Removal of carbon dioxide by a spray dryer

With the global warming due to greenhouse effects becoming serious, many efforts are carried out to decrease the emissions of CO2 from the combustion of carbonaceous materials. In Taiwan, there are 19 large-scale municipal solid waste incinerators running and their total emission of CO2 is about 16,950 kton y-1. Spray dryer is the most prevailing air pollution control devise for removing acid gas in waste incineration; however, the performance of spray dryer on the removal of CO2 is seldom studied. This study employs a laboratory-scale spray dryer to investigate the removal efficiency of CO2 under different operating conditions. The evaluated parameters include different absorbents mixed with CaOH2, operating temperature, the concentration of absorbent, and the inlet concentration of CO2. Experimental results show that the best removal efficiency of CO2 by a spray dryer is 48% as the absorbent is 10%NaOH+5%CaOH2 and the operating temperature is 150 degrees C. Comparing this result with previous study shows that the performance of spray dryer is better than traditional NaOH wet scrubber. For NaOH+CaOH2 spray dryer, the removal efficiency of CO2 is decreased with the inlet concentration of CO2 increased and the optimum operating temperature is 150 degrees C. Except NaOH+CaOH2, absorbents DEA+CaOH2, TEA+CaOH2, and single CaOH2 are not effective in removing CO2 by a spray dryer.     

Heavy metal extractable forms in sludge from wastewater treatment plants

The analysis of heavy metals is a very important task to assess the potential environmental and health risk associated with the sludge coming from wastewater treatment plants (WWTPs). However, it is widely accepted that the determination of total elements does not give an accurate estimation of the potential environmental impact. So, it is necessary to apply sequential extraction techniques to obtain a suitable information about their bioavailability or toxicity. In this paper, a sequential extraction scheme according to the BCR's guidelines was applied to sludge samples collected from each sludge treatment step of five municipal activated sludge plants. Al. Cd, Co, Cu, Cr, Fe, Mn, Hg, Mo, Ni, Pb, Ti and Zn were determined in the sludge extracts by inductively coupled plasma atomic emission spectrometry. In relation to current international legislation for the use of sludge for agricultural purposes none of metal concentrations exceeded maximum permitted levels. In most of the metal elements under considerations, results showed a clear rise along the sludge treatment in the proportion of two less-available fractions (oxidizable metal and residual metal).     

PM2.5 chemical source profiles for vehicle exhaust, vegetative burning, geological material, and coal burning in Northwestern Colorado during 1995

PM_2.5 (particles with aerodynamic diameters less than 2.5 μm) chemical source profiles applicable to speciated emissions inventories and receptor model source apportionment are reported for geological material, motor vehicle exhaust, residential coal (RCC) and wood combustion (RWC), forest fires, geothermal hot springs; and coal-fired power generation units from northwestern Colorado during 1995. Fuels and combustion conditions are similar to those of other communities of the inland western US. Coal-fired power station profiles differed substantially between different units using similar coals, with the major difference being lack of selenium in emissions from the only unit that was equipped with a dry limestone sulfur dioxide (SO₂) scrubber. SO₂ abundances relative to fine particle mass emissions in power plant emissions were seven to nine times higher than hydrogen sulfide (H₂S) abundances from geothermal springs, and one to two orders of magnitude higher than SO₂ abundances in RCC emissions, implying that the SO₂ abundance is an important marker for primary particle contributions of non-aged coal-fired power station contributions. The sum of organic and elemental carbon ranged from 1% to 10% of fine particle mass in coal-fired power plant emissions, from 5% to 10% in geological material, >50% in forest fire emissions, >60% in RWC emissions, and >95% in RCC and vehicle exhaust emissions. Water-soluble potassium (K⁺) was most abundant in vegetative burning profiles. K⁺/K ratios ranged from 0.1 in geological material profiles to 0.9 in vegetative burning emissions, confirming previous observations that soluble potassium is a good marker for vegetative burning.     

The formation of reactive oxygen species catalyzed by neutral, aqueous extracts of NIST ambient particulate matter and diesel engine particles

It is important to characterize the chemical properties of particulate matter in order to understand how low doses, inhaled by a susceptible population, might cause human health effects. The formation of reactive oxygen species catalyzed by neutral, aqueous extracts of two ambient particulate samples, National Institute of Standards & Technology (NIST) Standard Reference Materials (SRM) 1648 and 1649, and two diesel particulate samples, NIST SRM 1650 and SRM 2975, were measured. The formation of reactive oxygen species was estimated by measuring the formation of malondialdehyde from 2-deoxyribose in the presence of ascorbic acid; H2O2 was not added to this assay. SRM 1649, ambient particulate matter collected from Washington, DC, generated the most malondialdehyde, while SRM 2975, diesel particulate matter collected from a forklift, yielded the least amount. Desferrioxamine inhibited the formation of malondialdehyde from the particulate samples providing additional data to support the observation that transition metals were involved in the generation of reactive oxygen species. Six transition metal sulfates (iron sulfate, copper sulfate, vanadyl sulfate, cobalt sulfate, nickel sulfate, and zinc sulfate) were assayed for their ability to generate reactive oxygen species under the same conditions used for the particulate samples in order to facilitate comparisons between particles and these transition metals. The concentration of transition metals was measured in aqueous extracts of these particulate samples using ion-coupled plasma mass spectrometry (ICP-MS) analysis. There was qualitative agreement between the concentrations of Fe, Cu, and V and the amount of malondialdehyde produced from extracts of these particulate samples. These data suggest that transition metals can be dissolved from particles in neutral, aqueous solutions and that these metals are capable of catalyzing the formation of reactive oxygen species.     

Interactive analysis of waste recycling and energy recovery program in a small-scale incinerator

Conflicting goals affecting solid waste management are explored in this paper to find the best implementation of resource recovery with a small-scale waste-to-energy process. Recycling paper and plastic material often leaves a shortage of thermal energy to support incineration that forces operators to supplement the process with auxiliary fuels. Although there are considerable profits to be made from material recovery, the increase of fuel usage causes conflict given that it is cost prohibitive. A series of trials performed on a small-scale 1.5-t/day incineration plant with a cyclone heat recovery system found that material recycling can impede performance. Experimental results are expressed as empirical regression formulas with regard to combustion temperature, energy transfer, and heat recovery. Process optimization is possible if the waste moisture content remains <30%. To test the robustness of the optimization analysis, a series of sensitivity analyses clarify the extent of material recycling needed with regard to plastic, paper, and metal. The experiments also test whether the moisture in the waste would decrease when recycling paper because of its exceptional capacity to absorb moisture. Results show that recycling paper is strongly recommended when the moisture content is >20%, whereas plastic recycling is not necessary at that moisture condition. Notably, plastic recovery reduces the heat needed to vaporize the water content of the solid waste, thus it is recommended only when the moisture content is <10%. For above-normal incineration temperatures, plastic recycling is encouraged, because it removes excess energy. Metal is confirmed as an overall priority in material recycling regardless of the moisture content of the incoming waste.     

Droplet charging for wet scrubbers

Water droplet charge/mass of wet scrubbers was measured over the direct charging applied potential range of 0-20 kV, 30-70 pounds per square inch gauge (206.8-482.6 kPa) water pressure, and with spiral, impingement, and whirl nozzles. The measured charge/mass ranged from -0.0005 to 0.2 microcoulomb/gm and was directly related to the applied voltage. The water charge/mass was a function of the spray nozzle, with the smaller orifice lower-flow nozzles having the higher charge/mass.     

Plant uptake and translocation of air-borne chlordane and comparison with the soil-to-plant route

In order to assess fully the impact of persistent organic pollutants (POPs) on human health, pollutant exchange at the interface between terrestrial plants, in particular food crops, and other environmental compartments must be thoroughly understood. In this regard, transfers of multicomponent and chiral pollutants are particularly informative. In the present study, zucchini (Cucurbita pepo L.) was planted in containerized, uncontaminated soil under both greenhouse and field conditions and exposed to air-borne chlordane contamination at 14.0 and 0.20 ng/m(3) (average, greenhouses), and 2.2 ng/m(3) (average, field). Chiral gas chromatography interfaced to an ion trap mass spectrometer was used to determine the chiral (trans-chlordane, TC, and cis-chlordane, CC) and achiral (trans-nonachlor, TN) chlordane components in vegetation, air, and soil compartments. The chlordane components of interest were detected in all vegetation tissues examined--root, stem, leaves, and fruits. When compared with the data from a soil-to-plant uptake study, the compositional profile of the chlordane components, i.e. the component fractions of TC, CC, and TN, in plant tissues, showed significantly different patterns between the air-to-plant and soil-to-plant pathways. Changes in the enantiomer fractions of TC and CC in plant tissues relative to the source, i.e. air or soil, although observed, were not markedly different between the two routes. This report provides the first comprehensive comparison between two distinct plant uptake routes for POPs and their subsequent translocation within plant tissues.     

Oil spill in the Rio de la Plata estuary, Argentina: 2-hydrocarbon disappearance rates in sediments and soils

The 6-month assessment of the oil spill impact in the Rio de la Plata described in the preceding paper [Colombo, J.C., Barreda, A., Bilos, C., Cappelletti, N., Demichelis, S., Lombardi, P., Migoya, M.C., Skorupka, C., Suarez, G., 2004. Oil spill in the Rio de la Plata estuary, Argentina: 1 - biogeochemical assessment of waters, sediments, soils and biota. Environmental Pollution] was followed by a 13- and 42-month campaigns to evaluate the progress of hydrocarbon decay. Average sediment hydrocarbon concentrations in each sampling include high variability (85-260%) due to contrasting site conditions, but reflect a significant overall decrease after 3 years of the spill: 17 +/- 27, 18 +/- 39 to 0.54 +/- 1.4 microg g(-1) for aliphatics; 0.44 +/- 0.49, 0.99 +/- 1.6 to 0.04 +/- 0.03 microg g(-1) for aromatics at 6, 13 and 42 months, respectively. Average soil hydrocarbon levels are 100-1000 times higher and less variable (61-169%) than sediment values, but display a clear attenuation: 3678 +/- 2369, 1880 +/- 1141 to 6.0 +/- 10 microg g(-1) for aliphatics and 38 +/- 26, 49 +/- 32 to 0.06 +/- 0.04 microg g(-1) for aromatics. Hydrocarbon concentrations modeled to first-order rate equations yield average rate constants of total loss (biotic+abiotic) twice as higher in soils (k = 0.18-0.19 month(-1)) relative to sediments (0.08-0.10 month(-1)). Individual aliphatic rate constants decrease with increasing molecular weight from 0.21 +/- 0.07 month(-1) for isoprenoids and n-C27, similar to hopanes (0.10 +/- 0.05 month(-1)). Aromatics disappearance rates were more homogeneous with higher values for methylated relative to unsubstituted species (0.17 +/- 0.05 vs. 0.12 +/- 0.05 months(-1)). Continued hydrocarbon inputs, either from biogenic (algal n-C15,17; vascular plant n-C27,29) or combustion related sources (fluoranthene and pyrene), appear to contribute to reduced disappearance rate. According to the different loss rates, hydrocarbons showed clear compositional changes from 6-13 to 42 months. Aliphatics disappearance rates and compositional changes support an essentially microbiologically-mediated recovery of coastal sediments to pre-spill conditions in a 3-4 year period. The lower rates and more subtle compositional changes deduced for aromatic components, suggest a stronger incidence of physical removal processes.     

Tracing impacts of partner abundance in facultative pollination mutualisms: from individuals to populations

Partner abundance affects costs and benefits in obligate mutualisms, but its role in facultative partnerships is less clear. We address this gap in a pollination web consisting of two clovers (Trifolium) that differ in specialization on a bumble bee pollinator Bombus balteatus. We examine how pollination niche breadth affects plant responses to pollinator abundance, comparing early-flowering (specialized) and late-flowering (generalized) cohorts of T. parryi and early T. parryi to T. dasyphyllum, a pollination generalist. Co-pollinators disrupt the link between B. halteatus visitation and pollination rate for both clovers. Only for early-flowering T. parryi do visitation, pollination, and seed set increase with density of B. balteatus. Bumble bee density also alters timing of seed germination in T. parryi, with seeds from plants receiving augmented B. balteatus germinating sooner than seeds of open-pollinated counterparts. Benefits saturate at intermediate bumble bee densities. Despite strong effects of B. balteatus density on individual plant fitness components, population models suggest little impact of B. balteatus density on lamda in T. parryi or T. dasyphyllum. Findings show that functional redundancy in a pollinator guild mediates host-plant responses to partner density. Unexpected effects of pollinator density on life history schedule have implications for recruitment under pollinator decline.     

Nitrogen and sulphur mustard induced histopathological observations in mouse visceral organs

Nitrogen mustards (HN) and sulphur mustard (SM) are potent alkylating blister inducing chemical warfare agents. Single 1.0 LD50 dose produced a progressive fall in body weight from second day onwards in all groups of mustard agents exposed animals. Histological examination of spleen, liver skin and kidney revealed significant histopathological lesions in nitrogen mustards and sulphur mustard. These lesions include granulovascular degeneration with perinuclear clumping of the cytoplasm of hepatocytes and renal parenchymal cells. Renal lesions were characterized by congestion and hemorrhage. The maximum toxic manifestation were noted in spleen and skin of HN-3 exposed mice while sulphur mustard reported maximum toxicity in liver and kidneys. The study suggests both nitrogen mustards and sulphur mustard to be extremely toxic by percutaneous route based on histopathological observation and can contributed to earlier reported free radical generation by these toxicants.