Oceanic squid do fly

Using powerful jet propulsion, some squid species are able to exit the water and become airborne; this is a common behavior seen throughout the world’s oceans. However, direct scientific observation is rare, with most studies relying on anecdotal evidence and limited photographic documentation. Here, we examine the flying behavior of young oceanic squid (Ommastrephidae) observed in sequential photographs taken in the Northwest Pacific (35^o34.0′N, 146^o19.3′E) on July 25, 2011. We define four phases in the flight process: launching, jetting, gliding and diving. During flight, squid actively change their aerial posture and attitude depending on the flight phase and their distance from the water. The present study demonstrated that flight of squid is not simple gliding after incidental exit from the water, but involves jet propulsion, generation of lift force and control of different body postures in different flight phases, which have evolved to enhance escape from predators.     

Diurnal Profile of Particle-bound Polycyclic Aromatic Hydrocarbon (pPAH) Concentration in Urban Environment in Tokyo Metropolitan Area

Traffic emits particles under 1 m. The particles arethe most responsible to particle-bound polycyclic aromatichydrocarbon (pPAH) which can impact human health. To assessthem as health hazards, we monitored diurnal changes in theconcentration and distribution of pPAH near roads in Tokyo.The total pPAH concentration was determined using aphotoelectric aerosol sensor (PAS) which ionized PAH-adsorbingparticles. The total pPAH concentration was compared withchemical analyses by gas chromatography/mass spectrometry(GC/MS). Two sampling sessions, one in August and one inSeptember 2000, were done at three sampling sites at the Hongo Campus of the University of Tokyo. Monitoring was every two minutes for six consecutive days for the first session and for seven consecutive days for the second session.Correlation of the pPAH concentration with traffic flow andwith meteorological conditions were also assessed. The pPAHconcentration varied in the same manner on all days: it sharplyincreased in the early morning by a sudden burden of traffic, and it rapidly decreased during the daytime, probably owing tophotodegradation and/or dilution by rising in the mixingzone. The local wind field, and consequently thetransportation of pPAH from the road, were stronglyinfluenced by the configuration and location of thesurrounding buildings. The pPAH clearly changed in 1- and0.5 day cycles, particularly at the roadside.     

Combustible and incombustible speciation of Cl and S in various components of municipal solid waste

Chlorine (Cl) and sulfur (S) in municipal solid waste (MSW) are important reactive elements during combustion. They generate the acidic pollutants HCl and SOx, and, furthermore, produce and suppress organic chlorinated compounds. Nevertheless, few practical reports about Cl and S content in MSW have been published. In combustion and recycling processes, both combustible Cl and S, and incombustible Cl and S species are equally important. This paper presents the results of a comprehensive study about combustible and incombustible Cl and S in MSW components, including kitchen garbage, paper, textiles, wood and leaves, plastics and small chips. By integrating this collected data with data about MSW composition, not only the overall content of Cl and S in MSW, but also the origins of both combustible and incombustible Cl and S were estimated. The average Cl content in bulk MSW was 3.7 g/kg of raw MSW, of which 2.7 and 1.0 g/kg were combustible and incombustible, respectively. The Cl contribution from plastics was 76% and 27% with respect to combustible and incombustible states. The average S content in bulk MSW was 0.81 g/kg of raw MSW, of which 0.46 g/kg was combustible and 0.35 g/kg was incombustible. Combustible S was mainly due to synthetic textiles, while incombustible S was primarily from paper.     

Towards a microscopic theory of electrostatic precipitation

The statistical mechanics of particles at the surface of a dust deposit are presented as a step towards a microscopic theory of electrostatic precipitation. The paper consists of three major divisions: (1) field induced entrainment, (2) particle condensation at the surface, and (3) hydrodynamic limits on precipitation.In the first part of this paper, the entrainment of dust from surfaces by electrostatic forces was considered as a simple Markov process. A choice of x⁻¹ for the dependence of the adhesive potential (van der Waals particle attraction) led to an exponential emission rate in the Kramers-Chandrasekhar approximation. This result suggested a simple experimental procedure for determining the adhesive properties of the dust. In addition it was found that both thermal Brownian and particle-deposit collisions contribute to the entrainment.In the second part, the precipitation problem was discussed in terms of a two-dimensional Ising model. The Markovian assumption demanded that the efficiency of the electrostatic precipitator be divided into a product of factors depending on particle migration and condensation in the two-dimensional surface. From this perspective a new collection criterion was established and the importance of particle collisions at the surface of the deposit was demonstrated.Finally, in the third part the role of bulk fluid flows in particle condensation and migration was addressed. The superficial gas flow and secondary flow were found to introduce anisotropy into the Ising lattice and also to enhance the mean particle energy at the surface. The Navier Stokes Equation was numerically integrated for the case of a wire-plate type corona. Plots of the stream function and gas velocity profile were presented and these suggested the existence of a lower limit on the shear stress that acts on surface particles.     

Plutonium concentration and 240Pu/239Pu atomic ratio in liver of squid collected in the coastal sea areas of Japan

Plutonium isotopes, 239Pu and 240Pu, were measured in liver samples from Surume squid using a sector-field high resolution ICP-MS after radiochemical purification. Surume squid samples were obtained from nine landing ports in Japanese inshore during fishery season from September to December 2002. Concentrations of 239Pu and 240Pu ranged from 1.5 to 28 mBq kg(-1) and 1.1 to 24 mBq kg(-1), respectively. Plutonium (239,240Pu) concentrations in liver were several thousand times higher than levels found in seawater. The concentration factor (CF) compared to seawater for 239,240Pu and 13 other elements ranged from 10(0) to 10(7). The CF values for 239,240Pu, V and Th were 10(2)-10(4). Pu had an intermediate CF between conservative and scavenged elements. 240Pu/239Pu atomic ratios in the squid liver ranged from 0.177 to 0.237 which were slightly higher than 0.178+/-0.014 for global fallout. The variations of 240Pu/239Pu atomic ratios in ocean currents with different source functions are important for interpreting high 240Pu/239Pu atomic ratios in Surume squid liver. It seems likely that Pu with high 240Pu/239Pu atomic ratio is continuously transported through the solubilization and seawater transport from the North Equatorial Current to Kuroshio and its branch, Tsushima Current. By assuming that Pu found in Surume squid liver is a mixture of global fallout Pu (0.178) and close-in fallout Pu with high 240Pu/239Pu atomic ratio (0.30-0.36) around Bikini Atoll, Pu contribution from Bikini close-in fallout Pu accounts for close to 35% of the whole plutonium in Surume squid liver. These results highlight that Surume squid is a useful organism for evaluating environmental Pu levels of larger sea area and facilitate the development of models to understand oceanic transport of close-in fallout Pu from Bikini Atoll.     

Production of male neonates in Daphnia magna (Cladocera, Crustacea) exposed to juvenile hormones and their analogs

We exposed the water flea Daphnia magna (Cladocera, Crustacea) to either juvenile hormone I (JH I), juvenile hormone II (JH II), or the juvenile hormone-mimicking insecticides kinoprene, hydroprene, epofenonane, or fenoxycarb. By 21-day reproduction tests, we investigated the effects on the number of neonates born per female and the offspring sex ratio. All six chemicals induced D. magna to produce male neonates; the male sex ratio of the offspring increased as the chemical concentration increased. EC50 values for production of male neonates were estimated as 400 (JH I), 410 (JH II), 190 (kinoprene), 2.9 (hydroprene), 64 (epofenonane), and 0.92 (fenoxycarb) microg/l. The number of neonates produced was reduced with all chemicals at the concentrations investigated. At the EC50 for male production, five of the six chemicals reduced the reproductive rate to less than 50%; the exception was epofenonane, which caused only a slight reduction in reproductive rate. These results were similar to those obtained for five juvenoids studied previously, one of which was studied here again. There are now 10 chemical substances--all juvenile hormones or their analogs-that are known to induce D. magna to produce male neonates. This suggests that juvenile hormone is involved in initiating male production followed by sexual reproduction in D. magna, and probably in most cladocerans that exhibit cyclic parthenogenesis.     

Japan’s greenhouse gas reduction scenarios toward net zero by 2050 in the material cycles and waste management sector

The first draft scenario toward net zero greenhouse gas (GHG) emissions by 2050 for the material cycles and waste management sector was presented by the Ministry of the Environment, Japan in August 2021. The details of the future GHG emission estimation used to create the draft scenario are described in this document. For multiple scenarios where more aggressive measures, such as carbon capture, utilization, and storage (CCUS), were included in addition to business-as-usual and the current policy continuity scenario, future GHG emissions were estimated as the sum of the products of activities and emission factors indicating changes in measures between scenarios. The estimation outcomes demonstrated that future GHG emissions from the solid waste management sector could be anticipated to be zero or even negative when material conversion to biomass, primarily for plastics, recycling to raw materials, and installation of CCUS at incineration facilities are assumed. Extensions of prior plans are not enough to reach the goal of net zero emissions, according to the measures necessary and the volume and pace of their implementation suggested in this study. Stakeholders should collaborate with great ambition.

     

Scenarios for reducing copper smelting-related atmospheric mercury emissions through copper recycling and mercury removal technologies in major countries

Journal of Material Cycles and Waste Management - Smelting of copper, a crucially important resource, releases small amounts of mercury into the atmosphere, thereby endangering people and the...