Impact of ozone on the growth of birch (Betula pendula) saplings

Saplings of one half-sib family of birch, Betula pendula, were exposed to three levels of ozone in open-top chambers (OTCs) during two growing seasons 1997-1998. The ozone treatments were non-filtered air (NF, accumulated daylight AOT40 over the two growing seasons of 3.0 l l-1 h), non-filtered air with extra ozone (NF+, accumulated daylight AOT40 of 27.3 l l-1 h) and non-filtered air with additional extra ozone (NF++, accumulated daylight AOT40 of 120 l l-1 h). The birch saplings, including the roots, were harvested after the first and second growing seasons. After the first growing season, the NF++ treatment reduced the total wood biomass by 22%, relative to the NF treatment. There was no further reduction of the total wood biomass in the NF++ treatment after the second growing season. The root biomass was reduced by 30% after the first growing season. The shoot/root ratio, as well as the proportional biomass of leaves, were increased by ozone during both years. The ozone impact on the relative growth rate was estimated to -2% per 10 l l-1 h daylight AOT40 per growing season.     

Anaerobic digestion of thermo-oxidized excess municipal sludge.

The effect of a thermo-oxidative co-treatment placed between the two reactors of two-stage anaerobic digestion of excess municipal sludge was studied. The oxidant used was hydrogen peroxide (H2O2), and moderate temperatures below the boiling point of water were considered. The first experiment was to elucidate the effect of two different temperatures (65 and 90 degrees C) of oxidation using a constant oxidant dose of 1.0 g H2O2/g influent volatile suspended solids (VSSinfluent). The use of thermo-oxidative co-treatment increased overall solids destruction by 24.9 and 33.5%, respectively, when operating at 65 and 90 degrees C, respectively. Because of this significant effect of temperature on the performance of the process, a second experiment was conducted using the higher temperature of 90 degrees C while decreasing the hydrogen peroxide dosage to 0.5, 0.25, and 0.1 g H2O2/g VSSinfluent. An increase in solids destruction of 13.9, 18.9, and 25.6% was observed when the thermo-oxidative co-treatment was used using oxidant dosages of 0.1, 0.25, and 0.5 g H2O2/g VSSinfluent, respectively.     

ESPR subject area 5 ‘Environmental Microbiology, (Bio)Technologies, Health Issues’

Goal, Scope and Background  Aquaculture activities are well known to be the major contributor to the increasing level of organic waste and toxic compounds in the aquaculture industry. Along with the development of intensive aquaculture in China, concerns are evoked about the possible effects of everincreasing aquaculture waste both on productivity inside the aquaculture system and on the ambient aquatic ecosystem. Therefore, it is apparent that appropriate waste treatment processes are needed for sustaining aquaculture development. This review aims at identifying the current status of aquaculture and aquaculture waste production in China. Main Features  China is the world’s largest fishery nation in terms of total seafood production volume, a position it has maintained continuously since 1990. Freshwater aquaculture is a major part of the Chinese fishery industry. Marine aquaculture in China consists of both land-based and offshore aquaculture, with the latter mostly operated in shallow seas, mud flats and protected bays. The environmental impacts of aquaculture are also striking. Results  Case studies on pollution hot spots caused by aquaculture have been introduced. The quality and quantity of waste from aquaculture depends mainly on culture system characteristics and the choice of species, but also on feed quality and management. Wastewater without treatment, if continuously discharged into the aquatic environment, could result in remarkable elevation of the total organic matter contents and cause considerable economy lost. Waste treatments can be mainly classified into three categories: physical, chemical and biological methods. Discussion  The environmental impacts of different aquaculture species are not the same. New waste treatments are introduced as references for the potential development of the waste treatment system in China. The most appropriate waste treatment system for each site should be selected according to the sites’ conditions and financial status as well as by weighing the advantages and disadvantages of each system. Strategies and perspectives for sustainable aquaculture development are proposed, with the emphasis on environmental protection. Conclusions  Negative effects of waste from aquaculture to aquatic environment are increasingly recognized, though they were just a small proportion to land-based pollutants. Properly planned use of aquaculture waste alleviates water pollution problems and not only conserves valuable water resources but also takes advantage of the nutrients contained in effluent. It is highly demanding to develop sustainable aquaculture which keeps stocking density and pollution loadings under environmental capacity. Recommendations and Perspectives  The traditional procedures for aquaculture waste treatment, mainly based on physical and chemical means, should be overcome by more site-specific approaches, taking into account the characteristics and resistibility of the aquatic environment. Further research needs to improve or optimize the current methods of wastewater treatment and reuse. Proposed new treatment technology should evaluate their feasibility at a larger scale for practical application. ESS-Submission Editor: Dr. Ding Wang (wangd@ihb.ac.cn)     

Cobalt-based alumina pillared zirconium phosphate catalysts for the selective catalytic reduction of NO by propane

A series of cobalt containing alumina pillared zirconium phosphate materials have been prepared by ion exchange or by impregnation, and fully characterised. The catalytic behaviour of these materials in the selective catalytic reduction of NO by propane, in excess of oxygen, at temperatures ranging between 350 and 550 degrees C, has been also evaluated. A maximum NO conversion close to 14% is obtained on Co-impregnated catalysts heated at 600 degrees C. The NO reduction seems to be related to the presence of Co3+, thus the calcination temperature of samples influences the resulting activity much more than the cobalt content.     

Concentrations of cadmium and other metals in Fucus vesiculosus L. and Fontinalis dalecarlica Br. Eur. from the northern Baltic Sea and the southern Bothnian Sea

Concentrations of Cd and ten other metals (Al, Co, Cr, Cu, Fe, Mn, Ni, Pb, V and Zn) were determined in the brown seaweed Fucus vesiculosus L. and the aquatic moss, Fontinalis dalecarlica Br. Eur. from the northern Baltic Sea and the southern Bothnian Sea. Elevated concentrations of metals were found in samples taken close to densely populated areas, such as Stockholm and Nyn?shamn. Very high concentrations of especially Zn were found in both Fucus and Fontinalis samples taken from the area south of the Gulf of G?vle. The results indicate that mining and industrial activities along the river Dal?lven are the main sources of Zn and several other metals. Cd concentrations in Fucus plants reached maximum values (24.5 mg kg(-1)) at the northern site. The gradual increase of Cd concentrations in Fucus plants northward could not be totally explained by the salinity gradient in the Baltic Sea; reasons for this are discussed in this paper.     

Comparison of vehicle exhaust emissions from modified diesel fuels

Three diesel fuels, one oil sand-derived (OSD) diesel serving as base fuel, one cetane-enhanced base fuel, and one oxygenate [diethylene glycol dimethyl ether (DEDM)]-blended base fuel, were tested for their emission characterizations in vehicle exhaust on a light-duty diesel truck that reflects the engine technology of the 1994 North American standard. Both the cetane-enhanced and the oxygenate-blended fuels were able to reduce regulated [CO, particulate matter (PM), total hydrocarbon (THC)] and nonregulated [polyaromatic hydrocarbons (PAHs), carbonyls, and other volatile organic chemicals] emissions, except for nitrogen oxides (NO(x)), compared with the base fuel. Although burning a fuel that contains oxygen could conceivably yield more oxygenated compounds in emissions, the oxygenate-blended diesel fuel resulted in reduced emissions of formaldehyde along with hydrocarbons such as benzene, 1,3-butadiene, and PAHs. Reductions in nitro-PAH emissions have been observed in both the cetane-enhanced and oxygenated fuels. This further demonstrates the benefits of using a cetane enhancer and the oxygenated fuel component.     

A voltammetric screening method to determine ronidazole in bovine meat

Abstract

An original voltammetric screening method, employing glassy carbon electrode (GCE) with the differential-pulse voltammetry technique (DPV), has been developed to determine residues of the anti-parasitic agent Ronidazole (RNZ) in bovine meat. By using cyclic voltammetry (CV), it has been demonstrated that an irreversible cathodic process occurs at approximately ?0.740?V (vs. Ag|AgCl, KCl 3?mol L^?1) in a 0.100?mol L^?1 phosphate buffer at pH 6.5 as supporting electrolyte. Furthermore, the behavior of RNZ in CV indicates the occurrence of a diffusion mass transfer process to the working electrode surface. The RNZ reduction mechanism was proposed as a 6-electron transfer, similar to Metronidazole under the same pH range. Quantification of RNZ and method validation were then carried out by DPV. The relative standard deviation (RSD) were 3.21% for intraday precision of 10 consecutive repetitions and 6.78% for interday precision after five analysis. Limits of detection and quantification were also obtained, and the values were 0.107 and 0.358?mg kg^?1, respectively. The recovery percentage for three different concentrations of RNZ in the bovine meat matrix ranged between 98.1% and 100.3%. The method proved to be efficient for screening RNZ in bovine meat.     

Effects of the phenylurea herbicide isoproturon on periphytic diatom communities in freshwater indoor microcosms

The toxic effects of the phenylurea herbicide Isoproturon -IPU: (3-(4-isopropylphenyl)-1, 1-dimethylurea)-were studied on the colonization of periphytic diatom communities, within indoor microcosms consisting of a mixed biotope (water column and natural sediment) and two biological species-rooted macrophyte cuttings (Elodea densa) and benthic bivalve molluscs (Corbicula fluminea). The periphyton, essentially composed of diatoms, was collected on artificial substrata (glass slides) in the upper layers of the water column, after two periods of exposure (34 and 71 days). IPU was initially added in the water or in the sediment compartment, at two nominal concentrations (L1 and L2 levels) for each contamination source-5 and 20 microg litre(-1) and 100 and 400 microg kg(-1) in sediment (w/w) respectively. The effects of IPU on the density and community structure of periphytic diatoms are described. A marked reduction in the diatom density was observed after 34 days exposure to the lower concentration of IPU in the water (5 microg litre(-1)). For the L2 levels, the very small number of live cells present did not permit quantification of the diatom density. After 71 days, recovery in community parameters occurred for the two contamination levels of the sediment and water column sources. Samples collected in the experimental units contaminated with the L2 levels were dominated by heterotrophic and smaller diatom species, such as Sellaphora seminulum. Data treatment based on factorial discriminant analysis enabled us to distinguish the different contamination conditions, with only 11 species from the 130 taxa identified.     

Geochemical characterization of acid mine drainage from a waste rock pile, Mine Doyon, Québec, Canada

Water quality in the unsaturated and saturated zones of a waste rock pile containing sulphides was investigated. The main objectives of the project were (1) the evaluation of geochemical trends including the acid mine drainage (AMD)-buffering mechanism and the role of secondary minerals, and (2) the investigation of the use of stable isotopes for the interpretation of physical and geochemical processes in waste rock. Pore water in unsaturated zone was sampled from suction lysimeters and with piezometers in underlying saturated rocks. The investigation revealed strong temporal (dry period vs. recharge period), and spatial (slope vs. central region of pile) variability in the formation of acid mine drainage. The main secondary minerals observed were gypsum and jarosite. There was a higher concentration of gypsum in solid phase at Site TBT than at Site 6, suggesting that part of the gypsum formed at Site 6 in the early stage of AMD has been already dissolved. Formation of secondary minerals contributed to the formation of AMD by opening of foliation planes in waste rock, thus increasing the access of oxidants like O2 and Fe3+ to previously encapsulated pyrite. The behavior of several dissolved species such as Mg, Al, and Fe2+ can be considered as conservative in the leachate. Stable isotopes, deuterium and 18O, indicated internal evaporation within the pile, and were used to trace recharge pulses from snowmelt. Isotope trends for 34S and 18O(SO4) indicated a lack of sulfate reduction and zones of active oxidation of pyrite, respectively. Results of numerical modeling of pyrite oxidation and gas and water transport were consistent with geochemical and isotopic trends and confirmed zones of high evaporation rate within the rock pile close to the slope. The results indicate that physical and chemical processes within the pile are strongly coupled and cannot be considered separately when oxidation rates are high and influence gas transport as a result of heat generation.     

Temperature dependence of Henry's law constants of metolachlor and diazinon

A dynamic system based on the water/air equilibrium at the interface within the length of a microporous tube has been used to determine experimentally the Henry's law constants (HLC) of two pesticides: metolachlor and diazinon. The measurements were conducted over the temperature range 283-301 K. At 293 K, HLCs values are (42.6+/-2.8) x 10(3) (in units of M atm(-1)) for metolachlor and (3.0+/-0.3)x10(3) for diazinon. The obtained data were used to derive the following Arrhenius expressions: HLC=(3.0+/-0.4) x 10(-11) exp((10,200+/-1,000)/T) for metolachlor and (7.2+/-0.5) x 10(-15) exp((11,900+/-700)/T) for diazinon. At a cumulus cloud temperature of 283 K, the fractions of metolachlor and diazinon in the atmospheric aqueous phase are about 57% and 11% respectively. In order to evaluate the impact of a cloud on the atmospheric chemistry of both studied pesticides, we compare also their atmospheric lifetimes under clear sky (tau(gas)), and cloudy conditions (tau(multiphase)). The calculated multiphase lifetimes (in units of hours) are significantly lower than those in gas phase at a cumulus temperature of 283 K (in parentheses): metolachlor, 0.4 (2.9); diazinon, 1.9 (5.0).