The Smogless Automobile

Demands for high performance and reliability of electrostatic precipitators for collection of fly ash from low sulfur fuels has led to rapid escalation of sizes and uncertainties in sizings of cold-side precipitators. This has led to utilization of the so-called “hot-side” precipitator. The underlying concept of hot-side precipitation is the avoidance of the necessity to operate the precipitator under high resistivity conditions. Data on in-situ measurements of resistivity of low sulfur fuel ash, as well as performance parameters of a number of operating installations, will be reviewed. These data will demonstrate the reduced sensitivity of hot-side precipitator sizing to fuel conditions. Other advantages of hot-side precipitators will be discussed.

Operating experience with hot-side precipitators has focused on structural problems which are peculiar to the larger, higher temperature installations. The nature and solution of these problems will be discussed. General comparative economics of hot-side and cold-side precipitators as they relate to fuel properties will be reviewed.     

Principal Plume Dispersion Models: TVA Power Plants

The body of information presented in this paper is directed to those individuals who may be concerned with principal plume dispersion models at coal-burning power plants. About 20 years of comprehensive field surveillance and documentation of dispersion of power plant emissions for a varied range of unit sizes, stack heights, and meteorological conditions have determined the Tennessee Valley Authority’s interpretation of principal plume dispersion models. TVA’s experience indicates that as unit sizes are increased and taller stacks are constructed, the plume dispersion model associated with maximum surface concentrations changes. Maximum surface concentrations for principal plume dispersion models were approximately equal for the early small plants. However, the coning model was considered the critical plume dispersion model because the frequency of recurrence of surface concentrations from this model was appreciably greater than other models.

There were progressive changes because of an increase in unit sizes and stack heights; the magnitude of maximum surface concentrations from the coning model decreased, and the magnitude (relative to the coning model) of concentrations from the inversion breakup model increased. However, with plumes from newer and larger units with higher stacks, the trapping dispersion model became prominent. Finally, by the time unit size had increased to 900 mw and stack height to about 245 meters, as at Bull Run Power Plant, the magnitude of surface concentrations associated with trapping had increased to such a degree that it became the critical dispersion model identified with power plants of this size.     

DETERMINING THE SOURCE OF STREAM CONTAMINATION IN A KARST‐WATER SYSTEM,SOUTHWEST VIRGINIA,USA1

ABSTRACT: Karst terrane provides a linkage between surface water and ground water regimes by means of caves, sinkholes and swallets, and sinking streams, and facilitates the inter‐watershed transfer of water and contaminants through these subsurface systems. The goal of this study was to develop procedures to identify the sources of degradation of a creek situated in a complex karst‐water system. The study approach consisted of using dye tracing technique to determine subsurface flow paths through the karst system, a water‐sampling network to identify and characterize pollution sources within the surface watershed and subsurface flow regime, and evaluation of analytical data for several water quality parameters. The results of this study provide an interesting perspective of water and contaminant movement in karst‐water systems and pinpoint the sources of stream contamination for a case study site in southwest Virginia where two springs supply water to a contaminated freshwater stream.     

NONPOINT SOURCE POLLUTION POTENTIAL IN AN AGRICULTURAL WATERSHED IN NORTHWESTERN PENNSYLVANIA1

ABSTRACT: A 155,947 ha portion of the Shenango River watershed in western Pennsylvania was evaluated as to the potential impact of agriculture drainage on water quality. Approximately a third of the area is being used as either cropland or pasture with approximately an equal percentage in forest lands. Eleven subwatersheds were evaluated as to their potential for nonpoint source pollution according to the criteria established by the Pennsylvania Department of Environmental Resources for the Chesapeake Bay Pollution Abatement Program. The individual components and overall rating for each subwatershed were then evaluated as to their correlation with four water quality variables based on 104 samples collected at 26 sampling stations throughout the watershed. There was a significant correlation between the overall rating factor for each subwatershed and each of the four water quality variables. In general, the watershed delivery factor, animal nutrient factor, and management factors were correlated with fecal coliform and phosphorus in the receiving streams, whereas the ground water delivery factor appeared to be more important in determining nitrate concentrations in these streams. These results indicate that manure and nutrient management, along with the exclusion of livestock from streams and the enhancement and/or replacement of riparian wetlands, are important approaches in reducing agricultural impacts in fresh water ecosystems.     

Role of iron chemistry in controlling the release of pollutants from resuspended sediments

Aquatic sediments often contain a large number of chemical contaminants that are potential pollutants. It is often presumed that such contaminants are released to the water column during sediment resuspension and, in there, adversely impact aquatic life and other beneficial uses of the water. However, extensive laboratory and field studies of about 100 contaminated sediments from across the United States that specifically addressed this type of release showed that of about 30 common heavy metals, organic compounds, and other potential pollutants, only manganese II and ammonia were released to then remain in the water column after sediment resuspension. These results indicated that the chemistry of aqueous iron controls the availability of many contaminants in resuspended sediment. The formation of ferric hydroxide during sediment suspension into the water column, as a result of the reaction between ferrous iron in the sediments and dissolved oxygen in the water column, leads to rapid scavenging of many contaminants in the Fe(OH)₃ precipitate. The scavenged contaminants are redeposited in the sediments. This article reviews the role of the aqueous chemistry of iron as it relates to controlling the release of potential pollutants from resuspended sediments. © 2005 Wiley Periodicals, Inc.     

An Optical Transistorized Ignition System

Annually about 100 million automobiles suck in vast quantities of air and eject it in a contaminated state. When, pollutants are measured by weight,¹ it seems that the automobile is the nation’s worst polluter. The EPA estimates that in 1969 motor vehicles accounted for 98 million tons of CO, 8.7 million tons of NO_x and more than 17 million tons of HC.     

Trap mortality in mark-recapture studies

When animals die in traps in a mark-recapture study, straightforward likelihood inferences are possible in a class of models. The class includes M₀, M_t, and M_b as reported by White et al. (Los Alamos National Laboratory, LA-8787-NERP, pp 235, 1982), those that do not involve heterogeneity. We include three Markov chain “persistence” models and show that they provide good fits in a trapping study of deer mice in the Cascade-Siskiyou National Monument of Southern Oregon where trapping mortality was high.

Allowable levels of take for the trade in Nearctic songbirds

The take of Nearctic songbirds for the caged-bird trade is an important cultural and economic activity in Mexico, but its sustainability has been questioned. We relied on the theta-logistic population model to explore options for setting allowable levels of take for 11 species of passerines that were subject to legal take in Mexico in 2010. Because estimates of population size necessary for making-periodic adjustments to levels of take are not routinely available, we examined the conditions under which a constant level of take might contribute to population depletion (i.e., a population below its level of maximum net productivity). The chance of depleting a population is highest when levels of take are based on population sizes that happen to be much lower or higher than the level of maximum net productivity, when environmental variation is relatively high and serially correlated, and when the interval between estimation of population size is relatively long (> or = 5 years). To estimate demographic rates of songbirds involved in the Mexican trade we relied on published information and allometric relationships to develop probability distributions for key rates, and then sampled from those distributions to characterize the uncertainty in potential levels of take. Estimates of the intrinsic rate of growth (r) were highly variable, but median estimates were consistent with those expected for relatively short-lived, highly fecund species. Allowing for the possibility of nonlinear density dependence generally resulted in allowable levels of take that were lower than would have been the case under an assumption of linearity. Levels of take authorized by the Mexican government in 2010 for the 11 species we examined were small in comparison to relatively conservative allowable levels of take (i.e., those intended to achieve 50% of maximum sustainable yield). However, the actual levels of take in Mexico are unknown and almost certainly exceed the authorized take. Also, the take of Nearctic songbirds in other Latin American and Caribbean countries ultimately must be considered in assessing population-level impacts.