铁改性海泡石除锑的影响因素研究

选择廉价海泡石, 用氯化铁对其改性。研究铁改性海泡石对锑的吸附特性。结果表明,氯化铁浓度、吸附时间、初始锑浓度以及温度等因素对锑的吸附影响较大,溶液初始pH影响不明显。在初始锑浓度50 mg/L,pH 6.8,5%氯化铁改性海泡石投加量为2 g/L,吸附90 min, 温度35℃下,吸附量可达21.6 mg/g。海泡石对吸附锑具有缓冲特性,溶液的初始pH值在3.1～10.1范围时,吸附后溶液的最终pH值为8～8.5。IMS吸附锑是放热过程。改性后海泡石比表面积增大,表面羟基数量增加,导致其吸附能力增强。通过XRD谱图并未发现铁晶体的存在。     

微生物絮凝剂改善城市污水厂浓缩污泥脱水性能的研究

采用酱油曲霉(Aspergillus sojae)产生的微生物絮凝剂(MBF)作为污泥絮凝脱水剂,对城市污水处理厂浓缩污泥进行调理,确定该絮凝剂对浓缩污泥脱水的处理工艺参数为：微生物絮凝液最佳投加体积为6%～8%（体积比）,发挥絮凝作用的最适污泥温度为28～32℃,最适pH为6～7。经微生物絮凝剂调理的污泥在3 000 r/min离心9 min,污泥脱水率高达82.7%,滤饼含水率降低至77.3%,污泥脱水后体积减至原来的1/5左右。     

脉冲电晕反应器结构对乙硫醇消除效果的影响

研究了脉冲电晕等离子体反应器结构的变化对乙硫醇消除效果的影响规律。结果表明,在反应器内设置折流板,可以增加气流的湍动程度,有利于活性粒子与污染物的充分接触,从而提高消除率。高压电极间距对电晕区范围及消毒效果有较大影响,间距较小将导致各电极产生的电场相互干扰明显,消除率减小;而电极间距过大,虽然电极间电场分布相互干扰小,但是反应器内可排布的电极数减少,总电晕区减少,消除率也减小。根据实验结果,电极间距设置为50 mm比较合理。另外,在相同的电场强度和脉冲频率下,毛刺形高压电极比线电极结构能耗低,能量利用率高。     

三氯生在碳纳米管上的吸附

药品和个人护理用品(PPCPs)已成为一个引起广泛关注的新的环境问题。采用碳纳米管（CNTs）对水溶液中的三氯生进行吸附处理,考察了碳纳米管粒径及用量、温度、pH、振荡时间等因素对三氯生去除率的影响。研究结果表明,碳纳米管能快速吸附水中的三氯生,粒径较小的碳纳米管可获得较高的三氯生去除率;低温有利于吸附反应的进行;pH在6.5～7.0时,三氯生的去除率可达97%。三氯生在碳纳米管上的吸附可以很好地用Langmuir和Freundlich吸附等温方程进行描述。     

Composting clam processing wastes in a laboratory- and pilot-scale in-vessel system

Waste materials from the clam processing industry (offal, shells) have several special characteristics such as a high salinity level, a high nitrogen content, and a low C/N ratio. The traditional disposal of clam waste through landfilling is facing the challenges of limited land available, increasing tipping fees, and strict environmental and regulatory scrutiny. The aim of this work is to investigate the performance of in-vessel composting as an alternative for landfill application of these materials. Experiments were performed in both laboratory-scale (5L) and pilot-scale (120L) reactors, with woodchips as the bulking agent. In the laboratory-scale composting test, the clam waste and woodchips were mixed in ratios from 1:0.5 to 1:3 (w/w, wet weight). The high ratios resulted in a better temperature performance, a higher electrical conductivity, and a higher ash content than the low-ratio composting. The C/N ratio of the composts was in the range of 9:1-18:1. In the pilot-scale composting test, a 1:1 ratio of clam waste to woodchips was used. The temperature profile during the composting process met the US Environmental Protection Agency sanitary requirement. The final cured compost had a C/N ratio of 14.6, with an ash content of 167.0+/-14.1g/kg dry matter. In addition to the major nutrients (carbon, nitrogen, calcium, magnesium, phosphorus, potassium, sulfur, and sodium), the compost also contained trace amounts of zinc, manganese, copper, and boron, indicating that the material can be used as a good resource for plant nutrients.     

The Shape Memory Properties of Biodegradable Chitosan/Poly(l-lactide) Composites

The shape memory behavior of PLLA (poly(l-lactide)) and chitosan/PLLA composites was studied. PLLA and chitosan were compounded to fabricate novel materials which may have biodegradability and biocompatibility. Chitosan does not significantly affect the glass and melting transition temperature of the PLLA. Both the pure PLLA and chitosan/PLLA composites showed shape memory effect arising from the viscoelastic properties of PLLA comprised of semi crystalline structures. The shape recovery ratio of the chitosan/PLLA composites decreased significantly with increasing chitosan contents due to the incompatibility between PLLA and chitosan. Phase separation structures of the composites were observed by using atomic force microscopy. To obtain good shape memory effect, the chitosan content should be below 15 wt%.     

有毒气体危害区域划分之临界浓度标准研究

通过研究毒物伤害准则进而界定有毒气体危害浓度,对有毒气体泄漏扩散后的危害区域进行分级划分,以采取相应的防护措施,最大限度的即时有效的减轻有毒气体对人员的伤害.最后,以氯为例,对比其在不同伤害准则下危害区域划分临界浓度标准值,数值差别较大,因此在使用时应根据实际情况加以判断,选择最适当的标准来划分危害区域.