Cyanide generation during preservation of chlorinated wastewater effluent samples for total cyanide analysis.

Dechlorinating agents and pH adjustment are often used to preserve wastewater samples for cyanide analysis. The effects of four approved preservation protocols on the results of the total cyanide analysis of effluents from four water reclamation plants were examined. The results differed widely, and a clear pattern emerged. Immediate analysis without pH adjustment generally gave total cyanide concentrations below the reporting limit of 5 microg/L, irrespective of the dechlorinating agents used. When the pH was adjusted to > or =12, a slight increase in the measured total cyanide concentration was observed when thiosulfate was used to dechlorinate the samples, and a significant increase (>10 microg/L) was observed when arsenite was used as the dechlorinating agent. These results provide evidence that approved preservation protocols may give rise to cyanide formation in chlorinated wastewater effluent matrices.     

Solidification and recycling of incinerator bottom ash through the addition of colloidal silica (SiO2) solution

The possibility of using incinerator bottom ash as a substitute for natural aggregates was investigated. Rough, porous surface of bottom ash, which diminishes the strength of solidified products, was improved by colloidal silica solution. As a result, a significant increase of mechanical strength was accomplished by a slight amount of silica (<1 wt% to total). Moreover, pozzolanic reaction was induced in initial cement hydration due to the nano-particle size of about 20 nm in colloidal silica solution. Cylindrical specimens and bricks were prepared from bottom ash added to a colloidal silica (SiO2) solution and cement, and then their compressive strengths were evaluated. Cylindrical specimens showed an increase of approximately 60% in compressive strength when colloidal solution containing 4 wt% silica particles was sprayed onto the bottom ash. The strength of bricks containing colloidal silica was in excess of 20 MPa, which meets the requirement of construction materials. Results of leaching tests based on Toxicity Characteristic Leaching Procedure (TCLP) proved that the solidified bottom ash possessed good chemical stability.     

Membrane introduction/laser photoionization time-of-flight mass spectrometry

Two-photon resonance enhanced multiphoton ionization (REMPI) has been shown to be a unique ionization method for mass spectrometry, exhibiting both high sensitivity and chemical selectivity. Because REMPI is a gas-phase method, its applications have been limited either to direct analysis of vapor phase samples, or in conjunction with an initial laser desorption or other vaporization step. We describe here for the first time a combination of membrane introduction mass spectrometry (MIMS) and REMPI with time-of-flight mass spectrometry (TOF-MS), which allows for the direct analysis of trace amounts of organic compounds in water samples. The objective of our research was the detection of very low levels of aromatic contaminants, particularly benzene, toluene, and xylene (BTX), in aqueous solutions without interference due to the water. We have measured limits of detection (LOD) for selected aromatics in water below 1 part-per-trillion with an averaging time of less than 10 s using a continuous sample flow.     

Excess copper induced physiological and proteomic changes in germinating rice seeds

Copper is an essential micronutrient for plants. Present at a high concentration in soil, copper is also regarded as a major toxicant to plant cells due to its potential inhibitory effects against many physiological and biochemical processes. The interference of germination-related proteins by heavy metals has not been well documented at the proteomic level. In the current study, physiological, biochemical and proteomic changes of germinating rice seeds were investigated under copper stress. Germination rate, shoot elongation, plant biomass, and water content were decreased, whereas accumulation of copper and TBARS content in seeds were increased significantly with increasing copper concentrations from 0.2mM to 1.5mM followed by germination. The SDS-PAGE showed the preliminary changes in the polypeptides patterns under copper stress. Protein profiles analyzed by two-dimensional electrophoresis (2-DE) revealed that 25 protein spots were differentially expressed in copper-treated samples. Among them, 18 protein spots were up-regulated and 7 protein spots were down-regulated. These differentially displayed proteins were identified by MALDI-TOF mass spectrometry. The up-regulation of some antioxidant and stress-related proteins such as glyoxalase I, peroxiredoxin, aldose reductase, and some regulatory proteins such as DnaK-type molecular chaperone, UlpI protease, and receptor-like kinase clearly indicated that excess copper generates oxidative stress that might be disruptive to other important metabolic processes. Moreover, down-regulation of key metabolic enzymes like alpha-amylase or enolase revealed that the inhibition of seed germinations after exposure to excess copper not only affects starvation in water uptake by seeds but also results in failure in the reserve mobilization processes. These results indicate a good correlation between the physiological and biochemical changes in germinating rice seeds exposed to excess copper.     

Photodecomposition of o-cresol by UV-LED/TiO2 process with controlled periodic illumination

This study investigated the effect of controlled periodic illumination on the photonic efficiency and temporal decomposition behavior of o-cresol by UV/TiO2 process in a slurry reactor using light emitting diodes as the light source. Based on the same UV light intensity of 6.7 W m(-2), the calculated photonic efficiencies increased from 1.5% to 6.3% with the decreasing duty cycle from 1.0 to 0.1 possibly ascribed to the decreasing electron-hole recombination. Actually, the calculated photonic efficiency under periodic illumination at sufficiently intermittence was inferior to, but approached, those under continuous illumination at equivalent average UV light intensity. The calculated electric energy per order increased from 32 to 37 k W h m(-3)order(-1) for experiments conducted with the increasing duty cycle from 0.1 to 1.0, and the electric energy consumption decreased significantly due to the lower duty cycle and average UV light intensity. The photocatalytic decomposition of o-cresol with the UV-light emitting diodes light could be well modeled by the Langmuir-Hinshelwood kinetic equation.     

Seasonal breeding aggregations in low-density populations of the bathyal echinoid Stylocidaris lineata

Reproduction of bathyal cidaroid sea urchins was studied between 1985 and 1991 with the aid of a manned submersible in the northern Bahamas. During May 1988 and February 1990, discrete, single-species aggregations of Stylocidaris lineata containing 2 to 6 individuals were observed between 510 and 640 m depths. Reproductive conditions of isolated and aggregated individuals were determined histologically. In February, all individuals, regardless of their spatial distribution, contained developing gametes. During the May spawning season, most isolated individuals contained spent gonads with only relict gametes, whereas individuals in discrete aggregations mostly contained ripe gonads with mature or nearly-mature gametes. Aggregations were not observed during the autumn months, when gonads were spent or immature. These data suggest that bathyal cidaroids aggregate for reproduction. An in situ survey during May indicated that pairs of S. lineata are more common than larger clumps, but no more so than predicted by chance. Homosexual and heterosexual pairs occur at the relative frequencies predicted on the basis of sex ratio. We evaluated the need for reproductive aggregation by applying Denny's (1988) model that predicts downstream sperm concentration in a turbulent boundary layer. Flow parameters were measured with dye injected from the submersible, sperm-release rate was estimated in the laboratory, and the relationship between fertilization success and sperm concentration was determined in a laboratory dilution-experiment. The model predicted that, on smooth sandy bottoms at bathyal depths, sperm concentration should remain high enough to fertilize at least some eggs several meters directly downstream from a spawning male. Aggregation may facilitate spawning synchrony, increase gamete encounter probabilities, or cause gametes to be retained at high concentrations near the adults long enough for fertilization to occur.     

ECONOMIC EVALUATION OF ON-FARM WATER MANAGEMENT PROJECTS1

ABSTRACT: During the last three decades, developing countries have invested enormous amounts of resources (running into billions of dollars) in the development of large surface irrigation systems. Investment funds were largely spent on the development of the main systems such as dams, canals and distributaries. Very little attention and resources have been spent on the development of below-the-outlet subsystems, in spite of very low levels of water use efficiency due to lack of proper land leveling, high water losses in field channels, and skewed distribution of available water among farmers served by individual water courses. This state of affairs has resulted in a lack of confidence on the part of most farmers in the reliability of surface irrigation systems to deliver water on time and in adequate quantities which, in turn, has resulted in farmers using below optimum levels of all other complementary inputs except labor. Realizing the importance of improving water use efficiency, both the domestic governments and donor agencies are increasingly paying serious attention to these problems. On-Farm Water Management (OFWM) as a strategy to improve water use efficiency and consequently agricultural production in many developing countries has been currently receiving very wide and vigorous consideration among economists, water management experts, policymakers, and donor agencies. A judicious use of the newly allocated funds of OFWM projects obviously needs proper evaluation procedures so that money could be allocated for the most deserving purposes and projects. In particular, recently, private profitability calculations due to public investments in OFWM activities have received attention from economists and decision makers in developing countries’governments and in donor agencies are very much interested in knowing the impacts of their investments in OFWM activities on farmers’income and welfare. However, the evaluation procedures commonly used in empirical studies, using a production function approach, seem to be at variance and sometimes inconsistent with proper comparative-static procedures. Thus, the primary objective of this paper is to develop consistent procedures for evaluating the impacts created by OFWM investments on farmers’income and resource use. In this context, the paper examines the critical relationship between the market price of the agricultural output and production function parameters which are affected by the OFWM investments.     

Nonparametric Monte Carlo Simulation for Flood Frequency Curve Derivation: An Application to a Korean Watershed1

Abstract: A mix of causative mechanisms may be responsible for flood at a site. Floods may be caused because of extreme rainfall or rain on other rainfall events. The statistical attributes of these events differ according to the watershed characteristics and the causes. Traditional methods of flood frequency analysis are only adequate for specific situations. Also, to address the uncertainty of flood frequency estimates for hydraulic structures, a series of probabilistic analyses of rainfall‐runoff and flow routing models, and their associated inputs, are used. This is a complex problem in that the probability distributions of multiple independent and derived random variables need to be estimated to evaluate the probability of floods. Therefore, the objectives of this study were to develop a flood frequency curve derivation method driven by multiple random variables and to develop a tool that can consider the uncertainties of design floods. This study focuses on developing a flood frequency curve based on nonparametric statistical methods for the estimation of probabilities of rare floods that are more appropriate in Korea. To derive the frequency curve, rainfall generation using the nonparametric kernel density estimation approach is proposed. Many flood events are simulated by nonparametric Monte Carlo simulations coupled with the center Latin hypercube sampling method to estimate the associated uncertainty. This study applies the methods described to a Korean watershed. The results provide higher physical appropriateness and reasonable estimates of design flood.     

Methane Ice Worms: Hesiocaeca methanicola Colonizing Fossil Fuel Reserves

 During a research cruise in July 1997 in the Gulf of Mexico we discovered a gas hydrate approximately 1 m thick and over 2 m in diameter which had recently breached the sea floor at a depth of 540 m. The hydrate surface visible from the submarine was considerably greater than that of any other reported hydrate. Two distinct color bands of hydrate were present in the same mound, and the entire exposed surface of the hydrate was infested (2500 individuals/m²) with 2 to 4 cm-long worms, since described as a new species, Hesiocaeca methanicola, in the polychaete family Hesionidae (Desbruyères and Toulmond 1998). H. methanicola tissue stable isotope values are consistent with a chemoautotrophic food source. No evidence of chemoautotrophic symbionts was detected, but geochemical data support the presence of abundant free living bacteria on the hydrate. The activities of the polychaetes, grazing on the hydrate bacteria and supplying oxygen to their habitats, appears to contribute to the dissolution of hydrates in surface sediments. Received: 16 August 1999 / Accepted in revised form: 19 January 2000