Performance assessment of NAPL remediation in heterogeneous alluvium

Over the last few years, more than 40 partitioning interwell tracer tests (PITTs) have been conducted at many different sites to measure nonaqueous phase liquid (NAPL) saturations in the subsurface. While the main goal of these PITTs was to estimate the NAPL volume in the subsurface, some were specifically conducted to assess the performance of remedial actions involving NAPL removal. In this paper, we present a quantitative approach to assess the performance of remedial actions to recover NAPL that can be used to assess any NAPL removal technology. It combines the use of PITTs (to estimate the NAPL volume in the swept pore volume between injection and extraction wells of a test area) with the use of several cores to determine the vertical NAPL distribution in the subsurface. We illustrate the effectiveness of such an approach by assessing the performance of a surfactant/foam flood conducted at Hill Air Force Base, UT, to remove a TCE-rich NAPL from alluvium with permeability contrasts as high as one order of magnitude. In addition, we compare the NAPL volumes determined by the PITTs with volumes estimated through geostatistical interpolation of aquifer sediment core data collected with a vertical frequency of 5-10 cm and a lateral borehole spacing of 0.15 m. We demonstrate the use of several innovations including the explicit estimation of not only the errors associated with NAPL volumes and saturations derived from PITTs but also the heterogeneity of the aquifer sediments based upon permeability estimates. Most importantly, we demonstrate the reliability of the     

Using polymer mats to biodegrade atrazine in groundwater: laboratory column experiments

Large-scale column experiments were undertaken to evaluate the potential of in situ polymer mats to deliver oxygen into groundwater to induce biodegradation of the pesticides atrazine, terbutryn and fenamiphos contaminating groundwater in Perth, Western Australia. The polymer mats, composed of woven silicone (dimethylsiloxane) tubes and purged with air, were installed in 2-m-long flow-through soil columns. The polymer mats proved efficient in delivering dissolved oxygen to anaerobic groundwater. Dissolved oxygen concentrations increased from <0.2 mg l(-1) to approximately 4 mg l(-1). Degradation rates of atrazine in oxygenated groundwater were relatively high with a zero-order rate of 240-380 microg l(-1) or a first-order half-life of 0.35 days. Amendment with an additional carbon source showed no significant improvement in biodegradation rates, suggesting that organic carbon was not limiting biodegradation. Atrazine degradation rates estimated in the column experiments were similar to rates determined in laboratory culture experiments, using pure cultures of atrazine-mineralising bacteria. No significant degradation of terbutryn or fenamiphos was observed under the experimental conditions within the time frames of the study. Results from these experiments indicate that remediation of atrazine in a contaminated aquifer may be achievable by delivery of oxygen using an in situ polymer mat system.     

Spatial characteristics of fine particulate matter: identifying representative monitoring locations in Seattle, Washington

This study investigates how PM2.5 varies spatially and how these spatial characteristics can be used to identify potential monitoring sites that are most representative of the overall ambient exposures to PM2.5 among susceptible populations in the Seattle, WA, area. Data collected at outdoor sites at the homes of participants of a large exposure assessment study were used in this study. Harvard impactors (HIs) were used at 40 outdoor sites throughout the Seattle metropolitan area. Up to six sites at a time were monitored for 10 consecutive 24-hr average periods. A fixed-effect analysis of variance (ANOVA) model that included date and location effects was used to analyze the spatial variability of outdoor PM2.5 concentrations. Both date and location effects were shown to be highly significant, explaining 92% of the variability in outdoor PM2.5 measurements. The day-to-day variability was 10 times higher than the spatial variability between sites. The site mean square was more than twice the error mean square, showing that differences between sites, while modest, are potentially an important contribution to measurement error. Variances of the model residuals and site effects were examined against spatial characteristics of the monitoring sites. The spatial characteristics included elevation, distance from arterials, and distance from major PM2.5 point sources. Results showed that the most representative PM2.5 sites were located at elevations of 80-120 m above sea level, and at distances of 100-300 m from the nearest arterial road. Location relative to industrial PM2.5 sources is not a significant predictor of residential outdoor PM2.5 measurements. Additionally, for sites to be representative of the average population exposures to PM2.5 among those highly susceptible to the health effects of PM2.5, areas of high elderly population density were considered. These representative spatial characteristics were used as multiple, overlapping criteria in a Geographic Information System (GIS) analysis to determine where the most representative sites are located.     

Induction of PAH-catabolism in mushroom compost and its use in the biodegradation of soil-associated phenanthrene

This paper describes the induction of phenanthrene-catabolism within Phase II mushroom compost resulting from its incubation with (1) phenanthrene, and (2) PAH-contaminated soil. Respirometers measuring mineralization of freshly added 14C-9-phenanthere were used to evaluate induction of phenanthrene-catabolism. Where pure phenanthrene (spiked at a concentration of 400 mg kg(-1) wet wt.) was used to induce phenanthrene-catabolism in compost, induction was measurable, with maximal mineralization observed after 7 weeks phenanthrene-compost contact time. Where PAH-contaminated soil was used to induce phenanthrene-catabolism in un-induced compost, induction was observed after 5 weeks soil-compost contact time. Microcosm-scale amelioration of soil contaminated with 14C-phenanthrene (aged in soil for 516 days prior to incubation with compost) indicated that both induced (using pure phenanthrene) and uninduced Phase II mushroom composts were equally able to promote degradation of this soil-associated contaminant. After 111 days incubation time, 42.7 +/- 6.3% loss of soil-associated phenanthrene was observed in the induced-compost soil mixture, while 36.7 +/- 2.9% loss of soil-associated phenanthrene was observed in the uninduced-compost soil mixture. These results are notable as they indicate that while pre-induction of phenanthrene-catabolism within compost is possible, it does not significantly increase the extent of degradation when the compost is used to ameliorate phenanthrene-contaminated soil. Thus, compost could be used directly in the amelioration of contaminated land i.e. without pre-induction of catabolism.     

Potential role of fire retardant-treated polyurethane foam as a source of brominated diphenyl ethers to the US environment

Five tetra- to hexabrominated diphenyl ether (BDE) congeners (BDE-47, -99, -100, -153 and -154) are the most frequently reported in wildlife and humans. The commercial penta-BDE product, used predominantly to flame-retard polyurethane foam, consists primarily of these same congeners. In 1999, North American demand accounted for 98% of the total global penta-market of 8500 metric tons. Frogs, housed with flame retardant-treated polyurethane foam as a dry substrate, accumulated 10,100 microg/kg (wet weight) of the above BDEs. Crickets kept therein as food contained 14,400 microg/kg. The crickets are believed to have browsed directly on the foam and, in turn, were consumed by the frogs. BDE congener composition in all three matrices matched that of the penta-commercial product. Similar congeners were also observed in soil and stream sediments collected near a polyurethane foam manufacturing plant. Summed concentrations of BDE-47, -99 and -100, the dominant congeners observed in these samples, ranged from < 1 to 132 microg/kg (dry weight basis). Sunfish fillets obtained from a nearby, off-site pond contained a total of 624 microg/kg (lipid basis). Sewage treatment plant (STP) sludge exhibited these same congeners at 1370 microg/kg (dry weight). BDE-209, the fully brominated congener predominant in the commercial deca-BDE product, was also present at 1470 microg/kg. While no known polyurethane foam manufacturers discharged to this plant, the distribution pattern of the low brominated congeners in the sludge matched that of the penta-product. After four weeks of exposure to ambient outdoor conditions, the surface of flame-retarded polyurethane foam became brittle and began to disintegrate. Subsequent dispersal of these penta-containing foam fragments may be one mechanism by which these BDEs reach the environment.     

Variation in CO2 assimilation rate induced by simulated dew waters with different sources of hydroxyl radical (*OH) on the needle surfaces of Japanese red pine (Pinus densifora Sieb. et Zucc.)

The hydroxyl radical (*OH) is generated in polluted dew on the needle surfaces of Japanese red pine (Pinus densiflora Sieb. et Zucc.). This free radical, which is a potent oxidant, is assumed to be a cause of ecophysiological disorders of declining trees on the urban-facing side of Mt. Gokurakuji, western Japan. Mists of *OH-generating N(III) (HNO2 and NO2-) and HOOH + Fe + oxalate solutions (50 and 100 microM, pH 5.1-5.4) simulating the dew water were applied to the foliage of pine seedlings grown in open-top chambers in the early morning. Needles treated with 100 microM N(III) tended to have a greater maximum CO2 assimilation rate (Amax), a greater stomatal conductance (g(s)) and a greater needle nitrogen content (Nneedle), suggesting that N(III) mist acts as a fertilizer rather than as a phytotoxin. On the other hand, needles treated with 100 microM HOOH + Fe + oxalate solution showed the smallest Amax, g(s), and Nneedle, suggesting that the combination of HOOH + Fe + oxalate caused a decrease in needle productivity. The effects of HOOH + Fe + oxalate mist on pine needles were very similar to the symptoms of declining trees at Mt. Gokurakuji.     

UV-VIS spectroscopy of 2,4,6-trinitrotoluene-hydroxide reaction

Contamination of groundwater, surface water and soil by explosives has occurred at military sites throughout the world as a result of manufacture of explosive compounds, assembly of munitions, and deployment of explosives containing devices. Due to the adverse effects of explosives on humans and other natural receptors, a low cost means of decontaminating these areas of contamination is needed. Base-induced transformation of explosives has shown promise as a rapid, low cost, and minimally resource-intensive technology for detoxifying explosives in soil and water. In order to understand the reaction mechanism, a reaction mixture of 2:1:1 (water:2,4,6-trinitrotoluene (TNT):1 N KOH) was analyzed by UV/VIS spectrometry from 190 to 1,100 nm. Time course measurements were conducted at 25, 20, 15, and 12 degrees C. A factor analysis program was used to analyze the spectral data. Principal component analysis indicated that six principal components explained the spectra to within experimental error, with four factors explaining the majority of the variance. Test spectral vectors for four components were developed, including TNT, two intermediates, and the final product, and were tested against the abstract vectors. Two possible reaction mechanisms were suggested and tested to explain the spectral data.     

Bioaccumulation and elimination of 14C-lindane by Enchytraeus albidus in artificial (OECD) and a natural soil

Bioaccumulation and elimination of 14C-lindane in Enchytraeus albidus was studied in artificial OECD soil and a silty loam from an agricultural field in Central West Portugal. Results showed that enchytraeids were able to bioaccumulate the chemical with a kinetic pattern similar to that of earthworms: fast uptake within a few days and a biphasic elimination pattern. A 10 day period to study uptake was sufficient, but a few more days were probably necessary for elimination. Bioaccumulation was influenced by soil type. The authors suggest that higher organic matter (OM) content and also the higher content on sand particles in the OECD soil may have led to a faster elimination: hydrophobic chemicals tend to adsorb to OM being in this way less bioavailable and therefore less bioaccumulated having bioaccumulation factor value around 6 while in natural soil is 10; the sand could act as abrasive particles (helpers) in the elimination process leading to an elimination of 90% of the chemical in two days while in natural soil 67% was eliminated in the same period of time.     

Composite tin and zinc oxide nanocrystalline particles for enhanced charge separation in sensitized degradation of dyes

Composite ZnO/SnO2 catalyst has been studied for the sensitized degradation of dyes e.g. Eosin Y (2', 4', 5', 7'-tetrabromofluorescein disodium salt) in relation to efficient charge separation properties of the catalyst. Improved photocatalytic activity was observed in the case of ZnO/SnO2 composite catalyst compared to the catalytic activity of ZnO, SnO2 or TiO2 powder. The suppression of charge recombination in the composite ZnO/SnO2 catalyst led to higher catalytic activity for the degradation of Eosin Y. Degradation of Eosin follows concomitant formation of CO2 and formation of CO2 followed a pseudo-first-order rate. Photoelectrochemical cells constructed using SnO2, ZnO, ZnO/SnO2 sensitized with Eosin Y showed V(oc) of 175, 306, 512 mV/cm2 and I(sc) of 50, 70, 200 microA/cm2 respectively. A higher irreversible degradation of Eosin Y and higher V(oc) observed on composite ZnO/SnO2 than ZnO and SnO2 separately can be considered as a proof of enhanced charge separation of ZnO/SnO2 catalyst. Eosin Y showed a higher emission decreases on ZnO/SnO2 composite than on individual ZnO, SnO2 or TiO2 indicating dominance of the charge injection process. Photoinjected electrons are tunneled from ZnO to SnO2 particles accumulating injected electrons in the conduction bands allowing wider separation of excited carriers.     

Effects of cadmium on sediment processing on members of the Capitella species-complex

The effect of cadmium on sediment processing by laboratory-cultured specimens of Capitella sp I and Capitella sp B was investigated. Specimens were exposed to 0, 60, 90 and 140 microg Cd g(-1) dry weight sediment for a 10 day period (two census days) to observe effects of cadmium on their feeding activity. Under unstressed conditions, Capitella sp I specimens were larger, had higher biomass and produced more fecal pellets than Capitella sp B. Cadmium concentrations had no effect on pellet production and body mass of the studied populations. However, cadmium exposure time significantly affected Capitella sp B pellet production and body mass of both populations following different trends: after 10 days of exposure, the average processed sediment per unit worm mass decreased in Capitella sp I but increased in Capitella sp B. The latter population did not reduce its feeding activity in the presence of cadmium maybe related to the fact that it is derived from a highly polluted environment. This study has shown an unimpaired response of Capitella sp I and Capitella sp B to cadmium in their sediment processing activity, which indicates the potential importance of this species complex in the trophic transfer of metals from sediments to other marine organisms.