Alcohol-assisted dyeing processes: a chemical substitution study

Dyeing processes of various yarns (wool, cotton, polyester, nylon 6 and acrylic) were studied with the aim to substitute some auxiliary agents with ethanol at low concentration. The results observed in isothermal dyeing showed a favorable effect of alcohol addition, at about 1-3% v/v, on the dye uptake, with some differences depending on fiber nature and dye class. This effect was correlated with contact angle measurements of water-ethanol solutions on the mentioned yarns, which confirmed a lower surface tension in the same concentration range. Then, laboratory tests with dye triads at programmed temperature were carried out comparing the results of standard dyeing recipes with those obtained by replacing wetting, retardant and leveling agents with ethanol. Good color imitations were generally shown with respect to standard processes. A wetting effect of ethanol was shown for all the tested yarns and dye classes, while in wool dyeing with acid, pre-metallized and reactive dyes, ethanol was suitable to replace also leveling and retarding agents. Light and wash fastnesses were also compared. Finally the environmental benefits arising from chemical substitution of auxiliary agents with ethanol were highlighted and the cost of alcohol introduction was compared with the cost saving of auxiliary substitution. A positive economic balance was obtained.     

Rapid,recurring, structured survey versus bioblitz for generating biodiversity data and analysis with a multispecies abundance model

A bioblitz inexpensively and quickly generates biodiversity data, but bioblitzes are often conducted with haphazard, unreplicated sampling. Results tend to be taxonomically, geographically, or temporally biased, lack metadata, and consist of lists of observed taxa that do not enable further analyses or correction for imperfect detection. A rapid, recurring, structured survey (RRSS) uses a structured sampling design and temporal and spatial replication to survey randomly selected sites on a conservation property. We participated in a loosely structured bioblitz and a subsequent RRSS at Big Canoe Creek Nature Preserve in Springville (St. Clair County), Alabama (USA) to compare observed richness derived from the 2 survey approaches. The RRSS data structure enabled us to fit models that accounted for imperfect detection to estimate abundances, occupancy probabilities, and habitat associations. The loosely structured bioblitz data could not be used in such models. We present a new integrated multispecies abundance model that we applied to avian RRSS data. Our model extension enables estimation for the community, employs data augmentation to estimate the number of undetected species, and incorporates covariates. The RRSS generated a more comprehensive and less biased list of observed taxonomic richness than the loosely structured bioblitz (e.g., 73 vs. 45 bird species and 104 vs. 63 insect families from the RRSS vs. loosely structured bioblitz, respectively). Models fit to the RRSS data identified seasonal patterns in avian community composition and allowed for estimation of habitat–occupancy relationships for insect taxa. The RRSS protocol has potential for broad transferability as a standardized, quick, and inexpensive way to inventory biodiversity and estimate ecological parameters while providing an outreach opportunity.     

Microplastics in seawater: sampling strategies,laboratory methodologies,and identification techniques applied to port environment

Environmental Science and Pollution Research - The European Interreg Italy–France 2014–2020 Maritime Project SPlasH! (Stop to Plastics in H2O!) focused on the study of microplastics...     

Industrial point source CO<Subscript>2</Subscript> emission strength estimation with aircraft measurements and dispersion modelling

CO₂ remains the greenhouse gas that contributes most to anthropogenic global warming, and the evaluation of its emissions is of major interest to both research and regulatory purposes. Emission inventories generally provide quite reliable estimates of CO₂ emissions. However, because of intrinsic uncertainties associated with these estimates, it is of great importance to validate emission inventories against independent estimates. This paper describes an integrated approach combining aircraft measurements and a puff dispersion modelling framework by considering a CO₂ industrial point source, located in Biganos, France. CO₂ density measurements were obtained by applying the mass balance method, while CO₂ emission estimates were derived by implementing the CALMET/CALPUFF model chain. For the latter, three meteorological initializations were used: (i) WRF-modelled outputs initialized by ECMWF reanalyses; (ii) WRF-modelled outputs initialized by CFSR reanalyses and (iii) local in situ observations. Governmental inventorial data were used as reference for all applications. The strengths and weaknesses of the different approaches and how they affect emission estimation uncertainty were investigated. The mass balance based on aircraft measurements was quite succesful in capturing the point source emission strength (at worst with a 16% bias), while the accuracy of the dispersion modelling, markedly when using ECMWF initialization through the WRF model, was only slightly lower (estimation with an 18% bias). The analysis will help in highlighting some methodological best practices that can be used as guidelines for future experiments.     

On the selection of stimulus for the auditory variant of the detection response task method for driving experiments

Objectives: The detection response task (DRT) is a method for measuring attentional effects of secondary tasks on a driver's cognitive load by measuring response times and hit rates to different types of stimuli as indirect indicators of increased cognitive load. ISO 17488 (International Organization for Standardization 2016) only provides guidelines for the technical implementation and measurement methods for the visual and tactile versions (use of visual and tactile stimuli) of the DRT method. This article presents a study with the goal of finding the most appropriate auditory stimulus for the implementation of an auditory version of the DRT method.

Methods: This article presents the results of an experiment in which responses to 7 different auditory DRT stimuli—varying in frequency—were compared while inducing users' cognitive load with a modified n-back task. The experiment was conducted in a surrogate driving environment and in a within-subject design. Response times, hit rates, and secondary task performances were observed as indicators of increased cognitive load.

Results: Significantly shorter response times were found for the white noise signal compared to single-frequency signals. However, the largest differences in response times, for trials without and with a cognitive task, were found for 4- and 8-kHz single-frequency signals. No significant differences were found for hit rates and secondary task performances between the different stimuli.

Conclusions: Consistent significant differences in response times for all tested stimuli prove that the auditory DRT variant is also sensitive to changes in cognitive load. The mean increase in response times of more than 25% for 4- and 8-kHz signals for trials with a cognitive task compared to trials without one indicates that one of these signals could be used as a potential auditory stimulus for the auditory DRT variant.     

Utilization of pulverized fuel ash in Malta

In Malta all of the waste produced is mixed and deposited at various sites around the island. None of these sites were purpose built, and all of the waste is above groundwater level. The landfills are not engineered and do not contain any measures to collect leachate and gases emanating from the disposal sites. Another waste, which is disposed of in landfills, is pulverized fuel ash (PFA), which is a by-product of coal combustion by the power station. This has been disposed of in landfill, because its use has been precluded due to the radioactivity of the ashes. The aim of this study was to analyze the chemical composition of the pulverized fuel ash and to attempt to utilize it as a cement replacement in normal concrete mixes in the construction industry. The levels of radiation emitted from the ashes were measured by gamma spectrometry. The results of this study revealed that although at early ages cement replacement by PFA resulted in a reduction in compressive strength (P=0), when compared to the reference concrete at later ages the strengths measured on concrete cores were comparable to the reference concrete (P>0.05). The utilization of PFA up to 20% cement replacement in concrete did not raise the radioactivity of the concrete. In conclusion, utilization of PFA in the construction industry would be a better way of disposing of the ashes rather than controlling the leachate and any radioactivity emitted by the landfilled ashes.     

4-hours resolution data to study PM10 in a “hot spot” area in Europe

Nowadays, high-time resolved aerosol studies are mandatory to better understand atmospheric processes, such as formation, removal, transport, deposition or chemical reactions. This work focuses on PM10 physical and chemical characterisation with high-time resolution: elements (from Na to Pb), ions and OC/EC fractions concentration were determined during two weeks in summer and two in winter 2006 with 4-hours resolution. Further measurements aimed at hourly elemental characterisation of fine and coarse fractions and at the determination of particles number concentration in the 0.25-32 microm size range in 31 bins. The chemical mass closure was carried out in both seasons, enhancing intra-day differences in PM10 composition. In Milan, the highest contribution came from organic matter (34% and 33% in summer and winter, respectively); other important contributors were secondary inorganic compounds (16% and 24% in summer and winter, respectively) and, in summer, crustal matter (14%). Temporal trends showed strong variations in PM10 composition during contiguous time-slots and diurnal variations in different components contribution were identified. Moreover, peculiar phenomena, which would have hardly been detected with 24-hours samplings, were evidenced. Particles removal due to precipitations, aerosol local production and long range transport were studied in detail.     

Analysis of indoor gaseous formic and acetic acid, using radial diffusive samplers

A diffusive sampling method for the determination of gaseous acetic and formic acids, using a radial symmetry diffusive sampler, has been optimised for a 7-day exposure time in this study. Sampling rate determinations were performed on data obtained from a dynamic exposure chamber, simulating the indoor conditions of an empty, closed, room, at room temperature and minimal wind speed. Analysis has been performed by means of ion chromatography. The sampling rates for formic acid concentrations of 128 microg m(-3) and 1248 microg m(-3) were determined to be 91.2 +/- 3.9 ml min(-1) and 111.6 +/- 2.8 ml min(-1), respectively. The acetic acid sampling rate was independent of the concentration in the range 160 microg m(-3)-1564 microg m(-3), and amounted to 97.3 +/- 3.1 ml min(-1). Experimentally determined sampling rates showed deviations of 3% for acetic acid, and 3-21% for formic acid, in relation to theoretically derived values. The blank values were as low as 1.69 +/- 0.07 microg for formic acid and 1.21 +/- 0.14 microg for acetic acid, and detection limits lower than 0.5 microg m(-3) could be achieved, which is an improvement of 98-99% compared to previously validated diffusive sampling methods. This study describes the first step of an extended validation program in which the applicability of these types of samplers for the measurement of organic acids will be validated and optimised for the environmental conditions typical for museum showcases.     

Assessment of groundwater quality in a region of endemic fluorosis in the northeast of Brazil

The aim of this study was to estimate the risk for caries and fluorosis in a desertification area, applying the calcium/fluoride concentration ratio of underground water and the quality of water in a selected geographical region. This study was performed in the municipality of São João do Rio do Peixe, located in the tropical semiarid lands of Brazil. A total of 111 groundwater samples were collected. Fluoride concentration varied from 0.11 to 9.33 mg/L. Thirty percent of all samples analyzed showed values above 1.5 mg/L, while 64 % were above the ideal limit of 0.7 mg/L. Mean calcium concentration was 47.6 mg/L, and 14.4 % of all samples presented values above the WHO acceptable limits. The proportional value of calcium/fluoride in water showed that only 12 % of the samples were suitable for dental caries prevention with minimal risk for dental fluorosis. Mapping of the fluoride distribution indicated that approximately 2,465 people could be affected by dental fluorosis and 1,057 people might be affected by skeletal fluorosis. It can be concluded that, in addition to fluoride, many water parameters were not suitable for the drinking water. Mapping out calcium/fluoride ratio may indicate areas of water suitability for caries control, whereas the fluoride concentration solely can indicate the areas with the risk for fluorosis. This approach can be relevant for health authorities for identifying communities where dental caries or dental fluorosis is prevalent.     

Pendrin mediates uptake of perchlorate in a mammalian in vitro system

Perchlorate is a known endocrine disruptor present in groundwater, vegetables and dairy food products in many regions of the United States. It interferes with the uptake of iodide into the thyrocyte by the sodium-iodide symporter at the basolateral surface, thus potentially disrupting the synthesis of thyroid hormone. Because transport of iodide from the thyroid follicular cells to the follicular lumen is mediated by the protein pendrin at the apical surface, we hypothesized that perchlorate may also interact with this protein. Therefore, HeLa cells were transfected with the human SLC26A4 gene, which encodes pendrin, to generate an in vitro mammalian system expressing the recombinant pendrin protein (HeLa-PDS). The HeLa-PDS cells, along with untransfected cells, were then cultured in presence of iodide and/or perchlorate. Intracellular levels of these two chemicals were measured by ion chromatography tandem mass spectrometry. Results from this study show that iodide and perchlorate uptake increases significantly in HeLa-PDS cells as compared to untransfected cells. Thus, recombinant HeLa cells expressing pendrin protein accumulate iodide and perchlorate intracellularly, indicating that pendrin is involved in the uptake of perchlorate. Additional results from this study suggest that iodide and perchlorate competitively inhibit each other for uptake by pendrin. The ability of perchlorate to compete with iodide for uptake by both basal and apical transporters may increase the potential of perturbation of thyroid homeostasis and therefore the estimated risk posed to susceptible human populations.