戴明循环理论在规划环评工作程序中的应用初探

通过分析现阶段我国规划环评的现状和存在的问题,结合国内外规划环评及其工作程序的研究成果,提出使用戴明循环理论对现阶段的规划环评工作程序进行改进,使程序层次化、工作细分化,增强整个规划环评工作的可操作性,使规划环评工作落实到单位和人,明确责任,减少部门间冲突.戴明循环理论的引入,提高规划环评的评价效果和效率,为规划环评提供了一个有效科学的评价方法,有助于规划环评的顺利开展,使环境问题从源头上得到控制,适应建设和谐社会的需要.     

Seed yeast cultivation for salad oil manufacturing wastewater treatment

The mixture of five yeast strains obtained from soil could remove about 85% TOC of oil-rich wastewater in batch test.While the highest MLSS was obtained at an N:C of 1:5,the oil removal decreased with the increase of N:C during yeast sludge cultivation.Ammonium chloride was the best nitrogen source for yeast cultivation from the viewpoint of yeast growth and oil utilizxation.An ammonia concentration of over 1300 mg/L led to mass death of yeast at a pH of 5.The ammonia concentration should be controlled at a level of 1000 mg/L or lower.     

水质特性和NOM在臭氧氧化和PAC吸附去除MIB、GEOSMIN上的作用

介绍了臭氧氧化、活性炭吸附去除MIB、GEOSMIN时的主要影响因素，分析了各因素对去除率的影响程度及原因。还介绍了臭氧、PAC去除痕量异味物质的机理。     

孔板结构脱硫脱水性能的试验研究

通过真实规模的试验台对应用于烟气湿法脱硫洗涤塔中的孔板结构进行了脱硫、脱水效果的试验研究 ,得出了孔板结构与其他结构的脱硫效率间的差异 ,比较了不同结构孔板的脱水效率 ,并进行了理论分析     

Fulvic acid removal by nanoparticle TiO2 using a submerged membrane photocatalysis reactor

The degradation of fulvic acid（FA） by nanoparticle TiO2 in a submerged membrane photocatalysis（SMPC） reactor was studied. In this reactor, photocatalytic oxidation and membrane separation co-occured. The continuous air supplier provided O2 for the photocatalytical reaction and mixed the solution through an airflow controller. The particle TiO2 could automatically settle due to gravity without particle agglomeration so it could be easily separated by microfiltration（MF） membrane. It was efficient to maintain high flux of membranes. The effects of operational parameters on the photocatalytic oxidation rate of FA were investigated. Results indicated that photocatalyst at 0.5 g/L and airflow at 0.06 m^3/h were the optimum condition for the removal of fulvic acid, the removal efficiency was higher in acid media than that in alkaline media. The effects of different filtration duration on permeate flux rate of MF with P25 powder and with nanoparticle TiO2 were compared. Experimental results indicated that the permeate flux rate of MF was improved and the membrane fouling phenomenon was reduced with the addition of nanoparticle TiO2 catalyst compared with conventional P25 powder. Therefore, this submerged membrane photocatalysis reactor can faciliate potential application of photocatalytic oxidation process in drinking water treatment.     

常温酸性腐蚀对热障涂层性能的影响

采用酸性盐雾腐蚀试验对物理气相沉积法制备的热障涂层进行了常温腐蚀,研究了常温酸性盐雾腐蚀对热障涂层的微观形貌以及高温性能的影响.试验结果表明：常温酸性腐蚀使热障涂层表面变得粗糙不平,产生了较大的裂纹.经过150次高温循环氧化后,顶层氧化锆晶粒排列疏松,裂纹进一步扩展,中间层--粘结层氧化速度加快,生成了疏松的TGO层.TGO的体积膨胀效应使得陶瓷/粘结层界面结合力降低,缩短了涂层的使用寿命.     

城市污水高效低耗生物脱氮工艺研究

采用活性污泥与生物膜法相结合工艺处理城市生活污水，可以高效去除污水中的有机物和NH4^ -N。研究结果表明：水力停留时间为7．5h、回流比为1．5、无外加碳源时，COD的去除率大于90％，NH4^ -N的去除率大于99％；平均出水COD小于40mg／L，NH4^ -N小于1mg／L，TN的去除率60％左右；反硝化过程的适宜C／N为4～5。     

ABR工艺预处理木薯酒糟废水的工程应用

木薯酒糟废水有机物浓度高、悬浮物含量大、pH呈酸性、可生化性能较差 ,通常直接采用固液分离—厌氧 (UASB)—好氧曝气生化法处理效果并不理想 ,而采用ABR工艺进行厌氧水解酸化预处理木薯酒糟废水迄今为止未见报道。经绵阳市酒厂废水治理工程证明 ,强化ABR预处理工序是保证后续处理措施能否正常运行的关键     

影响微生物絮凝剂产生的因素研究

本文通过改变培养基的种类、培养基的碳源、氮源、无机盐离子来选择絮凝剂产生菌“Dfjm-1”高效低廉的培养基 ;通过改变培养基初始 p H值、培养温度、培养过程中的通气量等因素 ,得出“Dfjm-1”菌株产生絮凝剂的最佳条件。Dfjm-1产生絮凝剂的最佳因素为 :培养基初始 p H值为 6.5～ 7.0 ,培养温度为 3 0℃ ,培养时间为 60小时左右 ,通气量为 :早期 :2 50 r/ min;中期 1 50 r/ min;后期 1 0 0～ 1 50 r/ min     

小诺霉素发酵废水好氧生物处理试验研究

对具有强抑制性污染物的抗生素小诺霉素发酵废水，选择活性污泥、粉末活性炭（ＰＡＣＴ）、纯氧曝气等３种好氧生物处理法进行了比较试验。根据实验结果，小诺霉素发酵废水的生物降解呈抑制动力学，采用Ｍａｒｑｕａｒｔ方法对动力学模式进行参数估计。ＰＡＣＴ能够有效地降低降解过程中微生物受到的抑制作用，从而明显地改善了生物处理过程动力学。