Designing Treatability Studies for CERCLA Sites: Three Critical Issues

A great urgency has developed in the past few years within the U.S. EPA remediation program to perform treatability studies at Superfund (CERCLA) sites. The major reasons for this urgency is to ensure the selected treatment technology is applicable to the waste characteristics, and that Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) cleanup goals can be achieved. However, prior to conducting a treatability study, three critical issues must be resolved by the site manager. First, what scale and timing are appropriate? Second, should the treatability study be performed by a treatment technology vendor using proprietary equipment and processes, or can a generic study be performed? Third, should the study be performed in the field or should the waste be taken to the laboratory for testing? The objectives of the treatability study will have a major impact on how these issues are resolved. This paper discusses these major issues and provides information for the design and conduct of Superfund treatability programs.     

Relationship of Particulate Control,SO2 Removal,and Waste Management

Results with the EPRI 2.5 MW(e) Integrated Environmental Control Pilot Plant (IECPP) indicate the interrelationship of particulate penetration, SO₂ scrubber operation, waste production, and waste properties. Tests compared a fabric filter/wet scrubber and ESP/wet scrubber, the latter operated to simulate 1979 New Source Performance Standards (NSPS), 1971 NSPS, and pre-NSPS ESP units. Tests were conducted with low-sulfur coal producing a flue gas concentration of400ppm; flue gas spiking could be used to increase SO₂ to 2000 ppm. Scrubber waste was dewatered in a thickener and vacuum belt filter (to 55 percent solids content), and mixed with fly ash. The pilot SO₂ scrubber—when preceded by an ESP and forced to operate in zero-discharge—captured less SO₂ than when preceded by a fabric filter. Also, scrubber operation with the ESP produced a greater quantity of waste with difficult handling characteristics, as compared to operation with the fabric filter. These difficulties occurred with particulate penetration above 0.10 lb/MBtu, which could reduce reagent utilization to 80percent. These results are attributable to inhibited limestone dissolution due to accumulation of an aluminum/fluoride compound. For both lowsulfur and simulated high-sulfur test conditions, allowing wastewater discharge to purge aluminum/fluoride content restored performance to design levels. Particulate control efficiency also affected solid waste physical properties. The fabric filter/wet scrubber produced the lowest solid waste permeability (10^?8 cm/s). ESP operation at 1979 NSPS and pre-1971 NSPS ESPs increased solid waste permeability to 10^?7 and 10^?6 cm/s, respectively. These results are meaningful for SO₂ scrubbers both for new plants and for retrofit to units with pre-NSPS ESPs, and could become significant with the increasing trend to restricted water discharge.     

The Relationship Between Atmospheric Transport and the Particle Scattering Coefficient at the Grand Canyon

Air trajectory and particle scattering data (bsp) for the period 1984-1989 are used to determine the relationship between atmospheric transport and visual air quality at the Grand Canyon National Park. Using cluster analysis, 72-hour back-trajectories arriving four times per day were grouped into distinct transport patterns. Northwesterly and southerly/southwesterly flow dominate in the winter and summer seasons, respectively. Comparisons of bsp values accompanying different transport patterns showed a clear relationship between air flow pathway and light scattering due to small particles during the non-summer months only. An index is defined which describes the percentage of annual trajectories belonging to specific transport routes delivering predominantly clear air to the GCNP.     

Some Technical and Economic Aspects of Residual Fuel Oil Desulfurization

Combustion of residual, the most common type of fuel oil used in industrial and commercial steam generating plants, accounts for about 600,000 tons or 37 percent of the sulfur oxide emissions in New York state. On the average, residual oil available in New York state contains about 2.2 percent sulfur and is consumed at an annual rate of approximately 85 million barrels. The removal of sulfur from many types of residuals should become economically feasible as a result of the development of the HDS and H-Oil hydrodesulfurization processes. From studies recently made, these methods of desulfurization have been estimated to vary from a minimum of no appreciable increase in overall cost to a maximum of about one cent per gallon. The by-product distillates produced in hydrodesulfurization are a very significant factor in making the process economical and the demand for these is increasing at a greater rate than residual.     

Air Pollution Emissions from Increased Industrial Coal Use in the Northeastern United States

Evaluating the air pollution impacts of energy use in the industrial sector is difficult because of the diversity and multiplicity of sources and a general lack of systematic, up-to-date data collection mechanisms. Fuel-specific energy consumption for a multi-state region is provided by the U.S. Department of Energy PIES model for a base year (1975), together with scenarios for future years. A computer model developed in this study—the Sub-regional Energy and Emissions Model (SEEM)—is applied to disaggregate the regional industrial figures to the county level according to fuel type and industrial category at the two-digit SIC level. The resulting emissions of total suspended particulates (TSP) and sulfur dioxide (SO₂) for all industrial categories are estimated at the county level by Incorporating county-specific air pollution regulations in SEEM, and are then aggregated to larger geographical regions. The model has been applied to evaluate the increased air pollution impacts of industrial energy use in the northeastern United States for two alternative 1990 scenarios: (1) the midrange/trendlong PIES projections, and (2) a Coal Replacement Scenario, which assumes a higher percentage of fuel burned in new boilers will be coal. The results are discussed in terms of implications for air pollution control policy.     

Dry Deposition of Ammonia at Environmental Concentrations on Selected Plant Species

The deposition velocity of NH₃ on six plant species at environmental concentrations has been studied in a dynamic plant gas exchange reactor. The total resistance to the transport of NH₃ was studied. The aerodynamic resistance was determined directly by NH₃ gas absorption in aqueous solutions at environmental concentrations in a two-phase gradientless reactor modeling the transfer processes through the stomata in a leaf. The concentration of NH₃ in the gas phase ranged from 50 to 1000 ppb and the temperature varied from 25 to 30°C. The results for the deposition velocity for NH₃, during the day, varied from 0.3 to 1.3 cm/s. The deposition velocities at night were about one order of magnitude smaller. These results are compared with estimates from the Frdssling equation which consistently yields higher values of the same order of magnitude. To determine accurate atmospheric transport models or global budget models, a variable deposition velocity should be used to account for the diurnal and seasonal variations in the surface resistance.     

Is an assessment factor of 10 appropriate to account for the variation in chemical toxicity to freshwater ectotherms under different thermal conditions?

Ecotoxicity tests are often conducted following standard methods, and thus carried out at a fixed water temperature under controlled laboratory conditions. Yet, toxicity of a chemical contaminant may vary in a temperature-dependent manner, depending on the physiology of the test organism and physicochemical properties of the chemical. Although an assessment factor of 10 (AF10) is commonly adopted to account for variability in toxicity data related to temperature in the development of water quality guidelines and/or ecological risk assessment, no one has ever rigorously assessed the appropriateness of AF10 to account for potential variation in temperature-dependent chemical toxicity to aquatic organisms. This study, therefore, aims to address this issue through a meta-analysis by comparing median lethal concentration data for nine chemicals (cadmium, copper, nickel, lead, silver, zinc, arsenic, selenium and DDT) on a range of freshwater ectothermic animal species at different temperatures, and to assess whether AF10 is under- or over-protective for tropical and temperate freshwater ecosystems. Our results reveal varying extents of interaction between temperature and different chemicals on organisms and the complexity of these interactions. Applying AF10 sufficiently protects 90 % of the animal species tested over a range of temperatures for cadmium, copper, nickel, silver, zinc and DDT in the tropics, but it is insufficient to adequately encompass a larger temperature variation for most studied chemicals in temperate regions. It is therefore important to set specific AFs for different climatic zones in order to achieve the desired level of ecosystem protection.     

固相萃取和液相色谱/质谱/质谱在正离子和负离子模式下检测水中的农药残留

使用固相萃取和液相色谱/质谱/质谱,在正离子和负离子模式下,分别分析了46个和14个农药化合物.无需衍生化,就能达到pg水平的分析灵敏度.对于所有农药的化合物,在5 pg-1 ng的范围内具有很好的线性.