Integrated assessment of future CAP policies: land use changes,spatial patterns and targeting

The recent and upcoming reforms of the Common Agricultural Policies (CAPs) aim at strengthening the multifunctional role of agriculture, acknowledging the differences in economic, environmental and social potentials within European regions. This paper presents results from an integrated assessment of existing and future policies within the framework set up in the FP6 EU project MEA-Scope. Spatial explicit procedures allow for the MEA-Scope modelling tools to provide information related to regional, environmental and socio-economics settings. The impact of different policy scenarios on structural change, land abandonment and cropping pattern of typical farms has been assessed based on linked agent-based (ABM) and Linear Programming (LP) models at regional and farm scale for two study areas. For the German case study area Ostprignitz-Ruppin (OPR), the issue of policy targeting has been addressed by relating non-commodity outputs (NCOs) to soil quality and protection status. For the Italian case study area (Mugello), changes in landscape patterns in terms of increased fragmentation or homogeneity as affected by changes in agricultural intensity have been analysed using semivariance analysis. The spatial explicit approach highlighted the relevance of case study research in order to identifying response structures and explaining policy implementation patterns.     

Pesticide exposure and serum organochlorine residuals among testicular cancer patients and healthy controls

The incidence of testicular cancer (TC) has been increasing worldwide during the last decades. The reasons of the increase remains unknown, but recent findings suggest that organochlorine pesticides (OPs) could influence the development of TC. A hospital-based case-control study of 50 cases and 48 controls was conducted to determine whether environmental exposure to OPs is associated with the risk of TC, and by measuring serum concentrations of OPs, including p,p'-dichlorodiphenyldichloroethylene (p,p'-DDE) isomer and hexachlorobenzene (HCB) in participants. A significant association was observed between TC and household insecticide use (odds ratio [OR] = 3.01, 95 % CI: 1.11-8.14; OR(adjusted) = 3.23, 95 % CI: 1.15-9.11). Crude and adjusted ORs for TC were also significantly associated with higher serum concentrations of total OPs (OR = 3.15, 95 % CI: 1.00-9.91; OR(adjusted) = 3.34, 95 % CI: 1.09-10.17) in cases compared with controls. These findings give additional support to the results of previous research that suggest that some environmental exposures to OPs may be implicated in the pathogenesis of TC.     

The Fate of Priority Areas for Conservation in Protected Areas: A Fine-Scale Markov Chain Approach

Park managers in alpine areas must deal with the increase in forest coverage that has been observed in most European mountain areas, where traditional farming and agricultural practices have been abandoned. The aim of this study is to develop a fine-scale model of a broad area to support the managers of Paneveggio Nature Park (Italy) in conservation planning by focusing on the fate of priority areas for conservation in the next 50–100 years. GIS analyses were performed to assess the afforestation dynamic over time using two historical maps (from 1859 and 1936) and a series of aerial photographs and ortho-photos (taken from 1954 to 2006) covering a time span of 150 years. The results show an increase in the forest surface area of about 35%. Additionally, the forest became progressively more compact and less fragmented, with a consequent loss of ecotones and open habitats that are important for biodiversity. Markov chain-cellular automata models were used to project future changes, evaluating the effects on a habitat scale. Simulations show that some habitats defined as priority by the EU Habitat Directive will be compromised by the forest expansion by 2050 and suffer a consistent loss by 2100. This protocol, applied to other areas, can be used for designing long-term management measures with a focus on habitats where conservation status is at risk.     

Biodegradability of soil water soluble organic carbon extracted from seven di erent soils

Water soluble organic carbon (WSOC) is considered the most mobile and reactive soil carbon source and its characterization is an important issue for soil ecology study. A biodegradability test was set up to study WSOC extracted from 7 soils di erently managed. WSOC was extracted from soil with water (soil/water ratio of 1:2, W/V) for 30 min, and then tested for biodegradability by a liquid state respirometric test. Result obtained confirmed the finding that WSOC biodegradability depended on the both land use and management practice. These results suggested the biodegradability test as suitable method to characterize WSOC, and provided useful information to soil fertility.     

Assessment and comparison of the environmental performances of a regional incinerator network

In Emilia-Romagna region (Northern Italy) the integrated waste treatment system consists of material collection and recycling, incineration with energy recovery and landfill as final disposal. In particular, at least one incineration plant is working in almost every province of the region. In this work, a screening life cycle assessment approach is applied to seven different incinerators, to compare the different plant technologies and identify the most relevant environmental impacts and processes. The characterization method used in the life cycle impact assessment step is Eco-indicator 99. The functional unit is 1 ton of waste input. As a first result, it can be noted that while the combustion systems are rather similar, the main variables are ascribable to gas cleaning options and efficiency in energy recovery, which result in quite different environmental performances. Among heavy metals, particular attention must be paid to Cd and As, due to their high toxicity, despite their low quantities. The impact due to dioxin emission is orders of magnitude lower than other contaminants (e.g., heavy metals). Furthermore, a catalytic system could be useful for a complete removal of organic contaminants and for a more effective abatement of nitrogen oxides. Finally, the environmental impact assessment sorts the various plants according to their age, i.e., the most recent plants provide the best environmental performances for the same quantity of combusted waste.     

Use of biosurfactants from urban wastes compost in textile dyeing and soil remediation

A compost isolated humic acid-like (cHAL) material was pointed out in previous work for its potential as auxiliary in chemical technology. Its potential is based on its relatively low 0.4gL(-1) critical micellar concentration (cmc) in water, which enables cHAL to enhance the water solubility of hydrophobic substances, like phenanthrene, when used at higher concentrations than 0.4gL(-1). This material could be obtained from a 1:1 v/v mixture of municipal solid and lignocellulosic wastes composted for 15 days. The compost, containing 69.3% volatile solids, 39.6% total organic C and 21C/N ratio, was extracted for 24h at 65 degrees C under N2 with aqueous 0.1molL(-1) NaOH and 0.1molL(-1) Na4P2O7, and the solution was acidified to separate the precipitated cHAL in 12% yield from soluble carbohydrates and other humic and non-humic substances. In this work two typical applications of surfactants, i.e., textile dyeing (TD) and soil remediation by washing (SW), were chosen as grounds for testing the performance of the cHAL biosurfactant against the one of sodium dodecylsulfate (SDS), which is a well established commercial synthetic surfactant. The TD trials were carried out with nylon 6 microfiber and a water insoluble dye, while the SW tests were performed with two soils contaminated by polycyclic aromatic hydrocarbons (PAH) for several decades. Performances were rated in the TD experiments based on the fabric colour intensity (DeltaE) and uniformity (sigmaDeltaE), and in the SW experiments based on the total hydrocarbons concentration (CWPAH) and on the residual surfactant (Cre) concentrations in the washing solution equilibrated with the contaminated soils. The results show that both cHAL and SDS exhibit enhanced performance when applied above their cmc values. However, while in the TD case a significant performance effect was observed at the surfactants cmc value, in the SW case the required surfactants concentration values were equivalent to 25-125xcmc for cHAL and to 4-22xcmc for SDS. The vis-a-vis comparison of the two surfactants gave the following results: in the TD case the cHAL biosurfactant at 0.4gL(-1) yields good colour intensity and equal colour uniformity as SDS at 5gL(-1), in the SW case cHAL was found to enhance CWPAH by a factor of 2-4 relative to SDS with one soil, whereas with the other soil the two surfactants behaved similarly. The Cre data, however, showed that both soils absorbed by far more SDS (68-95%) than cHAL (12-54%). The results point out intriguing technological and environmental perspectives deriving from the use of compost isolated biosurfactants in the place of synthetic surfactants.     

Development of regenerative dye impregnated mesoporous silica materials for assessing exposure to ammonia

The mesostructured materials MCM-41 and SBA-15 were studied as possible supports of bromocresol green (BG) dye impregnation for the ammonia gas detection because of their large surface area, high regenerative property, and high thermal stability. X-ray diffraction, transmission electron microscopy, scanning electron microscope, and N2 adsorption analysis were used to characterize the prepared materials. These materials could sense ammonia via visible color change from yellowish-orange to blue color. The color change process of the nanostructured materials was fully reversible during 10 cyclic tests. The results indicated that the ammonia absorption responses of the two nanostructured materials were both very sensitive, and high linear correlation and high precision were achieved. As the gaseous ammonia concentrations were 50 and 5 ppmv, the response times for the SBA-15/BG were only 1 and 5 min, respectively. Moreover the BG dye-impregnated SBA-15 was less affected by the variation in the relative humidity. It also had faster response for the detection of NH3, as well as lower manufacturing price as compared to that of the dye-impregnated MCM-41. Such feature enables SBA-15/BG to be a very promising material for the detection of ammonia gas.     

Chlorpyrifos residues levels in fruits and vegetables after field treatment

Chlorpyrifos (O,O-diethyl O-3,5,6-trichloro-2-pyridyl phosphorothioate) was applied with three different formulations on oranges, peaches, tomatoes, wine and table grapes, and its behaviour was evaluated after field treatment. The formulations applied were emulsifiable concentrates (EC), microencapsulates (ME), and wettable granules (WG). The residues were similar in all crops studied in the EC and WG experiments, except peaches with WG treatment, the residue amount was lower than EC values. Tomatoes which were grown in greenhouse showed similar residues in all treatments just after treatment. Wine and table grapes showed different decline curves in the EC experiments ascribable to the different growing technology. Instrumental limit of determination (LOD) and limit of quantification (LOQ) for all matrices were 0.01, and 0.03 mg kg?1, respectively. Repeated treatments showed that Chlorpyrifos can accumulate leading to residue levels at the preharvest interval (PHI) over the maximum residue level (MRL), especially on oranges and peaches. Among the formulates used ME showed the higher risk of residues over the MRL at harvest.     

Comparative analysis for the production of fatty acid alkyl esterase using whole cell biocatalyst and purified enzyme from Rhizopus oryzae on waste cooking oil (sunflower oil)

The petroleum fuel is nearing the line of extinction. Recent research and technology have provided promising outcomes to rely on biodiesel as the alternative and conventional source of fuel. The use of renewable source - vegetable oil constitutes the main stream of research. In this preliminary study, Waste Cooking Oil (WCO) was used as the substrate for biodiesel production. Lipase enzyme producing fungi Rhizopus oryzae 262 and commercially available pure lipase enzyme were used for comparative study in the production of Fatty Acid Alkyl Esters (FAAE). The whole cell (RO 262) and pure lipase enzyme (PE) were immobilized using calcium alginate beads. Calcium alginate was prepared by optimizing with different molar ratios of calcium chloride and different per cent sodium alginate. Entrapment immobilization was done for whole cell biocatalyst (WCB). PE was also immobilized by entrapment for the transesterification reaction. Seven different solvents - methanol, ethanol, n-propanol, n-butanol, iso-propanol, iso-butanol and iso-amyl alcohol were used as the acyl acceptors. The reaction parameters like temperature (30°C), molar ratio (1:3 - oil:solvent), reaction time (24 h), and amount of enzyme (10% mass ratio to oil) were also optimized for methanol alone. The same parameters were adopted for the other acyl acceptors too. Among the different acyl acceptors - methanol, whose reaction parameters were optimized showed maximum conversion of triglycerides to FAAE-94% with PE and 84% with WCB. On the whole, PE showed better catalytic converting ability with all the acyl acceptor compared to WCB. Gas chromatography analysis (GC) was done to determine the fatty acid composition of WCO (sunflower oil) and FAAE production with different acyl acceptors.     

Foraminiferal biotopes and their distribution control in Ria de Aveiro (Portugal): a multiproxy approach

Ria de Aveiro, which is located in the centre of Portugal (40° 38′ N, 8° 45′ W), is a well-mixed and complex coastal lagoon that is separated from the sea by a sandy barrier and connects with the Atlantic through an artificial inlet. Tidal currents are the main factor controlling the lagoon’s hydrodynamics and, to a great extent, the sedimentary dynamic. The inner lagoonal zones receive input from several rivers and experience the pressure caused by the accumulation of organic matter and pollutants (namely, trace metals) from diverse anthropic activities. This paper is the first piece of work aiming to recognize, characterize and explain the main benthic foraminiferal biotopes in Ria de Aveiro. To provide a broad overview of this kind of setting, our results are compared to those of previous published studies conducted in similar transitional environments. The research is based on an investigation of 225 sites spread throughout this ecosystem. Utilizing a statistical approach, this study analyses the details of dead benthic foraminiferal assemblages composed of 260 taxa, the texture and composition (mineralogical and geochemical) of the sediment and physicochemical data. On the basis of the results of R-mode and Q-mode cluster analyses, several different biotopes can be defined as marsh biotope/near-marsh biotope; marginal urban/marginal urban mixing biotope; inner-outer lagoon biotope or enclosed lagoon; outer lagoon biotope, mixed sub-biotope; and outer lagoon, marine sub-biotope. These biotopes are related to foraminifera assemblages and substrate type and are influenced by local currents, water depth, chemical and physicochemical conditions, river or oceanic proximity, and anthropogenic impact, as evidenced by the mapping of the six factor loadings of the principal component analysis conducted herein. Based on a similar methodology of analysis as that applied in previous studies in the Lagoon of Venice, comparable biotypes were identified in Lagoon of Aveiro.