Diurnal Profile of Particle-bound Polycyclic Aromatic Hydrocarbon (pPAH) Concentration in Urban Environment in Tokyo Metropolitan Area

Traffic emits particles under 1 m. The particles arethe most responsible to particle-bound polycyclic aromatichydrocarbon (pPAH) which can impact human health. To assessthem as health hazards, we monitored diurnal changes in theconcentration and distribution of pPAH near roads in Tokyo.The total pPAH concentration was determined using aphotoelectric aerosol sensor (PAS) which ionized PAH-adsorbingparticles. The total pPAH concentration was compared withchemical analyses by gas chromatography/mass spectrometry(GC/MS). Two sampling sessions, one in August and one inSeptember 2000, were done at three sampling sites at the Hongo Campus of the University of Tokyo. Monitoring was every two minutes for six consecutive days for the first session and for seven consecutive days for the second session.Correlation of the pPAH concentration with traffic flow andwith meteorological conditions were also assessed. The pPAHconcentration varied in the same manner on all days: it sharplyincreased in the early morning by a sudden burden of traffic, and it rapidly decreased during the daytime, probably owing tophotodegradation and/or dilution by rising in the mixingzone. The local wind field, and consequently thetransportation of pPAH from the road, were stronglyinfluenced by the configuration and location of thesurrounding buildings. The pPAH clearly changed in 1- and0.5 day cycles, particularly at the roadside.     

Combustible and incombustible speciation of Cl and S in various components of municipal solid waste

Chlorine (Cl) and sulfur (S) in municipal solid waste (MSW) are important reactive elements during combustion. They generate the acidic pollutants HCl and SOx, and, furthermore, produce and suppress organic chlorinated compounds. Nevertheless, few practical reports about Cl and S content in MSW have been published. In combustion and recycling processes, both combustible Cl and S, and incombustible Cl and S species are equally important. This paper presents the results of a comprehensive study about combustible and incombustible Cl and S in MSW components, including kitchen garbage, paper, textiles, wood and leaves, plastics and small chips. By integrating this collected data with data about MSW composition, not only the overall content of Cl and S in MSW, but also the origins of both combustible and incombustible Cl and S were estimated. The average Cl content in bulk MSW was 3.7 g/kg of raw MSW, of which 2.7 and 1.0 g/kg were combustible and incombustible, respectively. The Cl contribution from plastics was 76% and 27% with respect to combustible and incombustible states. The average S content in bulk MSW was 0.81 g/kg of raw MSW, of which 0.46 g/kg was combustible and 0.35 g/kg was incombustible. Combustible S was mainly due to synthetic textiles, while incombustible S was primarily from paper.     

Industrial waste management simulation game and its educational effect

The purposes of this study were to develop the Industrial Waste Game and to examine the validity of this game as a tool for environmental education. The aim of this game is to enable players to understand the social dilemma between individual interest of hazardous dumping and the social cost of purifying pollution, and to find a solution to the social dilemma by providing the monitoring and sanction system for illegal dumping or other efficient systems. The game was played by 213 undergraduate students who were divided into 40 groups of 5 to 6 people. One of 4 combinations of monitoring and penalty conditions was assigned to each group. The players were asked to answer questionnaires concerning their interests and understanding of the industrial waste issue before and after the game to evaluate educational effects. The results indicated that the players increased their awareness of industrial waste problems and came to understand that these problems were caused not by psychological factors such as immorality of the illegal dumper but mainly by social structural factors like the social dilemma. Through playing the game and participating in post-game discussion, players were able to obtain interesting experience and gain motivation to learn more.     

Towards a microscopic theory of electrostatic precipitation

The statistical mechanics of particles at the surface of a dust deposit are presented as a step towards a microscopic theory of electrostatic precipitation. The paper consists of three major divisions: (1) field induced entrainment, (2) particle condensation at the surface, and (3) hydrodynamic limits on precipitation.In the first part of this paper, the entrainment of dust from surfaces by electrostatic forces was considered as a simple Markov process. A choice of x⁻¹ for the dependence of the adhesive potential (van der Waals particle attraction) led to an exponential emission rate in the Kramers-Chandrasekhar approximation. This result suggested a simple experimental procedure for determining the adhesive properties of the dust. In addition it was found that both thermal Brownian and particle-deposit collisions contribute to the entrainment.In the second part, the precipitation problem was discussed in terms of a two-dimensional Ising model. The Markovian assumption demanded that the efficiency of the electrostatic precipitator be divided into a product of factors depending on particle migration and condensation in the two-dimensional surface. From this perspective a new collection criterion was established and the importance of particle collisions at the surface of the deposit was demonstrated.Finally, in the third part the role of bulk fluid flows in particle condensation and migration was addressed. The superficial gas flow and secondary flow were found to introduce anisotropy into the Ising lattice and also to enhance the mean particle energy at the surface. The Navier Stokes Equation was numerically integrated for the case of a wire-plate type corona. Plots of the stream function and gas velocity profile were presented and these suggested the existence of a lower limit on the shear stress that acts on surface particles.     

Waterproof and translucent wings at the same time: problems and solutions in butterflies

Although the colour of butterflies attracts the most attention, the waterproofing properties of their wings are also extremely interesting. Most butterfly wings are considered “super-hydrophobic” because the contact angle (CA) with a water drop exceeds 150°. Usually, butterfly wings are covered with strongly overlapping scales; however, in the case of transparent or translucent wings, scale cover is reduced; thus, the hydrophobicity could be affected. Here, we present a comparative analysis of wing hydrophobicity and its dependence on morphology for two species with translucent wings Parantica sita (Nymphalidae) and Parnassius glacialis (Papilionidae). These species have very different life histories: P. sita lives for up to 6 months as an adult and migrates over long distance, whereas P. glacialis lives for less than 1 month and does not migrate. We measured the water CA and analysed wing morphology with scanning electron microscopy and atomic force microscopy. P. sita has super-hydrophobic wing surfaces, with CA > 160°, whereas P. glacialis did not (CA = 100–135°). Specialised scales were found on the translucent portions of P. sita wings. These scales were ovoid and much thinner than common scales, erect at about 30°, and leaving up to 80% of the wing surface uncovered. The underlying bare wing surface had a remarkable pattern of ridges and knobs. P. glacialis also had over 80% of the wing surface uncovered, but the scales were either setae-like or spade-like. The bare surface of the wing had an irregular wavy smooth pattern. We suggest a mode of action that allows this super-hydrophobic effect with an incompletely covered wing surface. The scales bend, but do not collapse, under the pressure of a water droplet, and the elastic recovery of the structure at the borders of the droplet allows a high apparent CA. Thus, P. sita can be translucent without losing its waterproof properties. This characteristic is likely necessary for the long life and migration of this species. This is the first study of some of the effects on the hydrophobicity of translucency through scales’ cover reduction in butterfly wings and on the morphology associated with improved waterproofing. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

泳动床技术处理高浓度废水特性研究

熊本大学自然科学研究院,熊本860-8555,日本     

Female mate preference for a costly ornament in male guppies

Female mate preference for dorsal fin length in male guppies (Poecilia reticulata) was investigated. In a dichotomous choice experiment using live males, females preferred males with longer dorsal fins to those with shorter dorsal fins. When the dorsal fin lengths of the two males were reversed by surgical manipulation, the females reversed their preference. To further examine this preference behaviour, a second dichotomous choice experiment was conducted using digitally modified male images that differed only in dorsal fin lengths. In this next experiment, females preferred male images with a longer dorsal fin than those with a shorter dorsal fin. In order to clarify the cost of possessing a long dorsal fin for males, the effect of dorsal fin length on swimming performance of males was also examined with a flow chamber. Male swimming performance was enhanced by surgically shortening the dorsal fin. The result of this study suggests that the long dorsal fin of male guppies is a costly handicap that may have evolved due to female mate choice.     

Mechanical behavior of inert waste landfills under seismic condition

Journal of Material Cycles and Waste Management - Mechanical properties and slope stability of inert waste landfills under seismic condition were studied with three different approaches: in-situ...     

Ultraweak photon emission from herbivory-injured maize plants

Following perception of herbivory or infection, plants exhibit a wide range of inducible responses. In this study, we found ultraweak photon emissions from maize leaves damaged by Helicoverpa armigera (Noctuidae). Interestingly, mechanically damaged maize leaves treated with caterpillar regurgitants emitted the same intensity and pattern of photon emissions as those from maize leaves damaged by caterpillars. Furthermore, two-dimensional imaging of the leaf section treated with the oral secretions clearly shows that photon emissions were observed specifically at the lip of the wound exposed to the secretions. These results suggest that the direct interaction between maize leaf cells and chemicals contained in caterpillar regurgitants triggers these photon emissions.     

Dissolution kinetics of high explosives particles in a saturated sandy soil

Solid phase high explosive (HE) residues from munitions detonation may be a persistent source of soil and groundwater contamination at military training ranges. Saturated soil column tests were conducted to observe the dissolution behavior of individual components (RDX, HMX, and TNT) from two HE formulations (Comp B and C4). HE particles dissolved readily, with higher velocities yielding higher dissolution rates, higher mass transfer coefficients, and lower effluent concentrations. Effluent concentrations were below solubility limits for all components at superficial velocities of 10-50 cm day(-1). Under continuous flow at 50 cm day(-1), RDX dissolution rates from Comp B and C4 were 34.6 and 97.6 microg h(-1) cm(-2) (based on initial RDX surface area), respectively, significantly lower than previously reported dissolution rates. Cycling between flow and no-flow conditions had a small effect on the dissolution rates and effluent concentrations; however, TNT dissolution from Comp B was enhanced under intermittent-flow conditions. A model that includes advection, dispersion, and film transfer resistance was developed to estimate the steady-state effluent concentrations.