利用卷枝毛霉成球特性高效收获微藻

利用卷枝毛霉孢子悬液与小球藻共培养,用过滤含藻菌球的方式来收获微藻.以人工配水为培养基,收获效率为指标,通过单因子试验和正交试验得到最佳收获条件为:pH=6.0,葡萄糖质量浓度为1.25 g·L~(-1),菌藻比为1∶250,收获效率为91.08%.对培养前后培养液中多糖质量浓度进行测定,发现小球藻在培养48 h后多糖质量浓度较培养前增加了约0.047g·L~(-1),而菌藻共培养后的混合液中多糖质量浓度为0.019 g·L~(-1).由此可知在菌藻共培养过程中,小球藻会向外分泌某些水溶性多糖物质供卷枝毛霉利用,二者有一定的共生作用.对小球藻和卷枝毛霉细胞表面Zeta电位进行测量发现,小球藻细胞表面的Zeta电位值随着藻液pH值变化波动不大;而卷枝毛霉细胞表面的Zeta电位值,随着pH值的变小,电位值可由原先最低的-37.7 m V升至-9.87 m V.由此推定菌藻相互吸附的主要机制为电中和吸附.     

黄孢原毛平革菌处理染料废水过程中细胞结构损伤效应研究

利用透射电子显微镜观察分析白腐真菌(黄孢原毛平革菌)在处理染料废水活性艳红X-3B过程中,染料和盐度对黄孢原毛平革菌的细胞结构产生的毒性作用.结果表明:活性艳红X-3B染料对黄孢原毛平革菌产生生物毒性作用,且随着染料浓度的增加,细胞受损伤程度不断加深.加入100 mg/L的染料活性艳红X-3B后,黄孢原毛平革菌菌丝细胞形态发生变化,出现质壁分离现象;染料浓度进一步加大,菌丝细胞超微结构受到损伤逐渐严重.染料废水中的盐度对黄孢原毛平革菌细胞也会造成损伤,且损伤程度随盐度增大而增大.NaCl浓度为3 g/L时,菌丝细胞发生质壁分离;而当NaCl加入量高于8 g/L时,细胞膜受损,线粒体、细胞核呈现空泡化,表现为受到不可逆的损伤.染料和盐双因子对黄孢原毛平革菌细胞的损伤效应表现为其损伤程度与单因子作用一致,且染料的影响作用占主导.     

Seasonal and spatial occurrence and distribution of atmospheric polycyclic aromatic hydrocarbons (PAHs) in rural and urban areas of the North Chinese Plain

Passive air sampling (PAS) was employed to study the occurrence of gaseous and particle-bound PAHs in the North Chinese Plain. The averaged concentrations of gaseous and particle-bound PAHs were 485 ± 209 ng/m³ and 267 ± 161 ng/m³, respectively. The PAHs concentrations at urban sites were generally higher than those at rural ones with ratios <1.5 in spring, summer and fall, but differences between them were not significant for the wintertime and annually averaged concentrations. This urban-rural distribution pattern was related to the PAHs emission sources. PAHs spatial variation can be partially (49%) explained by emission with a simple linear regression method. Both the gaseous and particle-bound PAHs were highest in winter and lowest in summer, with winter/summer ratios of 1.8 and 8, respectively. Emission strength was the most important factor for the seasonality.     

Non-aromatic hydrocarbons in surface sediments near the Pearl River estuary in the South China Sea

Surface sediment samples at 4 sites along an offshore transect from outer continental shelf off the Pearl River estuary to the shelf slope region of the northern South China Sea, have been analyzed for total organic carbon (TOC), total nitrogen (TN), solvent extractable organic matter (EOM) and non-aromatic hydrocarbons. TOC, TN and EOM show distinct spatial variations. Their highest values are all recorded at the shelf slope region. EOM varies from 18.70-38.58 microgg(-1) dry sediment and accounts for 0.20-0.72% of the TOC contents. The non-aromatic hydrocarbons are an important fraction of EOM. Their contents range from 3.43-7.06 microgg(-1) dry sediment. n-Alkanes with carbon number ranging from 15-38 are identified. They derive from both biogenic and petrogenic sources in different proportions. Results of isoprenoid hydrocarbons, hopanes and steranes also suggest possible petroleum contamination.     

西部地区加快开发应当克服“资源近视症”

本文从分析我国传统的经济增长方式入手,通过对资源近视症”的表现及后果的分析,提出西部西地区,特别是西部少数民族地区只有树立全面的资源观,立足优势,面向市场,抓住机遇,合理开发资源和利用资源,才能走出一条符合本民族,本地区实际的可持续发展之路。     

Effects of Compounded Curing Agents on Properties and Performance of Urea Formaldehyde Resin

The effects of three compounded curing agents on the properties and performance of the urea-formaldehyde (UF) resin were investigated in this study. The compounded curing agents were prepared by mixing ammonium chloride with hexamethylenetetramine, citric acid, and oxalic acid respectively at a ratio of 1:1, named N-H, N–CA, and N–OA, respectively. The curing process, crystallinity, and physical properties were measured, and the three-ply plywood was fabricated to measure its prepress strength, wet shear strength, and formaldehyde emission. Results showed that the compounded curing agents N–CA and N–OA enhanced the initial viscosity, crosslinking density and thermal stability of UF resin. Additionally, the prepress strength of the plywood bonded by UF resin with N–CA and N–OA increased by 82 and 111% respectively compared to the UF resin with NH₄Cl, and the wet shear strength increased by 14 and 16%, the formaldehyde emission decreased by 19 and 42% respectively. However, owing to the short pot-life of these curing agent limited their storage time, the curing agents N–CA and N–OA should be applied to fabricate plywood in winter for obtaining a better bond strength and a lower formaldehyde emission. While the UF resin with N–HT showed a suitable pot-life, so it could be applied to fabricate plywood in summer for long time storage and avoiding procuring problem.     

Linking landscape development intensity within watersheds to methyl-mercury accumulation in river sediments

An indicator of the disturbance of natural systems, the landscape development intensity (LDI) index, was used to assess the potential for land-use within watersheds to influence the production/accumulation of methyl-mercury (MeHg) in river sediments. Sediment samples were collected from locations impacted by well-identified land-use types within the Mobile-Alabama River Basin in Southeastern USA. The samples were analyzed for total-Hg (THg) and MeHg concentrations and the obtained values correlated to the calculated LDI indexes of the sampled watersheds to assess the impact of prevalent land use/land cover on MeHg accumulation in sediments. The results show that unlike THg, levels of MeHg found in sediments are impacted by the LDI indexes. Overall, certain combinations of land-use types within a given watershed appear to be more conducive to MeHg accumulation than others, therefore, pointing to the possibility of targeting land-use practices as potential means for reducing MeHg accumulation in sediments, and ultimately, fish contamination.     

Increasing the recovery of heavy metal ions using two microbial fuel cells operating in parallel with no power output

The present study aimed to improve the performance of microbial fuel cells (MFCs) by using an intermittent connection period without power output. Connecting two MFCs in parallel improved the voltage output of both MFCs until the voltage stabilized. Electric energy was accumulated in two MFCs containing heavy metal ions copper, zinc, and cadmium as electron acceptors by connection in parallel for several hours. The system was then switched to discharge mode with single MFCs with a 1000-Ω resistor connected between anode and cathode. This method successfully achieved highly efficient removal of heavy metal ions. Even when the anolyte was run in sequencing batch mode, the insufficient voltage and power needed to recover heavy metals from the cathode of MFCs can be complemented by the developed method. The average removal ratio of heavy metal ions in sequencing batch mode was 67 % after 10 h. When the discharge time was 20 h, the removal ratios of zinc, copper, and cadmium were 91.5, 86.7, and 83.57 %, respectively; the average removal ratio of these ions after 20 h was only 52.1 % for the control group. Therefore, the average removal efficiency of heavy metal ions increased by 1.75 times using the electrons stored from the bacteria under the open-circuit conditions in parallel mode. Electrochemical impedance data showed that the anode had lower solution resistance and polarization resistance in the parallel stage than as a single MFC, and capacitance increased with the length of time in parallel.