Use of biosurfactants from urban wastes compost in textile dyeing and soil remediation

A compost isolated humic acid-like (cHAL) material was pointed out in previous work for its potential as auxiliary in chemical technology. Its potential is based on its relatively low 0.4gL(-1) critical micellar concentration (cmc) in water, which enables cHAL to enhance the water solubility of hydrophobic substances, like phenanthrene, when used at higher concentrations than 0.4gL(-1). This material could be obtained from a 1:1 v/v mixture of municipal solid and lignocellulosic wastes composted for 15 days. The compost, containing 69.3% volatile solids, 39.6% total organic C and 21C/N ratio, was extracted for 24h at 65 degrees C under N2 with aqueous 0.1molL(-1) NaOH and 0.1molL(-1) Na4P2O7, and the solution was acidified to separate the precipitated cHAL in 12% yield from soluble carbohydrates and other humic and non-humic substances. In this work two typical applications of surfactants, i.e., textile dyeing (TD) and soil remediation by washing (SW), were chosen as grounds for testing the performance of the cHAL biosurfactant against the one of sodium dodecylsulfate (SDS), which is a well established commercial synthetic surfactant. The TD trials were carried out with nylon 6 microfiber and a water insoluble dye, while the SW tests were performed with two soils contaminated by polycyclic aromatic hydrocarbons (PAH) for several decades. Performances were rated in the TD experiments based on the fabric colour intensity (DeltaE) and uniformity (sigmaDeltaE), and in the SW experiments based on the total hydrocarbons concentration (CWPAH) and on the residual surfactant (Cre) concentrations in the washing solution equilibrated with the contaminated soils. The results show that both cHAL and SDS exhibit enhanced performance when applied above their cmc values. However, while in the TD case a significant performance effect was observed at the surfactants cmc value, in the SW case the required surfactants concentration values were equivalent to 25-125xcmc for cHAL and to 4-22xcmc for SDS. The vis-a-vis comparison of the two surfactants gave the following results: in the TD case the cHAL biosurfactant at 0.4gL(-1) yields good colour intensity and equal colour uniformity as SDS at 5gL(-1), in the SW case cHAL was found to enhance CWPAH by a factor of 2-4 relative to SDS with one soil, whereas with the other soil the two surfactants behaved similarly. The Cre data, however, showed that both soils absorbed by far more SDS (68-95%) than cHAL (12-54%). The results point out intriguing technological and environmental perspectives deriving from the use of compost isolated biosurfactants in the place of synthetic surfactants.     

Is PM10 mass measurement a reliable index for air quality assessment? An environmental study in a geographical area of north-eastern Italy

The aim of this study was to measure the concentration of some metals (Cd, Cr, Cu, Fe, Mn, Ni, Pb, and Ti) in PM(10) samples collected in one urban and one industrial site and to assess that PM(10) total mass measurement may be not sufficient as air quality index due to its complex composition. Metals were determined by inductively coupled plasma-atomic emission spectroscopy (ICP-AES) and differential pulsed anodic stripping voltammetry (DPASV). The measured concentrations were used to calculate the content of metals in the PM(10) total mass, and to estimate the enrichment factors and the correlations between PM(10), metal concentrations and meteorological data for the two sites. The mean PM10 concentration during the sampling period in the urban site exceeded the annual European Union (EU) standard (40 microg/m(3)) and, for some sampling days, the daily EU standard (50 microg/m(3)) was also exceeded. In opposite, both EU standards were never exceeded in the industrial site. The overall metal content was nearly double in the industrial site compared to the urban one, and the mean Ni concentration exceeded the EU annual limit value (10 ng/m(3)). The metals with the highest enrichment factor were Cd, Cu, Ni and Pb for both sites, suggesting a dominant anthropogenic source for these metals. Metal concentrations were very low and typical of rural background during Christmas holidays, when factories were closed. PM(10) total mass measurement is not a sufficient air quality index since the metal content of PM(10) is not related to its total mass, especially in sites with industrial activities. This measurement should be associated with the analysis of toxic metals.     

Distribution, sources, and potential risk of polycyclic aromatic hydrocarbons (PAHs) in drinking water resources from Henan Province in middle of China

Distribution and risk assessment of polycyclic aromatic hydrocarbons (PAHs) in drinking water resources have been carried out for the first time in Henan Province, China. Water samples collected from four river systems and their tributaries, as well as groundwater resources, were analyzed according to EPA method 525.2. Total of 68 water samples were collected in 18 cities in Henan province in May, August and November, 2001. Concentrations of sum of 16 priority PAHs in water samples ranged from 15 to 844 ng/L with a mean value of 178 +/- 210 ng/L (n = 68). The spatial and temporal distribution of PAHs showed that the Huanghe and the Huaihe river systems had relatively higher concentrations of total PAHs. Higher concentrations of total PAHs were observed in August and November than in May, with respective mean values of 262, 232 and 33.6 ng/L. Ratios of Ant/(Ant + Phe) and Flur/(Flur + Pyr) were calculated to evaluate the possible sources of PAH contamination, which indicated that the coal combustion sources were the main contributors to PAHs in most drinking water resources. Some petrogenic (or pyrolytic) sources of PAHs were also found. The toxic equivalency factors (TEFs) were used to calculate benzo[a]pyrene equivalents (BaPE) for water samples. The average value of BaPE was 0.6 ng/L. The values in most stations were much lower than the guideline values in drinking water of Chinese Environmental Protection Agency (CEPA, 2.8 ng/L) and the US Environmental Protection Agency (US EPA, 200 ng/L). Overall, the drinking water resources in Henan province showed some carcinogenic potential.     

Hydrology, suspended sediment dynamics and nutrient loading in Lake Takkobu, a degrading lake ecosystem in Kushiro Mire, northern Japan

Suspended sediment and nutrient loadings from agricultural watersheds have lead to habitat degradation in Lake Takkobu. To examine their relationships with land-use activities, we monitored sediment, nutrient and water discharges into the lake for a 1-year sampling period. The Takkobu River contributed the largest portion of the annual water discharge into the lake, compared with the other tributaries. During dry conditions, lake water flowed into the Kushiro River, and conversely during flooding, Kushiro River water flowed into the lake. Inflows from the Kushiro River had a high proportion of inorganic matter, with high concentrations of total nitrogen and total phosphorus, attributed to agricultural land-use development and stream channelization practiced since the 1960s in the Kushiro Mire. Nutrient loadings from these two rivers were significantly higher during flooding than in dry conditions. However, there was no clear correlation between river discharge and nutrient concentrations. Since land-use activities in the Kushiro River and Takkobu River watersheds were concentrated near rivers, nutrients easily entered the drainage system under low flow conditions. In contrast, water discharged from small, forest-dominated watersheds contained a low proportion of inorganic matter, and low nutrient concentrations. The suspended sediment delivered to the lake during the sample period was estimated as approximately 607 tons, while the total nitrogen and total phosphorus inflows were about 10,466 and 1,433 kg, respectively. Suspended sediment input into the lake was 65%, and total nitrogen and total phosphorus were 40% and 48%, respectively, being delivered by the Kushiro River.     

Impact of untreated wastewater irrigation on soils and crops in Shiraz suburban area, SW Iran

In this study an assessment is made of the negative impacts of wastewater irrigation on soils and crops sampled along the Khoshk River channel in suburban area of Shiraz City, SW Iran. For this purpose, samples of soil profiles (0–60 cm in depth) and crops were collected from two wastewater irrigated sites and a tube well-irrigated (control) site. Total concentrations of the five heavy metals (Ni, Pb, Cd, Zn and Cr) and their phytoavailable contents were determined. The Pollution Load Indexes (PLIs) and Contamination Factors (CFs) for soils and Hazard quotients (ΣHQ) for some vegetables were also calculated. The results showed the use of untreated wastewater has caused the following changes as compared to control site: (1) a 20–30% increase in organic matter content of soil; (2) increase in pH by 2–3 units; (3) significant concentration increase in Ex-Ca especially in top layers of soil resulting in high CEC; (4) build up of heavy metals (notably Pb and Ni) in topsoil above Maximum Permissible Limits (MPLs) indicating a moderate contamination (PLI > 1, CF > 2.5); (5) contamination of some vegetables (spinach and lettuce) with Cd due to its high phytoavailability in topsoil causing a HQ > 1; (6) excessive accumulation of Ni and Pb in wheat due to continual addition of heavy metals through long-term wastewater application. The study concludes that strict protection measures, stringent guidelines and an integrated system for the treatment and recycling of wastewater are needed to minimize the negative impacts of wastewater irrigation in the study area.     

Preliminary assessment of polybrominated diphenyl ethers (PBDEs) in the Scottish aquatic environment, including the Firth of Clyde

This paper presents preliminary data on polybrominated diphenyl ethers (PBDEs) in the Scottish aquatic environment. Sediment and biota (fish liver, fish muscle and mussels) from a number of locations around Scotland were analysed for PBDEs with samples being from both remote and from potentially contaminated areas such as the former sewage sludge dump site at Garroch Head in the Clyde. PBDEs were measured in both cultivated, rope grown mussels and wild mussels collected from 5 sites around Scotland in 2006. Total PBDE concentrations (sum of tri- to hepta-BDEs) ranged from 相似文献   

Soil subsampling in environmental sciences: the role of granulometry

Uncertainty associated to analytical results is an issue of major interest for the whole analytical community. A large effort has been made to improve analytical techniques and procedures aimed to achieve a well characterized uncertainty associated with analysis. However, it is becoming increasingly recognised that uncertainty deriving from sampling and subsampling can even dominate the global uncertainty budget. A study on subsampling activities on different soil typologies has been performed by granulometry determinations. The differences between sieving methodologies based on both wet and dry mode have been studied. Subsampling is approached by replicated measurements providing a quantitative assessment of the distribution heterogeneity, a suitable method validation scheme and an empirical determination of uncertainty.     

Characteristics of dwellings contaminated by moulds

Dwellings showing a presence of moulds are considered to be unhealthy both by the inhabitants and by sanitary authorities. Although the thresholds of pathogenicity have not yet been established, the toxic, allergic and infectious risk of indoor moulds is better understood today. A study on indoor fungi contamination for 128 dwellings was done between October and May in France. It concerned 69 dwellings, the occupants of which either complained to the sanitary authorities about problems of moulds and humidity or consulted a doctor who related their symptoms to housing conditions. Fifty-nine other dwellings, the occupants of which were healthy, constituted the control group. We present the statistical analysis of questionnaires, which aimed to clarify characteristics of dwellings associated with high concentrations of airborne moulds. Air samples were taken with an impactor in 500 rooms. On visiting dwellings, investigators obtained answers to 25 questions concerning characteristics of inhabitants and living space, as well as the presence of mould indicators. Indoor and outdoor temperature and indoor relative humidity of air measurements were taken. The total concentration of fungi in the air was significantly higher in ground floor apartments versus those on other floors (p = 0.047), in small and highly occupied dwellings (p = 0.03 and 0.003), in dwellings with electric heating (p = 0.04), without a ventilation system (p = 0.003), with water damage (p = 0.003), and finally, in those where the investigator noted an odour of moisture or visible moulds (p < 0.001). The efficacy of the latter criteria in the evaluation of insalubrity is discussed.     

Trace metal speciation during dry and wet weather flows in the Tama River, Japan, by using diffusive gradients in thin films (DGT)

The labile species of Ni, Cu, Zn, Cd, and Pb in the Tama River, an urban river in Tokyo, Japan, were measured using diffusive gradients in thin films (DGT) method under dry and wet weather conditions, and the results were compared with total dissolved concentrations in hourly samples collected in parallel. A total of 10 DGT deployments were made and 251 hourly samples were collected during 2 rounds of sampling, conducted between August and October, 2006. Two types of diffusive gradients in thin films (DGT) devices-DGT-RG for labile inorganic and DGT-APA for total (inorganic and organic) labile species-were applied throughout the samplings. The proportions of metals measured by DGT, compared with the dissolved metal concentrations (filtered using a membrane of 0.5 microm pore size), were 38 +/- 5% (RG) and 45 +/- 8% (APA) for Ni and 45 +/- 22% (RG) and 53 +/- 23% (APA) for Zn. No labile Cu was detected throughout the sampling; Cu was assumed to be in stable complexed forms. Labile Pb was detected in 3 out of 10 deployments only; the rest were lower than the detection limit. Dissolved and labile Cd concentrations were below the detection limits. Three rain events encountered during the sampling periods were evaluated. Rains brought considerably higher loads of metals in dissolved form, and DGT measurements indicated that labile metal loads also increased. Selected DGT measurements were compared with the WHAM 6 speciation model and found to be similar to the model-computed results.     

Organotins in a medium-size Mediterranean basin (the Herault River)

This study reports the first assessment of organotin pollution in the Hérault watershed, a medium size Mediterranean basin. Organotin compounds were analyzed in surface waters, wells supplying drinking water and sewage treatment plants (STPs). In surface and ground waters, a background contamination by total organotin compounds has been identified in the range of 0.51 +/- 0.02-71 +/- 2 ng(Sn) L(-1), which is of the same order of magnitude as those observed in other European areas. Organotins were systematically present in STP influents and sludge. Total or partial elimination of organotin compounds from treated wastewater was observed. STP effluents appeared nevertheless to be a non-negligible source of contamination not only of rivers but also of aquifers tapped for drinking water supply.Tributyltin concentration was higher than the maximum allowable concentration proposed by the European Commission in some surface waters and wells supplying drinking water. This could compromise the water resource and have serious and irreversible consequences for the aquatic eco-system. As it was the case for the ban of antifouling paints, a regulatory regime in decreasing point-source emissions of these harmful compounds used in household products might be applied.