis aimed at zoning for optimal location of potential activities. The zoning permits the design of protected areas following the criteria underlying the declaration of these two categories in accordance with the Spanish environmental legislation in force. A practical tool for policy decision-making is provided. However, the final decision taken by policymakers in the design and zoning of protected areas differed from the model output used by the scientists. This is discussed in the paper to illustrate the interactions between political decision-making and scientific modelling.     

Assessment of the levels of DDT and DDE in soil and blood samples from Tabasco, Mexico

In Mexico, 1,1,1-trichloro-2,2-bis(p-chlorophenyl)ethane (DDT) was used until the year 2000, principally in agriculture and anti-paludal program health campaigns. The southeastern region of Mexico was an important area of malaria, and from 1957 DDT was applied indoors every 6?months, with a coverage of 2?g/m². The current study was performed in Tabasco, a Mexican state located in the southeastern region of Mexico. DDT and 1,1-dichloro-2,2-bis(4-chlorophenyl)ethene (DDE) were analyzed by gas chromatography/mass spectrometry. In general, low levels were found in household outdoor samples; the levels of DDT ranged from not detectable to 0.048?mg/kg, and of DDE from 0.001 to 0.068?mg/kg. An important finding was that, in all communities where DDT in blood was analyzed, exposure to DDT was found, indicating both past and present exposure. Although the levels found in this study were lower than other studies in Mexico, there is a need to evaluate whether the people living in the study area are at risk.     

Preliminary assessment of plastic waste valorization via sequential pyrolysis and catalytic reforming

In this article, a life cycle assessment approach is used to carry out a preliminary assessment of the environmental and energy performance of a specific chemical recycling and recovery system that supplies a variety of petrochemical blendstocks through the sequential pyrolysis and catalytic reforming of plastic wastes. Characterization results are presented for a selection of seven impact categories: abiotic depletion, global warming, acidification, eutrophication, ozone layer depletion, photochemical oxidant formation and cumulative non-renewable energy demand. From a combined environmental and energy perspective, the results suggest the suitability of this system for plastic waste valorization. However, improvement actions aimed at reducing the thermal energy demand and mitigating direct emissions to the air should be undertaken. Furthermore, the environmental profiles of the proposed petrochemical blendstocks are compared with those of conventional energy products. A comparison among this chemical recycling and recovery system and two conventional management practices (municipal incineration and landfilling) is also addressed. The results show that the considered system could entail relevant environmental and energy benefits when compared to conventional energy systems and waste management strategies.     

Novel polyol initiator from polyurethane recycling residue

Flexible polyurethane foams can be advantageously treated by two-phase glycolysis in order to recover polyols with improved quality. The bottom phase obtained, which contains highly toxic reaction by-products and the excess glycol, presents an environmental and economic problem which should be solved. The main purpose of this work is the development of process for the valorization of these by-products, converting them in non-dangerous and profitable substances. For this process, most of the glycol can be recovered by means of vacuum distillation in order to reuse it in the glycolysis. On the other hand, the vacuum residue, containing the isocyanate part of the glycolysis by-products, was assayed as initiator in the synthesis of new polyols. Propoxylation of the initiator was carried out in different experimental conditions to obtain several polyether-polyols. Rigid polyurethane foams with suitable technical properties were synthesized with those polyols synthesized with the dangerous glycolysis by-products.     

Protected area characteristics that help waterbirds respond to climate warming

Protected area networks help species respond to climate warming. However, the contribution of a site's environmental and conservation-relevant characteristics to these responses is not well understood. We investigated how composition of nonbreeding waterbird communities (97 species) in the European Union Natura 2000 (N2K) network (3018 sites) changed in response to increases in temperature over 25 years in 26 European countries. We measured community reshuffling based on abundance time series collected under the International Waterbird Census relative to N2K sites’ conservation targets, funding, designation period, and management plan status. Waterbird community composition in sites explicitly designated to protect them and with management plans changed more quickly in response to climate warming than in other N2K sites. Temporal community changes were not affected by the designation period despite greater exposure to temperature increase inside late-designated N2K sites. Sites funded under the LIFE program had lower climate-driven community changes than sites that did not received LIFE funding. Our findings imply that efficient conservation policy that helps waterbird communities respond to climate warming is associated with sites specifically managed for waterbirds.     

Are CO2 Emissions Stationary After All? New Evidence from Nonlinear Unit Root Tests

Environmental Modeling & Assessment - This study applies a large battery of state-of-the-art nonlinear unit root tests to examine the stationarity properties of carbon dioxide emission series...     

Ecotoxicity of oil sludges and residuals from their washing with surfactants: soil dehydrogenase and ryegrass germination tests

Environmental Science and Pollution Research - Oil sludge washing (OSW) with surfactants and co-solvents is used to recover the oil, and this process leaves some residuals (sediments and surfactant...     

Auramine dyes induce toxic effects to aquatic organisms from different trophic levels: an application of predicted non-effect concentration (PNEC)

Environmental Science and Pollution Research - The dyes Auramine and Auramine O are used in several industrial products, despite the scarce information regarding their ecotoxicity. The aim of the...