Estimating and comparing greenhouse gas emissions with their uncertainties using different methods: A case study for an energy supply utility

Energy supply utilities release significant amounts of greenhouse gases (GHGs) into the atmosphere. It is essential to accurately estimate GHG emissions with their uncertainties, for reducing GHG emissions and mitigating climate change. GHG emissions can be calculated by an activity-based method (i.e., fuel consumption) and continuous emission measurement (CEM). In this study, GHG emissions such as CO₂, CH₄, and N₂O are estimated for a heat generation utility, which uses bituminous coal as fuel, by applying both the activity-based method and CEM. CO₂ emissions by the activity-based method are 12–19% less than that by the CEM, while N₂O and CH₄ emissions by the activity-based method are two orders of magnitude and 60% less than those by the CEM, respectively. Comparing GHG emissions (as CO₂ equivalent) from both methods, total GHG emissions by the activity-based methods are 12–27% lower than that by the CEM, as CO₂ and N₂O emissions are lower than those by the CEM. Results from uncertainty estimation show that uncertainties in the GHG emissions by the activity-based methods range from 3.4% to about 20%, from 67% to 900%, and from about 70% to about 200% for CO₂, N₂O, and CH₄, respectively, while uncertainties in the GHG emissions by the CEM range from 4% to 4.5%. For the activity-based methods, an uncertainty in the Intergovernmental Panel on Climate Change (IPCC) default net calorific value (NCV) is the major uncertainty contributor to CO₂ emissions, while an uncertainty in the IPCC default emission factor is the major uncertainty contributor to CH₄ and N₂O emissions. For the CEM, an uncertainty in volumetric flow measurement, especially for the distribution of the volumetric flow rate in a stack, is the major uncertainty contributor to all GHG emissions, while uncertainties in concentration measurements contribute a little to uncertainties in the GHG emissions.

Implications:Energy supply utilities contribute a significant portion of the global greenhouse gas (GHG) emissions. It is important to accurately estimate GHG emissions with their uncertainties for reducing GHG emissions and mitigating climate change. GHG emissions can be estimated by an activity-based method and by continuous emission measurement (CEM), yet little study has been done to calculate GHG emissions with uncertainty analysis. This study estimates GHG emissions and their uncertainties, and also identifies major uncertainty contributors for each method.     

添加炭基材料对蔬菜废物好氧堆肥进程和腐熟度的影响

以蔬菜废弃物辣椒秸秆和树叶为堆肥原料(CK),采用密闭式好氧堆肥工艺,研究了添加5%木本泥炭(T1)、5%活性炭(T2)和10%木本泥炭(T3)等炭基材料对堆肥p H、EC、CO2累积量、物料损失率、T值、C/N和发芽率指数的影响。结果显示,T2处理的p H在60 d后维持在8~9之间;EC值随着堆肥进行呈现先下降后升高再下降的趋势,最终CK、T1、T2和T3处理的EC值(m S/cm)分别降低了1.02、0.76、0.33和0.48;T2和T3处理的CO2累积量一直高于其他处理;所有处理的物料损失率均在20%以上;4个处理堆肥产品的T值分别为0.56、0.65、0.68和0.69;堆肥产品的发芽率指数分别为63.2%、69.3%、93.5%和86.1%。T值和发芽率指数显示T2和T3处理达到了腐熟阶段。结果表明,在蔬菜堆肥处理中添加炭基材料可改善堆肥产品的理化性质,加速堆肥物料的分解,有效地缩短堆肥周期和提高堆肥产品的腐熟度。     

A real-time monitoring and assessment method for calculation of total amounts of indoor air pollutants emitted in subway stations

Subway systems are considered as main public transportation facility in developed countries. Time spent by people in indoors, such as underground spaces, subway stations, and indoor buildings, has gradually increased in the recent past. Especially, operators or old persons who stay in indoor environments more than 15 hr per day usually influenced a greater extent by indoor air pollutants. Hence, regulations on indoor air pollutants are needed to ensure good health of people. Therefore, in this study, a new cumulative calculation method for the estimation of total amounts of indoor air pollutants emitted inside the subway station is proposed by taking cumulative amounts of indoor air pollutants based on integration concept. Minimum concentration of individual air pollutants which naturally exist in indoor space is referred as base concentration of air pollutants and can be found from the data collected. After subtracting the value of base concentration from data point of each data set of indoor air pollutant, the primary quantity of emitted air pollutant is calculated. After integration is carried out with these values, adding the base concentration to the integration quantity gives the total amount of indoor air pollutant emitted. Moreover, the values of new index for cumulative indoor air quality obtained for 1 day are calculated using the values of cumulative air quality index (CAI). Cumulative comprehensive indoor air quality index (CCIAI) is also proposed to compare the values of cumulative concentrations of indoor air pollutants. From the results, it is clear that the cumulative assessment approach of indoor air quality (IAQ) is useful for monitoring the values of total amounts of indoor air pollutants emitted, in case of exposure to indoor air pollutants for a long time. Also, the values of CCIAI are influenced more by the values of concentration of NO₂, which is released due to the use of air conditioners and combustion of the fuel. The results obtained in this study confirm that the proposed method can be applied to monitor total amounts of indoor air pollutants emitted, inside apartments and hospitals as well.

Implications: Nowadays, subway systems are considered as main public transportation facility in developed countries. Time spent by people in indoors, such as underground spaces, subway stations, and indoor buildings, has gradually increased in the recent past. Especially, operators or old persons who stay in the indoor environments more than 15 hr per day usually influenced a greater extent by indoor air pollutants. Hence, regulations on indoor air pollutants are needed to ensure good health of people. Therefore, this paper presents a new methodology for monitoring and assessing total amounts of indoor air pollutants emitted inside underground spaces and subway stations. A new methodology for the calculation of cumulative amounts of indoor air pollutants based on integration concept is proposed. The results suggest that the cumulative assessment approach of IAQ is useful for monitoring the values of total amounts of indoor air pollutants, if indoor air pollutants accumulated for a long time, especially NO₂ pollutants. The results obtained here confirm that the proposed method can be applied to monitor total amounts of indoor air pollutants emitted, inside apartments and hospitals as well.     

Physicochemical properties of chars at different treatment temperatures

In this study, the physicochemical properties of the char of Indonesian SM coal following heat treatment at various temperatures were evaluated using X-ray photoelectron spectroscopy (XPS), Fourier-transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), and morphological and specific surface area analysis. Based on these analyses, heat treatment of coal was determined to be the most effective in increasing the coal rank. In the XPS analysis, the C-O and C-O-C groups and quaternary-N species were found to be of a lower grade coal when the pretreatment temperature decreased, meanwhile the C-C group and pyridinic species increased. In the FT-IR analysis, the collapse of the C-O and C-O-C group was observed due to the collapse of the ether group. In SEM and Brunauer-Emmett-Teller (BET) analysis, a decrease in the ether group was shown to be accompanied with the formation of micropores.     

生物倍增工艺同步脱氮除磷强化途径分析

通过对生物倍增工艺处理市政污水的沿程污染物降解规律的考察表明,工艺对有机物的去除效果显著,COD和BOD5出水分别为47.80 mg/L和19.80 mg/L;氨氮去除率可达100%。发现厌氧区提前发生反硝化并一定程度上影响系统除磷效果;通过对各主要影响因素进行分析,认为低碳源的进水条件是影响系统同步脱氮除磷效果的关键因素;提出在进水口直接添加碳源以及分点进水的碳源分配＋辅助化学除磷的方式可强化氮磷去除效果。     

城市自来水中挥发性有机氯污染物检测及健康风险评价初步研究

水质安全是饮用水安全的重中之重,直接关系到人体健康。采用健康风险评价模式,对某市饮用水进行了分析和评价。研究结果表明,该市通过饮水途径引起的非致癌健康风险中四氯化碳最大,三氯甲烷次之,两者风险水平在10-5～10-6,远低于美国环境保护署推荐的最大可接受风险水平。通过饮水途径所致健康风险中,四氯乙烯所引起的致癌风险最大(1.2×10-8),但远远低于美国环境保护署推荐的通过饮水途径最大可接受风险水平(5×10-5)。根据美国环境保护署的推荐值,初步认为目前该市饮用水中挥发性有机污染物不会对人体产生明显的健康危害。     

Cadmium tolerance in six poplar species

Selection of poplar species with greater Cd tolerance and exploiting the physiological mechanisms involved in Cd tolerance are crucial for application of these species to phyto-remediation. The aim of this study is to investigate variation in Cd tolerance among the six poplar species and its underlying physiological mechanisms. Cuttings of six Populus species were cultivated for 10 weeks before exposure to either 0 or 200 μM CdSO₄ for 20 days. Gas exchange in mature leaves was determined by a portable photosynthesis system. Cd concentrations in tissues were analyzed by a flame atomic absorbance spectrometry. Subsequently, Cd amount per plant, bio-concentration factor (BCF) and translocation factor (T _f) were calculated. Nonenzymatic compounds and activities of antioxidative enzymes in tissues were analyzed spectrophotometrically. Cd exposure caused decline in photosynthesis in four poplar species including Populus cathayana (zhonghua 1). Among the six species, P. cathayana (zhonghua 1) displayed the highest Cd concentrations in tissues, the largest Cd amount in aerial parts, the highest BCF in aerial parts and T _f under Cd exposure. Under Cd stress, increases in total soluble sugars in roots but decreases in starch in roots, wood, and leaves of P. cathayana (zhonghua 1) were found. Induced O ₂ ^?? and H₂O₂ production in roots and leaves, and increases in free proline, soluble phenolics, and activities of antioxidative enzymes were observed in P. cathayana (zhonghua 1). Based on results of this pot experiment, it is concluded that P. cathayana (zhonghua 1) is superior to other five species for Cd phyto-remediation, and its well-coordinated physiological changes under Cd exposure confer the great Cd tolerance of this species.     

Bioaccessibility of polychlorinated biphenyls in workplace dust and its implication for risk assessment

Human exposure to bioaccessible PCBs via indoor dust is limited around the world. In the present study, the workplace dust sample from commercial office, hospital, secondary school, shopping mall, electronic factory and manufacturing plant were collected from Hong Kong for PCBs analyses. Total PCBs concentrations ranged from 46.8 to 249 ng g⁻¹, with a median of 107 ng g⁻¹. Manufacturing plant showed the highest concentration among all of sampling sites. PCB 77 was found as the dominant congeners. The bioaccessibility of PCBs in small intestinal juice ranging from 8.3% to 26.0% was significantly higher than that in gastric condition, ranging from 4.8% to 12.4%. In addition, significant negative correlations (p < 0.05) were observed between K_OW and bioaccessibility for all workplace dust samples. Risk assessment indicated that the averaged daily dose of dioxin-like PCBs via non-dietary intake of workplace dust, considering the bioaccessibility of PCBs, were much lower than the TDI of dioxins (2.3 pg WHO-TEQ kg bw⁻¹ d⁻¹) established by Joint FAO/WHO Expert Committee on Food Additives.     

碱预处理污泥产酸效果及其生物群落研究

为了提高污泥水解酸化过程中的挥发酸产量,获取污水脱氮除磷所需的内碳源,以深圳市罗芳污水厂的二沉池污泥为研究对象,采用不同的碱量对其进行预处理。通过测定碱预处理污泥水解酸化过程中的挥发酸浓度,并采用聚合酶链式反应-变性梯度凝胶电泳(polymerase chain reaction denature gradient gel electrophoresis,PCR-DGGE)技术对参与碱预处理污泥水解酸化产酸过程的主要微生物种群进行分析,结果表明,当碱投加量为0.20 g NaOH/g VSS时,初始溶出的蛋白浓度为1 780 mg/L;水解酸化15 d时,挥发酸总量达到3 473 mg/L;参与产酸的主要细菌属于Firmicutes、Proteobacteria、Bacteroidetes三个门类。     

Modeling of a combined ultraviolet-biofilter system to treat gaseous chlorobenzene I: model development and parametric sensitivity

A new type of a combined ultraviolet (UV)-biofilter system for air pollution control is developed. In this paper, two conceptual mathematical submodels of the UV reactor and standalone biofilter are developed. All model parameters have been determined by independent experiments or have been taken from literature. Results from UV and the standalone biofilter submodels are in a good agreement with experimental data. However, the performance of the combined system has significantly deviated from those of the UV or standalone submodels because of the stimulating effects of UV irradiation products on the subsequent biofilter performance. A modified model that considers the stimulating effects has agreed well with experimental data over a wide range of operating conditions. Further analysis of the primary parametric sensitivity of the model has shown that inlet chlorobenzene concentrations, gas empty-bed residence time in the UV reactor, and light intensity are important operating conditions.