Efficiency of natural reproduction of sturgeons in the lower Volga under current conditions

The results are presented that have been obtained during long-term studies (1991–2009) on the efficiency of natural reproduction of the beluga, Russian sturgeon, stellate sturgeon, and sterlet in different spawning zones of the Volga. The influence of major environmental factors on the formation of the offspring of these fishes is analyzed. It is shown that the productivity of Volga spawning grounds varies depending on the river flow volume during spring floods and the abundance of active spawners. Practical recommendations are proposed for enhancing sturgeon reproduction in the Volga.     

Apparent Photosynthesis as a Measure of Air Pollution Damage

A system has been developed to automatically measure the effects of air pollutants in the ambient air on the rate of CO₂ exchange by intact leaves of citrus trees growing in the field. A miniaturized system utilizing the same nondispersive infrared CO₂ analyzer has been designed to study individually the effects of different concentrations of air pollutants on photosynthesis and respiration by plants.     

New Approaches to the Design of Afterburners for Varnish Cookers

The best method of controlling varnish kettle emissions is by thermal incineration. Two new approaches have been developed; these utilize the integral-blower burner and the non-powered raw gas burner. Both of these new approaches offer significant advantages over conventional methods of incineration. Installation, operating, and maintenance costs are substantially reduced when either approach is utilized.

When compared to conventional methods, the new approaches achieve an increase of 100% in mixing velocity or turbulence. This results in a reduction of 20% in fuel consumption. Residence time is reduced by 29% via the non-powered raw gas burner approach. An average reduction of 65% is obtained in the length to diameter ratio. Choice of which approach depends upon several factors, primarily the type of fuel available and the minimum oxygen concentration in the fume stream.     

Forecasting COH Levels at Six Outlying Sampling Stations in Allegheny County Using Statistical Correlations Derived from the Downtown Station

Verification of forecasts of COH levels at the Downtown Sampling Station using our objective forecast method developed in conjunction with the Allegheny County Bureau of Air Pollution Control gave excellent results. The next step was to expand the area of forecast coverage.

COH data taken from July 1968 through June 1969 from six sampling stations located roughly in a large concentric arc around the Downtown Station were studied. Three of the stations are located in river valleys near large industrial plants and the other three are located on higher terrain in suburban areas.

COH levels of Low, Moderate, High, and Very High (where Low = 0–0.9, Moderate = 1.0–1.9, High = 2.0–3.0, and Very High = >3.0) were used.

The total number of occurrences of High and Very High COHS at the Downtown Station was 10.7% of the total data sample. This was more than twice the frequency of any of the outlying stations.

An evaluation of the statistical frequencies indicate the Downtown Station can safely be used as a “control station” in forecasting Low or Moderate COH levels for the six surrounding stations. However, the occurrence of High or Very High COH levels at the six outlying stations do not occur with a high enough statistical consistency to be predicted by using the forecast value of the Downtown Station.

The valley stations exhibit the characteristics of separate sub air basins particularly during a period in which morning inversions occur for two or more consecutive days and the average daily wind speed does not exceed 4 m/sec.

The results show it is possible to forecast only Low or Moderate COH levels for each of the six outlying stations by using statistical correlations derived from the Downtown Station. Separate objective forecasts which relate the pollution buildup in each valley sub air basin must be used when High or Very High COHS are forecast at the Downtown Station.     

Surface Air Pollutant Concentration Frequency Distributions: Implications for Urban Modeling

With the development of ambient air quality standards (AAQS), the need arises to describe the characteristics of regional surface air-pollutant concentration frequency distributions. In the evaluation of land use plans, numerous agencies will be concerned with evaluating the effectiveness of emission zoning and/or control actions. On a regional basis, one means of performing this assessment lies in determining the changes in the pollutant frequency distributions resulting from control actions.

This study presents new data concerning the surface air-pollutant concentration frequency distributions observed for area sources and continuous point sources, and compares these distributions with those of the pertinent meteorological variables describing the transport and diffusion of the pollutant. The observed surface air pollutant frequency distributions are compared to those corresponding to simple modeling concepts from either an urban area source or a continuous point source. For an urban source and a relatively inert pollutant like CO, we found that the observed frequency distribution for CO surface air concentration parallels the approximately log-normal frequency distribution of the reciprocal of the wind speed. We show that the constant relating these two well-correlated frequency distributions can be determined either experimentally or with a numerical simulation model of air pollution. The usefulness of numerical models in air pollution is discussed.     

Performance and Cost Comparisons between Fabric Filters and Alternate Participate Control Techniques

A study was conducted to evaluate performance and cost comparisons of fabric filters and alternate fine particulate control techniques. In relating the removal of fine particulate to costs, due to the lack of fractional efficiency data, it was found necessary to treat a specific application in order to make the study manageable. The case chosen is that of the coal fired industrial boiler since Enviro-Systems has a pilot program in this application area.     

Results of Field Measurements of Industrial Particulate Sources and Electrostatic Precipitator Performance

This paper presents results of source size distribution measurements over the size range from 0.1 μm to 5 μm for six classes of particulate sources and fractional efficiency measurements on five full scale electrostatic precipitators and one pilot scale precipitator. The precipitators all showed moderately high to high particulate collection efficiencies for particles having diameters larger than a few micrometers or smaller than a few hundredths of a micrometer and a minimum in collection efficiency for particles having diameters of a few tenths of a micrometer.     

An Integrated Program to Achieve Maximum Performance of Electrostatic Precipitators

The objective of this paper is to describe the Tennessee Valley Authority's efforts and plans in designing an operating and maintenance program that will ensure maximum performance of the electrostatic precipitators at our power generating stations. Detailed operating and maintenance manuals are being prepared for each plant for the use of plant personnel. These manuals include instructions on operation, maintenance, and testing of the precipitators. Instructions on internal and external equipment inspections to be performed during unit operation, emergency and scheduled outages, and problem diagnostic procedures are included to help the plant personnel solve problem areas. Performance curves are included in the manuals which show the effect of gas volume flow, gas temperature, gas resistivity, coal changes, and loss of transformer-rectifier sets on the precipitator performance. In addition, opacity monitors that record continuous opacity readings are being installed at all our plants to assist the plant in monitoring precipitator performance. Full-time operating and maintenance crews are being organized at the plants to monitor and maintain the precipitator and ash-removal systems. Also, a staff of technical personnel is being organized at the central office to provide technical advice and assistance in design, operation, and maintenance problems and liaison and coordination for all the plants concerning the precipitators. Periodic precipitator field inspections, performance and operating parameter optimization testing, and review of the equipment operating logs are made by the central office technical personnel. Recommendations and technical assistance are then furnished to the plant with regard to the precipitator overall performance and operating characteristics.     

Some Factors in Minimizing Precipitator Costs

This paper is directed to those individuals involved in design of electrostatic precipitators. The Deutsch-Anderson model is usually employed by industry for the design of electrostatic precipitators. The so-called process design variable in this approach is the total capture area in the precipitator. Unfortunately, little is available on the equipment design of this unit, i.e., the geometric arrangement of the plates that constitute the capture area and the external dimensions of the physical structure that houses the precipitator components. These are important economic considerations, and it is to this subject that this paper is directed. It is relatively easy to predict equipment costs for “off-the-shelf” electrostatic precipitators; it is more difficult to closely predict the cost for a custom-made unit, which is more often the case encountered in practice. Once the capture area is calculated, the total precipitator cost becomes a strong function of the outer casing and outer accessories of the physical system. In this paper, a model is presented that can help minimize precipitator cost. An illustrative example complements the development of the model.