Scenario-based assessment and multi-objective optimization of urban development plan with carrying capacity of water system

• Impact of urban development on water system is assessed with carrying capacity. • Impacts on both water resource quantity and environmental quality are involved. • Multi-objective optimization revealing system trade-off facilitate the regulation. • Efficiency, scale and structure of urban development are regulated in two stages. • A roadmap approaching more sustainable development is provided for the case city. Environmental impact assessments and subsequent regulation measures of urban development plans are critical to human progress toward sustainability, since these plans set the scale and structure targets of future socioeconomic development. A three-step methodology for assessing and optimizing an urban development plan focusing on its impacts on the water system was developed. The methodology first predicted the pressure on the water system caused by implementation of the plan under distinct scenarios, then compared the pressure with the carrying capacity threshold to verify the system status; finally, a multi-objective optimization method was used to propose regulation solutions. The methodology enabled evaluation of the water system carrying state, taking socioeconomic development uncertainties into account, and multiple sets of improvement measures under different decisionmaker preferences were generated. The methodology was applied in the case of Zhoushan city in South-east China. The assessment results showed that overloading problems occurred in 11 out of the 13 zones in Zhoushan, with the potential pressure varying from 1.1 to 18.3 times the carrying capacity. As a basic regulation measure, an environmental efficiency upgrade could relieve the overloading in 4 zones and reduce 9%‒63% of the pressure. The optimization of industrial development showed that the pressure could be controlled under the carrying capacity threshold if the planned scale was reduced by 24% and the industrial structure was transformed. Various regulation schemes including a more suitable scale and structure with necessary efficiency standards are provided for decisionmakers that can help the case city approach a more sustainable development pattern.     

Biological conversion pathways of sulfate reduction ammonium oxidation in anammox consortia

• The SRAO phenomena tended to occur only under certain conditions. • High amount of biomass and non-anaerobic condition is requirement for SRAO. • Anammox bacteria cannot oxidize ammonium with sulfate as electron acceptor. • AOB and AnAOB are mainly responsible for ammonium conversion. • Heterotrophic sulfate reduction mainly contributed to sulfate conversion. For over two decades, sulfate reduction with ammonium oxidation (SRAO) had been reported from laboratory experiments. SRAO was considered an autotrophic process mediated by anammox bacteria, in which ammonium as electron donor was oxidized by the electron acceptor sulfate. This process had been attributed to observed transformations of nitrogenous and sulfurous compounds in natural environments. Results obtained differed largely for the conversion mole ratios (ammonium/sulfate), and even the intermediate and final products of sulfate reduction. Thus, the hypothesis of biological conversion pathways of ammonium and sulfate in anammox consortia is implausible. In this study, continuous reactor experiments (with working volume of 3.8L) and batch tests were conducted under normal anaerobic (0.2≤DO<0.5 mg/L) / strict anaerobic (DO<0.2 mg/L) conditions with different biomass proportions to verify the SRAO phenomena and identify possible pathways behind substrate conversion. Key findings were that SRAO occurred only in cases of high amounts of inoculant biomass under normal anaerobic condition, while absent under strict anaerobic conditions for same anammox consortia. Mass balance and stoichiometry were checked based on experimental results and the thermodynamics proposed by previous studies were critically discussed. Thus anammox bacteria do not possess the ability to oxidize ammonium with sulfate as electron acceptor and the assumed SRAO could, in fact, be a combination of aerobic ammonium oxidation, anammox and heterotrophic sulfate reduction processes.     

Muskox status,recent variation,and uncertain future

Ambio - Muskoxen (Ovibos moschatus) are an integral component of Arctic biodiversity. Given low genetic diversity, their ability to respond to future and rapid Arctic change is unknown, although...     

Circumpolar status of Arctic ptarmigan: Population dynamics and trends

Rock ptarmigan (Lagopus muta) and willow ptarmigan (L. lagopus) are Arctic birds with a circumpolar distribution but there is limited knowledge about their status and trends across their circumpolar distribution. Here, we compiled information from 90 ptarmigan study sites from 7 Arctic countries, where almost half of the sites are still monitored. Rock ptarmigan showed an overall negative trend on Iceland and Greenland, while Svalbard and Newfoundland had positive trends, and no significant trends in Alaska. For willow ptarmigan, there was a negative trend in mid-Sweden and eastern Russia, while northern Fennoscandia, North America and Newfoundland had no significant trends. Both species displayed some periods with population cycles (short 3–6 years and long 9–12 years), but cyclicity changed through time for both species. We propose that simple, cost-efficient systematic surveys that capture the main feature of ptarmigan population dynamics can form the basis for citizen science efforts in order to fill knowledge gaps for the many regions that lack systematic ptarmigan monitoring programs.

     

New Metal Emission Patterns in Road Traffic Environments

The increased awareness of traffic as a major diffuse metal emission source emphasizes the need for more detailed information on the various traffic-related sources and how and where the metals are dispersed. In this study, metal emission patterns in the road traffic environment were examined from the perspective of different surrounding factors, e.g. the importance of intersections, deceleration, vehicle speed and traffic density. A total of 148 topsoil samples from 18 south Swedish roads were analysed (using GFAAS) for traffic-emitted metals, i.e. Cd, Cr, Cu, Ni, Pb, Sb and Zn. The roadside topsoil metal concentrations were used to examine correlations between metals and surrounding factors. The studied metals were divided into three groups corresponding to different emission sources: metals from decelerating activities (Cu, Sb and Zn), metals as historical residues from the combustion of petrol (Pb and Cd), and non-source-specific metals (Cr and Ni). It was found that Cu and Sb, despite their rather short history as traffic-emitted metals, have increased more than eightfold in roadside soils compared to background levels. The major source of road traffic related Cu and Sb is brake linings. The significant increase of Cu and Sb in roadside topsoil stresses the need for metal transport studies as well as effect studies of these metals. Metals emitted due to decelerating activities were not correlated to elevated concentrations near road junctions. Emission patterns of traffic-related metals alongside roads are crucial in order to be able to evaluate the optimal localization of storm water treatment ponds.     

Comparison of 24 h averaged VOC monitoring results for residential indoor and outdoor air using Carbopack X-filled diffusive samplers and active sampling--a pilot study

Analytical results obtained by thermal desorption GC/MS for 24 h diffusive sampling of 11 volatile organic compounds (VOCs) are compared with results of time-averaged active sampling at a known constant flow rate. Air samples were collected with co-located duplicate diffusive sampling tubes and one passivated canister. A total of eight multiple-component sampling events took place at fixed positions inside and outside three private homes. Subsequently, a known amount of sample air was transferred from the canister to an adsorbent tube for analysis by thermal desorption GC/MS. Results for the 11 most prevalent compounds--Freon 11, 1,3-butadiene, benzene, toluene, tetrachloroethene, ethylbenzene, m,p-xylene, o-xylene, 4-ethyltoluene, 1,3,5-trimethylbenzene, and p-dichlorobenzene--show that the ratio of average study values (diffusive sampling to active sampling) is 0.92 with 0.70 and 1.14 extreme ratios. Absolute percent difference for duplicate samples using diffusive sampling was <10% for the four most prevalent compounds. Agreement between the two sampling approaches indicates that the prediction of approximately constant diffusive sampling rates based on previous laboratory studies is valid under the field conditions.     

SAOZ measurements of NO2 at Aberystwyth

We present in this paper fifteen years' measurements, from March 1991 to September 2005, of stratospheric NO2 vertical columns measured by a SAOZ zenith-sky visible spectrometer. The instrument spent most of its time at Aberystwyth, Wales, with occasional excursions to other locations. The data have been analysed with the WinDOAS analysis program with low-temperature high-resolution NO2 cross-sections and fitting a slit function to each spectrum. Because of a change in detector in May 1998 there is some uncertainty about the relative changes before and after this date, which are partially constrained by the results of an intercomparison exercise. However, the effect of the Mt Pinatubo aerosol cloud is very evident in the data from 1991-94, with a decrease of 10% in NO2 in the summer of 1992 (the SAOZ was located in Lerwick, Scotland during the winter of 1991-92 and observed very low NO2 values but these cannot be directly compared to the Aberystwyth data). To focus more on interannual and long-term variations in NO2, a seasonal variation comprising an annual and semi-annual component was fitted to the morning and evening twilight separately from 1995 to the present. This fit yielded average NO2 columns of 4.08 x 10(15) cm(-2) and 2.68 x 10(15) cm(-2) for the evening and morning twilight, respectively, with a corresponding annual amplitude of +/-2.08 x 10(15) cm(-2) and +/-1.50 x 10(15) cm(-2). Departures from the fitted curve show a trend of 6% per decade, consistent with that reported elsewhere, for the period 1998-2003, but in the past two years a distinct interannual variation of amplitude of approximately 8% has emerged.     

Determination of Steroid Estrogens in Wastewater Treatment Plant of A Controceptives Producing Factory

Steroid estrogens such as estrone (E1), 17β-estradiol (E2), estriol (E3), and 17α-ethynylestradiol (EE2) have been suspected to be the main contaminants, which can affect the endocrine system of animals. Many authors have investigated these chemicals in the domestic wastewater treatment plants (WTP). However, wastewater from industries producing steroid contraceptives has not got ample attention. From the environmental point of view, the four steroids are very significant because even very low concentrations (ng/L) can cause reproductive disturbances in human, livestock and wildlife. The main purpose of the present investigation was to develop an analytical method for the determination of the four steroid estrogens present in WTP of a pharmacy factory, mainly producing contraceptive medicine in Beijing, China. Analysis was performed by solid-phase extraction (SPE) system and liquid chromatography combined with tandem mass spectrometry (LC/MS/MS). The average recoveries from effluent samples ranged from 88% to 103% and the precision of the method ranged from 9% to 4%. Based on 0.5-L wastewater samples, the limit of quantification (LOQ) was determined at 0.7 ng/L for E1, 0.8 for E2, 0.9 ng/L for E3, and 0.5 ng/L for EE2 in influent, and 1.0 ng/L for E2 and EE2, and 2.0 ng/L for E1 and E3 in effluent. In the influent samples, average concentrations of 80, 85, 73 and 155 ng/L were determined for E1, E2, E3 and EE2, respectively, showing that they were removed in this WTP to the extent of 79, 73, 85 and 67%, respectively.     

Comparative Metal Distribution in Hair of Pakistani and Libyan Population and Source Identification by Multivariate Analysis

Using nitric acid-perchloric acid wet digestion based FAAS method ten selected metals (Cd, Co, Cr, Fe, K, Mn, Na, Ni, Pb and Zn) were determined in the scalp hair of male Pakistani and Libyan donors (n = 62), between 3–54 years age and residing in typical urban areas. The study was taken up to identify sources of metal distribution in two diverse population segments exposed to different environments. Sodium emerged with the highest mean hair concentration of 511.0 μg/g and 496.9 μg/g for Libyan and Pakistani donors respectively, followed by K, at 266.2 μg/g and 242.4 μg/g for the two donor categories. Cadmium showed the lowest mean hair concentration for both Pakistani (0.380 μg/g) and Libyan (0.530 μg/g) donors. Levels of Na, K, Pb, Cr and Cd were higher in hair of Libyan donors compared with Pakistani counterparts which showed higher comparative levels of Zn, Fe, Co, Ni and Mn. Strong metal-to-metal correlations were found between Na–K (r = 0.638) and Cd–Co (r = 0.574) for Pakistani donors, while for Libyan donors, Na–K (r = 0.680) and Fe–Mn (r = 0.624) correlations emerged as strongly significant. Only K was found to have a strong positive correlation (r = 0.611) with age for Pakistani donors while this correlation was significantly negative (r = −0.500) for Libyan donors, probably arising from individual food habits. Other metals showed no viable relationship with age. Principal Component Analysis (PCA) and Cluster Analysis (CA) of the data evidenced food, industrial emissions and automobile emissions as possible sources of metal distribution. The results of the present study are compared with those reported for subjects from other regions of the world.     

Kinetics and thermodynamic studies of Methyl Orange removal by polyvinylidene fluoride-PEDOT mats

We report the preparation of poly(3,4-ethylene dioxythiophene) (PEDOT)-modified polyvinylidene fluoride electrospun fibers and their use as a novel adsorbent material for the removal of the anionic dye Methyl Orange (MO) from aqueous media. This novel adsorbent material can be used to selectively remove MO on a wide pH range (3.0–10.0), with a maximum capacity of 143.8 mg/g at pH 3.0. When used in a recirculating filtration system, the maximum absorption capacity was reached in a shorter time (20 min) than that observed for batch mode experiments (360 min). Based on the analyses of the kinetics and adsorption isotherm data, one can conclude that the predominant mechanism of interaction between the membrane and the dissolved dye molecules is electrostatic. Besides, considering the estimated values for the Gibbs energy, and entropy and enthalpy changes, it was established that the adsorption process is spontaneous and occurs in an endothermic manner. The good mechanical and environmental stability of these membranes allowed their use in at least 20 consecutive adsorption/desorption cycles, without significant loss of their characteristics. We suggest that the physical-chemical characteristics of PEDOT make these hybrid mats a promising adsorbent material for use in water remediation protocols and effluent treatment systems.