Studies on the Effects of Saline Aerosols of Cooling Tower Origin on Plants

A research program was undertaken to develop information that could be used to estimate the risk of adverse effects of saline cooling tower drift on native and cultivated flora in the Indian Point, New York area. Eleven species of woody plants were exposed at 85 % relative humidity to a saline mist with 95% of the particles between 50 and 150 nm in diameter. Three biological factors—stage of development, species, and phenotype—determined the susceptibility of plants to saline aerosols when the occurrence of any lesion on the foliage was used as a measure of response. The effects of stage of development on the incidence and severity of foliar lesions depended upon the kind of plant. In deciduous woody species, the youngest leaves were most susceptible, but in conifers, the year-old needles were most susceptible. Canadian hemlock was the most susceptible species and witch hazel was the least susceptible. Median effective doses for these two species, although undetermined, could be more than 100-fold different (less than 2.4, the lowest used, and greater than 264 ng CI cm^-2, respectively). Other species, ranked in decreasing order of susceptibility were: white ash, white flowering dogwood, forsythia, chestnut oak, silk tree, black locust, red maple, eastern white pine, and golden rain free. Phenofypic variation within a species was not so great—within a 10 to 20-fold increase in dose the incidence of injury went from 0 to 100%. Exposures with bush bean showed that the relative humidity (RH) during or after the exposure period affected the incidence of saline induced foliar injury. A change from 50 to 85% RH doubled the effectiveness of the saline mist. It was also found that compared to particles between 50 and 150 jum in diameter, an increase in the fraction of particles above 150 /xm increased the toxicity of the mist.     

Prevention Of Significant Deterioration A Critical Review

Prevention of significant deterioration has been a subject of study and discussion for about ten years. An extensive survey of the legislative and legal aspects of this concept is presented in this review. The growth of the concept and its implementation are subjected to critical scrutiny.     

Needed: A National R&D Effort To Develop Individual Air Pollution Monitor Instrumentation

The results from the regional air quality analysis for the Four Corners Study are discussed in this paper. This study was one of five regional studies conducted for the National Commission on Air Quality. Potential regional air quality impacts were evaluated through the year 1995 for alternative energy scenarios under current and alternative regulatory policies. The alternative regulatory policies include emission fees, technology standards, emission ceilings, and prevention of significant deterioration class elimination. The alternatives were compared in terms of their impacts on regional visibility and on the ambient concentrations of SO₂, SO₄, and primary fine particulates. The fate of the pollutants was estimated. The alternative regulatory policies were quite different with respect to their control of SO_X emissions and their impacts on regional visibility. Sources located outside of the study region were estimated to have a major impact on regional air quality within the study region.     

Transmissometer Measurement of Participate Emissions from a Jet Engine Test Facility

The body of information presented in this paper is directed toward those individuals involved with handling hazardous materials, whether in actual use of such chemicals, or in monitoring atmospheric emissions. Although specifically relating experience in the design and testing of phosgene emission control equipment, it attempts to establish general guidelines for effectively dealing with emissions of hazardous materials. An approach for handling chemical pollutants having no established air quality emission standards is developed. The paper presents a technique for establishing process emissions at acceptably low levels to insure the health and safety of the general population as well as that of the process workers themselves. Methods, suitable for measuring phosgene at these low levels, have been investigated, and problems associated with such an investigation are discussed. While complete theoretical scrubber design criteria are beyond the scope of this paper, many of the "real world" problems which affected scrubber performance are presented. Finally, the practical aspects of process emissions control are illustrated by actual results from the system test.     

An Ozone Event in Indianapolis

There are doubts concerning the sources of the pollutant ozone in an urban location. Current control regulations,¹ for example, are based on local sources. Many studies suggest that plumes of pollutants released by upwind areas are the cause. For example, New York City has been associated with high O₃ in New England,² Chicago with O₃ in Milwaukee,³ and St. Louis with O₃ in rural Illinois.⁴ Others^5,6 have suggested the problem must be treated on a synoptic scale. In an effort to understand the problem at Indianapolis better, a series of experiments involving aircraft flights were conducted in the Indianapolis area and their results are herein reported. Specifically, a cross country flight of over 100 mi both to the northeast and southwest of Indianapolis, a vertical spiral to 28,000 ft, low level data associated with takeoff and landing of the aircraft, and ground data at four sites, are available for the afternoon of June 9,1976.     

Sulfate and Nitrate in Total Suspended Participate in Ontario

In order to make the information in the Federal Register more easily accessible, a summary has been prepared of Federal standards of performance for new stationary sources of air pollution. The standards of performance promulgated by the Environmental Protection Agency in the period from December 1971 through June 1979 are presented in tabular form.     

Desulfurization of Flue Gases in A Fluidized Bed of Modified Limestone

This publication concerns the dry removal of SO₂ from gases using limestone absorbents. It reports bench-scale experiments made with commercial samples of powdered limestone (CaCO₃) activated by addition of a cheap substance, namely CaCl₂. The absorption was carried out in a fluidized bed traversed by the flue gases, between 600° and 900° C. The degree and rate of transformation of CaCO₃ to CaSO₄ in the presence of SO₂ and air have been compared for unmodified and modified absorbents. Initial rates of reaction, and the variation of the rate of absorption with time have been measured. The influence of the SO₂ content of the gas has been assessed. At 700° C, the maximum degree of transformation of activated limestone to sulfate exceeds 90%, whereas untreated CaCO₃ transforms only to 16–20%. At the same temperature, more than 90% of SO₂ contained In a gas carrying 0.35% SO₂ is removed. Because of the much smaller quantity of solid absorbent required, dry absorption processes based on the modified absorbents might get renewed interest. The modified absorbents might also be used for in situ absorption in fluidized bed combustion, in which the temperatures are in the range studied in the present paper.     

Canada’s Mobile Sources Air Pollution Control Program

The chemical and optical properties of particle emissions from onroad vehicles were investigated at the Allegheny Tunnel on the Pennsylvania Turnpike during July 1981. The optical results are in agreement with earlier data: (1) in terms of light extinction per km driven, diesel particle emissions are at least an order of magnitude more important than particle emissions from spark-ignition vehicles; (2) for diesel particle emissions, light absorption is about twice as efficient as light scattering. Chemical analyses showed that: (1) 24% of the vehicle aerosol was extractable material, (2) 75% of the total mass was carbon, (3) 55% of the total mass was unextractable (elemental) carbon, and (4) the stoichiometry of the extractable fraction of the diesel particle emissions was C_nH_t.7nN_0.05n , i.e., the extractable material was composed predominantly of alkanes. The results of the chemical analyses allow the calculation of the massspecific light absorption coefficient for the elemental carbon component of the diesel particle emissions, i.e., 10.9 ± 1.8 m²/g (500 nm).     

The Inadequacy of PSD Increments to Protect Visibility in Class I Areas

This study includes an application of the first two phases of a new three-phased decision-making structure that was developed to overcome the problems related to ecological safety and social justice in site selection applications. It was conducted on a current site selection problem related to the municipal solid waste disposal facilities in Kocaeli, the most industrialized region of Turkey. In order to assess the deficiencies of the legal site selection procedures related to ecological safety, two different decision tree modes were applied separately. The first mode (“Legislation”) concerns the current buffer zone applications given in the regulations, while the second one (“Proposed”) includes the applications of the new decision-making structure proposed in this study. Since it was assumed that the subjective tendencies of the decision makers on the weightings would have a significant effect on the final decision, these two modes were assessed by employing two different weighting models. The results were obtained from all of the scenarios related to selection of suitable sites with three different area requirements (15, 250, and 500 acres) for the solid wastes generated in the Kocaeli region. The results showed that the possible changes in the decision structure could cause significant differences in the final decision related to selection of the most suitable sites. The most highest and lowest differences were at the “Legislation” mode for 15 acres and 500 acres, respectively. Furthermore, the results obtained in the study showed that the possible differentiations in the criteria weightings could also cause significant differences in the suitability ranking. Therefore, to get a reliable final decision, a statistical assessment of these differentiations should be made.

Implications: The results showed that the possible changes in the decision structure could cause significant differences in the final decision related to selection of the most suitable sites. Furthermore, the results obtained in the study showed that the possible differentiations in the criteria weightings could also cause significant differences in the suitability ranking. Therefore, to get a reliable final decision, a statistical assessment of these differentiations should be made.