曙光油田节能减排现状调查及对策研究

曙光采油厂随着超稠油的不断开发,生产能耗也随之增加,通过开展节能减排及节能挖潜工作,全厂能耗增长状态得到了良好的控制,能耗总量由2005年的58.21×10~4t标煤下降到2008年的47.75×10~4t标煤;原油(气)液生产单位综合能耗为52.02 kg标煤/t,同期对比减少0.38 kg标煤/t;生产系统运行效率不断提高。文章详细介绍了曙光油田从机采系统、热注系统、集输系统等方面推广应用节能新技术、新产品,达到其投资和运行费用最少,经济性较好,对油田减排挖潜进行了探讨。     

NaCl和KCl对厌氧污泥抑制的动力学研究

在厌氧颗粒污泥和厌氧絮状污泥系统中,进行盐质量浓度(NaCl或KCl质量浓度,下同)对厌氧污泥抑制动力学的研究,得到不同拟合的COD降解动力学方程及参数.实验结果表明:当盐质量浓度为10～30 g/L时,KCl对厌氧污泥的COD比降解速率的抑制程度大于NaCl;当盐质量浓度由0 g/L增至10 g/L时,半速率常数逐渐增加;当盐质量浓度由10 g/L增至30 g/L时,半速率常数逐渐减小;在厌氧污泥系统中,NaCl抑制作用下的盐抑制常数高于KCl,且颗粒污泥的盐抑制常数高于絮状污泥.     

稀土在废水处理中的应用进展

综述了国内稀土金属在废水处理中的最新应用进展,总结了稀土复合吸附剂的制备方法及其在含磷、氨氮、砷、氟、铬、镉等废水处理中的效果,讨论了稀土复合混凝剂和稀土催化剂在染料、助剂、化工等高浓度有机废水处理中的应用,为找到高效环保的处理工业废水的方法提供了依据.     

选择性催化还原烟气脱硝技术在玉环电厂4×1000MW机组上的应用

以华能玉环电厂4×1000MW机组增设烟气选择性催化还原法（SCR）脱硝装置的技术改造为例,简要介绍了玉环电厂原机组增加SCR脱硝系统的工艺构成和流程特点、设计参数、总体布置,并对该工程中相关设备的改造进行了描述,为我国大型燃煤机组的脱硝改造工程提供参考。     

Study on Biodegradable Starch/OMMT Nanocomposites for Packaging Applications

The thermoplastic starch (TPS) and nanocomposite(TPS/OMMT) was prepared with 15% carbamide, 15% ethanolamine and different contents of organic activated montmorillonite (OMMT) by twin-screw extruder with a 130 °C barrel temperature. Fourier transforms infrared spectroscopy and wide angle X-ray diffraction shown that the alkylamine in dodecyl benzyl dimethyl ammonium bromide could react with MMT via cation exchange reaction. After treated, the d(001)space distance of MMT increased from 1.5 to 1.7 nm. Scanning electron microscope revealed that the lower contents of OMMT could disperse well in the matrixes of TPS. The carbamide, ethanolamine and the OMMT could destroy the crystallization behavior of starch, but only the OMMT restrained this behavior for long-term storing. Mechanical properties investigation indicated that the tensile strength and modulus of TPS/OMMT nanocomposites were better than those of TPS, while the elongation at break was descended with the increasing of OMMT contents. When the content of OMMT was 4%, the tensile strength and modulus of TPS was improved from 4.2 and 42 MPa to 6.0 and 76 MPa, respectively.     

可持续发展导向的环境规划研究

在论述可持续发展与环境规划之间关系的基础上,指出环境规划的指导思想是环境与经济、社会的可持续发展。针对可持续发展的实质,提出了环境承载力变化趋势是衡量可持续发展的依据,从而为区域可持续发展提供了量化的依据。并以长春技术开发区环境规划为例进行了案例分析,验证结果合理、可行。     

Co-treatment of hydrogen sulfide and methanol in a single-stage biotrickling filter under acidic conditions

Biofiltration of waste gases is cost-effective and environment-friendly compared to the conventional techniques for treating large flow rates of gas streams with low concentrations of pollutants. Pulp and paper industry off-gases usually contain reduced sulfur compounds, such as hydrogen sulfide and a wide range of volatile organic compounds (VOCs), e.g., methanol. It is desirable to eliminate both of these groups of compounds. Since the co-treatment of inorganic sulfur compounds and VOCs in biotrickling filters is a relatively unexplored area, the simultaneous biotreatment of H2S and methanol as the model VOC was investigated. The results showed that, after adaptation, the elimination capacity of methanol could reach around 236 g m(-3) h(-1) with the simultaneous complete removal (100%) of 12 ppm H2S when the empty bed residence time is 24 s. The pH of the system was around 2. Methanol removal was hardly affected by the presence of hydrogen sulfide, despite the low pH. Conversely, the presence of the VOC in the waste gas reduced the efficiency of H2S biodegradation. The maximal methanol removal decreased somewhat when increasing the gas flow rate. This is the first report on the degradation of methanol at such low pH in a biotrickling filter and on the co-treatment of H2S and VOCs under such conditions.     

影响煤矿作业人员不安全行为的因素

本文论述了如何预防和消除煤矿作业人员的不安全行为,克服职工不健康的心理状态,改善作业环境,实行作业标准化和对作业人员的技能培训。     

强化混凝去除微污染原水胶体颗粒的研究

对珠江水系统进行了强化混凝处理,燕利用准弹性激光散射技术（PCS）对常规混凝和强化混凝前后水中胶体颗粒（小于0.45um)的大小与分布进行了测定,探讨了搅拌条件对混凝效果的影响。     

固相微萃取-气相色谱/质谱联用法测定饮用水中苯类化合物

用固相微苹取(ＳＰＭＥ)－气相色谱/质谱联用法测定饮用水中苯类化合物,以１００μｍ ＰＤＭＳ(聚二甲基硅氧烷)萃取针提取、浓缩、分离与测定九种目标化合物．萃取时间经优化选定为８ｍｉｎ,而热解析时间设定为２ｍｉｎ． 本方法的相对标准偏差小于５%,线性范围宽(２０ｎｇ·ｍｌ－１－１００００ｎｇ·ｍｌ－１),多数化合物的检测限低于５μｇ·ｌ－１．饮用水样品检测显示,样品加标回收率范围在８４%至１１０%内．