Phosmet residues in an orchard and adjacent recreational area 1

Abstract

Two cover sprays of phosmet were applied to an orchard adjoining a camping area and a bird sanctuary with a resident goose population. Insecticide residues were monitored on orchard leaves, orchard ground cover, ground cover in the camp‐site and along the adjacent lakeshore. Despite attempts to minimize drift, significant spray residues were found outside the target area. Residues on ground cover and leaves were reduced by sprinkler irrigation subsequent to spray application.     

Interinstrument comparison of remote-sensing devices and a new method for calculating on-road nitrogen oxides emissions and validation of vehicle-specific power

Emissions of nitrogen oxides (NOx) by vehicles in real driving environments are only partially understood. This has been brought to the attention of the world with recent revelations of the cheating of the type of approval tests exposed in the dieselgate scandal. Remote-sensing devices offer investigators an opportunity to directly measure in situ real driving emissions of tens of thousands of vehicles. Remote-sensing NO₂ measurements are not as widely available as would be desirable. The aim of this study is to improve the ability of investigators to estimate the NO₂ emissions and to improve the confidence of the total NOx results calculated from standard remote-sensing device (RSD) measurements. The accuracy of the RSD speed and acceleration module was also validated using state-of-the-art onboard global positioning system (GPS) tracking. Two RSDs used in roadside vehicle emissions surveys were tested side by side under off-carriageway conditions away from transient pollution sources to ascertain the consistency of their measurements. The speed correlation was consistent across the range of measurements at 95% confidence and the acceleration correlation was consistent at 95% confidence intervals for all but the most extreme acceleration cases. VSP was consistent at 95% confidence across all measurements except for those at VSP ≥ 15 kW t^?1, which show a small underestimate. The controlled distribution gas nitric oxide measurements follow a normal distribution with 2σ equal to 18.9% of the mean, compared to 15% observed during factory calibration indicative of additional error introduced into the system. Systematic errors of +84 ppm were observed but within the tolerance of the control gas. Interinstrument correlation was performed, with the relationship between the FEAT and the RSD4600 being linear with a gradient of 0.93 and an R² of 0.85, indicating good correlation. A new method to calculate NOx emissions using fractional NO₂ combined with NO measurements made by the RSD4600 was constructed, validated, and shown to be more accurate than previous methods.

Implications: Synchronized remote-sensing measurements of NO were taken using two different remote-sensing devices in an off-road study. It was found that the measurements taken by both instruments were well correlated. Fractional NO₂ measurements from a prior study, measurable on only one device, were used to create new NO_x emission factors for the device that could not be measured by the second device. These estimates were validated against direct measurement of total NO_x emission factors and shown to be an improvement on previous methodologies. Validation of vehicle-specific power was performed with good correlation observed.     

Dioxins and furans in emissions from medical waste incinerators

Dioxins and furans were detected in emissions from eight medical waste incinerators tested in California. Total uncontrolled emissions ranged from 363 to 11, 811 nanograms per dry standard cubic meter. The most effective of three wet scrubbers achieved an emissions control efficiency of 95 percent for total PCDD and PCDF. A baghouse was less than 30 percent efficient in removing PCDD and PCDF from the incinerator emissions.     

Miscible fluid displacement stability in unconfined porous media:: Two-dimensional flow experiments and simulations

In situ flushing groundwater remediation technologies, such as cosolvent flushing, rely on the stability of the interface between the resident and displacing fluids for efficient removal of contaminants. Contrasts in density and viscosity between the resident and displacing fluids can adversely affect the stability of the displacement front. Petroleum engineers have developed techniques to describe these types of processes; however, their findings do not necessarily translate directly to aquifer remediation. The purpose of this laboratory study was to investigate how density and viscosity contrasts affected cosolvent displacements in unconfined porous media characterized by the presence of a capillary fringe. Two-dimensional flow laboratory experiments, which were partially scaled to a cosolvent flushing field experiment, were conducted to determine potential implications of flow instabilities in homogeneous sand packs. Numerical simulations were also conducted to investigate the differential impact of fluid property contrasts in unconfined and confined systems. The results from these experiments and simulations indicated that the presence of a capillary fringe was an important factor in the displacement efficiency. Buoyant forces can act to carry a lighter-than-water cosolvent preferentially into the capillary fringe during displacement of the resident groundwater. During subsequent water flooding, buoyancy forces can act to effectively trap the cosolvent in the capillary fringe, contributing to the inefficient removal of cosolvent from the aquifer.     

Hydrological and geochemical factors affecting leachate composition in municipal solid waste incinerator bottom ash: Part I: The hydrology of Landfill Lostorf, Switzerland

The objective of the investigation of the municipal solid waste incinerator (MSWI) bottom ash landfill, Landfill Lostorf, was to determine the residence time of water in the landfill and the flow paths through the landfill. Over a period of 22 months, measurements of rainfall, landfill discharge and leachate electrical conductivity were recorded and tracer experiments made. Over the yearly period 1995, approximately 50% of the incident rainfall was measured in the discharge. An analysis of single rain events showed that in winter, 90–100% of rainfall was expressed in the landfill discharge, whereas in summer months, the value was between 9 and 40% depending on the intensity of the rain event. The response to rainfall was rapid. Within 30–100 h, approximately 50% of water discharged in response to a rain event had left the landfill. The discharge was less than 4 l/min for approximately 50% of the measurement periods. Qualitative tracer studies with fluorescein, pyranine and iodide clearly showed the existence of preferential flow paths. This was further substantiated by quantitative tracer studies of single rain events using / ratios and electrical conductivity measurements. The proportion of rainwater passing directly through the landfill was found to be between 20 and 80% in summer months and around 10% in winter months. The difference has been ascribed to the water content in the landfill. The average residence time of the water within the landfill has been estimated to be roughly 3 years and this water is the predominant component in the discharge over a yearly period.     

Interaction of higher marine fungi with the herbicide atrazine. III. Adsorption of atrazine to the marine fungus Dendryphiellasalina

The adsorption of the herbicide ¹⁴C-atrazine to the marine fungus $\text{Dendryphiella}$$\text{salina}$ was studied using sodium azide as an inhibitor of active uptake. Adsorption of atrazine (94 ppb) was found to reach equilibrium within six hours. Adsorption as a function of concentration (9.4 to 468 ppb) conformed to the empirically derived Freundlich equation giving a K value of 6.2. Atrazine on the fungal cell surface was easily desorbed by successive artificial seawater washes indicating a relatively loose binding. The ability of the marine fungus $\text{D.}$$\text{salina}$ to remove ¹⁴C-atrazine from an artificial seawater medium suggests an environmental role in the transport and redistribution of atrazine in estuaries.     

Exposure to polychlorinated biphenyls from an overheated transformer

A Polychlorinated Biphenyl (PCB) containing transformer released approximately 50 gallons of askarel oil. No polychlorinated dibenzofurans (PCDF) or polychlorinated dibenzodioxins (PCDD) were detected in a sample of the askarel (analytical limit of detection of 40 parts per billion per isomer group). Skin irritation, unusual tiredness, and headaches occurred in approximately 20% of the individuals at the scene of the incident. Serum PCB levels, and mean values for blood and urine tests were within normal ranges.     

Brominated flame retardant concentrations and trends in abiotic media

BFR burdens in abiotic media have been less studied than in biota, despite their essential value as an aide to identifying sources, temporal and geographic trends and exposure routes. Many polymer products consist of several percent by weight of BFRs. Global trade in these can result in rapid and wholesale BFR movement. Loss from in-use products of nonreactive BFRs may be important, particularly in respect to indoor exposure. In the case of BDE-209, discharges from publicly owned treatment works may be substantial. BFR burdens in air, water and sewage sludge respond rapidly to changes in environmental BFR inputs. PBDEs have been the most widely studied. In many locales PBDE burdens in these media now surpass those of PCBs. Air and water near sources and urban areas are typically enriched relative to rural locales. The more volatile PBDEs dominate in the vapor phase, while BDE-209 typically predominates on particulates. Evidence exists for long-range transport of the more volatile PBDEs. A greater diversity of BFRs (mostly PBDEs, HBCD and TBBP-A) has been detected in sewage sludges. Land application of these sludges on agricultural fields is one conduit for soil contamination. In general, environmental concentrations of BDE-209 appear to be increasing, while penta-BDE burdens in Europe may have peaked. Sediments function as longer-term integrators of environmental burdens. Concentrations of common BFRs therein may be substantial near point sources. Evidence for debromination in the environment has been limited to date. However, some laboratory and field observations suggest it is possible to a limited extent.     

Does lipophilicity of toxic compounds determine effects on drought tolerance of the soil collembolan Folsomia candida?

The ability of Collembola to survive drought stress is crucial for their distribution in the terrestrial environment. Previous studies have suggested that several toxic compounds affect the drought tolerance of Folsomia candida in a synergistic manner and that these compounds have the feature in common that they elicit their toxicity by causing membrane damage. We hypothesised that the detrimental effect of toxic chemicals on drought tolerance in F. candida depends on the lipophilicity (log K(ow)) of the compound because a higher log K(ow) would mean a closer interaction with membranes. In this study the three chemicals 4-nonylphenol, pyrene and p,p'-DDE were tested. Surprisingly, 4-nonylphenol, with the lowest log K(ow), was the most potent with respect to reducing drought tolerance followed by pyrene, suggesting that interactions between drought tolerance and chemical stress do not depend on lipophilicity alone.