一株1,2,3,4-四氯苯降解菌的筛选和降解特性研究

从广东某化学试剂厂周边土壤中筛选、分离并纯化出一株能有效降解1,2,3,4-四氯苯(1,2,3,4-TeCB)的菌株,命名为L-1号菌.探索不同接种量(2%;3%;5%)菌株对25 mg·L-1的1,2,3,4-四氯苯模拟废水化学需氧量(COD)、氯离子释放浓度、1,2,3,4-四氯苯降解效果影响,并结合气相质谱联用仪(GC-MS)工作站分析菌株对1,2,3,4-TeCB降解产物.结果表明:经16S rDNA鉴定该菌株为枯草芽孢杆菌;菌株接种量为5%对1,2,3,4-TeCB降解效果最佳,在pH=7.0、温度30℃,摇床转速110 r·min-1条件下反应7d,COD降解率达62.71%;氯离子释放浓度4.98mg·L-1;四氯苯降解量达20.47 mg·L-1.通过对L-1号菌降解1,2,3,4-TeCB产物分析,发现L-1号菌对1,2,3,4-TeCB的降解是通过先开环后脱氯的途径实现的.     

UraniumVI sorption behavior on silicate mineral mixtures

UraniumVI sorption experiments involving quartz and clinoptilolite, important mineral phases at the proposed US nuclear waste repository at Yucca Mountain, NV, were conducted to evaluate the ability of surface complexation models to predict UVI sorption onto mineral mixtures based on parameters derived from single-mineral experiments. The experiments were conducted at an initial UVI aqueous concentration of approximately 2.0 x 10(-7) mol.l-1 (0.1 mol.l-1 NaNO3 matrix) and over the pH range approximately 2.5 to approximately 9.5. The UVI solutions were reacted with either quartz or clinoptilolite only, or with mixtures of the two minerals. The experiments were carried out under atmospheric pCO2(g) conditions (in loosely capped containers) or under limited pCO2(g) (in capped containers or in a glove box). Data from sorption experiments on quartz at atmospheric pCO2 conditions were used to derive UVI binding constants for a diffuse-layer surface complexation model (DLM). The DLM was then used with surface area as a scaling factor to predict sorption of UVI onto clinoptilolite and clinoptilolite/quartz mixtures under both atmospheric and low pCO2 conditions. The calculations reproduced many aspects of the pH-dependent sorption behavior. If this approach can be demonstrated for natural mineral assemblages, it may be useful as a relatively simple method for improving radionuclide transport models in performance-assessment calculations.     

Accumulation of organochlorine contaminants in double-crested cormorants

Cormorant eggs and lipid samples from juvenile Cormorants were analyzed for 14 organochlorine contaminants. Low concentrations (geometric mean < 0.05 microg/g) of hexachlorobenzene (HCB), lindane, oxy-chlordane, heptachlor epoxide, dieldrin, endrin, mirex, DDD and DDT in eggs primarily reflected the wintering-ground origin of organochlorine contaminants. Overall geometric mean concentrations of DDE and PCBs in Cormorant eggs were 3.90 and 2.22 microg/g egg respectively, and would not affect reproduction or eggshell thickness. Eggshells averaged 0.44 mm in thickness and no correlation (r2 = 0.17) with log-transformed DDE residues in Cormorant eggs was evident. Only DDE and PCBs were detected in lipid samples from 5- to 8-week-old Cormorants (geometric mean approximately 1.0 microg/g lipid for each compound). The PCB: DDE ratios in Cormorant lipid from some individual colonies were 2-3.5 times greater than the ratio in eggs from the same colony, suggesting an accumulation of PCBs related to local diet. Juvenile Cormorants might serve as regional indicators of chemical residue contamination in Alberta, and provide a temporal perspective on changes in contaminant burdens in aquatic ecosystems.     

Modelling trace metal partitioning in forest floors of northern soils near metal smelters

Trace metal (TM) mobility and toxicity varies with changing soil conditions. Geochemical models can account for the influence of soil characteristics on TM behaviour. We tested the effectiveness of the Stockholm humic model (SHM), and the NICA-Donnan model (NDM) to estimate partitioning coefficients (logKd) in 26 forest floor horizons of podzolic soils enriched in trace metals from deposition by metal smelters. We wanted to know if a consistent approach could be applied to model metal partitioning in forest floors without optimizing each individual soil. When optimized, the SHM reproduced the partitioning of Cd, Cu and Zn but not Pb. It was necessary to revise the affinity constants for the NDM to simultaneously simulate the partitioning of the four metals. Revised affinity constants for the NDM model based on a fixed definition of soil organic carbon, i.e., a fixed ratio of fulvic and humic acids per unit carbon, reproduced metal partitioning more effectively in an independent data set of 16 soils than the use of generic affinity constants available for these models. From the perspective of the applicability of these models to risk assessment, this result suggests geochemical models using affinity constants that have been verified and/or modified against multiple soils from a region can provide good estimates of metal partitioning on a regional scale.     

Metabolism of aromatic hydrocarbons by the filamentous fungus Cyclothyrium sp

The metabolism of biphenyl, naphthalene, anthracene, phenanthrene, pyrene and benzo[a]pyrene by Cyclothyrium sp. CBS 109850, a coelomycete isolated for the first time in Brazil from industrially polluted estuarine sediment, was studied. The metabolites were extracted and separated by high performance liquid chromatography (HPLC) and characterized by UV spectral analyses and mass, and proton nuclear magnetic resonance ((1)H NMR) spectrometry. Cyclothyrium sp. transformed biphenyl to 4-hydroxybiphenyl and anthracene to anthracene trans-1,2-dihydrodiol. This isolate metabolized 90% of [9-(14)C]phenanthrene, producing phenanthrene trans-9,10-dihydrodiol as a major metabolite, phenanthrene trans-3,4-dihydrodiol, 1-hydroxyphenanthrene, 3-hydroxyphenanthrene, 4-hydroxyphenanthrene, and a novel metabolite, 2-hydroxy-7-methoxyphenanthrene. Circular dichroism spectra analyses indicated that the major enantiomers of phenanthrene trans-9, 10-dihydrodiol, phenanthrene trans-3,4-dihydrodiol and pyrene trans-4,5-dihydrodiol, a pyrene metabolite produced previously by Cyclothyrium sp. CBS 109850, were predominantly in the (R,R) configuration, revealing a high stereoselectivity for initial monooxygenation and enzymatic hydration of phenanthrene and pyrene by Cyclothyrium sp. CBS109850. The results also show a high regioselectivity since the K-regions of phenanthrene and pyrene were the major sites of metabolism.     

The first discovery of a brachiosaurid from the Asian continent

Described here is a sauropod tooth from the Early Cretaceous of South Korea, similar to Brachiosaurus. The crown of the tooth is beveled off lingually so that when worn it presents a chisel-like edge. This find confirms the presence of a brachiosaurid in East Asia during the Early Cretaceous.     

In-situ oxidation of trichloroethene by permanganate: effects on porous medium hydraulic properties

In-situ oxidation of dense nonaqueous-phase liquids (DNAPLs) by strong oxidants such as potassium permanganate (KMnO4) has been proposed as a possible DNAPL remediation strategy. In this study, we investigated the effects of in-situ trichloroethene (TCE) oxidation by KMnO4 on porous medium hydraulic properties. In particular, we wanted to determine the overall effects of concurrent solid phase (MnO2) precipitation, gas (CO2) evolution and TCE dissolution resulting from the oxidation reaction on the porous medium's aqueous-phase relative permeability, krw. Three TCE removal experiments were conducted in a 95-cm long, 5.1-cm i.d. glass column, which was homogeneously packed with well-characterized 30/40-mesh silica sand. TCE was emplaced in the sand-pack in residual, entrapped form through a sequence of water/TCE imbibition and drainage steps. The column was then flushed under constant aqueous flux conditions for up to 104 h with either deionized water (reference experiment), deionized water containing 5 mM KMnO4 or deionized water containing 5 mM KMnO4 and 300 mM Na2HPO4. Aqueous-phase relative permeabilities were computed from measured flow rates and measurements of aqueous-phase pressure head, h obtained using pressure transducers connected to tensiometers distributed along the column length. A dual-energy gamma radiation system was used to monitor changes in fluid saturation that occurred during each experiment. In addition, column effluent samples were collected for chemical analyses. Dissolution of TCE during deionized water flushing led to an increase in krw by approximately 22% and a local reduction in h. On the other hand, vigorous CO2 gas production and precipitation of MnO2 was visually observed during flushing with deionized water that contained 5 mM KMnO4. As a consequence, krw declined by approximately 96% and h increased locally by more than 1000 cm H2O during the first 24 h of the experiment, causing sand-pack ruptures and pump failure. Conversely, less CO2 gas production and MnO2 precipitation was visually observed during flushing with deionized water that contained 5 mM KMnO4 and 300 mM Na2HPO4. Consequently, only small increases in h (< 15 cm H2O) were observed in this experiment due to a reduction in krw of approximately 53%. While we must attribute changes in h due to variations in krw to our specific experimental design (constant aqueous flux, one-dimensional flow experiments), these experiments nevertheless confirm that successful application of in situ chemical oxidation of TCE requires consideration of detrimental processes such as MnO2 precipitation and CO2 gas formation. In addition, our results indicate that utilization of a buffered oxidant solution may improve the effectiveness of in-situ oxidation of TCE by KMnO4 in otherwise weakly buffered porous media.     

The safety implications of vehicle seat adjustments

INTRODUCTION: The goal of this study was to gather information on the preferred front seat position of vehicle occupants and to determine the impact of variation in seat position on safety during crashes. METHOD: The study evaluated the relationship between seat position and occupant size using the chi-square test and compared the risk of severe injury for small females and large males with regard to forward and rearward seat position using logistic regression. RESULTS: While smaller drivers sat closer to the steering wheel than larger drivers, front passengers of all sizes used similar seat positions. Additionally, the risk of injury was higher for small, unbelted females in rearward seat positions and large males (belted and unbelted) in forward seat positions. CONCLUSIONS: Occupants who adjust their seats to positions that are not consistent with required federal tests are at a greater risk for severe injury in a crash.     

Antecedents of injury among youth in agricultural settings: a longitudinal examination of safety consciousness,dangerous risk taking,and safety knowledge

PROBLEM: Injuries are the leading cause of death for adolescents in the United States. METHODS: This study longitudinally examined three psychological mediators of injury among 3,081 youths in agricultural settings: (a) safety consciousness, (b) dangerous risk taking, and (c) safety knowledge. These variables are examined within a nomological network of contextual variables. RESULTS: Cross-sectional results revealed that safety consciousness and dangerous risk taking were the strongest predictors of reported injury at Time 1 and Time 2. Safety knowledge had an unexpected negative association with injury, albeit weak. As predicted, participating in safety activities was positively associated with safety consciousness, and time spent working was strongly associated with safety knowledge. Furthermore, self-esteem had both positive and negative safety outcomes, suggesting a more complex functioning. Males exhibited fewer safety cognitions than females as predicted. Longitudinal data also revealed that injury at Time 1 and dangerous risk taking were the strongest predictors of Time 2 injury. IMPACT ON INDUSTRY: Results from this study emphasize the importance of assessing dangerous risk-taking perceptions when attempting to predict future injuries.     

表面活性剂的筛选与废纸脱墨剂配方的优化

以ONP/OMG混合废纸为脱墨对象,研究了常见的几种表面活性剂的脱墨效果,确定了在碱性条件下OP-10与FMEE单独脱墨时表现出较好的脱墨性能,并讨论了油酸钠作为油墨捕集剂以及尼诺尔6501作为泡沫稳定剂对脱墨效果的影响,最终确定了OP-10、FMEE、油酸钠与6501在45∶45∶5∶5的配比下具有最佳的协同增效作用,以该比例获得脱墨剂具有综合的乳化、分散、捕集、泡沫稳定性特点,适用于纸浆的浮选脱墨工艺.