Use of macroinvertebrate assemblages for assessing performance of stabilization ponds treating effluents from sugarcane and molasses processing

Wastewater discharge from sugarcane processing is a significant pollutant of tropical aquatic ecosystems. For most developing countries, monitoring of the level of pollutants is done mostly through chemical analysis, but this does not reflect potential impacts on aquatic assemblages. In addition, laboratory facilities for accurate concentration measurements are often not available for regular monitoring programs. In this study, we investigated the use of benthic macroinvertebrates for biological monitoring in western Kenya. Benthic macroinvertebrates were sampled in stabilization ponds treating wastewater from sugarcane- and molasses-based processing plants to assess their composition and abundance in relation to different concentrations of chemical variables. Optimum concentrations and tolerance values were identified for various taxa, and a biotic index was developed that combined tolerance values (ranked between 0 and 10) for the various macroinvertebrate taxa. A succession in composition and distribution of macroinvertebrate taxa was observed from the inlet to the outlet of the pond systems. Diptera dominated in the first ponds that had high concentrations of chemical oxygen demand (COD), biological oxygen demand (BOD₅), and nutrients, while intolerant Ephemeroptera, Plecoptera, and Trichoptera (EPT) appeared as the concentrations dropped in subsequent ponds. The effluent quality was classified as “good,” “fair,” and “poor,” corresponding with biotic index value ranges 0–3.50, 3.51–6.50, and 6.51–10, respectively. During validation, the index grouped sites with respect to levels of measured environmental variables. The study revealed that the developed biotic index would help in monitoring the quality of sugarcane processing and molasses effluents before release into recipient aquatic ecosystems, replacing the need for costly chemical analyses.     

Precipitation or evapotranspiration? Bayesian analysis of potential error sources in the simulation of sub-basin discharges in the Czech Elbe River basin

A global change assessment required detailed simulation of water availability in the Elbe River basin in Central Europe (148,268?km2). Using the spatially semi-distributed, eco-hydrological model SWIM, spatial calibration was applied. For 225 sub-areas covering the model domain (134,890?km2), evapotranspiration and groundwater dynamics were individually adjusted. The calibration aimed at good correspondences with long-term run-off contributions and the hydrographs for two extreme years. Measured run-off was revised from water management effects to produce quasi-natural discharges for calibration. At some gauges, there were large volume differences between these reference data and the simulations of the spatially uncalibrated model. Most affected were some sub-basins in the Czech part of the basin where the density of available climate stations was much lower than the German part. Thus, both erroneous precipitation data and systematic flaws in the evapotranspiration module of SWIM could have caused the differences. In order to identify the major error source and to validate the choice of spatial calibration parameters (evapotranspiration and groundwater dynamic corrections), MCMC analyses were made for three Czech areas. Optional precipitation correction had been considered by a third calibration parameter in the MCMC assessment. In two of the three cases, it can be shown that evapotranspiration corrections are preferable as precipitation errors are negligible. In the third case, where the analyses indicate a substantial error in precipitation data, an interpolation problem of the climate data at the edge of the model domain could be found. Hence, the applied method shows its potential to identify specific sources of uncertainty in hydrological modelling.     

Lead accumulation and association with Fe on Typha latifolia root from an urban brownfield site

Synchrotron X-ray microfluorescence and X-ray absorption near-edge microstructure spectroscopy techniques were applied to Typha latifolia (cattail) root sections and rhizosphere soils collected from a brownfield site in New Jersey to investigate lead (Pb) accumulation in T. latifolia roots and the role of iron (Fe) plaque in controlling Pb uptake. We found that Pb and Fe spatial distribution patterns in the root tissues are similar with both metals present at high concentrations mainly in the epidermis and at low concentrations in the vascular tissue (xylem and phloem), and the major Pb and Fe species in T. latifolia root are Pb(II) and Fe(III) regardless of concentration levels. The sequestration of Pb by T. latifolia roots suggests a potential low-cost remediation method (phytostabilization) to manage Pb-contaminated sediments for brownfield remediation while performing wetland rehabilitation.     

Air Quality Criteria for the Effects of Fluorides On Man

Minute traces of fluoride are found in the air of rural communities and of cities, having been contributed perhaps from volcanic effluvia, perhaps from burning coal, and perhaps from industrial sources. Atmospheres of urban areas of the U. S. have been found to contain from less than 0.2 μg F/m³ to as much as 1.9/μg F/m³. Fluorides released from industrial processes may release elemental fluorine, soluble gaseous fluorides, and soluble or insoluble fluoride dusts. At least in some instances inhaled fluoride from fluoride containing dusts has proven to be as biologically available as that from similar concentrations of inhaled HF. Measurement of the amount of fluoride excreted in the urine has proven to be a valuable index of exposure and a means of preventing cumulative injury. Average urinary F concentrations not exceeding 5 mg/liter, which corresponds approximately to a daily intake of 5 mg, are not associated with osteosclerosis in such workmen, and such changes are unlikely at daily intakes of 5 – 8 mg F. The amount of fluoride which is retained by an individual inhaling air containing 2.5 mg of fluoride dusts per m³ (the current TLV) is approximately 5-6 mg. A review of the literature describing the exposure of work forces to fluorides in industrial atmospheres indicates that concentrations have ranged from a fraction of a milligram/m³ to values mostly less than 10 mg/ml Surveys of populations living near installations emitting fluoride fumes or dusts indicate that, with few exceptions, the health of these persons has not been adversely affected. Many species of vegetation are far more susceptible to the effects of fluoride than is man, hence an air quality standard to protect vegetation will be far lower than those encountered in the factory, and can be expected to be of the order of 10 ppb or less. The probable daily intake of F at this level of exposure is 0.16 mg, an intake far below that required for the production of clear-cut effects in the human. Thus, air quality standards set to protect vegetation would contribute negligible quantities of F in terms of any possible adverse effect on human health, and would give a wide margin of protection for man.     

Assessment of Arsenic Losses during Ashing: A Comparison of Two Methods Applied to Atmospheric Participates

A comparison was made of over 300 pairs of arsenic results from instrumental neutron activation and flameless atomic absorption analyses of atmospheric particulates collected on glass fiber filters. Atomic absorption analyses involved low temperature ashing of filters at high power levels. No matrix modification chemicals were added to the acid extract which was analyzed. Neutron activation results are on the average 9% higher than those obtained by atomic absorption and the difference is statistically significant. This small difference is probably due to the analytical techniques or acid extraction and not in any important way to losses during low temperature ashing. This conclusion is in sharp contrast to other recently reported situations where low temperature ashing losses in analyzing atmospheric particulate were sizable. Although the atmospheres sampled differed somewhat between these situations the most obvious difference was in the combustibility of the filters used in sampling.     

Extreme Values in TSP Distribution Functions

The highest values in annual TSP distributions fall below the best-fit, log-normal straight line more than one would expect from ordinary sampling statistics but not dramatically so. The lowest values in annual TSP distributions overwhelmingly fall below the best-fit, log-normal straight line. The most highly improbable high values above the best-fit line in such distributions are very questionable and probably do not represent true air quality values. The most improbable cases of highest values falling below the best-fit, log-normal line are the result of data artifacts at the opposite end of the data distribution. They do not represent low probabilities and probably do represent true air quality values. The most improbable low values are all of highly doubtful validity.     

Characterization of Emissions from Vehicles Using Methanol and Methanol-Gasoline Blended Fuels

Exhaust and evaporative emissions were examined from vehicles fueled with methanol or a gasoline-methanol blend. Regulated automobile pollutants, as well as detailed hydrocarbons, methanol, and aldehydes were measured, and exhaust emission trends were obtained for vehicle operation over five different driving cycles. Results indicated that use of the blended fuel does not generally have any significant effect on base-line exhaust emission rates of regulated pollutants; however, emission rates of aldehydes increased during the Federal Test Procedure. Aldehyde emissions from the methanol-fueled car were roughly an order of magnitude higher than those resulting from blended fuel usage. The hydrocarbon composition of evaporative emissions with the blended fuel was similar to that with the base-line fuel except when canister breakthrough occurred. Evaporative emissions during breakthrough were comprised chiefly of N-butane.     

Investigation of Selective Catalytic Reduction Impact on Mercury Speciation under Simulated NOx Emission Control Conditions

Abstract

Selective catalytic reduction (SCR) technology increasingly is being applied for controlling emissions of nitrogen oxides (NO_x) from coal-fired boilers. Some recent field and pilot studies suggest that the operation of SCR could affect the chemical form of mercury (Hg) in coal combustion flue gases. The speciation of Hg is an important factor influencing the control and environmental fate of Hg emissions from coal combustion. The vanadium and titanium oxides, used commonly in the vanadia-titania SCR catalyst for catalytic NO_x reduction, promote the formation of oxidized mercury (Hg²⁺).

The work reported in this paper focuses on the impact of SCR on elemental mercury (Hg⁰) oxidation. Bench-scale experiments were conducted to investigate Hg⁰ oxidation in the presence of simulated coal combustion flue gases and under SCR reaction conditions. Flue gas mixtures with different concentrations of hydrogen chloride (HCl) and sulfur dioxide (SO₂) for simulating the combustion of bituminous coals and subbituminous coals were tested in these experiments. The effects of HCl and SO₂ in the flue gases on Hg⁰ oxidation under SCR reaction conditions were studied. It was observed that HCl is the most critical flue gas component that causes conversion of Hg⁰ to Hg²⁺ under SCR reaction conditions. The importance of HCl for Hg⁰ oxidation found in the present study provides the scientific basis for the apparent coal-type dependence observed for Hg⁰ oxidation occurring across the SCR reactors in the field.     

PFAS profiles in three North Sea top predators: metabolic differences among species?

Profiles of seven compounds of perfluoro-alkyl substances (PFASs) were compared among three species of top predators from the Danish North Sea: the white-beaked dolphin (Lagenorhynchus albirostris), the harbor porpoise (Phocoena phocoena), and the harbor seal (Phoca vitulina). The seals had higher total burdens (757.8 ng g^?1 ww) than the dolphins (439.9 ng g^?1 ww) and the porpoises (355.8 ng g^?1 ww), probably a reflection of feeding closer to the shore and thus contamination sources. The most striking difference among the species was the relative contribution of perfluorooctanesulfonamide (PFOSA) to the profiles; the seals (0.1 %) had much lower levels than porpoises (8.3 %) and dolphins (26.0 %). In combination with the values obtained from the literature, this result indicates that Carnivora species including Pinnipedia have a much higher capacity of transforming PFOSA to perfluorooctane sulfonic acid (PFOS) than cetacean species. Another notable difference among the species was that the two smaller species (seals and porpoises) with supposedly higher metabolic rates had lower concentrations of the perfluorinated carboxylic acids, which are generally more easily excreted than perfluorinated sulfonamides. Species-specific characteristics should be recognized when PFAS contamination in marine mammals is investigated, for example, several previous studies of PFASs in cetaceans have not quantified PFOSA.