Waste polyvinylchloride derived pitch as a precursor to develop carbon fibers and activated carbon fibers

Polyvinylchloride (PVC) was successfully recycled through the solvent extraction from waste pipe with an extraction yield of ca. 86%. The extracted PVC was pyrolyzed by a two-stage process (260 and 410 degrees C) to obtain free-chlorine PVC based pitch through an effective removal of chlorine from PVC during the heat-treatment. As-prepared pitch (softening point: 220 degrees C) was spun, stabilized, carbonized into carbon fibers (CFs), and further activated into activated carbon fibers (ACFs) in a flow of CO2. As-prepared CFs show comparable mechanical properties to commercial CFs, whose maximum tensile strength and modulus are 862 MPa and 62 GPa, respectively. The resultant ACFs exhibit a high surface area of 1200 m2/g, narrow pore size distribution and a low oxygen content of 3%. The study provides an effective insight to recycle PVC from waste PVC and develop a carbon precursor for high performance carbon materials such as CFs and ACFs.     

Leachate recirculation effects on waste degradation: study on columns

The purpose of this study is to determine the impact of leachate recirculation on the degradation of municipal solid wastes (bioreactor concept). The study was carried out using columns containing approximately 50 kg of waste, in order to follow waste degradation over a limited time. Three types of waste were studied: fresh waste of standard composition, fresh waste of fermentable composition and some 8-yr-old waste extracted from a site in France. Measurement of the global parameters, such as chemical oxygen demand (COD), volatile acidity, alkalinity, leachate conductivity, methane potential of the wastes and biogas production monitoring (volume of CO2 and CH4 produced), were carried out. The quantity of oxydizable matter and biogas production was increased by the leachate recirculation, and the duration of the first degradation phases was reduced in all cases. Chloride, ammonium and organic pollution accumulation was observed according to the duration of recirculation. After 400 days of degradation, waste stabilization seemed to be reached for all of the recirculated columns (COD<300 mg/L O2, and methane potential reached).     

Diel cycles of arsenic speciation due to photooxidation in acid mine drainage from the Iberian Pyrite Belt (Sw Spain)

Twenty four hours diel cycles of arsenic speciation in Acid Mine Drainage (AMD) due to photooxidation have been reported for the first time. AMD samples were taken during 48 h (31st March and 1st April, 2005) at 6 h intervals from the effluent of a massive abandoned polymetallic sulphide mine of the Iberian Pyrite Belt (Sw Spain). Samples were preserved in situ using cationic exchange prior to analysis by coupled high performance liquid chromatography, hydride generation and atomic fluorescence spectrometry (HPLC-HG-AFS) for arsenic speciation. The results indicated the presence of inorganic arsenic species with daily means of 262mugl(-1) for As(V) and 107 microg l(-1) for As(III). No marked diel trend was observed for As(V). However, a marked diel trend was observed for As(III) in the two studied days, with maximum concentrations during nighttime (141-143 microg l(-1)) and minimum concentrations at daytime (72-77 microg l(-1)). This difference in concentration during daytime and nighttime is ca. 100%. A similar diel cycle was observed for iron. An explanation for the arsenic diel cycles observed is the light induced photooxidation of As(III) and the elimination of As(V) due to its adsorption onto Fe precipitates during the daytime. Furthermore, the diel changes in arsenic speciation emphasize the importance of designing suitable sampling strategies in AMD systems.     

Chloramphenicol influence on antioxidant enzymes with preliminary approach on microsomal CYP1A immunopositive-protein in Chamelea gallina

Chloramphenicol (CA) is a largely used antibiotic and it is an inhibitor of protein synthesis that also induces ROS production. In this work there were investigated activities and expressions in the Adriatic bivalve Chamelea gallina of some antioxidant and detoxification proteins like superoxide dismutase (Mn-SOD, Cu/Zn-SOD), catalase (CAT) and Cytochrome P450 (CYP1A). Clams exposed to 5mgl(-1) of chloramphenicol were sampled 2, 4 and 8 days after treatment (CA2, CA4 and CA8). SODs, CAT, and CYP1A activity and/or expression were detected in pooled digestive glands by Western blotting and by spectrophotometrical analysis. Enzymes activities increase during the entire antibiotic exposure. With respect to the control Cu/Zn-SOD expression increases, while Mn-SOD expression decreases significantly after 4 days. Two CYP1A immunopositive-proteins (57.7 and 59.8kDa) were detected. The lower band significantly decreases in CA8, the upper one also in CA4 condition. High levels of Mn-SOD, CAT activity and Cu/Zn-SOD expression, indicate intense ROS production while Mn-SOD expression inhibition might be ascribable to mitochondrial alterations due to CA and indirectly to ROS. CYP1A1 action determines H(2)O(2) production that would contribute to a CYP1A1 gene promoter down regulation, a response to oxidative stress with the antioxidant enzymes activation as a final result. This study highlights the close association, in C. gallina, in presence of chloramphenicol, between SOD/CAT and CYP system, and it appear particularly interesting to the lack of similar researches on mollusc species.     

Modular Design of Field Lysimeters for Specific Application Needs

In Europe, the use of direct methods using lysimeters for measuring water and solute flow in soils increased in recent years. Large weighable lysimeters are best suitable for obtaining reliable data about seepage water quantity and quality. Field lysimeters – lysimeters built in directly in agriculturally used areas – of high technical standard allow a precise determination of the influence of different cropping systems on groundwater quality. They combine the advantages of true field conditions and laboratory possibilities of varying parameters, handling and maintenance. Due to the specific needs of each application the instrumentation varies. Based on general remarks on the advantages of precise weighing lysimeters four standardized lysimeter configurations are presented. Beside the specific needs of design and setup of lysimeter stations, there is need to define general requirements to enable comparable results based on standardized basic design and to reduce individual mistakes.     

Three-Dimensional Modelling of Concentration Fluctuations in Complicated Geometry

The strong fluctuating component in the measured concentration time series of a dispersing gaseous pollutant in the atmospheric boundary layer, and the hazard level associated to short-term concentration levels, demonstrate the necessity of calculating the magnitude of turbulent fluctuations of concentration using computational simulation models. Moreover the computation of concentration fluctuations in cases of dispersion in realistic situations, such as built-up areas or street canyons, is of special practical interest for hazard assessment purposes. In this paper, the formulation and evaluation of a model for concentration fluctuations, based on a transport equation, are presented. The model is applicable in cases of complex geometry. It is included in the framework of a computational code, developed for simulating the dispersion of buoyant pollutants over complex geometries. The experimental data used for the model evaluation concerned the dispersion of a passive gas in a street canyon between 4 identical rectangular buildings performed in a wind tunnel. The experimental concentration fluctuations data have been derived from measured high frequency concentrations. The concentration fluctuations model is evaluated by comparing the model's predictions with the observations in the form of scatter plots, quantile-quantile plots, contour plots and statistical indices as the fractional bias, the geometrical mean variance and the factor-of-two percentage. From the above comparisons it is concluded that the overall model performance in the present complex geometry case is satisfactory. The discrepancies between model predictions and observations are attributed to inaccuracies in prescribing the actual wind tunnel boundary conditions to the computational code.     

Identifying the largest individual sample value from a two-way composite sampling design

Composite sampling techniques for identifying the largest individual sample value seem to be cost effective when the composite samples are internally homogeneous. However, since it is not always possible to form homogeneous composite samples, these methods can lead to higher costs than expected. In this paper we propose a two-way composite sampling design as a way to improve on the cost effectiveness of the methods available to identify the largest individual sample value.     

Biomonitoring zur wirkungsbezogenen Ermittlung der Schadstoffbelastung in terrestrischen Ökosystemen

Biomonitoring programmes provide relevant information, which may supplement ambient air pollution monitoring or modelling around emission sources. As a prerequisite, assessment scales for biomonitoring data have to be derived based on an objective evaluation of available data, as well as on a scheme of presentation, which is suggestive and easily understandable even for laymen. Based on an evaluation of numerous monitoring programmes, assessment scales for biomonitoring results are derived for plant biomonitoring, which also serve as a basis for the graphical presentation of monitoring results. This study is focussed on bioindicator plants like mosses (passive biomonitoring) and exposed lichens (active biomonitoring), in which 14 metal elements are investigated. As an example, data from a local biomonitoring network around a cement plant were used to demonstrate the use of the assessment scales derived and the presentation scheme developed. Data sets from about 15 moss and 24 lichen biomonitoring programmes, comprising more than 1000 specimens, were sorted by their pollutant characteristics in order to form the database. Data on the metal contents of species demonstrating similar values with respect to growth characteristics and habit, and representing background or low pollution levels, are aggregated and their statistical distributions are evaluated. Spacing of the assessment scales and their colour designations are derived from the 50-, 75-, 90- and 95-percentile values. Graphical presentation allows a comparison of the absolute values of metal contents and a relative association of measured values. Exemplary results from moss and lichen monitoring around a cement plant are generally below or slightly above the median values at background and low-pollution sites. Metal contents are higher in lichens compared to mosses for 7 elements (Cd, Cu, Hg, Pb, Sb, Sn, Zn), and are lower in lichens only for thallium. The assessment scheme presented is mainly aimed at the practitioner in the field of biomonitoring in order to provide a reliable and sound scale of assessment by comparison on an absolute scale rather than presenting the basis of ecological risk assessment. Differences in metal content of co-located samples of various moss species and possible correction procedures are briefly discussed- as well as the consequences of pooling monitoring data across various moss species for the quality of assessment scales. Further evaluations shall focus on species-specific rather than on pooled databases and will investigate the consequences of the use of correction factors when extrapolating metal data from one monitoring species to another.     

Molecular response of the sponge Suberites domuncula to bacterial infection

The aim of this study was the documentation of the molecular immune response of Suberites domuncula upon bacterial infection. Additionally, the bacteria that are naturally present in the sponge after prolonged aquarium maintenance were characterized. After 6 months of maintenance of S. domuncula in seawater aquaria, only one bacterial 16S rDNA sequence could be recovered, which belongs to the genus Pseudomonas. Concomitantly, morphologically uniform bacteria were found encapsulated in bacteriocytes. These findings indicate that certain bacteria, possibly of the genus Pseudomonas, are able to persist for long periods in host bacteriocytes. Subsequent to performing a previously established infection assay with S. domuncula, a potentially pathogenic Vibrio sp. was isolated from the tissues. Furthermore, the host tissue disintegrated and asexual propagation bodies (gemmules) were formed. In order to gain insights into the molecular events occurring after bacterial infection, the stress-response kinases, p38 protein kinase and JNK protein kinase, were analyzed. It is demonstrated that these two kinases are activated (phosphorylated) upon incubation of the tissue with the bacterial endotoxin lipopolysaccharide (LPS). Moreover, LPS strongly inhibits protein synthesis. It is concluded that there are many functionally different interactions between S. domuncula and bacteria and that the animal possesses mechanisms to differentiate between bacteria and to respond accordingly.     

Phylogenetic relationships within the Octocorallia (Cnidaria: Anthozoa) based on nuclear 18S rRNA sequences

We determined the nuclear 18S rRNA sequences for 41 species of octocorals and used these to address the validity of the historical ordinal divisions and the current subordinal divisions within the subclass Octocorallia. We also explored the phylogenetic affinities of the species Dendrobrachia paucispina, which was originally classified in the order Antipatharia (subclass Ceriantipatharia) although polyp structure indicates it belongs in the subclass Octocorallia. Trees constructed using maximum likelihood techniques are incongruent with the current and historical taxonomy of the Octocorallia. There appeared to be three major clades of octocorals. The first clade included most, but not all, pennatulaceans as a monophyletic group. The second clade contained 21 species, representing all major octocoral groups other than pennatulaceans. The third clade contained members from three suborders of the Alcyonacea and one member of the Pennatulacea. These data could not be used to distinguish the branching order of the three major clades. The species D. paucispina had a close affinity with the genera Corallium and Paragorgia (Alcyonacea: Scleraxonia), although its morphology suggests it is more similar to the genus Chrysogorgia (Alcyonacea: Calcaxonia). The morphological character of dimorphism (the presence of both autozooids and siphonozooids within a single colony) corresponded loosely with the topology of the most likely trees, and a single origin of dimorphism could not be rejected. Despite sampling from the majority of families within the Octocorallia, many of the relationships within this group remain ambiguous. Received: 16 June 2000 / Accepted: 14 September 2000