Evaluation of noise environments during daily activities of university students

Noise conditions specifically in areas inside university facilities and its impact on the quality of life of university students are topics that have received little attention. This paper presents a study of the noise conditions in which university students of various institutions in Madrid, Spain, carry out their daily studies. A representative number of measurements was carried out using noise dosemeters and dataloggers in order to evaluate the levels of noise, noise dose and exposure to noise during school periods and extracurricular activities. The results were compared with the recommendations given by current environmental noise regulations. This paper was complemented with a survey to get to know how students perceive the exposure to noise in university environments.     

Life cycle assessment of natural gas combined cycle power plant with post-combustion carbon capture,transport and storage

Hybrid life cycle assessment has been used to assess the environmental impacts of natural gas combined cycle (NGCC) electricity generation with carbon dioxide capture and storage (CCS). The CCS chain modeled in this study consists of carbon dioxide (CO₂) capture from flue gas using monoethanolamine (MEA), pipeline transport and storage in a saline aquifer.Results show that the sequestration of 90% CO₂ from the flue gas results in avoiding 70% of CO₂ emissions to the atmosphere per kWh and reduces global warming potential (GWP) by 64%. Calculation of other environmental impacts shows the trade-offs: an increase of 43% in acidification, 35% in eutrophication, and 120–170% in various toxicity impacts. Given the assumptions employed in this analysis, emissions of MEA and formaldehyde during capture process and generation of reclaimer wastes contributes to various toxicity potentials and cause many-fold increase in the on-site direct freshwater ecotoxicity and terrestrial ecotoxicity impacts. NO_x from fuel combustion is still the dominant contributor to most direct impacts, other than toxicity potentials and GWP. It is found that the direct emission of MEA contribute little to human toxicity (HT < 1%), however it makes 16% of terrestrial ecotoxicity impact. Hazardous reclaimer waste causes significant freshwater and marine ecotoxicity impacts. Most increases in impact are due to increased fuel requirements or increased investments and operating inputs.The reductions in GWP range from 58% to 68% for the worst-case to best-case CCS system. Acidification, eutrophication and toxicity potentials show an even large range of variation in the sensitivity analysis. Decreases in energy use and solvent degradation will significantly reduce the impact in all categories.     

A Simulation Study to Assess the Sensitivity of a Forest Health Monitoring Network to Outbreaks of Defoliating Insects

The sensitivity of the United States Forest Health Monitoring network to outbreaks of defoliating insects was examined by means of a simulation study. A model constructed specifically for the study was used to generate a wide variety of defoliation patterns in forested landscapes. Forest configuration was that of Minnesota, USA, as expressed by the GAP land cover classification. Combinations of model parameters were based on a Latin Hypercube sample. The relationship between the average number of plots defoliated and outbreak characteristics was then examined via multiple regression. Both theoretical and model results pointed to a strong, linear relationship between the average number of plots defoliated and outbreak size. Model results provided additional insight, suggesting a significant relationship between the average number of plots defoliated and other outbreak characteristics after outbreak size was taken into account.     

Open-path tunable diode laser absorption spectroscopy for acquisition of fugitive emission flux data

Air pollutant emission from unconfined sources is an increasingly important environmental issue. The U.S. Environmental Protection Agency (EPA) has developed a ground-based optical remote-sensing method that enables direct measurement of fugitive emission flux from large area sources. Open-path Fourier transform infrared spectroscopy (OP-FTIR) has been the primary technique for acquisition of pollutant concentration data used in this emission measurement method. For a number of environmentally important compounds, such as ammonia and methane, open-path tunable diode laser absorption spectroscopy (OP-TDLAS) is shown to be a viable alternative to Fourier transform spectroscopy for pollutant concentration measurements. Near-IR diode laser spectroscopy systems offer significant operational and cost advantages over Fourier transform instruments enabling more efficient implementation of the measurement strategy. This article reviews the EPA's fugitive emission measurement method and describes its multipath tunable diode laser instrument. Validation testing of the system is discussed. OP-TDLAS versus OP-FTIR correlation testing results for ammonia (R2 = 0.980) and methane (R2 = 0.991) are reported. Two example applications of tunable diode laser-based fugitive emission measurements are presented.     

Improving the extraction of tetrachloroethylene from soil columns using surfactant gradient systems

In this work, we extend the recently developed gradient approach for surfactant-enhanced remediation of dense non-aqueous phase liquid (DNAPL)-impacted sites. The goal of the gradient approach is to maximize the DNAPL solubilization capacity in swollen micelles (Type I aqueous microemulsions) while at the same time minimizing the potential for DNAPL mobilization. In this work, we introduce a modified version of the capillary/trapping curve that we refer to as the gradient curve to help interpret and/or design the gradient approach. The gradient curve presents the residual DNAPL saturation as a function of interfacial tension and microemulsion viscosity. This approach demonstrates that keeping a low viscosity of the microemulsion phase is not only important for keeping a low head loss during surfactant flooding but also to prevent oil mobilization. Eight microemulsion systems were evaluated in this research; these systems were evaluated based on their tetrachloroethylene (PCE) solubilization capacity, interfacial tension (IFT), viscosity, density, and coalescence kinetics. Two of these systems were chosen for evaluation in site-specific column tests using an increasing electrolyte gradient to produce a decreasing IFT/increasing solubilization gradient system. The column studies were conducted with media from Dover Air Force Base in Dover, DE. Both solubilized and mobilized DNAPL were quantified. During the column studies, we observed that substantial PCE was mobilized when the residual level of PCE in the column was significantly higher than the steady-state residual saturation level being approach (as predicted from the gradient curve). Four column studies were performed, three of which were used to asses the validity of the gradient curve in predicting the residual saturation after each gradient step. From these tests we observed that starting IFTs of less than 1 mN/m all produced the same mobilization potential. In the last column, we used an additional gradient step with an initial IFT above 1 mN/m to dramatically reduce the amount of PCE mobilize. Based on the good agreement between column results and projections based on the gradient curve, we propose this as a preferred method for designing gradient surfactant flushing systems.     

A cost worth paying: energetically expensive interactions with males protect females from intrasexual aggression

When approached by males, females of the Amarillo fish (Girardinichthys multiradiatus) perform a behaviour called vibration or they are aggressively challenged. We quantified vibration and assessed whether it compromises the rate of feeding attempts in dyads kept in outdoor enclosures. Male approaches resulted in female vibration and in a reduced feeding rate. Vibration was not evoked by female–female aggression, which was frequent and always ended in the subordinate fleeing from the dominant female. Using a closed respirometer we found that vibration is costly; oxygen consumption of females was greater in the presence of a male (which evoked vibration) than in the presence of a non-familiar female (when no vibration occurred). By recording interactions of females confined in aquaria in the presence and in the absence of males, we confirmed that escaping is the only available response to deal with female aggression. Females kept without males participated in frequent aggressive (even lethal) interactions that did not abate while the subordinate female was in sight of the dominant, and which caused premature births and injuries. Yet in the alternative treatment aggression ceased when a male approached, prompting vibration in both females. Thus, in the Amarillo, in as much as it evokes energetically costly female vibrations, male courtship is an expression of sexual conflict. However, in the absence of males, frequent female aggression potentially annuls the benefits of not vibrating. We propose that a complete appraisal of the consequences of sexual conflict must include an assessment of the costs imposed by intra-sexual interactions.     

Biomass Carbon Ratio of Polymer Composites Measured by Accelerator Mass Spectrometry

The evaluation method of biomass carbon ratio of polymer composite samples including organic and inorganic carbons individually was investigated. Biodegradable plastics and biobased plastics can have their mechanical properties improved by combining with inorganic fillers. Polymer composites consisting of biodegradable plastics and carbonate were prepared by two different methods. Poly(lactic acid) (PLA) composite was prepared by synthesis from l-lactide with catalyst and calcium carbonate (CaCO₃) powders from lime. Poly(butylene succinate) (PBS) composite was prepared by hot-pressing the mixture of PBS powder and CaCO₃ powders from oyster shells. The mechanical properties of composite samples were investigated by a tensile test and a compression test using an Instron type mechanical tester. Tensile test with a dumbbell shape specimen was performed for PBS composite samples and compression test with a column shape specimen for PLA composite samples. Strength, elastic modulus and fracture strain were obtained from the above tests. Biomass carbon ratio is regulated in the American Standards for Testing and Materials (ASTM). In ASTM standards on biomass carbon ratio, it is required that carbon atoms from carbonates, such as CaCO₃, are omitted. Biomass carbon ratio was evaluated by ratio of ¹⁴C to ¹²C in the samples using Accelerator Mass Spectrometry (AMS). The effect of pretreatment, such as oxidation temperature and reaction by acid, on results of biomass carbon ratio was investigated. Mechanical properties decrease with increasing CaCO₃ content. The possibility of an evaluation method of biomass carbon ratio of materials including organic and inorganic carbons was shown.     

From Rio to Johannesburg and Beyond: A long and winding road

This paper analyses the evolution of urban form in two North American metropolitan regions (Portland and Toronto) and asks how more sustainable regional form might come about in the future in these and other urban areas. In the past, dominant patterns of urban form have emerged in such regions at different historical periods. These morphological phases include mid 19th-century grids, streetcar suburb grids, garden suburbs, automobile suburbs and New Urbanist neighbourhoods (which have only recently made an appearance and may or may not become widespread). Judging by the performance of past types of urban morphology, five design values appear particularly important for more sustainable urban form in the future: compactness, contiguity, connectivity, diversity and ecological integration. Although these principles were not well supported by 20th-century development, contemporary movements such as the New Urbanism and Smart Growth re-emphasise them. The example of these two regions indicates that, in the absence of new technological, economic or geographical forces, public sector institutions and urban social movements represent the most likely means to bring about new, more sustainable types of urban form.