摇动床生物膜反应器和活性污泥法组合技术处理高浓度有机废水的研究

利用摇动床生物膜反应器(简称摇动床)技术具有的容积负荷高与污泥产量低的优点,在普通活性污泥池的前部填充高性能丙烯酸树脂纤维(Biofringe)填料,研究了摇动床和活性污泥法组合技术处理高浓度有机废水的有效性。结果表明,该组合技术具有很强的有机物去除能力,当进水COD平均质量浓度由1500mg/L上升到2514mg/L时,出水COD的平均去除率基本保持在96%以上;整个运行阶段的出水COD浓度均满足《污水综合排放标准》(GB8978—1996)的二级标准;当进水NH4+-N浓度增加时,NH4+-N的去除率由99.7%降低到76.5%,但是在试验运行的整个阶段,摇动床和活性污泥法组合技术系统都表现出较强的硝化能力;活性污泥池中最高的混合液悬浮固体(MLSS)质量浓度为10625mg/L,最高MLSS约为普通活性污泥法的4倍;运行结束后的污泥产率为0.186,污泥产率仅为普通活性污泥法的50%左右。     

Biodegradability and compostability of polymers—test methods and criteria for evaluation

The treatment of solid waste in controlled composting facilities is an important possibility for reducing garbage. Natural and synthetic polymeric materials can be used for many purposes, for example, as packaging materials, where compostability is required. A prerequisite for official regulations and the decision as to which materials may be composted is investigations on their biodegradability and the quality of the compost produced. Several standardization groups at the ISO, CEN, and DIN are developing definitions, test methods, and classification systems for differentiating compostable from noncompostable materials. The concept which will be standardized and used in Germany is described in detail. It includes characterization of the test material, determination of the biodegradability using laboratory tests such as simple aquatic batch tests and a controlled aerobic composting test, investigation of the disintegration of the test material in industrial or bench-scale composting facilities, and finally, chemical and ecotoxicological analysis of the compost produced.     

Low-pressure reverse osmosis as a process for treatment of anionic pollutants in water environment

The recent development of new generation Low-Pressure Reverse Osmosis (LPRO) or nanofiltration membranes have received attraction for application in the field of wastewater and water treatment through an increasingly stringent regulation for drinking purpose and water reclamation. In this research, the application on treatment of anionic pollutants (NO₃ ^-, NO₂ ^-, Cl^-, SO₄ ^2- &; H₂PO₄ ^-) was done under very much lower pressure range of operation (0.49 to less than 0.1 MPa) than any other previous research has done. Moreover, the extended Nernst-Planck equation was used for analysis of the experimental data by considering effective charge density of the membranes.     

Field validation of an active sampling cartridge as a passive sampler for long-term carbonyl monitoring

A carbonyl sampler originally designed for the active sampling method (Sep-Pak XPoSure) was used for long-term passive sampling, and its applicability as a passive sampler was examined through field experiments. The uptake rates of passive sampling were determined experimentally from collocated passive and active samplings for various sampling periods. The obtained uptake rates of formaldehyde, acetaldehyde, and acetone were 1.48, 1.23, and 1.08 mL/min, respectively. These uptake rates were consistent for a wide range of the sampling term (12 hr-2 weeks). Uptake rates of each carbonyl were proportional to the diffusion coefficients of each. Therefore, the ratios of diffusion coefficients were used to calculate the uptake rates of carbonyls for which the rates were not determined experimentally. Lower limits of determination were 2.16-17.5 microg/m3 for 2-week sampling. It was confirmed that 2-week monitoring of carbonyl concentrations up to 118-229 microg/m3 was possible. Relative standard deviations of the passive method generated from the repeatability test were 2-12.3% error for five samplings, and the recovery efficiencies were larger than 90%. Thus, the passive sampler was found to be highly suitable for long-term monitoring of carbonyl compounds.     

Studies on automated survey system of environmental chemicals by gas chromatography-mass spectrometry-computer II. Three dimensional mass chromatography

A three dimensional mass chromatography (TDMC), which is the extended method of mass chromatography, has been developed for the analysis of environmental chemicals. A considerable performance was suggested by the combination of TDMC to gas chromatography-mass spectrometry-computer system.     

Residual organic fluorinated compounds from thermal treatment of PFOA,PFHxA and PFOS adsorbed onto granular activated carbon (GAC)

Perfluorooctanoic acid (PFOA), perfluorohexanoic acid (PFHxA) and perfluorooctane sulfonate (PFOS) adsorbed onto granular activated carbon (GAC) were thermally treated in N₂ gas stream. The purpose was to assess the fate of perfluoroalkyl and polyfluoroalkyl substances (PFASs) during thermal regeneration of GAC, which had been used for water treatment. Mineralized F, residual PFASs including short-chained species, and volatile organic fluorine (VOF) were determined. In a temperature condition of 700 °C, VOF were 13.2, 4.8, and 5.9 % as for PFOA, PFHxA, and PFOS. However, the VOF decreased to 0.1 %, if the GAC and off-gas were kept at 1000 °C. No PFASs remained in GAC at 700–1000 °C; at the same time, short-chained PFASs were slightly detected in the aqueous trapping of off-gas at 800 and 900 °C conditions. The destruction of PFASs on GAC could be perfect if the temperature is higher than 700 °C; however, the process is competitive against volatile escape from GAC. Destruction in gaseous phase needs a temperature as high as 1000 °C. Destruction of PFASs on the surface of GAC, volatile escape from the site, and thermolysis in gas phase should be considered, as to thermal regeneration of GAC.     

Basic Research on the Emission of Polycyclic Aromatic Hydrocarbons caused by Waste Incineration

The emission of polycyclic aromatic hydrocarbons (PAH) caused by municipal waste incineration varies according to waste composition and operating parameters such as furnace temperature and excess air. However, to obtain a sample sufficient to measure the emission of PAH at trace levels, it is necessary to operate the incinerator for many hours. Since during these lengthy periods it has not always been possible to maintain stable conditions, it is very difficult to determine the relationship between the emission and waste composition.

In our basic research, therefore, we used municipal waste with an artificially regulated composition for our combustion experiments, and by using an experimental Incinerator we examined the emission behavior of PAH with respect to changes in waste composition and combustion conditions. The following facts were revealed by the results: ? The PAH found in the flue gas were predominantly the more volatile compounds.

? When municipal waste was incinerated at over 850 °C, the concentration of PAH in the flue gas increased rapidly as the proportion of plastics in the waste increased from 0 to 24 percent.

? The elimination of plastics from municipal waste by separate collection and the improvement of combustion conditions can effectively diminish the emission of PAH.

     

Age-Dependent Factors Affecting Thoracic Response: A Finite Element Study Focused on Japanese Elderly Occupants

Objectives: The ultimate goal of this research is to reduce thoracic injuries due to traffic crashes, especially in the elderly. The specific objective is to develop and validate a full-body finite element model under 2 distinct settings that account for factors relevant for thoracic fragility of elderly: one setting representative of an average size male and one representative of an average size Japanese elderly male.

Methods: A new thorax finite element model was developed from medical images of a 71-year-old average Japanese male elderly size (161cm, 60 kg) postmortem human subject (PMHS). The model was validated at component and assembled levels against original series of published test data obtained from the same elderly specimen. The model was completed with extremities and head of a model previously developed. The rib cage and the thoracic flesh materials were assigned age-dependent properties and the model geometry was scaled up to simulate a 50th percentile male. Thereafter, the model was validated against existing biomechanical data for younger and elderly subjects, including hub-to-thorax impacts and frontal impact sled PMHS test data. Finally, a parametric study was conducted with the new models to understand the effect of size and aging factors on thoracic response and risk of rib fractures.

Results: The model behaved in agreement with tabletop test experiments in intact, denuded, and eviscerated tissue conditions. In frontal impact sled conditions, the model showed good 3-dimensional head and spine kinematics, as well as rib cage multipoint deflections. When properties representative of an aging person were simulated, both the rib cage deformation and the predicted number of rib fractures increased. The effects of age factors such as rib cortical thickness, mechanical properties, and failure thresholds on the model responses were consistent with the literature. Aged and thereby softened flesh reduced load transfer between ribs; the coupling of the rib cage was reduced. Aged costal cartilage increased the severity of the diagonal belt loading sustained by the lower loaded rib cage.

Conclusions: When age-specific parameters were implemented in a finite element (FE) model of the thorax, the rib cage kinematics and thorax injury risk increased. When the effect of size was isolated, 2 factors, in addition to rib material properties, were found to be important: flesh and costal cartilage properties. These 2 were identified to affect rib cage deformation mechanisms and may potentially increase the risk of rib fractures.     

Behavior of PCNs, PCDDs, PCDFs, and dioxin-like PCBs in the thermal destruction of wastes containing PCNs

In the first known study to characterize the emissions of polychlorinated naphthalenes (PCNs), polychlorinated dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs), and dioxin-like polychlorinated biphenyls (dl-PCBs) from the thermal treatment of wastes containing PCNs, the formation and decomposition behavior of these pollutants was investigated both at laboratory scale and at plant scale. Exhaust gas measurements from laboratory-scale combustion of rubber belts containing PCNs (FB belts) were used as the basis for calculations predicting that the incremental dioxin toxic equivalency (TEQ) emissions from municipal solid waste (MSW) incinerators would be less than 0.1 ng/m3 N. In order to directly examine co-incineration of FB belts with MSW and to address potential differences between the laboratory experiment and full-scale MSW incinerators, experiments were conducted using a larger scale thermal treatment test facility with sampling and analysis at several points in the thermal treatment process. Congener specific analysis of PCNs clearly showed that both destruction and synthesis simultaneously occurred during combustion in the kiln. Most of the PCNs were destroyed by secondary combustion, and almost all PCNs were removed after flue gas treatment. Almost all PCDDs/DFs were synthesized as by-products of kiln combustion, most of them were destroyed by the secondary combustion, and almost all dioxins (PCDDs/DFs and dl-PCBs) were removed after flue gas treatment. The TEQ emission levels were less than 0.1 ng/m3 N for all plant-scale tests, and differences in TEQ emission levels were very small. Adding wastes containing PCNs to MSW will not influence thermal treatment emissions to the environment from modern solid waste incinerators.