Assessment of physicochemical parameters of wastewater samples

Water samples from selected locations of Nullah Lai and Koh-e-Noor textile mill in the metropolitan city of Rawalpindi and Islamabad, Pakistan, were collected. Physicochemical parameters and heavy metals were determined using standard analytical procedures in comparison with sites, locations and subsequent interval of 3 months. The results of the physicochemical analysis at different locations of Nullah Lai and Koh-e-Noor textile mill with an interval of 3 months were obtained in the following range: pH (7.16–8.29), temperature (17.8–28.8 °C), conductivity (1,005–3,347 μS/m), TDS (754.3–2,519.5 mg/L), turbidity (272.8–487.05 NTU), total hardness (300–452 mg/L), nitrates (10.11–22.95 ppm), calcium (74.31–139.2 ppm), chloride (127.72–396.16 ppm), sulphate (15.97–87.38 ppm), NaCl (210.5–631.1 ppm), Ni (0.30–0.72 ppm), Cd (0.005–0.03 ppm), Cr (0.2–7.4 ppm), Pb (0.12–0.73 ppm), Zn (0.03–0.08 ppm) and Cu (0.01–0.06 ppm). The highest value of physicochemical parameters (compared with Nullah Lai) was obtained in locations of Koh-e-Noor textile mill. The results obtained exceeded the maximum allowable limit set by the World Health Organization for drinking purpose but can be used for irrigation purposes after suitable treatment and purification.     

Characterization and Optimization of Persian Gum/Whey Protein Bionanocomposite Films Containing Betanin Nanoliposomes for Food Packaging Utilization

Journal of Polymers and the Environment - In this study, composite packaging films were produced from relatively inexpensive materials including Whey protein isolate (WPI) and Persian gum (PG),...     

Preparation and properties of chitosan–metal complex: Some factors influencing the adsorption capacity for dyes in aqueous solution

Chitosan–metal complexes have been widely studied in wastewater treatment, but there are still various factors in complex preparation which are collectively responsible for improving the adsorption capacity need to be further studied. Thus, this study investigates the factors affecting the adsorption ability of chitosan–metal complex adsorbents, including various kinds of metal centers, different metal salts and crosslinking degree. The results show that the chitosan–Fe( Ⅲ) complex prepared by sulfate salts exhibited the best adsorption efficiency(100%) for various dyes in very short time duration(10 min), and its maximum adsorption capacity achieved 349.22 mg/g. The anion of the metal salt which was used in preparation played an important role to enhance the adsorption ability of chitosan–metal complex. SO_4~(2-) ions not only had the effect of crosslinking through electrostatic interaction with amine group of chitosan polymer, but also could facilitate the chelation of metal ions with chitosan polymer during the synthesis process.Additionally, the p H sensitivity and the sensitivity of ionic environment for chitosan–metal complex were analyzed. We hope that these factors affecting the adsorption of the chitosan–metal complex can help not only in optimizing its use but also in designing new chitosan–metal based complexes.     

A fuzzy multi-stakeholder multi-criteria methodology for water allocation and reuse in metropolitan areas

In this paper, a fuzzy decision making methodology is proposed to find a socially optimal scenario for allocating effluent of wastewater treatment plants and urban and suburban runoffs to agricultural regions and recharging aquifers. The presented methodology named modified fuzzy social choice (MFSC) considers multi-stakeholder multi-criteria problems under uncertainties inherent in a decision making process utilizing a fuzzy ranking method and the fuzzy social choice (FSC) theory. A set of water and wastewater allocation scenarios are proposed for water quantity and quality management of the study area, while six main stakeholders with conflicting utilities and different negotiation powers are involved. The proposed methodology is applied to Tehran metropolitan area, the capital city of Iran with the population of about 8 million people, to examine its applicability and effectiveness. The results shows that using fuzzy multi-stakeholder multi-criteria decision making method considering equal and different negotiation powers can lead to different outcomes. Based on the results, the MFSC method, which considers a number of decision makers having different negotiation powers, degrees of importance of decision making criteria, and some important uncertainties, performs more promising in real water resources management problems.     

Optimization and treatment of wastewater of crude oil desalting unit and prediction of scale formation

In this article, one of Iran’s southwest oil fields that produces 3200 barrels per day (bbl/d) of wastewater from oil and gas processing was investigated. Experimental analysis of oil reservoir water and desalting wastewater disposal of crude oil desalting unit was performed. First, water was treated with a reverse osmosis membrane. As a result, the purified water, with lower total dissolved solids (TDS) and pH, was a suitable candidate for injection into the adjacent wells of the crude oil desalting unit. The effectiveness and compatibility of this wastewater to the formation water of the oil field wells were simulated. Finally, we studied and identified the formation, the amount, and the type of mineral scale deposits. These are the most important problems during water injection into the wells. The analysis shows that the refined water from the reverse osmosis (RO) process was a suitable and low-cost economical option for injection in onshore and offshore fields, due to the low amount of salts, the concentration of susceptible ions in scaling formation, and the appropriate pH. This oil field, which is in the second half of life, requires enhanced oil recovery methods (EOR) for the maintenance of pressure and an increase in oil recovery.

     

Economic growth and environmental pollution in Myanmar: an analysis of environmental Kuznets curve

Environmental Science and Pollution Research - This empirical study examines the short- and long-run relationship between GDP as an economic growth indicator and CO2 emissions as an environmental...     

Source identification of polycyclic aromatic hydrocarbons (PAHs) in sediment samples from the northern part of the Persian Gulf,Iran

Samples of surface sediments from the Iranian coast of the Persian Gulf were examined to determine the levels and sources of 15 polycyclic aromatic hydrocarbons (PAHs). Samples were collected from 30 sampling sites and analyzed for PAHs by gas chromatography–mass spectrometry (GC-MS). Total concentrations of PAHs ranged from 93 to 4,077 ng g^?1 dry weight. The PAH composition from 30 sampling sites was dominated by four-ring PAH compounds. Molecular indices based on the ratios of PAH concentrations were used to differentiate PAHs from pyrolitic to petrogenic and mixed origins. The results suggested that the main sources of PAHs in sediments from the studied region were mixed pyrolitic and petrogenic. Furthermore, benthic organisms in most of the investigated areas were not at ecotoxicological risk, according to the results from the effects range low (ERL)/effects range median (ERM) techniques suggested by the US Sediment Quality Guidelines (SQGs).     

Stimulating student’s pro-environmental behavior in higher education institutions: an ability–motivation–opportunity perspective

Environment, Development and Sustainability - The slow and inadequate environmental performance of higher education institutions is attracting the consideration of researchers toward a behavioral...     

Life cycle assessment of different municipal solid waste management options: a case study of Algiers (Algeria)

Journal of Material Cycles and Waste Management - This paper examines four strategies of municipal solid waste management (MSWM) for Algiers city using life cycle assessment methodology. Analyzed...     

Temporal patterns of road network development in the Brazilian Amazon

The Brazilian Amazon is a globally important ecosystem that is undergoing rapid development and land-use change. Roads are a key spatial determinant of land-use conversion and strongly influence the rates and patterns of habitat loss and represent a key component of models that attempt to predict the spatio-temporal patterns of Amazonian land-use change and the consequences of such changes. However, the spatio-temporal patterns of road network development are poorly understood and seldom quantified. Here, we used manually digitised satellite imagery at multiple temporal and spatial scales across the Brazilian Amazon to quantify and model the rate at which road networks are proliferating. We found that the road network grew by almost 17,000 km per year between 2004 and 2007. There was large spatial variation in road network density, with some municipalities having road densities as high as 0.5 km/km², and road network growth rates were highest in municipalities with an intermediate road network density. Simulations indicated that road network development within municipalities follows a logistic growth pattern through time, with most of the development occurring within a 39-year time period. This time period is similar to those of other boom and bust development dynamics observed in the Brazilian Amazon. Understanding the temporal patterns of road development will aid the development of better predictive land-use change models for the Amazon, given the key importance of roads as a predictor of deforestation in many existing models.