Assessment of urban air pollution and it's probable health impact

The present study deals with the quantitative effect of vehicular emission on ambient air quality during May 2006 in urban area of Lucknow city. In this study SPM, RSPM, SO2, NOx and 7 trace metals associated with RSPM were estimated at 10 representative locations in urban area and one village area for control. Beside this, air quality index (AQI), health effects of different metals and mortality were assessed. The 24 hr average concentration of SPM, RSPM, SO2 and NOx was found to be 382.3, 171.5, 24.3 and 33.8 microg m(-3) respectively in urban area and these concentrations were found to be significantly (p < 0.01) higher by 94.8, 134.8, 107.4 and 129.6% than control site respectively The 24 hr mean of SPM and RSPM at each location of urban area were found to be higher than prescribed limit of National Ambient Air Quality Standard (NAAQS) except SPM for industrial area. The 24 hr mean concentration of metals associated with RSPM was found to be higher than the control site by 52.3, 271.8, 408.9, 75.81, 62.7, 487.54 and 189.5% for Fe, Cu, Pb, Zn, Ni, Mn and Cr respectively. The inter correlation of metals Pb with Mn, Fe and Cr; Zn with Ni and Cr; Ni with Cr; Mn with Fe and Cu with Cr showed significant positive relation either at p < 0.05 or p < 0.01 level. Metals Pb, Mn and Cr (p < 0.01) and Cu (p < 0.05) showed significant positive correlation with RSPM. These results indicate that ambient air quality in the urban area is affected adversely due to emission and accumulation of SPM, RSPM, SO2, NOx and trace metals. These pollutants may pose detrimental effect on human health, as exposure of these are associated with cardiovascular and respiratory diseases, neurological impairments, increased risk of preterm birth and even mortality and morbidity.     

Removal of Oil from Oil-in-Water Emulsion by Poly (Sulfur/Soya Bean Oil) Composite Adsorbent: An Equilibrium Study

Journal of Polymers and the Environment - This work describes synthesis of poly (sulfur/soya bean oil) composite material by co-polymerization of elemental sulfur and soya bean oil at...     

Artificial Groundwater Recharge Zones Mapping Using Remote Sensing and GIS: A Case Study in Indian Punjab

Artificial groundwater recharge plays a vital role in sustainable management of groundwater resources. The present study was carried out to identify the artificial groundwater recharge zones in Bist Doab basin of Indian Punjab using remote sensing and geographical information system (GIS) for augmenting groundwater resources. The study area has been facing severe water scarcity due to intensive agriculture for the past few years. The thematic layers considered in the present study are: geomorphology (2004), geology (2004), land use/land cover (2008), drainage density, slope, soil texture (2000), aquifer transmissivity, and specific yield. Different themes and related features were assigned proper weights based on their relative contribution to groundwater recharge. Normalized weights were computed using the Saaty’s analytic hierarchy process. Thematic layers were integrated in ArcGIS for delineation of artificial groundwater recharge zones. The recharge map thus obtained was divided into four zones (poor, moderate, good, and very good) based on their influence to groundwater recharge. Results indicate that 15, 18, 37, and 30 % of the study area falls under “poor,” “moderate,” “good,” and “very good” groundwater recharge zones, respectively. The highest recharge potential area is located towards western and parts of middle region because of high infiltration rates caused due to the distribution of flood plains, alluvial plain, and agricultural land. The least effective recharge potential is in the eastern and middle parts of the study area due to low infiltration rate. The results of the study can be used to formulate an efficient groundwater management plan for sustainable utilization of limited groundwater resources.     

Estimation of radon exhalation rate, natural radioactivity and radiation doses in fly ash samples from Durgapur thermal power plant, West Bengal, India

Coal and its by products often contain significant amounts of radionuclides, including uranium which is the ultimate source of the radioactive gas radon. Burning of coal and the subsequent emission to the atmosphere cause the re-distribution of toxic trace elements in the environment. Due to considerable economic and environmental importance and diverse uses, the collected fly ash has become a subject of worldwide interest in recent years. In the present study, radon exhalation rate and the activity concentration of (238)U, (232)Th and (40)K radionuclides in fly ash samples from Durgapur thermal power plant (WB) have been measured by "Sealed Can technique" using LR-115 type II detectors and a low level NaI (Tl) based gamma ray spectrometer, respectively. Radon exhalation rate varied from 360.0 to 470.0 mBq m(-2)h(-1) with an average value of 406.8 mBq m(-2)h(-1). Activity concentrations of (238)U ranged from 84.8 to 126.4 Bq kg(-1) with an average value of 99.3Bqkg(-1), (232)Th ranged from 98.1 to 140.5 Bq kg(-1) with an average value of 112.9 Bq kg(-1) and (40)K ranged from 267.1 to 364.9 Bq kg(-1) with an average value of 308.9 Bq kg(-1). Radium equivalent activity obtained from activity concentrations is found to vary from 256.5 to 352.8 Bq kg(-1) with an average value of 282.5 Bq kg(-1). Absorbed gamma dose rates due to the presence of (238)U, (232)Th and (40)K in fly ash samples vary in the range 115.3-158.5 nGy h(-1) with an average value of 126.4 nGy h(-1). While the external annual effective dose rate varies from 0.14 to 0.19 mSv y(-1) with an average value of 0.15 mSv y(-1), effective dose equivalent estimated from exhalation rate varies from 42.5 to 55.2 microSv y(-1) with an average value of 47.8 microSv y(-1). Values of external hazard index H(ex) for the fly ash samples studied in this work range from 0.69 to 0.96 with a mean value of 0.77.     

Developing, designing, and testing artificial set of lithologies for soil-aquifer treatment (SAT) systems without soil, using geosynthetic materials

Conventional soil-aquifer treatment (SAT) systems comprise of natural lithological sections up to the depth of zone of saturation or dried aquifers, which through geopurification process recharge the aquifers using domestic or industrial wastewaters. Such SAT systems have low infiltration capacity and frequently face the clogging problems, which causes environment hazards in the local areas. Under this study, three artificial set of lithologies (Lithology I, Lithology II, and Lithology III) were generated without using soil. Each one meter set of lithology was generated within a transparent cylindrical pipe of diameter 15 cm. Each lithology was equipped with nonwoven geotextile and geogrid material at different levels and comprises of coarse aggregate, fine aggregate, coarse sand, medium sand, and fine sand. Use of geotextile material within the artificial lithology shows approximately 8–10 times enhancement in the filtration capacity of the tested lithologies. Municipal wastewater (after primary treatment) was used to test the Lithologies I, II, and III. Between 100–200 l of wastewater was passed through each set of lithology everyday for seven days. Different water quality parameters such as pH, turbidity, electrical conductivity, fluoride, total suspended solids, biological oxygen demand, dissolve oxygen and carbon oxygen demand, chloride, and manganese were analyzed before and after passing through the lithologies everyday. One meter set of artificial lithologies have successfully reduced the concentration of measured water quality parameters between 60 and 93 %, without clogging. Lithology III equipped with superficial fine sand layer and two set of nonwoven geotextile has successfully removed 70–93 % concentration of wastewater. This study aims to demonstrate that a SAT system equipped with geotextile and without soil is more effective then the prevailing SAT systems. Study also proposed designs of SAT systems, which can be formed at unfavorable sites using abundant dry wells in which artificial set of lithologies can be used.     

Overview of non-hazardous solid waste in the small island state of Mauritius

In Mauritius, solid waste disposal has been a cause for concern since the 1980s. Currently, there is no segregation of waste and some 1200 tonnes of solid waste are generated daily by the 1.24 million inhabitants of the island. As processes such as recycling and composting are still in their infancy stage, most of the waste generated have to be disposed of at the sole landfill. The solid waste management practices of 1980s and early 1990s are no longer compatible with the changing composition and quantity of wastes now generated. As a result, there is an urgency to review the whole waste management system and come forward with sustainable solutions.This paper presents an overview of the disposal of non-hazardous solid waste in Mauritius and provides recommendations for improving the current disposal system.     

Studies on oxidative stress induced nerve conduction deficits in cigarette smokers

An important role of oxidative stress for the development of vascular and neurological complications has encouraged us to undertake a study to assess the oxidative stress induced nerve conduction deficits among cigarette smokers. Eighteen regular male cigarette smokers and twenty nine male non-smokers were diagnosed for clinical neuro-physiological tests viz., motor and sensory nerve conduction velocity (MNCV and SNCV) and redox status. Significant depletion of reduced glutathione (GSH) level (p < 0.05) and significant increase in malondialdehyde (MDA) level (p < 0.01) was found in smokers compared to non-smokers. Motor and sensory nerve conduction velocity showed no significant difference among smokers compared to non-smokers. The present study shows that smoking can induce oxidative stress among smokers but could not exacerbate to nerve conduction deficits.     

Multi-route risk assessment from trihalomethanes in drinking water supplies

The USA is entering an era of energy diversity, and increasing nuclear capacity and concerns focus on accidents, security, waste, and pollution. Physical buffers that separate outsiders from nuclear facilities often support important natural ecosystems but may contain contaminants. The US Nuclear Regulatory Commission (NRC) licenses nuclear reactors; the applicant provides environmental assessments that serve as the basis for Environmental Impact Statements developed by NRC. We provide a template for the types of information needed for safe siting of nuclear facilities with buffers in three categories: ecological, fate and transport, and human health information that can be used for risk evaluations. Each item on the lists is an indicator for evaluation, and individual indicators can be selected for specific region. Ecological information needs include biodiversity (species, populations, communities) and structure and functioning of ecosystems, habitats, and landscapes, in addition to common, abundant, and unique species and endangered and rare ones. The key variables of fate and transport are sources of release for radionuclides and other chemicals, nature of releases (atmospheric vapors, subsurface liquids), features, and properties of environmental media (wind speed, direction and atmospheric stability, hydraulic gradient, hydraulic conductivity, groundwater chemistry). Human health aspects include receptor populations (demography, density, dispersion, and distance), potential pathways (drinking water sources, gardening, fishing), and exposure opportunities (lifestyle activities). For each of the three types of information needs, we expect that only a few of the indicators will be applicable to a particular site and that stakeholders should agree on a site-specific suite.