Disruption of zebrafish (Danio rerio) reproduction upon chronic exposure to TiO₂ nanoparticles

As common engineered nanomaterials, TiO(2) nanoparticles (nTiO(2)) are usually perceived as non-toxic, and have already been widely used in many products and applications. Such a perception might have been shaped by some short-term studies that revealed no/low toxicity of nTiO(2) to cells and eco-relevant organisms. However, given the ultimate release of nTiO(2) into the aquatic environment, which can act as a sink for engineered nanoparticles, their long-term impact on the environment and human health is still a concern and deserves more research efforts. Here, for the first time, we demonstrate that chronic exposure of zebrafish to 0.1 mg L(-1) nTiO(2), can significantly impair zebrafish reproduction. For instance, there was a 29.5% reduction in the cumulative number of zebrafish eggs after 13 weeks of nTiO(2) exposure. Thus, we provided timely information on indicating a serious risk of reproductive impairment of environments contaminated with low levels of nTiO(2) on aquatic organisms, leading to alterations in population dynamics and aquatic ecosystem balance, and thus warrants a careful scrutiny on toxicity assessment of nTiO(2), especially their long-term impact.     

History of mercury use and environmental contamination at the Oak Ridge Y-12 Plant

Between 1950 and 1963 approximately 11 million kilograms of mercury (Hg) were used at the Oak Ridge Y-12 National Security Complex (Y-12 NSC) for lithium isotope separation processes. About 3% of the Hg was lost to the air, soil and rock under facilities, and East Fork Poplar Creek (EFPC) which originates in the plant site. Smaller amounts of Hg were used at other Oak Ridge facilities with similar results. Although the primary Hg discharges from Y-12 NSC stopped in 1963, small amounts of Hg continue to be released into the creek from point sources and diffuse contaminated soil and groundwater sources within Y-12 NSC. Mercury concentration in EFPC has decreased 85% from ∼2000 ng/L in the 1980s. In general, methylmercury concentrations in water and in fish have not declined in response to improvements in water quality and exhibit trends of increasing concentration in some cases.     

Ascorbic acid, β-carotene, sugars, phenols, and heavy metals in sweet potatoes grown in soil fertilized with municipal sewage sludge

Municipal sewage sludge (MSS) used for land farming typically contains heavy metals that might impact crop quality and human health. A completely randomized experimental design with three treatments (six replicates each) was used to monitor the impact of mixing native soil with MSS or yard waste (YW) mixed with MSS (YW +MSS) on: i) sweet potato yield and quality; ii) concentration of seven heavy metals (Cd, Cr, Mo, Cu, Zn, Pb, and Ni) in sweet potato plant parts (edible roots, leaves, stem, and feeder roots); and iii) concentrations of ascorbic acid, total phenols, free sugars, and β-carotene in sweet potato edible roots at harvest. Soil samples were collected and analyzed for total and extractable metals using two extraction procedures, concentrated nitric acid (to extract total metals from soil) as well as CaCl? solution (to extract soluble metals in soil that are available to plants), respectively. Elemental analyses were performed using inductively coupled plasma mass spectrometry (ICP-MS). Overall, plant available metals were greater in soils amended with MSS compared to control plots. Concentration of Pb was greater in YW than MSS amendments. Total concentrations of Pb, Ni, and Cr were greater in plants grown in MSS+YW treatments compared to control plants. MSS+YW treatments increased sweet potato yield, ascorbic acid, soluble sugars, and phenols in edible roots by 53, 28, 27, and 48%, respectively compared to plants grown in native soil. B-carotene concentration (157.5 μg g?1 fresh weight) was greater in the roots of plants grown in MSS compared to roots of plants grown in MSS+YW treatments (99.9 μg g?1 fresh weight). Concentration of heavy metals in MSS-amended soil and in sweet potato roots were below their respective permissible limits.     

The development of soil organic matter in restored biodiverse Jarrah forests of South-Western Australia as determined by ASE and GCMS

Background, aim and scope  

Soil organic matter (SOM) is known to increase with time as landscapes recover after a major disturbance; however, little is known about the evolution of the chemistry of SOM in reconstructed ecosystems. In this study, we assessed the development of SOM chemistry in a chronosequence (space for time substitution) of restored Jarrah forest sites in Western Australia.     

Dry and wet heat transfer through clothing dependent on the clothing properties under cold conditions.

The purpose of this study was to investigate the effect of moisture on the heat transfer through clothing in relation to the water vapour resistance, type of underwear, location of the moisture and climate. This forms part of the work performed for work package 2 of the European Union THERMPROTECT project. Thermal manikin results of dry and wet heat loss are presented from different laboratories for a range of 2-layer clothing with similar dry insulations but different water vapour permeabilities and absorptive properties. The results obtained from the different manikins are generally consistent with each other. For each climate, total wet heat loss is predominately dependent on the permeability of the outer layer. At 10 degrees C, the apparent evaporative heat loss is markedly higher than expected from evaporation alone (measured at 34 degrees C), which is attributed to condensation within the clothing and to increased conductivity of the wet clothing layers.     

Phosphorus release from a biosolids-amended sandy spodosol

Most regulations governing biosolids land application do not consider that phosphorus (P) solubility can vary widely among biosolids. Current regulations typically group all biosolids together in one category or group biosolids together with manures. Research has shown that not all biosolids have the same potential to affect the environment when land applied, but the database is limited. The purpose of this study was to characterize P release from several biosolids produced and/or marketed in Florida. A small soil column dynamic laboratory incubation was conducted to assess P release potential. Eleven biosolids and a mineral fertilizer (triple super phosphate) were individually mixed with a typical low-P sorbing Florida soil (Immokalee fine sand) at 56 and 224 kg P ha(-1). Columns were periodically leached over 5.5 mo to attain 60 mL (1/2 pore volume) of drainage in each leaching. Soluble reactive P was determined and summed over the eight leachings to represent total P source release. Cumulative P release (as a percentage of P applied) was greatest from biological P removal (BPR) and BPR-like biosolids and least from heat-dried materials. Phosphorus release from biosolids depends on biosolids treatment type (digestion) and P chemistry, suggesting that biosolids regulations must account for differences in P lability to accurately gauge environmental risk.     

Investigation of polar organic chemical integrative sampler (POCIS) flow rate dependence for munition constituents in underwater environments

Munition constituents (MC) are present in aquatic environments throughout the world. Potential for fluctuating release with low residence times may cause concentrations of MC to vary widely over time at contaminated sites. Recently, polar organic chemical integrative samplers (POCIS) have been demonstrated to be valuable tools for the environmental exposure assessment of MC in water. Flow rate is known to influence sampling by POCIS. Because POCIS sampling rates (R_s) for MC have only been determined under quasi-static conditions, the present study evaluated the uptake of 2,4,6-trinitrotoluene (TNT), RDX (hexahydro-1,3,5-trinitro-1,3,5-triazine), and 2,4- and 2,6-dinitrotoluenes (DNT), by POCIS in a controlled water flume at 7, 15, and 30 cm/s in 10-day experiments using samplers both within and without a protective cage. Sampling rate increased with flow rate for all MC investigated, but flow rate had the strongest impact on TNT and the weakest impact on RDX. For uncaged POCIS, mean R_s for 30 cm/s was significantly higher than that for 7 cm by 2.7, 1.9, 1.9, and 1.3 folds for TNT, 2,4-DNT, 2,6-DNT, and RDX, respectively. For all MC except RDX, mean R_s for caged POCIS at 7 cm/s were significantly lower than for uncaged samplers and similar to those measured at quasi-static condition, but except for 2,6-DNT, no caging effect was measured at the highest flow rate, indicating that the impact of caging on R_s is flow rate-dependent. When flow rates are known, flow rate-specific R_s should be used for generating POCIS-derived time-averaged concentrations of MC at contaminated sites.     

Warm discharges in cold fresh water: 2. Numerical simulation of laminar line plumes

The behaviour of a discharge of warm water upwards into a homogeneous body of cold fresh water was investigated by means of a numerical model. The discharge has a parabolic velocity profile, with Reynolds number \(Re=50\), Prandtl number \(Pr=7\) and Froude number varied over the range \(0.2 \le {\rm Fr} \le 2.5\). Water density is taken to be a quadratic function of temperature, so that an initially positively buoyant discharge will experience buoyancy reversal as it mixes with an ambient below the temperature of maximum density. The resulting plume has some similarities to a fountain resulting from injection of negatively buoyant fluid upward into a less dense ambient. The plume is initially symmetric, but then its head detaches as it approaches its maximum height. The detached head is denser than the fluid in the plume below it, and the interaction between the sinking head and the rising plume causes a sideways deflection; as this cycle is repeated, the plume displays side-to-side flapping motion and vertical bobbing. As Froude number is increased (i.e. buoyancy reduced) the growth of the plume becomes slower, but the plume eventually reaches a greater height. We obtain empirical power-law scalings for maximum height and time taken to reach that height as functions of Froude number; these scalings are simlar to those for fountains with a linear dependence of density on temperature in the very weak regime.     

Environmental technology development and diffusion: panel data evidence from 56 countries

Environmental Economics and Policy Studies - This study analyzes environmental technology development and diffusion patterns in 56 countries and for the time period 2005–2014 to provide an...     

Estimation of effect of sugarcane bagasse biochar amendment in landfill soil cover on geotechnical properties and landfill gas emission

In a sanitary landfill, the final cover plays an important role in reducing the landfill gas emission to the atmosphere and in preventing the ingress of rainwater into the dumped waste. The present study investigated the suitability of sugarcane bagasse biochar as an amendment to the cover soil to improve the required landfill liner properties. The amended cover soil sugarcane bagasse (SSB) was tested for its stability and effectiveness, in terms of both geotechnical properties and methane mitigation efficiency. The effects of amending 15%, 20%, and 25% of sugarcane bagasse biochar (passing through 300 micron Indian Standard sieve) on the geotechnical properties of the SSB indicated that the SSB with 25% biochar showed the required values as per the standard with maximum dry density of 1.57 grams per cubic centimeter (g/cm³), liquid limit, plasticity index, and percentage of fines 48.5%, 16.3%, and 74.7%, respectively, and permeability of 0.9 × 10^?7. A column study that was conducted to determine the methane emission from the cover soil showed a 65.8% reduction in the methane emission compared to that of a column without SSB cover, with a cumulative methane emission of 410 milliliters (mL) at the end of 200 hours (h). On the other hand, the volume of methane emitted after 310 h from the column without cover and with the SSB cover was 1850 mL and 692 mL, respectively. The difference between these two values is found to be 22% of the total methane that the cover would have handled in its lifetime (5267 mL). Thus, there is an increase in the percentage of methane adsorption by soil cover from 15% to 22% when the soil was amended with 25% sugarcane bagasse biochar.