Risk estimation to human health caused by the mercury content of Sushi and Sashimi sold in Japanese restaurants in Brazil

Although fish is a healthy alternative for meat, it can be a vehicle for mercury (Hg), including in its most toxic organic form, methylmercury (MeHg). The objective of the present study was to estimate the risk to human health caused by the consumption of sushi and sashimi as commercialized by Japanese food restaurants in the city of Campinas (SP, Brazil). The total Hg content was determined by atomic absorption spectrometry with thermal decomposition and amalgamation, and the MeHg content calculated considering that 90% of the total Hg is in the organic form. The health risk was estimated from the values for the provisional tolerable weekly ingestion (PTWI) by both adults and children. The mean concentrations for total Hg were: 147.99, 6.13, and 3.42 µg kg^?1 in the tuna, kani, and salmon sushi samples, respectively, and 589.09, 85.09, and 11.38 µg kg^?1 in the tuna, octopus and salmon sashimi samples, respectively. The tuna samples showed the highest Hg concentrations. One portion of tuna sashimi exceeded the PTWI value for MeHg established for children and adults. The estimate of risk for human health indicated that the level of toxicity depended on the type of fish and size of the portion consumed.     

Evaluation of the sensitivity spectrum of a video tracking system with zebrafish (<Emphasis Type="Italic">Danio rerio</Emphasis>) exposed to five different toxicants

The aim of this study was to develop a biological early warning system for the detection of aquatic toxicity and test it with five toxicants with distinct chemical nature. This was done in order to verify the spectrum of sensitivities of the proposed system, as well as the potential identification capability of the tested contaminants, using only the analysis of zebrafish’s behavior. Six experimental conditions were tested: negative control and five toxicants (bleach, lindane, tributyltin, mercury, and formaldehyde). The exposure time was 45 min, and the concentrations used corresponded to 9% of LC₅₀’s-96 h for the tested compounds, to ensure ecologically relevant results. A total of 108 fish were used, with each individual experimental condition being tested 18 times. A statistical model of diagnosis was used, combining self-organizing map and correspondence analysis. The values of sensitivity, specificity, accuracy, false positive, false negative, positive predictive value (PPV), and negative predictive value (NPV) were calculated. The objectives of the work were accomplished and the system showed a good overall diagnostic performance with 79% in accuracy, 77% in sensitivity, and 88% in specificity. The lowest result of the predictive values was 78% (lindane and mercury), in the case of the NPV, and 86% (bleach and lindane), in the case of the PPV. The best result of the predictive values was 100% (bleach and tributyltin), for the NPV, and 89% (tributyltin), for the PPV. Regarding the five tested toxicants, the system was able to correctly identify the agent responsible for the contamination in 40% of the positive diagnoses.     

Elemental and isotopic determination of lead (Pb) in particulate matter in the Brazilian city of Goiânia (GO) using ICP-MS technique

Environmental Science and Pollution Research - The toxic metal lead (Pb) can be harmful to human health in various manners, but is also considered as a distinguished tracer of environmental...     

Use of cholinesterase activity in monitoring chlorpyrifos exposure of steer cattle after topical administration

The aim of this work was to study the pharmacokinetic behavior and the inhibitory effect of acetylcholinesterase (AChE) and butyrylcholinesterase (BChE) activities of chlorpyrifos (CPF) in steer cattle after pour-on administration. Determination of cholinesterase activity in plasma and erythrocyte was carried out according to Ellman kinetic method. CPF was analyzed by gas chromatography. AChE was the predominant form of cholinesterase analyzed, with low levels of BChE in plasma. Following the treatment with CPF, the maximum inhibitory effect on AChE or BChE were 50.88 ± 11.57 and 42.66 ± 12.01%, respectively. The chlorpyrifos plasma concentrations observed were low and they presented a high variability. Chlorpyrifos peak plasma concentration (10.42 ± 4.76 μ g/L) was reached at 8.42 ± 13.97 h. The pesticide was not detected in plasma after 48 h post treatment. The values of area under the curve (AUC) were 118.48 ± 87.46 μ g· h/L and mean resistance time (MRT) were 13.38 ± 10.41 h. The pour-on exposure to the organophosphate chlorpyrifos significantly reduced AChE and BChE activity in steer cattle and the recovery was not reached on 50 days post-treatment.     

Pesticide dissipation curves in peach,pear and tomato crops in Uruguay*

Dissipation curves of azoxystrobin and of the neonicotinoids acetamiprid and thiacloprid in peach; azinphos-methyl and carbaryl in pear and azoxystrobin, chlorfenapyr and chlorpyrifos in high-tunnel tomato crops were studied in the Southern region of Uruguay. An analytical methodology based on solid phase extraction (SPE) and detection by High Performance Liquid Chromatography with Diode Array Detector (HPLC/DAD) was used for acetamiprid and thiacloprid. Coupled SPE and detection by Gas Chromatography with Mass Selective Detector (GC/MSD) was used for the detection of azinphos-methyl, azoxystrobin, carbaryl, chlorfenapyr and chlorpyrifos residues. Curves were modeled mathematically with Solver program of Microsoft Excel®. The best fit for acetamiprid and thiacloprid in peach was achieved with the exponential model (r²=0.961 and 0.944, respectively). In the case of peach fruits there is not a Maximum Residue Limit (MRL) for acetamiprid in the Codex Alimentarius, while 0.5 mg/kg is the value rated for thiacloprid. The MRLs accepted by the European Union (EU) are 0.1 mg/kg for acetamiprid and 0.3 mg/kg for thiacloprid. According to the curves determined in these experiments, thiacloprid residues 10 to 12 days after application (daa) were below the MRLs established by both sources. In the case of acetamiprid, 25 daa would be required, according to the exponential mathematical model, to get residues levels below the MRL values established by the EU. For azinphos methyl in pear, the residues detected were mathematically fitted to an exponential model (r²=0.999). According to it, residue levels under the MRL established by the EU (0.05 mg/kg) are gotten in our conditions in 20 daa. In plastic tunnel tomato chlorfenapyr residues were not detected from 16 daa, having the dissipation curve an exponential trend. In the same condition, there was not a decay of the azoxystrobin concentration during a 24-day trial, being it around 0.40 ± 0.05 mg/kg.     

Near-source air quality impacts of large olefin flares

Large petrochemical flares, common in the Houston Ship Channel (the Ship Channel) and other industrialized areas in the Gulf of Mexico region, emit hundreds to thousands of pounds per hour of highly reactive volatile organic compounds (HRVOCs). We employed fine horizontal resolution (200 m?×?200 m) in a three-dimensional (3D) Eulerian chemical transport model to simulate two historical Ship Channel flares. The model reasonably reproduced the observed ozone rise at the nearest monitoring stations downwind of the flares. The larger of the two flares had an olefin emission rate exceeding 1400 lb/hr. In this case, the model simulated a rate of increase in peak ozone greater than 40 ppb/hr over a 12 km?×?12 km horizontal domain without any unusual meteorological conditions. In this larger flare, formaldehyde emissions typically neglected in official inventories enhanced peak ozone by as much as 16 ppb and contributed over 10 ppb to ambient formaldehyde up to ～8 km downwind of the flare. The intense horizontal gradients in large flare plumes cannot be simulated by coarse models typically used to demonstrate ozone attainment. Moreover, even the relatively dense monitoring network in the Ship Channel may not be able to detect many transient high ozone events (THOEs) caused by industrial flare emissions in the absence of stagnant air recirculation or stalled sea breeze fronts, even though such conditions are unnecessary for the occurrence of THOEs.

Implications: Flare minimization may be an important strategy to attain the U.S. federal ozone standard in industrialized areas, and to avoid inordinate exposure to formaldehyde in neighborhoods surrounding petrochemical facilities. Moreover, air quality monitoring networks, emission inventories, and chemical transport models with higher spatial and temporal resolution and more refined speciation of HRVOCs are needed to better account for the near-source air quality impacts of large olefin flares.     

Phenol and nitrophenols in the air and dew waters of Santiago de Chile

Phenol, nitrophenols and dinitrophenols were measured in air and dews in downtown Santiago de Chile. In both systems, phenol, 2-nitrophenol (2-NP), and 4-nitrophenol (4-NP) were the compounds found in higher concentrations and with major frequency. Temporal profiles in air were compatible with a significant direct incorporation from mobile sources. The data can be explained in terms of a faster removal of 2-NP than 4-NP, with the former predominating in fresh air masses and 4-NP in more aged samples. All these compounds, as well as dinitrophenols, were found in dew waters. Simultaneous measurements in air and dew indicate that phenol present in dew exceeds that expected in equilibrated samples, while the opposite occurs with 4-NP. This last result is associated to mass transfer limitations for the highly water soluble nitroderivative.     

The potential near-source ozone impacts of upstream oil and gas industry emissions

Increased drilling in urban areas overlying shale formations and its potential impact on human health through decreased air quality make it important to estimate the contribution of oil and gas activities to photochemical smog. Flares and compressor engines used in natural gas operations, for example, are large sources not only of NOx but also offormaldehyde, a hazardous air pollutant and powerful ozone precursor We used a neighborhood scale (200 m horizontal resolution) three-dimensional (3D) air dispersion model with an appropriate chemical mechanism to simulate ozone formation in the vicinity ofa hypothetical natural gas processing facility, based on accepted estimates of both regular and nonroutine emissions. The model predicts that, under average midday conditions in June, regular emissions mostly associated with compressor engines may increase ambient ozone in the Barnett Shale by more than 3 ppb beginning at about 2 km downwind of the facility, assuming there are no other major sources of ozone precursors. Flare volumes of 100,000 cubic meters per hour ofnatural gas over a period of 2 hr can also add over 3 ppb to peak 1-hr ozone somewhatfurther (>8 km) downwind, once dilution overcomes ozone titration and inhibition by large flare emissions of NOx. The additional peak ozone from the hypothetical flare can briefly exceed 10 ppb about 16 km downwind. The enhancements of ambient ozone predicted by the model are significant, given that ozone control strategy widths are of the order of a few parts per billion. Degrading the horizontal resolution of the model to 1 km spuriously enhances the simulated ozone increases by reducing the effectiveness of ozone inhibition and titration due to artificial plume dilution.     

NAPL migration and ecotoxicity of conventional and renewable fuels in accidental spill scenarios

Fuels derived from non-petroleum renewable resources have raised interest due to their potential in replacing petroleum-based fuels, but information on their fate and effects in the terrestrial and aquatic environments in accidental spill scenario is limited. In this study, migration of four fuels (conventional diesel, conventional gasoline, renewable diesel NExBTL, and ethanol-blended gasoline RE85 containing maximum 85 % ethanol) as non-aqueous phase liquids (NAPL) in soil was demonstrated in a laboratory-scale experiment. Ecotoxicity data was produced for the same fuels. There was no significant difference in migration of conventional and renewable diesel, but gasoline migrated 1.5 times deeper and 7–9 times faster in sand than diesel. RE85 spread horizontally wider but not as deep (p?Eisenia fetida followed by ethanol-blended gasoline (LC50 1,643 mg/kg THC) and conventional diesel (LC50 2,432 mg/kg THC), although gasoline evaporated fast from soil. For comparison, the toxicity of the water-accommodated fractions (WAF) of the fuels was tested with water flea Daphnia magna and Vibrio fischeri, also demonstrating groundwater toxicity. The WAF of conventional gasoline and RE85 showed almost similar toxicity to both the aquatic test species. EC50 values of 1:10 (by volume) WAF were 9.9 %WAF (gasoline) and 9.3 %WAF (RE85) to D. magna and 9.3 %WAF (gasoline) and 12.3 %WAF (RE85) to V. fischeri. Low solubility decreased toxicity potential of conventional diesel in aquatic environment, but direct physical effects of oil phase pose a threat to organisms in nature. Renewable diesel NExBTL did not show clear toxicity to any test species.