Natterer’s bat (Myotis nattereri Kuhl, 1818) hawks for prey close to vegetation using echolocation signals of very broad bandwidth

We present a hitherto unknown prey perception strategy in bats: Myotis nattereri (Vespertilionidae, Chiroptera) is able to perceive prey by echolocation within a few centimeters of echo-cluttering vegetation, by using frequency-modulated search signals of very large bandwidth (up to 135 kHz). We describe the species’ search behavior and echolocation repertoire from the field and from experiments in a flight tent. In the field, bats varied signal parameters in relation to their distance from vegetation and usually flew close to vegetation. In the flight tent, M. nattereri detected and localized prey by echolocation alone as close as 5 cm from vegetation. Apparently, the bats were able to tolerate some overlap between prey and clutter echoes. Passive prey cues (vision, olfaction, prey-generated sounds) were not used in prey perception. The bats selected prey by size. The animals performed aerial catches and produced approach sequences typical for aerial hawking bats, but were able to do so within a few centimeters of the substrate. M. nattereri thus has access to silent, suspended prey very close to vegetation (e.g., spiders, and caterpillars on threads). Received: 29 September 1999 / Received in revised form: 12 February 2000 / Accepted: 12 February 2000     

Chemical composition of the slippery epicuticular wax blooms on Macaranga (Euphorbiaceae) ant-plants

Summary. The stems of many Macaranga ant-plants (Euphorbiaceae) are covered by epicuticular wax crystals rendering the surface very slippery for most insects. These wax blooms act as selective barriers protecting the symbiotic ant partners, which are specialized “wax-runners”, against the competition of other ants. Glaucous stems occur almost exclusively among the ant-plants of the genus Macaranga (). We analyzed the cuticular lipids of 16 Macaranga species by GC-MS and investigated the wax crystal morphology using SEM. Presence of crystalline wax blooms was strongly correlated with high concentrations (52%–88%) of triterpenoids. In contrast epicuticular waxes of glossy Macaranga surfaces contained only 0% to 36% of these dominant components. Therefore we conclude that triterpenoids are responsible for the formation of the thread-like Macaranga wax crystals. In all Macaranga ant-plants investigated, the principal components were epitaraxerol and taraxerone accompanied by smaller portions of taraxerol, β-amyrin and friedelin. Only in the case of the non-myrmecophytic M. tanarius did β-amyrin predominate. Moreover, we found that only in M. tanarius, the dense wax crystal lacework is torn into large mosaic-like pieces in the course of secondary stem diameter growth. Both chemical and macroscopic differences may contribute to a reduced slipperiness of M. tanarius stems and appear to be functionally important. The distribution of wax crystals and their composition amongst different sections of the genus suggests that glaucousness is a polyphyletic character within Macaranga. Received 7 October 1999; accepted 3 December 1999     

A survey of antennal responses by five species of coniferophagous bark beetles (Coleoptera: Scolytidae) to bark volatiles of six species of angiosperm trees

Summary. Using Porapak Q traps, we collected the bark volatiles of six angiosperm trees native to British Columbia: black cottonwood, Populus trichocarpa Torr. & A. Gray (Salicaceae), trembling aspen, P. tremuloides Michx. (Salicaceae), paper birch, Betula papyrifera Marsh. (Betulaceae), bigleaf maple, Acer macrophyllum Pursh (Aceraceae), red alder, Alnus rubra Bong. (Betulaceae), and Sitka alder, A. viridis ssp. sinuata (Regel) á. L?ve & D. L?ve (Betulaceae). Utilising coupled gas chromatographic-electroantennographic detection analysis, the captured volatiles were assayed for antennal responses in five species of coniferophagous bark beetles (Coleoptera: Scolytidae), sympatric with most or all of the angiosperm trees: the Douglas-fir beetle, Dendroctonus pseudotsugae Hopkins, the mountain pine beetle, D. ponderosae Hopkins, the spruce beetle, D. rufipennis (Kirby), the western balsam bark beetle, Dryocoetes confusus Swaine, and the pine engraver, Ips pini (Say). The identities of 25 antennally-active compounds were determined by coupled gas chromatographic-mass spectroscopic analysis, and co-chromatographic comparisons with authentic chemicals. The compounds identified were: hexanal, (E)-2-hexenal, (Z)-3-hexen-1-ol, 1-hexanol, heptanal, α-pinene, frontalin, benzaldehyde, β-pinene, 2-hydroxycyclohexanone, 3-carene, limonene, β-phellandrene, benzyl alcohol, (E)-ocimene, salicylaldehyde, conophthorin, guaiacol, nonanal, methyl salicylate, 4-allylanisole, decanal, thymol methyl ether, (E)-nerolidol, and dendrolasin. A number of these compounds are known semiochemicals that are active in the behaviour of other organisms, including bark beetles, suggesting a high degree of semiochemical parsimony. Antennally-active compounds ranged from seven in A. viridis to 17 in P. trichocarpa. The fewest number of compounds (9) were detected by I. pini and the largest number (24) were detected by D. pseudotsugae. Six compounds excited the antennae of all five species of bark beetles. The large number of antennally-active compounds detected in common by numerous bark beetles and present in common in numerous nonhost trees supports the hypothesis of olfaction-based recognition and avoidance of nonhost angiosperm trees during the process of host selection by coniferophagous bark beetles. Received 13 December 1999; accepted 14 March 2000     

Ökotoxikologische und humantoxikologische Risikobewertung PAK-belasteter Böden vor und nach biologischer Behandlung

The goal of the present work is to assess the adverse effects of soil bound polycyclic aromatic hydrocarbons (PAH) which remain in soils after biological remediation. We focus on risk assessment for mammalian species with respect to the oral uptake of contaminated soil particles and compare the results of a biomarker test with those of an ecotoxicological assay, the bioluminescence inhibition test withVibrio fischeri. As a biomarker effect in mammals, we determined the liver microsomal cytochrome P450 enzyme CYP1A1 which is induced by PAH in exposed rats. After biological soil treatment, different amounts of PAH remain in the soil depending on the soil properties and initial pollutant composition. Particularly, higher condensated PAH resists biological treatment due to its hydrophobicity. In addition, high amounts of organic carbon in the soils affect remediation efficiency. In the bioluminescence inhibition test, eluates of all biologically treated soils studied do not reveal any or only low inhibitory effects. In contrast, the oral uptake of biologically treated contaminated soils leads to induction levels for CYP1A1 similar to those in the untreated samples. A good correlation is obtained between CYP1A1 levels and the amount of 5 and 6-ring PAH in the soil samples. The main result is that the remediation efficiency determined by the luminescence test is not reflected by the biomarker test, a finding which indicates the high bioavailability of residual PAH in soils. Consequently, new criteria for human risk assessment can be delineated.     

Application of a “closed-can” technique for measuring radon exhalation from mine samples of Punjab, Pakistan

Using the closed-can technique, radon exhalation rate measurements have been carried out for shale and coal samples collected from various mines located in the Chakwal and Makarwal areas of Pakistan. For the two areas, the measured average values of the exhalation rates from shale are 1.45±0.13 and 0.67±0.25 Bq m⁻² h⁻¹ and for coal are 1.0±0.03 and 0.65±0.32 Bq m⁻² h⁻¹, respectively. These values are much lower than the measured exhalation rates from alum-shale-based Nordic concrete which has values in the 50–200 Bq m⁻² h⁻¹ range. The lower values of the measured exhalation rates from the shale and coal deposits in the Chakwal and Makarwal areas are indicative of their lower uranium contents and mine workers in these areas do not face any abnormal health hazard due to radon since the exhalation rates have been found to be on the low side.     

Energy use,blue water footprint,and greenhouse gas emissions for current food consumption patterns and dietary recommendations in the US

This article measures the changes in energy use, blue water footprint, and greenhouse gas (GHG) emissions associated with shifting from current US food consumption patterns to three dietary scenarios, which are based, in part, on the 2010 USDA Dietary Guidelines (US Department of Agriculture and US Department of Health and Human Services in Dietary Guidelines for Americans, 2010, 7th edn, US Government Printing Office, Washington, 2010). Amidst the current overweight and obesity epidemic in the USA, the Dietary Guidelines provide food and beverage recommendations that are intended to help individuals achieve and maintain healthy weight. The three dietary scenarios we examine include (1) reducing Caloric intake levels to achieve “normal” weight without shifting food mix, (2) switching current food mix to USDA recommended food patterns, without reducing Caloric intake, and (3) reducing Caloric intake levels and shifting current food mix to USDA recommended food patterns, which support healthy weight. This study finds that shifting from the current US diet to dietary Scenario 1 decreases energy use, blue water footprint, and GHG emissions by around 9 %, while shifting to dietary Scenario 2 increases energy use by 43 %, blue water footprint by 16 %, and GHG emissions by 11 %. Shifting to dietary Scenario 3, which accounts for both reduced Caloric intake and a shift to the USDA recommended food mix, increases energy use by 38 %, blue water footprint by 10 %, and GHG emissions by 6 %. These perhaps counterintuitive results are primarily due to USDA recommendations for greater Caloric intake of fruits, vegetables, dairy, and fish/seafood, which have relatively high resource use and emissions per Calorie.     

Policy evaluation of vehicle exhaust standards in Japan from 1995 to 2005 based on two human health risk indices for air pollution and global warming

Measures for vehicle exhaust emissions aimed at reducing either air pollution or global warming could have counterproductive effects on one another. Increasing diesel passenger vehicles, which generally have lower CO₂ emissions than gasoline counterparts, leads to increasing particulate matter (PM) emissions, while gasoline has lower PM emissions than diesel. It is said that stringent limits on PM emission factors discourages improved CO₂ emission factors. Without including both effects in a risk evaluation, one cannot evaluate whether the total risk is reduced or not. Hence, we evaluated representative exhaust emission measures based on risk evaluation for both air pollution and global warming. Considering consumer choice between diesel and gasoline passenger vehicles and emissions standards adopted in Japan from 1995 to 2005, we built five cases for vehicle policy evaluation. For each case, we estimated disability-adjusted life years (DALY) as an index of human health risk caused by lung cancer linked to inhalation exposure of elemental carbon in PM as well as due to global warming linked to CO₂. The results of our risk evaluation reveal that the case adopting the 2005 new long-term Japanese emission standard reduces the human health risk caused by lung cancer due to air pollution by 0.6 × 10³ DALY, but would increase the risk due to global warming by 31.9 × 10³ DALY compared with the case of adopting EURO 4, for the same conditions of passenger vehicle choice from 1995. These results suggest that the characteristics of Japanese emissions standards are mainly designed to reduce air pollution.     

Drinking water risk assessment in practice: the case of Swedish drinking water producers at risk from floods

To achieve a safe and reliable drinking water supply, water producers need to manage a large range of risks regarding both water quality and quantity. A risk management approach where risks are systematically identified and handled in a preventive manner is promoted by the World Health Organization and supported by researchers and drinking water experts worldwide. Risk assessment is an important part of such a management approach, and a variety of tools for risk assessment are described in the literature. There is, however, little knowledge of how drinking water risk assessment is performed in practice, including which tools that are actually used. This study investigates the use of risk assessment tools, and the approach to risk management, on a local level in the Swedish water sector. It is based on interviews with key persons from a targeted selection of water producers. We find that the application of tools as well as the approach to risk assessment and management differs considerably between the water producers. The tools most frequently used are mainly the ones promoted or required by Swedish national organizations. Although many of the water producers have done some kind of risk assessment, most have not implemented a risk management approach. Furthermore, their knowledge of the concepts of risk and risk management is often limited. The largest challenge identified is to prioritize risk assessment, so that it is actually performed and then used as a basis for managing risk in a systematic way.     

An improvement selection methodology for key performance indicators

Key performance indicators (KPIs) are critical measures for determining the health of a manufacturing plant in relationship to the plant’s goals. In today’s competitive environment, manufacturers cannot be careless about their business; in fact, they must ensure that their KPIs are effective and use them to make improvements when necessary. This paper describes a method for suggesting improvements to a manufacturer’s KPIs, based on the results achieved from a workshop to score the KPI on a number of predefined criteria. The approach uses a prospect theory approach to weight the scoring. Different problem formulations were derived that allow for both recommendations for improvements and the recommendations for disinvestments to over-performing KPIs. The authors applied the developed approach to two workshop outputs, each from independent manufacturers, and the results highlighted the significant difference between the two manufacturers in terms of improvement priorities and KPI assessment. The optimal improvement suggestions were compared to those found through a fast heuristic. It was determined that given the underlying assumptions of the approach that the heuristic solutions were just as adequate as the optimal ones.