Applicability of the Mass Concentration Standards for Particulate Matter in Alaskan Areas

The so-called “Six Month Study” of the air toxics problem in the United States was initiated in November 1983 by the U.S. Environmental Protection Agency. The study focused on the magnitude, nature, and distribution of the problem—three major issues that were felt to be most useful to policy makers as they attempted to define the scope and direction of a national program for controlling toxic air pollutants. The following paper is based on a draft staff report on the study released for review in September 1984. The report has not been formally released by the U.S. EPA; a final report is due by late spring of 1985.     

Improvement of Ambient Sulfur Dioxide Concentrations by Conversion from Low to High Stacks

A study of the “before” and “after” ground-level S0₂ concentrations near the Muskingum River Plant of the American Electric Power System shows that the conversion from low to high stacks has accomplished marked reductions in ambient concentrations. These reductions are in reasonable agreement with theoretical calculations and are most apparent within 5 km of the source. EPA Standards are now being met in this area despite the presence of the 1440 MW power plant burning 5% sulfur fuel with no treatment of the stack gas.     

The Use of Nahcolite Ore and Bag Filters For Sulfur Dioxide Emission Control

This paper describes some technical and economic aspects of the nahcolite ore injection process for the simultaneous removal of fly ash and sulfur oxides from stack gases. The process is capable of removing greater than 99% of the particulate matter and greater than 70% of the sulfur oxides present in such gases. In the process, nahcolite ore, a naturally occurring material containing 70 to 90% sodium bicarbonate, is ground to 90% passing through —200 mesh screens. Approximately 20% of the ground ore is used to precoat the filter bags in a baghouse filter while the remainder of the material is fed into the flue gas Just ahead of the baghouse. The flue gas is drawn through the baghouse by induced draft fans and sent up the stack. Most of the SO₂ and practically all of the fly ash in the flue gas can be removed as the gas passes through the filter bags. The spent nahcolite ore and fly ash are collected and conveyed to waste disposal as landfill, or alternatively processed for insolubilization by coprecipitation prior to landfilling. The technical feasibility of the process has been demonstrated in both bench scale and pilot scale engineering studies. Economic analyses performed for the cases of plants located in the midwest and southwest indicate lower capital costs for the nahcolite injection process when compared to wet scrubbing. On an annual cost basis, the nahcolite ore Injection process is comparable in cost to wet scrubbing for the case of the southwestern power plant, and somewhat more expensive for the case of the midwestern plant.     

interpretation of air quality data with respect to the national ambient air quality standards

San Diego Gas &; Electric has developed a quality assurance program for continuous emission monitors (CEM). Extractive, rather than in situ, monitors were selected as a result of an in-house evaluation program. Two extractive systems have been certified and a good operating and maintenance record has been established on these systems. A successful program requires the involvement and support of all affected personnel. It is desirable to have one or two key personnel coordinate the development of the program. It is also highly desirable to have good in-house source testing capabilities.     

Methylcyclopentadienyl Manganese Tricarbonyl as an Antiknock: Composition and Fate of Manganese Exhaust Products

Methylcyclopentadienyl manganese tricarbonyl (MMT) has been marketed as a combustion improver for fuel oil and turbine fuel. Use concentrations for this purpose are about 0.025 g manganese/gal in fuel oil and 0.08 to 0.5 g/gal in turbine fuels. In addition, it has been used to a small extent in gasoline.     

The Need for Representative Ambient Air Carbon Monoxide Sampling

Recent investigations have indicated that ambient air CO measurements may not reflect population exposure to CO. The lack of correlation may be due to improper siting of CO instruments, improper interpretation of air quality data, or both. Studies of population carboxy-hemoglobin levels are evaluated and compared with ambient air data.,

No significant correlation was found between median population COHb levels and reductions in CO concentrations required to meet ambient air standards when calculations used to estimate reductions were based on the second highest 8 hour average. However, calculated reductions based on annual average concentrations and a trend analysis technique correlated significantly with COHb levels in five cities from which both CAMP and COHb data were available.

Studies to determine the nature of the relationship between ambient air CO concentrations and population COHb levels are needed. The differences between the Occupational Safety and Health Act Regulations and the National Ambient Air Standards for carbon monoxide should be scrutinized to determine if a redefinition of the standards or their applicability is warranted. A reevaluation of the controls necessary to make reductions in population COHb burden may be necessary.     

Emission Control in Coking Operations By Use of Stage Charging

At the Clairton Coke Works of the United States Steel Corporation (the world’s largest coke plant), with coal charges of about 30,000 net tons per day, a system designated as “stage charging” has been developed for charging coal into the coke oven chamber without emissions to the atmosphere. The principles of the system are based on controlled sequential flow of the coal from the charging hoppers, during which the oven chamber is maintained under a very slight negative pressure condition by use of steam aspiration in the offtakes for on-the-main charging. The techniques are basic but require knowledge of the coal characteristics, adequate and properly maintained aspirating systems, including clean offtake piping, control of coal volume in the individual hoppers, and last, and probably most important, adherence by the operating crew to specific charging and leveling practices.     

Cooling Towers and the Environment

Measurements of natural draft cooling tower plume behavior, as well as meteorological variables, were obtained from aircraft flights near major power plants of the American Electric Power System. Persistence of the visible plume to great distances depends essentially on ambient humidity. Atmospheric stability at plume elevation was also important. Cooling tower-induced fog at ground-level was never observed in any of the tests, and aerodynamic downwash of the visible plume was absent also. The cooling towers did cause modification of natural clouds and they occasionally shadowed some local areas from the sun. Merging of the stack and cooling tower plumes was a common occurrence.     

Characterization of Particulates from Power Plants

The emphasis on participate control from industrial processes has been shifted recently towards fine particulates, having diameters less than 3 microns. There exists an urgent need for more scientific information of fine particle characterization.^1,2 Coal and oil fired power plants are among the largest anthropogenic point sources of particulate matter.³ Limited knowledge is available on particle size distribution and trace metal composition in power plant emissions.^4-7 The morphological properties of particle emissions have been largely neglected. In this report we present some information on particle characteristics for an oil-fired and coal-fired power plant.     

A Wind Tunnel Study of Gaseous Pollutants in City Street Canyons

Steady state mean concentrations of tracer gas were measured in a 400:1 scale model of an idealized city with variable geometry placed within a wind tunnel at various orientations to the mean flow for a free stream velocity of 6.8 ft/sec. The tracer gas was released from two parallel line sources to simulate lanes of traffic in an effort to quantify the persistence of pollution as well as the mean values realized at street levels. An aerodynamically rough turbulent boundary layer of neutral thermal stratification was employed to simulate the atmosphere. Values of concentration measured in the model city were converted to prototype concentrations in ppm and compared to National Ambient Air Quality Standards. It was shown that single isolated structures may cause favorable mixing of pollution downwind but very high concentrations exist in the immediate leeward vicinity of the building. Two favorable geometries for city blocks tested were found to reduce pedestrian exposure to pollution both near heavy traffic congestion and downwind. It was concluded that the pollutant dilution was controlled by the mean flow rather than by turbulent diffusion and that the lateral spread of the plume was slight as one proceeded downwind of the line source. The combination of favorable geometry and higher dilution velocities may bring pollution levels down to existing Air Quality Standards. The body of information presented in this paper should interest city planners and air quality monitoring personnel, as well as those researchers attempting to study and model flow in city street canyons. It provides order of magnitude estimates on pedestrian and office worker exposure to pollutants under a wide range of conditions.