Mobility control: How injected surfactants and biostimulants may be forced into low‐permeability units

Recovering dense nonaqueous‐phase liquid (DNAPL) remains one of the most difficult problems facing the remediation industry. Still, the most common method of recovering DNAPL is to physically remove the contaminants using common technologies such as total fluids recovery pumps, vacuum systems, and “pump‐and‐treat.” Increased DNAPL removal can be attained using surfactants to mobilize and/or solubilize the pollutants. However, very little is understood of the methods developed by petroleum engineers beginning in the 1960s to overcome by‐passed, low‐permeability zones in heterogeneous oil reservoirs. By injecting or causing the formation of viscous fluids in the subsurface, petroleum engineers caused increased in‐situ pressures that forced fluid flow into low permeability units as well as the higher permeability thief zones. Polymer flooding involves injecting a viscous aqueous polymer solution into the contaminated aquifer. Foam flooding involves injecting surfactant to decontaminate the high‐permeability zones and then periodic pulses of air to cause a temporary viscous foam to form in the high‐permeable zones after all DNAPL is removed. Later surfactant pulses are directed by the foam into unswept low‐permeable units. These methods have been applied to DNAPL removal using surfactants but they can also be applied to the injection of bio‐amendments into low‐permeability zones still requiring continued remediation. Here we discuss the principles of mobility control as practiced in an alluvial aquifer contaminated with chlorinated solvent and coal tar DNAPLs as well as some field results. © 2003 Wiley Periodicals, Inc.     

Pilot‐scale demonstration of in situ capping of PCB‐containing sediments in the lower Grasse River

A fish‐consumption advisory is currently in effect in a seven‐mile stretch of the Grasse River in Massena, New York, due to elevated levels of PCBs in fish tissue. One remedial approach that is being evaluated to reduce the PCB levels in fish from the river is in situ capping. An in‐river pilot study was conducted in the summer of 2001 to assess the feasibility of capping PCB‐containing sediments of the river. The study consisted of the construction of a subaqueous cap in a seven‐acre portion of the river using various combinations of capping materials and placement techniques. Optimal results were achieved with a 1:1 sand/topsoil mix released from a clamshell bucket either just above or several feet below the water surface. A longer‐term monitoring program of the capped area commenced in 2002. Results of this monitoring indicated: 1) the in‐place cap has remained intact since installation; 2) no evidence of PCB migration into and through the cap; 3) groundwater advection through the cap is not an important PCB transport mechanism; and 4) macroinvertebrate colonization of the in‐place cap is continuing. Additional follow‐up monitoring in the spring of 2003 indicated that a significant portion of the cap and, in some cases, the underlying sediments had been disturbed in the period following the conclusion of the 2002 monitoring work. An analysis of river conditions in the spring of 2003 indicated that a significant ice jam had formed in the river directly over the capping pilot study area, and that the resulting increase in river velocities and turbulence in the area resulted in the movement of both cap materials and the underlying sediments. The pilot cap was not designed to address ice jam–related forces on the cap, as the occurrence of ice jams in this section of the river had not been known prior to the observations conducted in the spring of 2003. These findings will preclude implementation of the longer‐term monitoring program that had been envisioned for the pilot study. The data collected immediately after cap construction in 2001 and through the first year of monitoring in 2002 serve as the basis for the conclusions presented in this article. It should be recognized that, based on the observation made in the spring of 2003, some of these conclusions are no longer valid for the pilot study area.The occurrence of ice jams in the lower Grasse River and their importance on sediments and PCBs within the system are currently under investigation. © 2003 Wiley Periodicals, Inc.     

Local Environmental Investments and Sustainable Development: the evaluation of environmental projects in Scotland supported by the European Agriculture Guidance and Guarantee Fund

In the UK for the period 1994-99, a broad range of environmental projects were given financial support through the European Agriculture Guidance and Guarantee Fund under the Objective 1 and Objective 5b programmes. This paper is concerned with the ex-post evaluation of these projects set within a Sustainable Development framework. The aim was to identify project types or characteristics that offered the greatest return on investment. A classification of six broad project types was adopted. The evaluation revealed that there were significant differences between individual projects with respect to the type and scale, and temporal and social distribution of the benefits they delivered. In particular, as well as delivering environmental and economic benefits, many projects made a significant contribution to the development of human and social capital. The paper concludes that it is possible to improve the basis for future project selection in order to maximise the returns on environmental investments in the context of sustainable development.     

Alteration in Rhizosphere Soil Properties of Afforested <Emphasis Type="Italic">Rhamnus lycioides</Emphasis> Seedlings in Short-Term Response to Mycorrhizal Inoculation with <Emphasis Type="Italic">Glomus intraradices</Emphasis> and Organic Amendment

The reestablisment of autochthonous plant species is an essential strategy for recovering degraded areas under semiarid conditions. A field experiment was carried out to assess the short-term effect of two reafforestation methods involving mycorrhizal inoculation and compost addition on soil quality parameters and Rhamnus lycioides seedling growth. The nutrient content (NPK) and enzymatic activities (dehydrogenase, urease, protease-BAA, acid phosphatase and β-glucosidase) increased and bulk density decreased in the rhizosphere soil with the organic amendment. Biomass C of rhizosphere soil increased by at least 240% with respect to the control soil after mycorrhizal inoculation and the combination of compost addition + mycorrhizal inoculation. Both mycorrhizal inoculation and composted organic residue addition increased R. lycioides seedling growth in the same proportion. In the short term, we conclude that the application of both reafforestation methods not only enhances the establishment of R. lycioides seedlings, but also improves soil quality.     

INCORPORATING NATURAL VARIABILITY,UNCERTAINTY, AND RISK INTO WATER QUALITY EVALUATIONS USING DURATION CURVES1

ABSTRACT: Quantifying natural variability, uncertainty, and risk with minimal data is one of the greatest challenges facing those engaged in water quality evaluations, such as development of total maximum daily loads (TMDL), because of regulatory, natural, and analytical constraints. Quantification of uncertainty and variability in natural systems is illustrated using duration curves (DCs), plots that illustrate the percent of time that a particular flow rate (FDC), concentration (CDC), or load rate (LDC; “TMDL”) is exceeded, and are constructed using simple derived distributions. Duration curves require different construction methods and interpretations, depending on whether there is a statistically significant correlation between concentration (C) and flow (Q), and on the sign of the C‐Q regression slope (positive or negative). Flow DCs computed from annual runoff data vary compared with an FDC developed using all data. Percent exceedance for DCs can correspond to risk; however, DCs are not composed of independent quantities. Confidence intervals of data about a regression line can be used to develop confidence limits for the CDC and LDC. An alternate expression to a fixed TMDL is suggested as the risk of a load rate being exceeded and lying between confidence limits. Averages over partial ranges of DCs are also suggested as an alternative expression of TMDLs. DCs can be used to quantify watershed response in terms of changes in exceedances, concentrations, and load rates after implementation of best management practices.     

USE OF STAGE DATA TO CHARACTERIZE HYDROLOGIC CONDITIONS IN AN URBANIZING ENVIRONMENT1

ABSTRACT: This paper presents the results of a study on the use of continuous stage data to describe the relation between urban development and three aspects of hydrologic condition that are thought to influence stream ecosystems—overall stage variability, stream flashiness, and the duration of extreme‐stage conditions. This relation is examined using data from more than 70 watersheds in three contrasting environmental settings—the humid Northeast (the metropolitan Boston, Massachusetts, area); the very humid Southeast (the metropolitan Birmingham, Alabama, area); and the semiarid West (the metropolitan Salt Lake City, Utah, area). Results from the Birmingham and Boston studies provide evidence linking increased urbanization with stream flashiness. Fragmentation of developed land cover patches appears to ameliorate the effects of urbanization on overall variability and flashiness. There was less success in relating urbanization and streamflow conditions in the Salt Lake City study. A related investigation of six North Carolina sites with long term discharge and stage data indicated that hydrologic condition metrics developed using continuous stage data are comparable to flow based metrics, particularly for stream flashiness measures.     

THE MISUSE OF HYDROLOGIC UNIT MAPS FOR EXTRAPOLATION,REPORTING, AND ECOSYSTEM MANAGEMENT1

ABSTRACT: The use of watersheds to conduct research on land/water relationships has expanded recently to include both extrapolation and reporting of water resource information and ecosystem management. More often than not, hydrologic units (HUs) are used for these purposes, with the implication that hydrologic units are synonymous with watersheds. Whereas true topographic watersheds are areas within which apparent surface water drains to a particular point, generally only 45 percent of all hydrologic units, regardless of their hierarchical level, meet this definition. Because the area contributing to the downstream point in many hydrologic units extends far beyond the unit boundaries, use of the hydrologic unit framework to show regional and national patterns of water quality and other environmental resources can result in incorrect and misleading illustrations. In this paper, the implications of this misuse are demonstrated using four adjacent HUs in central Texas. A more effective way of showing regional patterns in environmental resources is by using data from true watersheds representative of different ecological regions containing particular mosaics of geographical characteristics affecting differences in ecosystems and water quality.     

Factor structure of the transformational leadership model in human service teams

The purpose of this study was to examine the factor structure of the transformational leadership model in human service teams. As the nature of this work environment mandates certain management‐by‐exception practices, patterns of correlations between perceptions of active and passive management‐by‐exception behaviors and transformational, transactional, and laissez‐faire leadership were of interest. 236 leaders and 620 subordinates from 54 mental health teams completed the Multifactor Leadership Questionnaire, form 8Y. Results suggest that active and passive management‐by‐exception factors are independent constructs. Copyright © 2003 John Wiley & Sons, Ltd.     

Regional Variations in the Implementation of the Local Air Quality Management Process within Great Britain

The UK National Air Quality Strategy has required local authorities to review and assess air quality in their area of jurisdiction and determine locations in their areas where concentrations of specific air quality pollutants are predicted to exceed national air quality objectives in the future. Statutory air quality management areas (AQMAs) are designated where air quality is predicted to be above specified objective concentrations by specific target dates, and statutory air quality action plans will be necessary to improve the local air quality within these areas. Over 124 local authorities in England (including London), Wales and Scotland anticipate declaring AQMAs following the conclusion of the statutory air quality review and assessment process. However, other influences are being exerted on the local air quality management process and AQMA decision-making processes. Such influences include regional and sub- regional collaborative working between local authorities and government agencies and wider political decision-making processes. Some regions of Great Britain (encompassing England (including London), Scotland and Wales) anticipate many AQMA designations, whilst other regions are not anticipating any such designations despite apparently similar air quality circumstances. Evidence for regional or sub-regional variations in the locations of anticipated AQMAs are examined through an evaluation of the outcomes of the scientific review and assessment process undertaken by local authorities declaring AQMAs, and through a local authority survey to identify influences on decision-making processes at a level above that of the local authority. Regional variation is reported in the type of pollutant causing AQMAs to be declared, in the numbers of AQMAs in regions and in the spatial distribution of AQMAs across Great Britain.