Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

电厂屏式过热器弯头开裂原因失效分析

通过外观检查、硬度、金相等检测方法,从金属管壁超温运行、蒸汽侧氧化行为、析出相及冷弯变形对组织性能影响等方面分析了某电厂1 000 MW超超临界机组屏式过热器弯头开裂原因,得出TP347HFG弯头开裂的主要原因是弯头组织富含较多的σ相、NbC等硬脆析出相,同时冷弯加工导致管子内部产生残余应力,加剧了弯头脆性开裂的倾向。     

二苯并噻吩降解菌筛选及16S rDNA序列分析

以DBT(dibenzothiophene,二苯并噻吩)为模型化合物,分离得到了一株能降解DBT的微生物HB2,应用HPLC对其脱硫特性进行了检测。应用PCR技术克隆到16SrDNA片段,核苷酸序列分析结果表明,该菌的16SrDNA全序列与假单胞菌存在98%的同源性,初步确定该菌在微生物系统发育学上的地位。     

超声对污泥流变性及絮凝脱水性的影响

采用旋转粘度法研究了活性污泥体系的流变特性,考察和比较了超声处理前后污泥粘度及过滤比阻的变化,并就超声处理污泥的絮凝脱水性能进行了相关测试和分析.结果表明,随剪切速率的增大,污泥表观粘度降低,流动性增大,表现出流体变稀;污泥的流变特性反映出其胶状网络结构具有相对稳定性,污泥对水的结合能力强,因此,其过滤比阻高、脱水性能差;在固定频率25 kHz条件下,低声能密度(0.10～0.15W·mL-1)、短时间(2～3 min)超声处理可有效降低污泥表观粘度及过滤比阻;在絮凝剂(PDMDAAC)投量为污泥干固体质量(TS的)0.5%时,超声处理污泥的过滤比阻与滤饼含水率可分别降低至最小值0.18×109s2·g-1和65.7%.实验结果表明,将超声与絮凝剂结合用于污泥调理是可行的.     

一株反硝化菌的分离鉴定和系统发育分析

从反硝化反应器中分离到一株异养型兼氧反硝化细菌,命名为菌株JIN1,分离菌株为革兰氏染色阴性杆状。茵落颜色为乳白色。该菌株能以硝酸钠为唯一氮源进行反硝化作用并产生亚硝酸。部分长度的16SrDNA序列分析表明,分离菌株JIN1与Aquaspirillum菌具有99%相似,与Microvirgulaaerodenitrificans菌具有99%相似。其生化性状与Aquaspirillum菌不相符。系统发育学分析表明菌株JIN1与Microvirgulaaerodenitrificans菌关系最近。故确认菌株JIN1属Microvirgulaaerodenitrificans菌。     

生物膜填料塔SO2废气净化性能研究

采用生物膜填料塔净化SO2废气,研究结果表明:当气体流量从100L/h增加到300L/h时,SO2净化效率由86.4%下降到73.2%;生化去除量随着入口SO2气体浓度的升高而增大;随着温度的升高,SO2净化效率和生化去除量都随之提高,且20℃以上时,净化效率可达90.9%以上,生化去除量可达75 mg/L·h以上,更利于微生物降解SO2.     

西藏农村能源消费及环境影响研究

西藏农村人口现有220多万,占全区总人口80％以上,农村经济落后,城乡差距很大。西藏农村能源资源主要有水力、地热、太阳能、风力、林木和畜粪等,煤炭、石油、天然气等高热值的优质能源很少。在这种经济发展水平及能源资源基础条件下,农村能源消费中高热值的现代能源比重很低,主要以生物质能如薪柴、牛粪、草皮等为主。这种低水平的能源消费结构已经对西藏脆弱的生态环境造成了巨大的破坏,西藏未来的能源发展战略迫切需要改变农村目前的消费结构,应发展太阳能、风能、农村小水电及输入高热值的化石能源替代目前生物质能的消费,减少因能源消费对西藏生态环境的破坏。