Effects of Heating Season on Residential Indoor and Outdoor Polycyclic Aromatic Hydrocarbons, Black Carbon, and Particulate Matter in an Urban Birth Cohort

Exposure to air pollutants has been associated with adverse health effects. However, analyses of the effects of season and ambient parameters such as ozone have not been fully conducted. Residential indoor and outdoor air levels of polycyclic aromatic hydrocarbons (PAH), black carbon (measured as absorption coefficient [Abs]), and fine particulate matter <2.5 μm (PM)(2.5) were measured over two-weeks in a cohort of 5-6 year old children (n=334) living in New York City's Northern Manhattan and the Bronx between October 2005 and April 2010. The objectives were to: 1) characterize seasonal changes in indoor and outdoor levels and indoor/outdoor (I/O) ratios of PAH (gas + particulate phase; dichotomized into Σ(8)PAH(semivolatile) (MW 178-206), and Σ(8)PAH(nonvolatile) (MW 228-278)), Abs, and PM(2.5); and 2) assess the relationship between PAH and ozone. Results showed that heating compared to nonheating season was associated with greater Σ(8)PAH(nonvolatile) (p<0.001) and Abs (p<0.05), and lower levels of Σ(8)PAH(semivolatile) (p<0.001). In addition, the heating season was associated with lower I/O ratios of Σ(8)PAH(nonvolatile) and higher I/O ratios of Σ(8)PAH(semivolatile) (p<0.001) compared to the nonheating season. In outdoor air, Σ(8)PAH(nonvolatile) was correlated negatively with community-wide ozone concentration (p<0.001). Seasonal changes in emission sources, air exchanges, meteorological conditions and photochemical/chemical degradation reactions are discussed in relationship to the observed seasonal trends.     

Insights into the nature of secondary organic aerosol in Mexico City during the MILAGRO experiment 2006

This study targets understanding the secondary sources of organic aerosol in Mexico City during the Megacities Impact on Regional and Global Environment (MIRAGE) 2006 field campaign. Ambient PM_2.5 was collected daily at urban and peripheral locations. Particle-phase secondary organic aerosol (SOA) products of anthropogenic and biogenic precursor gases were measured by gas chromatography mass spectrometry. Ambient concentrations of SOA tracers were used to estimate organic carbon (OC) from secondary origins (SOC). Anthropogenic SOC was estimated as 20–25% of ambient OC at both sites, while biogenic SOC was less abundant, but was relatively twice as important at the peripheral site. The OC that was not attributed secondary sources or to primary sources in a previous study showed temporal consistency with biomass-burning events, suggesting the importance of secondary processing of biomass-burning emissions in the region. The best estimate of biomass-burning-related SOC was in the range of 20–30% of ambient OC during peak biomass burning events. Low-molecular weight (MW) alkanoic and alkenoic dicarboxylic acids (C₂–C₅) were also measured, of which oxalic acid was the most abundant. The spatial and temporal trends of oxalic acid differed from tracers for primary and secondary sources, suggesting that it had different and/or multiple sources in the atmosphere.     

'All hazards approach' to disaster management: the role of information and knowledge management, Boyd's OODA Loop, and network-centricity

The ever-increasing complexity of disasters demands utilisation of knowledge that exists outside domains traditionally drawn upon in disaster management. To be operationally useful, such knowledge must he extracted, combined with information generated by the disaster itself, and transformed into actionable knowledge. The process, though, is hampered by existing, business-oriented approaches to knowledge management, by technical issues related to access to relevant, multi-domain information/knowledge, and by executive decision-making processes based predominantly on historical knowledge. Consequently, as shown by many recent incidents, the management of large-scale (mega) disasters is often inefficient and exceedingly costly. This paper demonstrates that the integration of modified information and knowledge management into the concepts of network-centric operations and network-enabled capabilities, and the employment of Boyd's OODA (Observe, Orient, Decide, and Act) Loop-based decision-making in unpredictable and dynamically changing environments, may address some of these problems.     

Externalization of employment in a service environment: the role of organizational and customer identification

This study investigates the impact of employment externalization (in the form of limited‐term vs. permanent employment status) on customer‐oriented service behavior, and how identification processes may help to resolve the ‘paradox of externalization’ (i.e., organizations relying more on potentially disenfranchised employees to maintain strong connections with their customers). Survey data were obtained from 369 sales, service, and technical support personnel from the Canadian subsidiary of a large international service organization in the high technology sector. Organizational and customer identification fully mediate the relationship between employment status and customer‐oriented service behavior. Additionally, the perceived external image of the organization and the visibility of one's affiliation with the organization moderate the relationships between employment status and organizational and customer identification. Copyright © 2007 John Wiley & Sons, Ltd.     

The effects of a mandatory motorcycle helmet law on helmet use and injury patterns among motorcyclist fatalities

BACKGROUND: The National Highway Traffic Safety Administration (NHTSA) has found that motorcycle helmets are 37% effective in preventing death and 65% effective in preventing brain injuries in a crash. Unfortunately, in 1995 Congress lifted federal sanctions against states without helmet laws and since then there have been a number of primary motorcycle helmet laws repealed or weakened. More lives could be saved and serious injuries avoided if there was increased helmet use throughout the United States. METHODS: This study analyzed helmet use and injury patterns among motorcycle riders in the United States involved in fatal crashes from 1995 through 2003 and compared the results between states with and without a primary helmet law. Age, sex, injury severity and helmet use are some of the variables obtained from the Fatality Analysis Reporting System (FARS). RESULTS: In the 20 states and the District of Columbia, which currently have a primary helmet law, 84.0% of fatally injured riders were wearing a helmet. In the 27 states with a secondary helmet law, 36.2% of fatalities used a helmet, and in the remaining three states with no law at all, helmet use dropped to 17.6%. In the two states (Arkansas and Texas) that changed from a primary helmet law to a secondary helmet law in 1997, helmet use decreased from 78.2% in 1996 to 31.7% in 2000. CONCLUSION: If all states were to enact a primary motorcycle helmet law, helmet use would dramatically increase while decreasing the number of motorcyclist head injuries and fatalities. IMPACT ON INDUSTRY: The results of this study will hopefully persuade law makers to enact primary helmet laws in all states throughout the nation. Helmet manufacturers can use this data to design more comfortable helmets while also improving upon the protective qualities of these safety devices.     

The roles of garment design and scene complexity in the daytime conspicuity of high-visibility safety apparel

INTRODUCTION: This study examines the effects of high-visibility garment design on daytime pedestrian conspicuity in work zones. Factors assessed were garment color, amount of background material, pedestrian arm motion, scene complexity, and driver age. METHOD: The study was conducted in naturalistic conditions on public roads in real traffic. Drivers drove two passes on a 31-km route and indicated when they detected pedestrians outfitted in the fluorescent garments. The locations of the vehicle and the pedestrian were recorded. RESULTS: Detection distances between fluorescent yellow-green and fluorescent red-orange garments were not significantly different, nor were there any significant two-way interactions involving garment color. Pedestrians were detected at longer distances in lower complexity scenes. Arm motion significantly increased detection distances for pedestrians wearing a Class 2 vest, but had little added benefit on detection distances for pedestrians wearing a Class 2 jacket. DISCUSSION: Daytime detection distances for pedestrians wearing Class 2 or Class 3 garments are longest when the complexity of the surround is low. The more background information a driver has to search through, the longer it is likely to take the driver to locate a pedestrian--even when wearing a high-visibility garment. IMPACT ON INDUSTRY: These findings will provide information to safety garment manufacturers about characteristics of high-visibility safety garments which make them effective for daytime use.     

Impact of using paper mill sludge for surface-mine reclamation on runoff water quality and plant growth

Paper mills generate large amounts of solid waste consisting of fibrous cellulose, clay, and lime. Paper mill sludge (PMS) can improve reclamation of surface-coal mines where low pH and organic-carbon levels in the spoil cover material can inhibit revegetation. When applied at high rates, however, PMS may adversely impact the quality of surface runoff. Therefore, we applied PMS at 0, 224, and 672 dry Mg ha(-)(1) to 22.1 x 4.6-m plots at a recently mined site and monitored runoff for a total of 13 mo. The zero-rate plots served as controls and received standard reclamation consisting of mulching with hay and fertilization at planting. Compared to the control plots, PMS reduced runoff fourfold to sixfold and decreased erosion from 47 Mg ha(-1) to <1 Mg ha(-1). Most of the reduction occurred in the 2.5 mo before the plots were planted. Flow-weighted average dissolved oxygen concentrations in runoff from plots at the 224 and 672 Mg ha(-1) rates, however, were much lower (相似文献   

Ammonia assessment from agriculture: U.S. status and needs

Recent studies suggest that human activities accelerate the production of reactive nitrogen on a global scale. Increased nitrogen emissions may lead to environmental impacts including photochemical air pollution, reduced visibility, changes in biodiversity, and stratospheric ozone depletion. In the last 50 yr, emissions of ammonia (NH3), which is the most abundant form of reduced reactive nitrogen in the atmosphere, have significantly increased as a result of intensive agricultural management and greater livestock production in many developed countries. These agricultural production practices are increasingly subject to governmental regulations intended to protect air resources. It is therefore important that an accurate and robust agricultural emission factors database exist to provide valid scientific support of these regulations. This paper highlights some of the recent work that was presented at the 2006 Workshop on Agricultural Air Quality in Washington, D.C. regarding NH3 emissions estimates and emission factors from agricultural sources in the U.S. and Europe. In addition, several best management practices are explored as the scientific community attempts to maximize the beneficial use of reactive nitrogen while simultaneously minimizing negative environmental impacts.     

Biological Responses to Contrasting Hydrology in Backwaters of Upper Mississippi River Navigation Pool 25

Water level management in Mississippi River Pool 25 differentially influences off-channel habitats in the mid-pool and lower pool. Hydrologic models indicate lower pool off-channel habitats dry with greater frequency and duration compared to similar habitats at mid-pool. We examined the influence of this contrasting hydrology on substrate characteristics, organic matter, macroinvertebrate, and fish communities in off-channel habitats during 2001–2003. Benthic organic matter standing stocks were stable in mid-pool habitats but lower pool values were variable because of annual differences in moist-soil vegetation production. Generally, small-bodied and multivoltine invertebrate taxa had high community biomass and dominated lower pool habitats, whereas longer-lived and large-bodied taxa were more abundant and had higher community biomass in mid-pool habitats having longer hydroperiods. Fish communities were dominated by cyprinids in both habitats, and mid-pool habitats tended to be higher in overall species richness. Unique fish taxa were collected in each pool, with primarily rheophilic forms in mid-pool habitats and limnophilic forms in lower pool habitats. Results indicate that contrasting hydrology associated with a mid-pool control point directly and indirectly influences biological communities in off-channel habitats. Further, management regimes that promote hydrologic diversity in off-channel habitats may enhance biological diversity at larger spatial and temporal scales.     

Microbial community dynamics in a chemolithotrophic denitrification reactor inoculated with methanogenic granular sludge

Denitrification is applied in the tertiary treatment of wastewater to reduce nitrogen pollution. Fluorescence in situ hybridization (FISH), catalyzed reporter deposition (CARD)-FISH, cloning, and scanning electron microscopy (SEM) were applied to follow the evolution of the microbial composition and structure of granular sludge in chemolithotrophic denitrifying bioreactors fed with nitrate and thiosulfate. FISH oligonucleotide probes for the chemolitoautotrophic denitrifiers Thiobacillus denitrificans and Thiomicrospira denitrificans were designed and their utility tested. CARD-FISH and cloning data showed that bacterial diversity in the biofilms changed during the reactor operation. Chemoorganotrophic fermentative Gram-positive strains in the phyla, Actinobacteria and Firmicutes, were dominant in the methanogenic inoculum, both in terms of biodiversity and in number. Other significant phyla were Bacteroidetes and Chloroflexi. After 6 months of operation, Proteobacteria became dominant (83% of the clones). The diversity of Gram-positive bacteria was partially maintained although their abundance decreased notably. After 110 d of operation, the abundance of Tb. denitrificans cells increased considerably, from 1% to 35% of total DAPI-stained cells and from no isolated clones to 15% of the total clones. Tm. denitrificans only represented a minor fraction of the microorganisms in the sludge (1-4% of the DAPI-stained cells). These findings confirm that Tb. denitrificans was the dominant chemolitoautotrophic denitrifying microorganism in the bioreactors. The Archaeal diversity remained almost unchanged and it was represented mostly by Methanosaeta soehngenii. SEM results indicated a considerable loss in the integrity of the sludge granules during the operation, with risk of sludge buoyancy.