N-甲基咪唑配体络合金属Cu(I)催化剂对水中2,4-二甲氧基溴苯还原脱溴

合成了以N-甲基咪唑为配体,Cu为活性中心的络合金属多相催化剂Cu(I)-NHC-SBA-15。通过1H-NMR、13CNMR、有机元素分析和FTIR对各步合成反应产物结构经行了鉴定;用SEM、N2吸附脱附等方法对催化剂进行了表征;用ICP测定了催化剂Cu含量。对催化剂催化2,4-二甲氧基溴苯还原脱溴活性进行了测试。在反应时间为24 h,通过正交实验和单因素实验,考察了催化剂用量、反应温度、还原剂用量等因素对脱溴率的影响,并确定了最佳反应条件:催化剂用量为0.05 g、水合肼用量为2 m L、反应温度为80℃,脱溴效果较好,脱溴率达到98.5%。对催化剂重复使用进行了初步研究。对催化反应动力学进行了初步研究,结果表明,该多相催化反应是由表面反应速度控制,并符合一级动力学反应。对反应机理进行了初步探讨。     

低浓度挥发酚在实验室内的质量控制

在环境监测中,低浓度的挥发酚在实验室内质量控制应采取以下措施:空白实验值的测定,检测限的确定,空白实验的质量控制图,校准曲线的检验和标准样品的测定.     

A 1-dodecanethiol-based phase transfer protocol for the highly efficient extraction of noble metal ions from aqueous phase

A 1-dodecanethiol-based phase-transfer protocol is developed for the extraction of noble metal ions from aqueous solution to a hydrocarbon phase, which calls for first mixing the aqueous metal ion solution with an ethanolic solution of 1-dodecanethiol, and then extracting the coordination compounds formed between noble metal ions and 1-dodecanethiol into a non-polar organic solvent. A number of characterization techniques, including inductively coupled plasma atomic emission spectroscopy, Fourier transform infrared spectroscopy, and thermogravimetric analysis demonstrate that this protocol could be applied to extract a wide variety of noble metal ions from water to dichloromethane with an efficiency of > 96%, and has high selectivity for the separation of the noble metal ions from other transition metals. It is therefore an attractive alternative for the extraction of noble metals from water, soil, or waste printed circuit boards.     

Monitoring and risk assessment of pesticide residue in plant-soil-groundwater systxem about medlar planting in Golmud

Environmental Science and Pollution Research - Farm worker and consumers are vulnerable to the potentially toxic pesticides accumulated in the environment and food. Nonetheless, few studies have...     

Enhanced photoelectrocatalytic degradation of ammonia by in situ photoelectrogenerated active chlorine on TiO2 nanotube electrodes

TiO_2 nanotube(Ti NT) electrodes anodized in fluorinated organic solutions were successfully prepared on Ti sheets. Field-emission scanning electron microscopy(FE-SEM) and X-ray diffraction(XRD) were performed to characterize the TiNT electrodes. The linear voltammetry results under irradiation showed that the TiNT electrode annealed at 450°C presented the highest photoelectrochemical activity. By combining photocatalytic with electrochemical process, a significantly synergetic effect on ammonia degradation was observed with Na_2SO_4 as supporting electrolyte at pH 10.7. Furthermore, the photoelectrocatalytic efficiency on the ammonia degradation was greatly enhanced in presence of chloride ions without the limitation of pH. The degradation rate was improved by 14.8 times reaching 4.98 × 10~(-2) min~(-1) at pH 10.7 and a faster degradation rate of 6.34 × 10~(-2) min~(-1)was obtained at pH 3.01. The in situ photoelectrocatalytic generated active chlorine was proposed to be responsible for the improved efficiency. On the other hand, an enhanced degradation of ammonia using TiNT electrode fabricated in fluorinated organic solution was also confirmed compared to TiNT electrode anodized in fluorinated water solution and TiO_2 film electrode fabricated by sol–gel method. Finally, the effect of chloride concentration was also discussed.     

富集因子法中参比元素的选取方法——以元江底泥中重金属污染评价为例

富集因子法中参比元素的选择对目标元素富集程度评价及源解析结果有至关重要的影响,盲目选用可能会导致偏颇或错误的结论,但目前鲜有针对参比元素的选择所进行的探讨.本文以元江沉积物中重金属元素污染水平评价及来源解析为例,详细介绍了运用顺序提取法、相关分析法、聚类分析法等化学分析和数理统计相结合并联系研究区域地球化学背景、产业分布及元素特性确定参比元素的方法.并采用所选出的参比元素进行富集因子法分析,将所得重金属污染等级评价结果及重金属来源的推论与地积累指数法对重金属污染等级评价的结果和以因子分析法对重金属溯源的推论相比较.结果表明,利用相关分析和顺序提取等方法选择参比元素是可靠可行的.     

粗媒体颗粒流化床半干法烟气脱硫

开发了粗媒体颗粒流化床半干法烟气脱硫技术。在流化床内加入惰性粗媒体颗粒，改善脱硫剂与烟气的接触。延长脱硫剂在床内的停留时间，促进脱硫反应进行，提高脱硫效率和脱硫剂利用率。以工业用石灰石为脱硫剂，实验研究了粗媒体颗粒的加入量及其他操作条件对此过程脱硫效率的影响。结果表明：随着粗媒体颗粒粒径减小及床内加入量增加，烟气脱硫效率提高；随着Ca／S增大、饱和接近度降低、空速及脱硫剂颗粒粒径减小，脱硫效率提高。当粗媒体颗粒的静止床高为122mm，饱和接近度为15～18℃、空速为2850h^-1、钙硫比为1．0—1．1、脱硫剂粒径为64μm时，脱硫效率可达90％以上。     

非平衡放电等离子体治理有害气体

重点分析了常温常压下非平衡放电等离子体产生的条件及其物理和化学性能，综合评述了放电技术的理烟气中有害气体ＳＯ２，ＮＯｘ，ＣＯ２的机理和研究现状。     

固定化微生物在废水处理中的应用

固定化微生物技术是一种有效的废水生物处理技术 ,与普通生物处理法相比有许多优点。本文对固定化微生物技术、微生物的固定化方法、固定化载体及固定化技术在废水处理中的应用及研究进展状况进行了综述 ,并对其以后的发展作了探讨     

利用烧结处理废旧电池的工艺研究

对利用烧结处理废旧电池的工艺进行了试验研究.结果表明,在焙烧温度为400℃、时间为90 min时,汞的去除率可达99%以上;在焙烧温度为1100℃、时间为90 min时,脱锌率可达到95%;将除汞除锌后的电池样添加到烧结原料中,其量为1%时,对烧结矿质量基本没有影响,说明该技术处理废旧电池是可行的,可为我国废旧电池的处理和利用开辟一条新的途径.