生物滴滤塔处理模拟甲硫醚废气

在常温条件下,采用生物滴滤塔处理模拟甲硫醚废气,考察了气体空床停留时间(EBRT)、容积负荷、喷淋密度及营养液pH对生物滴滤塔性能的影响。实验结果表明:当EBRT为90 s、进气甲硫醚质量浓度为150 mg/m~3、喷淋密度为0.65 m~3/(m~2·h),营养液pH为6.8时,甲硫醚去除率为90%;容积负荷高于15 g/(m~3·h)时,对生物滴滤塔的性能产生抑制作用;EBRT为90 s及60 s时,最佳喷淋密度分别为0.56~0.65 m~3/(m~2·h)及0.65~0.75 m~3/(m~2·h);降解甲硫醚的微生物对pH的变化较敏感,最适营养液pH为6~7。     

采用支持向量机算法优化电化学处理油田污水的工艺参数

采用支持向量机(SVM)算法,将Box-Behnken设计法与支持向量回归算法(SVR)实验参数优化软件相结合,优化电化学去除油田污水COD的工艺参数。通过量子粒子群算法对SVM算法参数进行优化,从建立的回归模型中找到工艺参数的全局最佳点:电解时间60 min,电解电流3 A,三维电极填充料中石英砂质量695 g。模型得到的COD理论最优去除率为92.48%,验证实验得到的COD去除率为91.43%。     

Numerical study of heat transfer characteristics of char from waste tire pyrolysis

To investigate heat transfer of char from waste tire pyrolysis, the cooling of char was simulated by the computational fluid dynamics. To scrutinize the heat transfer characteristics, bed height, temperature of cooling wall, and mixing time were selected as calculation parameters. From the results, increasing the char bed height from 0.005 to 0.02 m, the total heat transfer is decreased as from 45.5 to 26.5 J. As the char bed height is further increased from 0.02 to 0.06 m, the total heat transfer is decreased from 26.5 to 9.1 J. The char bed height affects the total heat transfer significantly. The total heat transfer decreases from 15.9 to 14.0 J as the temperature of cooling wall increases from 273.15 to 323.15 K. The total heat transfer mildly depends on the temperature of cooling wall. The particle mixing time increases from 10 to 120 s and the total heat transfer decreases from 28.6 to 22.6 J. It is noted that the particle contact is enhanced between char particles as well as the particles and cooling wall as the particle mixing time decreases. Consequently, heat transfer is augmented.     

Experimental assessment of characteristic turbulent scales in two-phase flow of hydraulic jump: from bottom to free surface

A hydraulic jump is a turbulent shear flow with a free-surface roller. The turbulent flow pattern is characterised by the development of instantaneous three-dimensional turbulent structures throughout the air–water column up to the free surface. The length and time scales of the turbulent structures are key information to describe the turbulent processes, which is of significant importance for the improvement of numerical models and physical measurement techniques. However, few physical data are available so far due to the complexity of the measurement. This paper presents an investigation of a series of characteristic turbulent scales for hydraulic jumps, covering the length and time scales of turbulent flow structures in bubbly flow, on free surface and at the impingement point. The bubbly-flow turbulent scales are obtained for Fr = 7.5 with 3.4 × 10⁴ < Re < 1.4 × 10⁵ in both longitudinal and transverse directions, and are compared with the free-surface scales. The results highlight three-dimensional flow patterns with anisotropic turbulence field. The turbulent structures are observed with different length and time scales respectively in the shear flow region and free-surface recirculation region. The bubbly structures next to the roller surface and the free-surface fluctuation structures show comparable length and time scales, both larger than the scales of vortical structures in the shear flow and smaller than the scales of impingement perimeter at the jump toe. A decomposition of physical signals indicates that the large turbulent scales are related to the unsteady motion of the flow in the upper part of the roller, while the high-frequency velocity turbulence dominates in the lower part of the roller. Scale effects cannot be ignored for Reynolds number smaller than 4 × 10⁴, mainly linked to the formation of large eddies in the shear layer. The present study provides a comprehensive assessment of turbulent scales in hydraulic jump, including the analyses of first data set of longitudinal bubbly-flow integral scales and transverse jump toe perimeter integral scales.     

重金属Cr(VI)、Pb及Cu胁迫对双齿围沙蚕体腔细胞的DNA损伤

为探讨重金属Cr(VI)、Pb以及Cu对沙蚕体腔细胞DNA的毒性效应,以双齿围沙蚕为受试动物,重金属按不同剂量水平,Cr(VI):10、100和200 mg·L~(-1),Pb:5、50和100 mg·L~(-1),Cu:1、10和20 mg·L~(-1),分别胁迫沙蚕24 h,以不加任何重金属离子的海水为对照,采用单细胞凝胶电泳技术,检测其体腔细胞DNA损伤程度。结果表明,与空白对照组相比,3种重金属离子的各浓度组都能引起沙蚕体腔细胞DNA损伤,且3种重金属胁迫浓度与细胞DNA损伤程度之间存在显著的剂量-效应关系。双齿围沙蚕可以作为单细胞凝胶电泳的实验材料用于重金属所致环境污染的生物监测指示生物。     

口服纳米银对大鼠的生物有效性及其体内分布的研究

由于独特的抗菌特性,纳米银(AgNP)在诸多领域得到广泛应用,但是其生物有效性、动物组织分布及排出尚不清楚。将聚乙烯吡咯烷酮包被的AgNP溶液按照10 mg kg^-1给雌性SD大鼠灌胃,采用ICP-MS检测SD大鼠组织、粪便及尿液中总银浓度。实验结果表明,AgNP通过小肠吸收后,可以通过血液循环快速分布在肝、肾、脾、肺、脑等靶器官。灌胃后1 h,大鼠各组织中总银浓度达到最大值(肝、肾、脾、肺、脑中银浓度分别为0.29 ± 0.13 mg kg^-1、0.23 ± 0.04 mg kg^-1、0.17 ± 0.05 mg kg^-1、0.11 ± 0.01 mg kg^-1、0.06 ±0.02 mg kg^-1),之后银浓度随时间降低直至和对照组无显著性差异。在灌胃途径下,AgNP对SD大鼠的有效性为8.5%,且73%的AgNP是通过粪便的途径排出体外。     

三氯卡班对小鼠血浆内源性物质影响的代谢组学研究

三氯卡班被认定为一种新型的环境污染物,可能对动植物和人体产生危害,为探究三氯卡班的有害作用机制,选择C57BL6小鼠作为载体,利用分子生物学和报告基因方法考察了三氯卡班对肝脏的作用,同时利用代谢组学技术考察三氯卡班对血浆内源性代谢物变化的影响。结果表明,三氯卡班是核受体CAR的激活剂,可以提高肝脏CYP2b10的m RNA表达。同时血浆主要的内源性代谢物也产生了显著性变化,血浆中的脂肪酸比例都呈下降趋势,肉毒碱与乙酰肉碱的比例都呈上升趋势,花生四烯酸与肌酸的比例都呈上升趋势,这都与核受体CAR被激活密切相关,由此说明利用代谢组学技术能够全面地反映三氯卡班所造成的对机体的影响。     

石墨烯纳米材料对哺乳动物的毒性及其作用机制

石墨烯是一种应用广泛的新兴非金属纳米材料,具有独特的电学机械性能、超大的比表面积以及潜在的生物相容性,在材料、电子、能源、光学以及生物医学等领域得到广泛应用。与此同时,石墨烯的环境行为和生物毒性也随之引起日益广泛的关注。本文通过对石墨烯纳米材料的动物毒性、细胞毒性、毒性影响因素和毒性机制等相关研究进展进行总结。石墨烯纳米材料可通过气管滴注、吸入、静脉注射、腹腔注射以及口服等方式进入体内,通过机械屏障、血脑屏障和血液胎盘屏障等积累在肺、肝、脾等部位引起急性或者慢性损伤;目前有关石墨烯毒性机制的研究主要集中于线粒体损伤、DNA损伤、炎性反应、凋亡等终点及氧化应激参与的复杂信号通路,不同石墨烯纳米材料的浓度、尺寸、表面结构和官能团等对石墨烯的生物毒性影响不同。鉴于当前该领域研究的局限性,对石墨烯纳米材料生物毒性研究的发展方向进行了展望,进而为石墨烯材料的安全应用提供理论借鉴和实践参考。     

稀有鮈鲫作为水生模式生物的研究及探讨

我国本土水生生物稀有鮈鲫(Gobiocypris rarus Ye et Fu,1983年)是一种优良的试验用鱼,具备成为模式生物必要条件。本文总结了稀有鮈鲫生物生态学研究情况,分析了稀有鮈鲫在多个应用领域与模式生物斑马鱼、青鳉存在的不足和差距,同时借鉴发达国家推动模式生物的实践经验,提出了针对性建议。     

农药混配制剂环境风险评估现状与展望

本文综述了欧洲和美国农药混配制剂的环境风险评估方法。详细介绍了欧洲食品安全局(EFSA)评估体系中的2种方法,即,基础的"整体测试法"和近年来提倡的"基于组分的方法"。"基于组分的方法"的特点是以浓度加和模型(CA模型)作为默认假设进行初级评估,以独立作用模型(IA模型)等作为高级评估手段的农药混配制剂环境风险评估方法。此外,本文还介绍了模型偏差率(MDR)、毒性相似度及毒力单元(TU)等概念以及混配制剂风险评估流程。本文的目的旨在为建立我国农药混配制剂的环境风险评估方法体系提供参考。