Organochlorine pesticides and polychlorinated biphenyls (PCBs) in eggs of red-legged frogs (Rana aurora) and northwestern salamanders (Ambystoma gracile) in an agricultural landscape

Organochlorine pesticides were widely used in the past in Sumas Prairie, British Columbia, Canada. In the 1990s, the hatching success of amphibians from agricultural sites was significantly depressed in the Sumas Prairie compared to reference sites. Therefore, in this study, organochlorine pesticides and polychlorinated biphenyls (PCBs) were measured in eggs of red-legged frogs (Rana aurora) and northwestern salamanders (Ambystoma gracile) from the Sumas Prairie. Egg masses were sampled from three agricultural sites that were exposed to agricultural runoff, and three reference sites that had lower agricultural runoff exposures. Not only was there little difference in contamination between agricultural and reference sites, but the levels of pesticides and PCBs found were lower than the concentrations reported to cause developmental or behavioural problems in amphibians.     

Organic mercury levels among the Yanomama of the Brazilian Amazon Basin

The Catrimani River basin in northern Brazil is the home of the Yanomama and has been the site of renegade gold mining since 1980. Gold-mining operations release inorganic mercury (Hg) into the environment where it is organified and biomagnified in aquatic ecosystems. Ingestion of mercury-contaminated fish poses a potential hazard to fish-eating populations such as the Yanomama. We surveyed Hg levels in Yanomama villagers living near mined and unmined rivers in 1994 and 1995, and analyzed Hg levels in piranha caught by villagers. In 1994, 90 Yanomama Indians from 5 villages and in 1995, 62 Yanomama Indians from 3 villages participated in the studies. Four villages surveyed in 1994 were located directly on the Catrimani River, approximately 140-160 km downstream from past gold-mining activities. The other village surveyed in 1994 was situated on the unmined Ajaraní River. In 1995, 2 of the Catrimani River villages were revisited, and a third Yanomama village, on the unmined Pacu River, was surveyed. Blood organic mercury levels among all villagers surveyed ranged from 0 to 62.6 microg L(-1) (mean levels in each village between 21.2 microg L(-1) and 43.1 microg L(-1)). Mercury levels in piranha from the mined Catrimani River ranged from 235 to 1084 parts per billion (ppb). Nine of 13 piranhas, measuring 30 cm or longer had total mercury levels which exceeded mercury consumption limits (500 ppb) set by both the World Health Organization and the Brazilian Ministry of Health. Unexpectedly, high mercury levels were also observed in fish and villagers along the unmined Ajaraní and Pacu Rivers suggesting that indirect sources may contribute to environmental mercury contamination in the Amazon basin.     

Designing monitoring networks to represent outdoor human exposure

Measurements of outdoor human exposure to suspended particulate matter (PM) are always constrained by available resources. An effective network design requires tradeoffs between variables measured, the number of sampling locations, sample duration, and sampling frequency. Sampling sites are needed to represent neighborhood and urban spatial scales with minimal influences from nearby sources. Although most PM measurements for determining compliance with standards are taken over 24-h periods every third to sixth day, outdoor human exposure assessment requires measurements taken continuously throughout the day, preferably over durations of 1 h or less. More detailed particle size and chemistry data are also desirable, as smaller size fractions and specific chemicals may be better indicators of adverse health effects than total mass samples.     

A comparative evaluation of accelerated solvent extraction and Polytron extraction for quantification of lipids and extractable organochlorine in fish

Optimal conditions for extraction methods using an accelerated solvent extractor (ASE) and a Polytron homogenizer were established for quantification of (crude) lipids and extractable organochlorine (EOCl) in fish. The two methods, an ASE consecutive extraction at 55 and 100 degrees C for ground, freeze-dried filets, and a Polytron extraction at room temperature with four repetitions for ground, wet filets and with two repetitions for wet fish livers were evaluated in terms of reproducibility and comparability. With respect to lipid measurement, the two methods have comparable reproducibility and the experimental errors are relatively small compared to natural variations of fish to fish within a sampling site. For EOCl measurement, the relative standard deviation tends to increase with decreasing levels of EOCl in specimens. An important factor for the relative standard deviation of measurements of analytes present at trace levels in fish matrices is sampling error in taking aliquots. Statistical analysis using a paired comparison design showed that measurement values (crude lipids or EOCl) obtained from these two extraction methods are, in general, not equivalent. There is a good correlation between the two methods for lipid measurement; whereas for EOCl measurements, high degrees of correlation exist within the exposed fish group, but not in the reference group.     

Impurities in industrial grade 4,4'-isopropylidene diphenol (bisphenol A): possible implications for estrogenic activity

Fifteen trace impurities, including a novel cyclohexene derivative, have been identified and quantified in samples of an industrial grade of the oestrogen-active compound 4,4'-isopropylidene diphenol (bisphenol A). All of these compounds, like bisphenol A itself, possess phenolic hydroxyl groups para to other substituents and all thus might also have oestrogenic properties. Published studies on the endocrine disrupting properties of bisphenol A have not considered potentially active impurities but full assessment of the oestrogenicity of bisphenol A, as it is used commercially, will become possible when adequate supplies of these compounds are available through synthesis.     

Characterizing the source/sink behavior of double-layer building materials

A model is developed to predict the rate of mass transfer between a double-layer material and indoor air. The model allows non-uniform initial material-phase concentrations in each of the two layers and a transient influent gas-phase concentration to be considered. This model builds on a recently validated single-layer model and should prove useful in predicting the behavior of double-layer material assemblies. Many indoor furnishings and building structures are comprised of layers of different material. The approach taken here represents a first step in the development of a more generally applicable multi-layer model. An analytical solution to the double-layer model is obtained and a parametric analysis is performed illustrating the behavior of the model as a function of the primary model parameters. The paper concludes by examining the potential use of thin diffusion barriers to reduce material emission rates and a hypothetical example of emissions from an adhesive that is part of an adhesive/material assembly.     

Water transformation in the media of biofilters controlled by Rhodococcus fascians in treating an ethyl acetate-contaminated airstream

Biofilters do not provide much water for bacteria to grow. To use them efficiently and properly, it is essential to understand the kinetics of water transformation and to control moisture levels. This study aims to clarify whether the metabolism of microorganisms will improve the water-holding capacity of media or will intensify drying. This experiment was conducted in duplicate, that is, both with and without bacterial inoculation. Both the constant water content mode and the declining water content mode show that microbial growth in a log phase will enhance drying. In contrast, the bacteria growing in a logarithmic decline phase will improve water-holding capacity. Basically, water evaporation can result from the latent heat obtained from microbial respiration or from the physical temperature difference between the unsaturated air and the wet media. Two ways that biofilters can gain water are from water incorporated into bacteria cells and from water obtained from the oxidation of volatile organic compounds (VOCs).