Determination of biomass burning emission factors: Methods and results

Biomass burning, in a broad sense, encompasses different burning practices, including open and confined burnings, and different types of vegetation. Emission factors of gaseous or particulate trace compounds are directly dependent both on the fuel type and the combustion process. Emission factors are generally calculated by stoichiometric considerations using the carbon mass balance method, applied either to combustion chamber experiments or to field experiments based on ground-level measurements or aircraft sampling in smoke plumes. There have been a number of experimental studies in the last 10 years to investigate wildfires in tropical, temperate, or boreal regions. This article presents an overview of measurement methods and experimental data on emission factors of reactive or radiatively active trace compounds, including trace gases and particles. It focuses on fires in tropical regions, that is, forest and savanna fires, agricultural burns, charcoal production, use of fuelwood, and charcoal combustion.     

Effects of exposure of aquatic snails to sublethal concentrations of waste drilling fluid

Static bioassays were carried out using two aquatic snails (Pilia sp. and Lanistes sp.) as test organisms in soft natural dilution water, with waste drilling fluid as the test material, at 28±2°C. Comparison of results for the control and different concentrations of the waste drilling fluid were made by means of the F-statistic method. The waste drilling fluid was practically non-toxic to the two aquatic snails.     

Sampling Benthic Macroinvertebrates in a Large Flood-Plain River: Considerations of Study Design, Sample Size, and Cost

Estimation of benthic macroinvertebrate populations over large spatial scales is difficult due to the high variability in abundance and the cost of sample processing and taxonomic analysis. To determine a cost-effective, statistically powerful sample design, we conducted an exploratory study of the spatial variation of benthic macroinvertebrates in a 37 km reach of the Upper Mississippi River. We sampled benthos at 36 sites within each of two strata, contiguous backwater and channel border. Three standard ponar (525 cm²) grab samples were obtained at each site ('Original Design'). Analysis of variance and sampling cost of strata-wide estimates for abundance of Oligochaeta, Chironomidae, and total invertebrates showed that only one ponar sample per site ('Reduced Design') yielded essentially the same abundance estimates as the Original Design, while reducing the overall cost by 63%. A posteriori statistical power analysis ( = 0.05, = 0.20) on the Reduced Design estimated that at least 18 sites per stratum were needed to detect differences in mean abundance between contiguous backwater and channel border areas for Oligochaeta, Chironomidae, and total invertebrates. Statistical power was nearly identical for the three taxonomic groups. The abundances of several taxa of concern (e.g., Hexagenia mayflies and Musculium fingernail clams) were too spatially variable to estimate power with our method. Resampling simulations indicated that to achieve adequate sampling precision for Oligochaeta, at least 36 sample sites per stratum would be required, whereas a sampling precision of 0.2 would not be attained with any sample size for Hexagenia in channel border areas, or Chironomidae and Musculium in both strata given the variance structure of the original samples. Community-wide diversity indices (Brillouin and 1-Simpsons) increased as sample area per site increased. The backwater area had higher diversity than the channel border area. The number of sampling sites required to sample benthic macroinvertebrates during our sampling period depended on the study objective and ranged from 18 to more than 40 sites per stratum. No single sampling regime would efficiently and adequately sample all components of the macroinvertebrate community.     

Characterization of microbial communities from coastal waters using microarrays

Molecular methods, including DNA probes, were used to identify and enumerate pathogenic Vibrio species in the Chesapeake Bay; our data indicated that Vibrio vulnificus exhibits seasonal fluctuations in number. Our work included a characterization of total microbial communities from the Bay; development of microarrays that identify and quantify the diversity of those communities; and observation of temporal changes in those communities. To identify members of the microbial community, we amplified the 16S rDNA gene from community DNA isolated from a biofilm sample collected from the Chesapeake Bay in February, 2000. The resultant 75 sequences were 95% or more similar to 7 species including two recently described Shewanella species, baltica and frigidimarina, that have not been previously isolated from the Chesapeake. When the genera of bacteria from biofilm after culturing are compared to those detected by subcloning amplified 16S fragments from community DNA, the cultured sample exhibited a strong bias. In oysters collected in February, the most common bacteria were previously unknown. Based on our 16S findings, we are developing microarrays to detect these and other microbial species in these estuarine communities. The microarrays will detect each species using four distinct loci, with the multiple loci serving as an internal control. The accuracy of the microarray will be measured using sentinel species such as Aeromonas species, Escherichia coli, and Vibrio vulnificus. Using microarrays, it should be possible to determine the annual fluctuations of bacterial species (culturable and non-culturable, pathogenic and non-pathogenic). The data may be applied to understanding patterns of environmental change; assessing the health of the Bay; and evaluating the risk of human illness associated with exposure to and ingestion of water and shellfish.     

Measurements of Ozone Concentrations in Zagreb

Ozone concentrations were measured in Zagreb at four sites from May 1999 to April 2001 in order to categorize the air quality with respect to ozone. In the summer of 2000, the ozone measurements were also extended to four sites in the suburbs of Zagreb. Methods of active and passive sampling with nitrite ion as a reagent were used. In the northern part of the town ozone was analyzed by an automatic device. Automatic device measurements in the years 1999 and 2000 showed that hourly averages of ozone concentrations did not exceed the Croatian recommended value of the 98th percentile (180 g m^–3). Over the two-year period, 24-h averages occasionally exceed 110 g m^–3 in city center and in the northern part of the town. Regardless of these isolated examples, ozone was well within acceptable concentrations. Ozone concentrations measured in summer 2000 were higher in the suburbs of Zagreb than in the city. The 98th percentile values higher than 110 g m^–3 were recorded at three sites.     

Spatial contaminant heterogeneity: quantification with scale of measurement at contrasting sites

Material within the terrestrial environment is rarely homogeneously distributed, either spatially or temporally. One consequence of heterogeneity is that uncertainty is usually generated in measurements that are taken with the aim of characterising the environment. For example, a measurement of analyte concentration within soil taken from one sampling location on contaminated land can vary substantially when compared against another sample taken at effectively the same nominal location. The measurement uncertainty arising from the heterogeneity can substantially limit the reliability of the interpretations made upon environmental investigations. The sampling uncertainty usually outweighs the analytical uncertainty from the laboratory, often by a factor of 20 or more. One approach to reducing the uncertainty is to design a more suitable sampling strategy. This might be achieved by predicting the degree of heterogeneity prior to the investigation, but this is often difficult to achieve accurately. Another approach, which was investigated here, is to actually characterise the heterogeneity prior to the main investigation using rapid and inexpensive technology, such as in situ measurement techniques. In situ portable X-ray fluorescence (PXRF) and X-ray microprobe (XMP) techniques were employed to test the feasibility of this approach. Two contrasting contaminated land sites were chosen to characterise the two-dimensional spatial heterogeneity of heavy metal contamination in topsoil at a range of scales (50 m to 0.001 m). The spatial heterogeneity of contaminants, expressed as relative standard deviations, was found to differ between the two sites by a factor of two, largely due to the mode of deposition of pollution. The study also indicated that the heterogeneity did not change systematically with the scale of measurement between sampling locations at either site.     

Total versus inhalable sampler comparison study for the determination of asphalt fume exposures within the road paving industry

Exposure to asphalt fumes has a threshold limit value (TLV of 0.5 mg m(-3) (benzene extractable inhalable particulate) as recommended by the American Conference of Governmental Industrial Hygienists (ACGIH). This reflects a recent change (2000) whereby two variables are different from the previous recommendation. First is a 10-fold reduction in quantity from 5 mg m(-3) to 0.5 mg m(-3). Secondly, the new TLV specifies the "inhalable" fraction as compared to what is presumed to be total particulate. To assess the impact of these changes, this study compares the differences between measurements of paving asphalt fume exposure in the field using an "inhalable" instrument versus the historically used 'total' sampler. Particle size is also examined to assist in the understanding of the aerodynamic collection differences as related to asphalt fumes and confounders. Results show that when exposures are limited to asphalt fumes, a 1:1 relationship exists between samplers, showing no statistically significant differences in benzene soluble matter (BSM). This means that for the asphalt fume ACGIH TLV, the 'total' 37-mm sampler is an equivalent method to the "inhalable" method, referred to as IOM (Institute of Occupational Medicine), and should be acceptable for use against the TLV. However, the study found that when confounders (dust or old asphalt millings) are present in the workplace, there can be significant differences between the two samplers' reported exposure. The ratio of IOM/Total was 1.37 for milling asphalt sites, 1.41 for asphalt paving over granular base, and 1.02 for asphalt over asphalt pavements.     

The efficacy of a limestone doser to mitigate stream acidification in a Maryland coastal plain stream: Implications for migratory fish species

The objective of this two-year study was to determine the efficacy of an automated limestone slurry doser to neutralize acidic pulses and improve water quality conditions for enhancing survival of early life stages of migratory fish species in a Maryland coastal plain stream. Implications for survival of early life stages of migratory fish species such as yellow perch (Perca flavescens), white perch (Morone americana), blueback herring (Alosa aestivalis) and alewife (Alosa pseudoharengus) are discussed based on the improved chemical conditions in the dosed area of the stream. Despite problems with overdosing in 1991 and failure of the stage transducer to work properly in 1992, the doser was generally effective in neutralizing acidic pulses (pH depressions) in the stream during three major rain events in both years. Chemical conditions (pH and inorganic monomeric aluminum) reported in the non-dosed area during major rainfall events were potentially stressful to both alewife and blueback herring although neither species was reported spawning in the stream during either year. Mitigating the potential impact of acidic conditions on early life stages of important migratory fish species was not sufficient to ensure spawning. It is therefore recommended that habitat improvement measures and well designed fish stocking programs be implemented concurrently with doser operations if the goal is to create optimum spawning conditions for migratory species.     

Measurement of atmospheric concentrations of common household pesticides: A pilot study

Air concentrations of 28 of the most commonly used household pesticides were measured inside nine homes in Jacksonville, Florida, and compared with corresponding outdoor levels. The households selected were sorted into three categories according to the degree of pesticide indoor usage. Personal air monitoring was also performed on one resident of each household by means of a portable sampler, which was kept with the person at all times. Five of the pesticides were found in the air inside of the majority of the homes at concentrations as high as 15 gm^–3 (average concentrations, 12 ngm^–3 to 2.4 gm^–3). Indoor levels were generally one to two ordrrs of magnitude higher than surrounding outdoor air levels and personal air measurements were within ± 50% of corresponding indoor values. All samples were collected over 24-hr periods on polyurethane foam and analyzed by capillary colum gas chromatography with mass spectrometric and/or electron capture detection.