Determination of first-order landfill gas modeling parameters and uncertainties

Using first-order kinetic empirical models to estimate landfill gas (LFG) generation and collection rates is well recognized in the literature. The uncertainty in the estimated LFG generation rates is a major challenge in evaluating performance of LFG collection and LFG to energy facilities. In this investigation, four methods for quantifying first-order LFG generation model parameters, methane generation potential, L₀, and methane generation rate constant, k, were evaluated. It was found that the model is insensitive to the approach taken in quantifying the parameters. However, considering the recognition of using the model in the literature, the optimum method to estimate L₀ and k is to determine L₀ using disposed municipal solid waste composition and laboratory component specific methane potential values. The k value can be selected by model fitting and regression using the first-order model if LFG collection data are available. When such data are not available, k can be selected from technical literature, based on site conditions. For five Florida case-study landfills L₀ varied from 56 to 77 m³ Mg⁻¹, and k varied from 0.04 to 0.13 yr⁻¹ for the traditional landfills and was 0.10 yr⁻¹ for the wet cell. Model predictions of LFG collection rates were on average lower than actual collection. The uncertainty (coefficient of variation) in modeled LFG generation rates varied from ±11% to ±17% while landfills were open, ±9% to ±18% at the end of waste placement, and ±16% to ±203% 50 years after waste placement ended.     

Characterization of Urea Encapsulated by Biodegradable Starch-PVA-Glycerol

The influence of the blending ratio of biodegradable starch/polyvinyl alcohol (PVA)/glycerol in encapsulating urea has been investigated. It is found that water absorption capacity increased approximately 135 % as the amounts of starch, PVA and glycerol in the composite film increase. Therefore, the swell ability of the composite film is increased and the urea is released from the composite film in the wet environment. The FTIR shows that the urea had been encapsulated successfully in the composite films. Moreover, the soil burial biodegradation results indicated that the biodegradability of the starch/PVA/glycerol/urea composite film strongly depended on the PVA proportion in the composite film matrix. The DSC results show that the higher the amount of PVA in the composite film, the less change of the melting enthalpy value. The crystalline region of PVA remains after biodegradation.     

Pathogenicity of Aeromonas hydrophila isolated from the Malaysian Sea against coral (Turbinaria sp.) and sea bass (Lates calcarifer)

Environmental Science and Pollution Research - A study was carried out to determine the pathogenicity (hemolytic activity) on corals (Turbinaria sp.) and sea bass (Lates calcarifer) of Aeromonas...     

Contaminants of emerging concern: a review of new approach in AOP technologies

The presence of contaminants of emerging concern (CECs) such as pharmaceuticals and personal care products (PPCPs), endocrine-disrupting compounds (EDCs), flame retardants (FRs), pesticides, and artificial sweeteners (ASWs) in the aquatic environments remains a major challenge to the environment and human health. In this review, the classification and occurrence of emerging contaminants in aquatic environments were discussed in detail. It is well documented that CECs are susceptible to poor removal during the conventional wastewater treatment plants, which introduce them back to the environment ranging from nanogram per liter (e.g., carbamazepine) up to milligram per liter (e.g., acesulfame) concentration level. Meanwhile, a deep insight into the application of advanced oxidation processes (AOPs) on mitigation of the CECs from aquatic environment was presented. In this regard, the utilization of various treatment technologies based on AOPs including ozonation, Fenton processes, sonochemical, and TiO₂ heterogeneous photocatalysis was reviewed. Additionally, some innovations (e.g., visible light heterogeneous photocatalysis, electro-Fenton) concerning the AOPs and the combined utilization of AOPs (e.g., sono-Fenton) were documented.     

The role of drug and alcohol use and the risk of motor vehicle crashes in Shiraz,Iran, 2014: A case–crossover study

Background: Traffic accidents and traffic-related injuries and mortality have become a major public health concern in Iran. This study aimed to examine the role of drug and alcohol use in motor vehicle accidents in Iran.

Methods: This case–crossover study was conducted on 441 drivers who survived a road traffic crash and were taken to the emergency department of Shahid Rajaee trauma hospital in Shiraz, southern Iran. Data were collected using checklists that included demographic characteristics and drug and alcohol use prior to driving. Alcohol and drug use was identified through self-report, and cannabis, morphine, and methamphetamine urine tests were used to confirm drug abuse among drivers.

Results: In total 17.9% of drivers reported using drugs (cannabis, opium, or metamphetamine) and 8.84% of drivers reported consuming alcohol prior to the collision. The crude odds ratios (ORs) for having a crash for opium, cannabis, and metamphetamine were 1.94 (95% interval confidence [CI], 1.11–3.38), 2.37 (95% CI, 1.03–5.42), 5.5 (95% CI, 1.21–24.81), respectively, and for all drugs was 3.83 (95% CI, 2.28–6.43). The OR for alcohol was 3.5 (95% CI, 1.73–7.06) based on self-report.

Conclusion: Drug and alcohol use are increasing the risk of traffic crashes in Iran. Risk-reducing programs must be designed and implemented.     

Optimal sizing and siting of renewable energy resources in distribution systems considering time varying electrical/heating/cooling loads using PSO algorithm

Distributed Generation (DG) sources based on Renewable Energy (RE) can be the fastest growing power resources in distribution systems due to their environmental friendliness and also the limited sources of fossil fuels. In general, the optimal location and size of DG units have profoundly impacted on the system losses in a distribution network. In the present article, the Particle Swarm Optimization (PSO) algorithm is employed to find the optimal location and size of DG units in a distribution system. The optimal location and size of DG units are determined on the basis of a multi-objective strategy as follows: (i) the minimization of network power losses, (ii) the minimization of the total costs of Distributed Energy Resources (DERs), (iii) the improvement of voltage stability, and (iv) the minimization of greenhouse gas emissions. The related distribution system was assumed to be composed of the fuel cells, wind turbines, photovoltaic arrays, and battery storages. The electrical, cooling, and heating loads were also considered in this article. The heating and cooling requirements of the system consist of time varying water heating load, space heating load, and space cooling load. In this study, the waste and fuel cell were used to produce the required heating and cooling loads in the distribution system. In addition, the absorption chiller was used to supply the required space cooling loads. A detailed performance analysis was carried out on 13 bus radial distribution system to demonstrate the effectiveness of the proposed methodology.     

Government management and overexploitation of groundwater resources: absence of local community initiatives in Ardabil plain-Iran

Although mismanagement of groundwater resources has resulted in their destruction over centuries, climate change is speeding up this process more than ever. On the one hand, urgent action by government bodies is needed to address the challenge. On the other hand, a vast body of literature proves that bottom-up collective action, although requiring a longer time period, is a better solution to manage such resources. This research aims to address this dilemma. The groundwater resource in Ardabil plain in Iran, which has long been managed solely through government intervention, has been chosen as a case study to explore the opportunities and limitations of managing a critically endangered area from a common pool resource perspective. Our study suggests that managing Ardabil groundwater resources should be conducted on two scales. The bottom-up institutional agreements should take place at village scale while the government should stay in charge of the overall organization at plain scale.     

Reliable method for prediction of the flash point of various classes of amines on the basis of some molecular moieties for safety measures in industrial processes

This work presents a novel, reliable and simple method of estimating the flash point of various types of flammable amines, which are important for safety measures in industrial processes. Different amines include aliphatic amines such as primary, secondary, tertiary and cyclic amines as well as aromatic amines and hetero arenes containing nitrogen heteroatom. The proposed correlation is based on the contribution of some specific molecular moieties and functional groups, which can easily be used for any types of amines. Intermolecular forces are important in the new method, which are counted by two increasing and decreasing parameters. The root mean square (rms) deviation is 18 K for different classes of amines including 133 diverse compounds. The estimated flash points have been compared with one of the best available predictive methods, which gives much lower value of the rms deviation.     

Photooxidative removal of the herbicide Acid Blue 9 in the presence of hydrogen peroxide: modeling of the reaction for evaluation of electrical energy per order (EEO)

The present work deals with photooxidative removal of the herbicide, Acid Blue 9 (AB9), in water in the presence of hydrogen peroxide (H₂O₂) under UV light illumination (30 W). The influence of the basic operational parameters such as amount of H₂O₂, irradiation time and initial concentration of AB9 on the photodegradation efficiency of the herbicide was investigated. The degradation rate of AB9 was not appreciably high when the photolysis was carried out in the absence of H₂O₂ and it was negligible in the absence of UV light. The photooxidative removal of the herbicide was found to follow pseudo-first-order kinetic, and hence the figure-of-merit electrical energy per order (E_Eo) was considered appropriate for estimating the electrical energy efficiency. A mathematical relation between the apparent reaction rate constant and H₂O₂ used was applied for prediction of the electricity consumption in the photooxidative removal of AB9. The results indicated that this kinetic model, based on the initial rates of degradation, provided good prediction of the E_Eo values for a variety of conditions. The results also indicated that the UV/H₂O₂ process was appropriate as the effective treatment method for removal of AB9 from the contaminated wastewater.