Controlled Enrichment System for Experimental Fumigation of Plants in the Field with Sulfur Dioxide

A prototype Free-Air Controlled Enrichment (FACE) system was developed at Brookhaven National "Laboratory (BNL) for the experimental control of gas concentrations in an open field, without any form of enclosure. This FACE system consists of a toroidal plenum chamber, 15 m in diameter, with a series of 32 vertical vent pipes from which the release of a test gas can be controlled. Data on gas concentration at the center of the array and wind velocity are fed to a microprocessor where a proportional, integrative, differential (PID) algorithm is used to regulate a mass-flow controller. Data on wind direction are used to control the opening and closing of the vertical vent pipes to maintain an upwind release. In 72 hours of continuous operation during which wind velocity varied between 0.3 to 8 m sec^-1, the FACE prototype maintained 1 -min averaged concentrations within twenty percent of the 40 ppb set point 94 percent of the time.     

Variation of the Relative Humidity of Air Released from Canisters after Ambient Sampling

ABSTRACT

Dalton's law of partial pressures and the hypothesis that water vapor equilibrium in a canister is identical to that established above liquid water are used to predict the variation of the percent relative humidity (%RH) of air released from canisters used in ambient air sampling, typically 6-L canisters pressurized with 18 L of air. When (and if) the water vapor partial pressure in a canister exceeds its saturation vapor pressure, water vapor condensation begins and the condensation rate equals the sampling rate of water vapor into the canister. Under constant temperature conditions, the air subsequently released from the canister is less humid than the original sample, following the relationship %RH = 100% (6 L/V_s) for V_s> V_r, where V_s is the residual air volume (referenced to atmospheric pressure), and V_r is shown to depend on the %RH of the ambient air sample. V_r is the residual air volume at which water is completely removed (except for adsorbed water vapor) from the canister wall. For V_s < V_r, the predicted %RH is constant and equal to its value at V_r. Experimental values agree reasonably well with predictions at both high (90%) and low (34%) RH. However, experimental values are often slightly displaced (usually towards lower values of %RH) for mid-range %RH (61%) and variations in %RH near V_r change from canister to canister.     

Comparison of Statistical Designs and Experimental Protocols Used to Evaluate Rain Acidity Effects on Field-Grown Soybeans

Published results of four field experiments testing effects of acidic precipitation in field-grown soybeans have led to contradictory conclusions. This paper examines the experimental procedures and protocols of the four experiments which could have contributed to differences in both the reported crop yields and the interpretations or conclusions drawn from the experiments.

The most important difference among the experiments is in their statistical designs. Two of the field layouts used only one plot per treatment, providing replication only for plants, rows or sectors within plots, but not among plots. By using real data from a highly replicated experiment it is shown that with such deficient statistical designs treatment effects cannot be separated from other microenvironmental variables peculiar to a specific plot location.

The other two experiments were highly replicated. They were designed to detect differences of approximately 10% among treatment means. Type 1 error, a, was predetermined, and replication was sufficient to keep type 2 error low. This design was made possible because a preliminary experiment was available to estimate the expected components of variance. Despite differences in the procedures and protocols among the four experiments, it is primarily the quality of the experimental design which has determined their validity and relative utility for crop loss assessment.     

Product Guide/1975

Measurements conducted on full-scale hazardous waste incinerators have occasionally shown a relationship between carbon monoxide (CO) emissions and emissions of toxic organic compounds. In this study, four mixtures of chlorinated C₁ and C₂ hydrocarbons were diluted in commercial-grade heptane and burned in a water-cooled turbulent flame reactor (TFR) under two different excess air levels. No correlation between CO and organic emissions could be discerned. Reasons for this lack of observable correlations are discussed in terms of combustion and chemical reaction kinetic theory.     

Impacts of pollution controls on air quality in Beijing during the 2008 Olympic Games

Air pollution has become one of the main environmental concerns in China since the 1980s due to China's rapid economic growth and resultant pollution. However, it is difficult to directly evaluate the anthropogenic contribution to air pollution in China. The 2008 Olympic Games in Beijing provided a unique opportunity for testing the contribution of anthropogenic pollution because of the clean-up controls on air quality in Beijing enforced over the period of the Games. In this case study, we monitored the concentrations of major air pollutants before, during, and after the Olympics at a suburban site in Beijing. Atmospheric concentrations of PM10, PM2.5, NH3, NO2, SO2, and the particulate ions NH4+, NO3-, SO4(2-) Ca2+, Mg2+, and K+ all decreased during the Olympic period because of strict emission controls, compared with the same period from 2005 to 2007. For example, the average PM10 concentration (61 microg m(-3)) during the Olympics was only 37% of that (166 microg m(-3)) in the same month (August) from 2005 to 2007. However, just 1 mo and 1 yr after the Games had ended, mean concentrations of these pollutants had increased significantly again. This rapid "recovery' of air pollutant concentrations after the Olympics suggests that China needs to implement long-lasting decreases in its air pollution in Beijing and other major cities.     

Invasive Microstegium populations consistently outperform native range populations across diverse environments

Plant species introduced into novel ranges may become invasive due to evolutionary change, phenotypic plasticity, or other biotic or abiotic mechanisms. Evolution of introduced populations could be the result of founder effects, drift, hybridization, or adaptation to local conditions, which could enhance the invasiveness of introduced species. However, understanding whether the success of invading populations is due to genetic differences between native and introduced populations may be obscured by origin x environment interactions. That is, studies conducted under a limited set of environmental conditions may show inconsistent results if native or introduced populations are differentially adapted to specific conditions. We tested for genetic differences between native and introduced populations, and for origin x environment interactions, between native (China) and introduced (U.S.) populations of the invasive annual grass Microstegium vimineum (stiltgrass) across 22 common gardens spanning a wide range of habitats and environmental conditions. On average, introduced populations produced 46% greater biomass and had 7.4% greater survival, and outperformed native range populations in every common garden. However, we found no evidence that introduced Microstegium exhibited greater phenotypic plasticity than native populations. Biomass of Microstegium was positively correlated with light and resident community richness and biomass across the common gardens. However, these relationships were equivalent for native and introduced populations, suggesting that the greater mean performance of introduced populations is not due to unequal responses to specific environmental parameters. Our data on performance of invasive and native populations suggest that post-introduction evolutionary changes may have enhanced the invasive potential of this species. Further, the ability of Microstegium to survive and grow across the wide variety of environmental conditions demonstrates that few habitats are immune to invasion.     

Light-stress avoidance mechanisms in a Sphagnum-dominated wet coastal Arctic tundra ecosystem in Alaska

The Arctic experiences a high-radiation environment in the summer with 24-hour daylight for more than two months. Damage to plants and ecosystem metabolism can be muted by overcast conditions common in much of the Arctic. However, with climate change, extreme dry years and clearer skies could lead to the risk of increased photoxidation and photoinhibition in Arctic primary producers. Mosses, which often exceed the NPP of vascular plants in Arctic areas, are often understudied. As a result, the effect of specific environmental factors, including light, on these growth forms is poorly understood. Here, we investigated net ecosystem exchange (NEE) at the ecosystem scale, net Sphagnum CO2 exchange (NSE), and photoinhibition to better understand the impact of light on carbon exchange from a moss-dominated coastal tundra ecosystem during the summer season 2006. Sphagnum photosynthesis showed photoinhibition early in the season coupled with low ecosystem NEE. However, later in the season, Sphagnum maintained a significant CO2 uptake, probably for the development of subsurface moss layers protected from strong radiation. We suggest that the compact canopy structure of Sphagnum reduces light penetration to the subsurface layers of the moss mat and thereby protects the active photosynthetic tissues from damage. This stress avoidance mechanism allowed Sphagnum to constitute a significant percentage (up to 60%) of the ecosystem net daytime CO2 uptake at the end of the growing season despite the high levels of radiation experienced.     

Model selection and model averaging in behavioural ecology: the utility of the IT-AIC framework

Behavioural ecologists often study complex systems in which multiple hypotheses could be proposed to explain observed phenomena. For some systems, simple controlled experiments can be employed to reveal part of the complexity; often, however, observational studies that incorporate a multitude of causal factors may be the only (or preferred) avenue of study. We assess the value of recently advocated approaches to inference in both contexts. Specifically, we examine the use of information theoretic (IT) model selection using Akaike’s information criterion (AIC). We find that, for simple analyses, the advantages of switching to an IT-AIC approach are likely to be slight, especially given recent emphasis on biological rather than statistical significance. By contrast, the model selection approach embodied by IT approaches offers significant advantages when applied to problems of more complex causality. Model averaging is an intuitively appealing extension to model selection. However, we were unable to demonstrate consistent improvements in prediction accuracy when using model averaging with IT-AIC; our equivocal results suggest that more research is needed on its utility. We illustrate our arguments with worked examples from behavioural experiments.     

Parameters Influencing Sediments Resuspension and the Link to Sorption of Inorganic Compounds

In the aquatic environment, the accumulation of chemicalcontaminants by sediments poses a potential threat to endemiclife forms and drinking water resources. Trace metals such asCd, Cu, Cr, Ni, Pb, and toxic organic compounds, are among awide variety of contaminants having an affinity for sediments.In this study, experiments were performed simulating sedimentresuspension in the lower Housatonic River, Connecticut, using aParticle Entrainment Simulator. Analyses of grain sizedistributions, porosities and total organic contents of thesediments suggested that these parameters influence theredistribution and entrainment of settleable solids in the watercolumn. These findings were established by evaluating the impactof one parameter on sediment resuspension as a function ofstream flow with the other two characteristics being heldconstant. Total suspended solids and volatile suspended solidsresuspension concentration ranged from 3.2 to 20648.3 mg L^-1,and 1.5 to 1823.8 mg L^-1, respectively, with subsequentincreases in flow rates from 9 to 6 dynes cm^-2. The resuspension concentrations were augmentedby sediment porosity (22.0 to 57.5%), percent finer grain-size distributions at 0.1 mm, and total organic content (2.7 g kg^-1 to 29.0 g kg^-1). Using K _p values, and the dissolvedcontaminant levels of various trace metals, the particulatecontaminant levels of the metals were determined under variousoscillation rates. As sediment resuspension increased withincreased stream flow, there was an overall general increasefrom 0.02 to 33.6 g L^-1 in the particulatecontaminant levels of Cd, Cu, Cr, Ni and Pb.     

New Technology for Conducting Radiation Hazard Assessments: The Application of the Underwater Radiation Spectral Identification System (URSIS) at the Massachusetts Bay Industrial Waste (U.S.A.)

The Underwater Radiation Spectral Identification System (URSIS) is a portable spectrometer used for the in situ detection of radioactivity in the marine environment. This paper reports on the first time application of this technology to assess, in a preliminary manner, the potential radiation threat to the public and environment at an aquatic disposal site – the Massachusetts Bay Industrial Waste Site (IWS). Utilizing the meneuvering capabilities of ROV and manned submersible vehicles, the URSIS was successfully positioned close (5–10 cm) to waste containers for a period sufficient to detect, in real time, the presence of radioactive materials. Spectral data from 45 individual targets indicated that the radionuclides present in sediments which draped or partially buried waste containers were consistent with natural background concentrations. No man-made radionuclides were detected at any of the target or background measurement locations. These data support the conclusion that low-level radiation does not pose an imminent and widespread human health or ecological threat in Massachusetts Bay.