Usability of non-standard lower anchor configurations for child restraint system (CRS) installation

Abstract

Objectives: The objective of this study was to determine whether the amount of tension required for proper child restraint system (CRS) installation varies with lower anchor spacing and to determine whether nonexperts can produce adequate tension on wider-than-standard lower anchor configurations.

Methods: CRSs were installed by certified child passenger safety technicians (CPSTs; n?=?6 subjects, n?=?72 installations) and nonexperts (n?=?30 subjects, n?=?120 installations) on a mock-up vehicle seat fixture with lower anchors set at 11 (standard), 15, 19, and 23 in. apart from one another. Each CPST installed a rear-facing (RF) infant base, RF convertible, and forward-facing (FF) convertible into each of the 4 spacing configurations in random order. The CPSTs were instructed to tighten the lower connector strap until the tension was exactly at the threshold between passing and failing the 1-in. test. Each nonexpert installed one CRS model into all 4 spacing conditions in random order. Nonexperts were instructed to install the CRS to the best of their ability. The tension produced on the lower connector strap was recorded via load cell in the lower anchor assembly of the vehicle seat. Resultant tension magnitudes were compared across spacing conditions using matched pair t-tests. The CPSTs’ mean 1-in. test threshold values were compared to tensions produced by nonexperts. Installations were visually evaluated for errors and qualitative usability feedback was collected via survey.

Results: CPSTs installed the infant base with higher tensions in the 15-, 19-, and 23-in. configurations compared to the standard 11-in. configuration (P = .034, .032, and .003, respectively). The nonexperts installed the infant base with higher tension in the 15- and 23-in. configurations compared to the 11-in. configuration (P = .004 and .026, respectively). The RF convertible and FF convertible installations showed no significant differences in tension among any of the spacing configurations for either group. Only 19% of the nonexperts’ installations were tight enough to pass CPST thresholds, and the pass rate did not vary with respect to lower anchor spacing. In feedback surveys, the nonexpert group did not show a consistent preference for either standard or wider-than-standard lower anchor configurations.

Conclusions: The amount of tension required to pass the 1-in. rule did not vary with lower anchor spacing configurations for the RF and FF convertible CRS, but the infant base required more tension in wider anchor configurations. Nonexperts tended to produce less than ideal tension in all configurations, although their tension magnitudes increased for the infant base in wider configurations.     

Environmental pollutants and type 2 diabetes: a review of human studies

The incidence of diabetes has increased dramatically in recent decades and become one of the leading health problems worldwide. Lifestyle and dietary changes alone cannot account for the dramatic rise of diabetes, while an increasing number of publications have reported the possible relationships between exposure to environmental pollutants and risk of diabetes. In the present review, our objective was to summarize the human studies on environmental pollutants, which includes persistent organic pollutants, pesticides (not on the Stockholm Convention list), bisphenol A, and phthalates, and the risk of diabetes. Currently published results suggest a positive relationship between certain persistent organic pollutants (dichlorodiphenyldichloroethene, dichlorodiphenyltrichloroethane, hexachlorobenzene, and polychlorinated biphenyls) and bisphenol A exposure and risk of diabetes. For pyrethroids, organophosphates, carbamates, and phthalates, there are insufficient studies to reach conclusions and therefore more studies, especially prospective studies, are needed along with in vivo and in vitro studies to understand the underlying mechanisms.     

Think globally,act locally: neighbourhood pollution and the future of the earth

Each year governments and industry around the globe spend billions of dollars in search of treatments and cures for diseases that shorten lives, which often means gadgets, implants, radiation and pills. These “cures”, do not get to the root of the problem. Perhaps it is time for us to adjust our thinking to be more proactive instead of reactive in public health. Perhaps we need to consider confronting environmental pollution of air, soil and water at a local level. As the Physicians for Social Responsibility point out, we should be “preventing what we cannot cure”. One such preventive measure is ensuring that our communities, including our poor inner-city neighbourhoods, enjoy a clean environment. We challenge local and national policy-makers to respond to the global call and to take action to address environmental toxins; to take local action to ameliorate the pollution of the air, water and soil in so many of our nation’s neighbourhoods. A person’s neighbourhood, and the proximity of dangerous environmental contaminants within it, is a powerful predictor of how long s/he will live. While situations like the poisoning of the water in Flint, Michigan have gotten some attention, they are generally treated as the exception rather than a reflection of real environmental hazards that exist in the west. Moreover we wonder why more endemic issues of neighbourhood environmental contamination that shorten human lives are not a priority for local action or that it is not linked to disproportionate production of greenhouse gases that cause climate change/warming/chaos.     

A case study of an isolated wind powered electricity system meeting 100% of local demand

Using meteorological and electricity demand data for a 4-year period, electricity demand in Shetland was modeled to provide an estimate of the demand over a 30-year period from 1 January 1981. That modeled demand was then compared to estimated wind power output over the same period using the WAsP model. The wind farm output was estimated for a range of sizes of wind farm up to the consented 370 MW Viking Wind Farm in Shetland. Some wind power was available for 94% of the time and the 370 MW wind farm would meet 100% of demand for nearly 80% of the time. The statistics of single and accumulated deficits were calculated for a range of wind farms and estimates of the amount of additional generation capacity and additional power requirements were assessed. The study suggests that with storage, wind power in Shetland could meet all electricity demand in Shetland at around £130 to £150/MWh (excluding subsidy) and with a grid connection allowing the sale of excess power, those costs could be reduced.     

Volatile Organic Compounds from Coal Tar and Soil Vapor Samples at MGP Sites

This study characterized organic compounds found in New York State manufactured gas plant (MGP) coal tar vapors using controlled laboratory experiments from four separate MGP sites. In addition, a limited number of deep (0.3–1.2 m above coal tar) and shallow (1.2–2.4 m above coal tar) soil vapor samples were collected above the in situ coal tar source at three of these sites. A total of 29 compounds were consistently detected in the laboratory-generated coal tar vapors at 50°C, whereas 24 compounds were detected at 10°C. The compounds detected in the field sample results were inconsistent with the compounds found in the laboratory-generated samples. Concentrations of compounds in the shallow soil vapor sample were either non-detectable or substantially lower than those found in deeper samples, suggesting attenuation in the vadose zone. Laboratory-generated data at 50°C compared the (% non-aromatic)/(% aromatic) ratio and indicated that this ratio may provide good discrimination between coal tar vapor and common petroleum distillates.     

Wild tomato leaf extracts for spider mite and cowpea aphid control

Glandular trichomes on the leaves of wild tomato, L. hirsutum f. hirsutum Mull, also known as Solanum habrochaites (Solanaceae), synthesize and accumulate high levels of methyl ketones (MKs). L. hirsutum accession LA 407, having high concentration of MKs, was grown from seeds under greenhouse conditions. Four MKs (2-undecanone, 2-dodecanone, 2-tridecanone, and 2-pentadecanone) were screened for their toxicity to spider mites, Tetranychus urticae Koch and cowpea aphids, Aphis craccivora Koch. The objectives of this investigation were to: (1) develop a bioassay for testing MKs on spider mite and cowpea aphid mortality and (2) compare the efficacies of wild tomato leaf crude extracts and pure standard materials of MKs against spider mite and cowpea aphid mortality. Our results revealed that spider mites are most sensitive to 2-tridecanone (LC₅₀ = 0.08 μmole cm^?2 of treated leaf surface) and least sensitive to 2-undecanone (LC₅₀ = 1.5 μmole cm^?2 of treated leaf surface) 4 h after treatment. Similarly, 2-tridecanone caused greatest mortality (LC₅₀ = 0.2 μmole cm^?2 of treated leaf surface), whereas 2-undecanone caused the lowest morality (LC₅₀ = 0.48 μmole cm^?2 of treated surface) of cowpea aphid. We concluded that all MKs tested in this investigation are toxic to spider mites and aphids. 2-Tridecanone is more effective in killing mites and aphids compared to other MKs. Toxicity of crude extracts, prepared from the leaves of L. hirsutum accession LA 407, to spider mites and cowpea aphids revealed greater mortality compared to a combined mixture of MKs standard material (used at the same concentration as found on LA 407 leaves). This indicates that in addition to MKs, other unidentified compounds in LA 407 leaf extract also have pesticidal properties. Accordingly, leaf extracts of LA 407 could be explored in crop protection, and they might open a new area of MK formulations and discovery of biorational alternatives for pest control in agricultural fields.     

Indoor/Outdoor Measurements of Volatile Organic Compounds in the Kanawha Valley of West Virginia

The Kanawha Valley region of West Virginia which is comprised of Charleston and surrounding communities Is the center of a heavily industrialized area known for its chemical manufacturing. As part of a larger study designed to investigate the Impact of the chemical industry on human exposures to volatile organic compounds (VOC), a study of the relationship between indoor and outdoor concentrations was conducted. Thirty-five homes were selected for monitoring from among volunteers; approximately ten in each of three distinct population-industry centers and four outside the Valley to act as controls. Monitoring was performed using passive, badge samplers with a three-week monitoring period. Two separate questionnaires were administered: one for characterization of the residence; and one to characterize source use during monitoring. Participants were also asked to keep a record of their activities with respect to in-home, outdoors and other Indoor environments. Analysis of the samplers was performed by solvent extraction followed by gas chromatography using a flame-ionization detector. Results suggest that indoor VOC concentrations are higher than outdoor concentrations. Additionally, certain ventilation-related parameters were identified that afforded some predictive power for indoor concentrations. No statistically significant differences between regions were identified.