TPH-contaminated Mexican Refinery Soil: Health Risk Assessment and the First Year of Changes

The soil of a coastal Mexican refinery is quite contaminated, especially by hydrocarbons, with detected concentrations up to 130000 mg kg(-1) as TPHs (total petroleum hydrocarbons). The main sources of contamination are pipelines, valves, and old storage tanks, besides the land disposal of untreated hydrocarbon sediments derived from the cleaning of storage tanks. A health risk assessment (HRA) was carried out in order to measure the risk hazard indexes and clean-up standards for the refinery soil. HRA suggested the following actions to be taken: benzene concentrations must be reduced in eight of the 16 studied refinery zones to 0.0074-0.0078 mg kg(-1). Also, vanadium concentration must be reduced in two zones up to a concentration of 100 mg kg(-1). In only one of all of the studied zones, benzo(a)pyrene concentration must be reduced to 0.1 mg kg(-1). After 1 yr, TPHs showed a diminution of about 52%. Even though TPHs concentrations were variable, during 1999 the average concentrations were as much as 15.5 times the goal concentration. For year 2000, TPHs concentrations were only 7.4-fold the proposed value. For the 1999-2000 period, PAHs (polycyclic aromatic hydrocarbons) concentrations decreased by 82%. Some PAHs with 2, 3, 4, and 5 aromatic rings were removed up to 100% values.     

Paleolimnological assessment of Grove and Plow Shop Ponds, Ayer, Massachusetts, USA--a superfund site

Three sediment cores from each of severely polluted Grove and Plow Shop Ponds, Ayer, Massachusetts, USA, were dated using (210)Pb, characterized for plant macrofossil assemblages, and analyzed for H(2)O, loss-on-ignition, stable Pb isotopes, and concentrations of As, Ca, Cd, Cr, Cu, Fe, Hg, methyl-Hg, Ni, Pb, and Zn. A core from nearby kettle Spectacle Pond, Littleton, Massachusetts, was similarly characterized (except for plant macrofossil assemblages) to assess the regional air pollution signal in sediment for comparison with the six cores. Accumulation rates for metals (mass per area per year), the anthropogenic component (mass per area per year), and total accumulation of the anthropogenic component (mass per area) indicate that As, Cd, Cr, Cu, Hg, methyl-Hg, Ni, Pb, and Zn have accumulated in sediment as a consequence of point source pollution from within the drainage basins of Grove and Plow Shop Ponds. Three distinct sources of pollution are inferred. As is entering Plow Shop Pond via groundwater in the southwest. Cd, Ni, Pb, and Zn are entering the system predominantly at the eastern end of, or upstream from, Grove Pond. Pb also comes from the northwest corner of Grove Pond, the principal source of Cr, Cu, and Hg. These results are consistent with chemistry of modern surface sediments. The history of pollution extends back more than 100 years. Intra- and inter-core variability of concentrations and accumulation rates indicate that much of the pollution was likely in particulate form with little physical redistribution. Recently, concentrations and accumulation rates have generally decreased substantially for those elements present in excessive concentrations in the past. This is a consequence of accumulation of recent, less polluted sediment. In Spectacle Pond, the nearby reference lake, accumulation rates for As, Cd, Hg, and Pb, adjusted for background values and changes in sedimentation rate, increased above background starting in the late 19th century, peaked about 1980, and declined substantially to 2000. These decreases suggest that the anthropogenic (pollution) component of atmospheric deposition of these elements declined after 1980 by at least 50%(As), 80%(Cd), 80%(Hg), and 80%(Pb).     

Development of an ombrotrophic peat bog (low ash) reference material for the determination of elemental concentrations

Given the increasing interest in using peat bogs as archives of atmospheric metal deposition, the lack of validated sample preparation methods and suitable certified reference materials has hindered not only the quality assurance of the generated analytical data but also the interpretation and comparison of peat core metal profiles from different laboratories in the international community. Reference materials play an important role in the evaluation of the accuracy of analytical results and are essential parts of good laboratory practice. An ombrotrophic peat bog reference material has been developed by 14 laboratories from nine countries in an inter-laboratory comparison between February and October 2002. The material has been characterised for both acid-extractable and total concentrations of a range of elements, including Al, As, Ca, Cd, Cr, Cu, Fe, Hg, Mg, Mn, Na, Ni, P, Pb, Ti, V and Zn. The steps involved in the production of the reference material (i.e. collection and preparation, homogeneity and stability studies, and certification) are described in detail.     

Natural mercury enrichment in a minerogenic fen--evaluation of sources and processes

Mercury (Hg) records in natural archives such as peat bogs are often used to evaluate anthropogenic or climatic influences on atmospheric Hg deposition. In this context, there is an ongoing discussion about natural sources or processes of Hg enrichment in natural archives. In the present study we estimated Hg fluxes from rock weathering, direct atmospheric deposition and from indirect atmospheric deposition in the catchment of a pristine minerogenic fen (GC2) located in the Magellanic Moorlands, southernmost Chile. The Hg record in the bog covers 11 174 cal. (14)C years and shows Hg concentrations of up to 570 [micro sign]g kg(-1) with an average of 268 [micro sign]g kg(-1). Hg was found to be enriched in the peat by a factor of 81 if compared to the mean Hg concentrations in the rocks of the catchment (3.2 [micro sign]g kg(-1)). Hg and also Pb, Fe, and As were found to be enriched predominately in goethite layers indicating high retention of these elements in the bog by iron oxyhydrates. It could also be demonstrated that the high peat decomposition rates in minerogenic bogs can increase the Hg concentrations in the minerogenic peat by a factor of approximately 2 at the same atmospheric Hg deposition rate if compared to ombrotrophic sites. This study has shown that Hg in minerogenic peat can be naturally enriched especially through the retention by autochthonous formed goethite and can be a solely internal process which does not require increased external Hg fluxes.     

High frequency monitoring of the coastal marine environment using the MAREL buoy

The MAREL Iroise data buoy provides physico-chemical measurements acquired in surface marine water in continuous and autonomous mode. The water is pumped 1.5 m from below the surface through a sampling pipe and flows through the measuring cell located in the floating structure. Technological innovations implemented inside the measuring cell atop the buoy allow a continuous cleaning of the sensor, while injection of chloride ions into the circuit prevents biological fouling. Specific sensors for temperature, salinity, oxygen and fluorescence investigated in this paper have been evaluated to guarantee measurement precision over a 3 month period. A bi-directional link under Internet TCP-IP protocols is used for data, alarms and remote-control transmissions with the land-based data centre. Herein, we present a 29 month record for 4 parameters measured using a MAREL buoy moored in a coastal environment (Iroise Sea, Brest, France). The accuracy of the data provided by the buoy is assessed by comparison with measurements of sea water weekly sampled at the same site as part of SOMLIT (Service d'Observation du Milieu LIToral), the French network for monitoring of the coastal environment. Some particular events (impact of intensive fresh water discharges, dynamics of a fast phytoplankton bloom) are also presented, demonstrating the worth of monitoring a highly variable environment with a high frequency continuous reliable system.     

Development and validation of methods for environmental monitoring of cyclophosphamide in workplaces

Methods to monitor contamination of workplaces with antineoplastic drugs have been developed and validated. Cyclophosphamide (CP) was used as a model compound as it is one of the most commonly used antineoplastic drugs. A wipe sampling method to detect contamination with CP at surfaces was developed. A personal air sampling method to sample gas and vapour on solid sorbent tubes and particles with filters was also developed. Wipe and filter samples were extracted and sorbent samples were eluted, all with ethyl acetate. The samples were analysed with liquid chromatography tandem mass spectrometry. (2)H(6)-labelled cyclophosphamide was used as an internal standard. The between-day precision was 2-5% for wipe samples, 4-6% for sorbent samples and 3-8% for filter samples. The limit of detection was 0.02 ng CP per sample for the wipe and filter methods and 0.03 ng CP per sample for the solid sorbent method. Wipe sampling on surfaces made of different materials resulted in mean recoveries between 78-106%. The desorption recovery was between 97-102% for the wipe samples, 97% for the sorbent samples and 101% for the filter samples. Samples were stable for up to 2 months at 5 degrees C and -20 degrees C and for about 2 d at room temperature. The developed methods were applied to the measurement of contamination with CP in a hospital pharmacy. Trace amounts of CP, 1.3 and 1.4 ng, were detected on surfaces in the pharmacy.     

A combination of micro-porous membrane liquid-gas extraction and solid-phase trapping for ultra trace determination of benzene in urine

A method was developed for the determination of benzene in urine. The sample was pumped through the donor channel of a membrane extraction unit with a micro-porous membrane, separating the donor channel from an identical acceptor channel purged with nitrogen. The analyte reached the acceptor channel by diffusion through the membrane and was then swept by the carrier to a solid sorbent tube, where it was trapped. The analyte was subsequently thermally desorbed and analyzed by gas chromatography (GC) with mass selective detection (MS). After optimization, the recovery was close to quantitative, or 95%. Purging the membrane unit with pure water in between the samples eliminated any memory effects. The linearity was good in the concentration range examined (20-4000 ng l(-1)), with a correlation coefficient of 0.9996. The repeatability at 50 ng l(-1) and 400 ng l(-1) was 1.4% and 1.2%, respectively. The limit of detection was 12 ng l(-1) and the limit of quantification 35 ng l(-1). This enables assessment of benzene exposures of occupationally exposed subjects, of smokers and the majority of the general population. The developed method can be easily automated.     

How and why is Aquatic Quality Changing at Nahanni National Park Reserve, nwt, Canada?

Nahanni National Park Reserve is located at southwestern NWT-Yukon border. One of the first UNESCO World Heritage sites, Nahanni lies within Taiga Cordillera and Taiga Shield Ecozones. Base and precious metal mining occurred upstream of Nahanni prior to park establishment. Nahanni waters, sediments, fish, and caribou have naturally elevated metals levels. Baseline water, sediment and fish tissue quality data were collected and analyzed throughout Nahanni during 1988–91 and 1992–97. These two programs characterized how aquatic quality variables are naturally varying in space and time, affected by geology, stream flow, seasonality, and extreme meteorological and geological events. Possible anthropogenic causes of aquatic quality change were examined. Measured values were compared to existing Guidelines and site-specific objectives were established.     

Benchmarking for best practice environmental management

Benchmarking of environmental performance to demonstrate theachievement of best practice environmental management is acomponent of a new form of licensing of industrialdischarges in Western Australia. The paper describes theapproaches to benchmarking for the critical environmentalissues for an alumina refinery and wastewater treatmentplant. It also describes the lessons learnt from thebenchmarking process on appropriate methods, the benefitsand difficulties in the benchmarking process, and changesthat would assist benchmarking for best practiceenvironmental management.