The impact of nudging coefficient for the initialization on the atmospheric flow field and the photochemical ozone concentration of Seoul,Korea

In order to incorporate correctly the large or local scale circulation in the model, a nudging term is introduced into the equation of motion. Nudging effects should be included properly in the model to reduce the uncertainties and improve the air flow field. To improve the meteorological components, the nudging coefficient should perform the adequate influence on complex area for the model initialization technique which related to data reliability and error suppression. Several numerical experiments have been undertaken in order to evaluate the effects on air quality modeling by comparing the performance of the meteorological result with variable nudging coefficient experiment. All experiments are calculated by the upper wind conditions (synoptic or asynoptic condition), respectively. Consequently, it is important to examine the model response to nudging effect of wind and mass information. The MM5–CMAQ model was used to assess the ozone differences in each case, during the episode day in Seoul, Korea and we revealed that there were large differences in the ozone concentration for each run.These results suggest that for the appropriate simulation of large or small-scale circulations, nudging considering the synoptic and asynoptic nudging coefficient does have a clear advantage over dynamic initialization, so appropriate limitation of these nudging coefficient values on its upper wind conditions is necessary before making an assessment. The statistical verifications showed that adequate nudging coefficient for both wind and temperature data throughout the model had a consistently positive impact on the atmospheric and air quality field. On the case dominated by large-scale circulation, a large nudging coefficient shows a minor improvement in the atmospheric and air quality field. However, when small-scale convection is present, the large nudging coefficient produces consistent improvement in the atmospheric and air quality field.     

Valuation of Spatial Configurations and Forest Types in the Southern Appalachian Highlands

Site-specific estimates of the values of spatial configuration and forest composition are presented. Amenity values of forest patches are found to vary the most by urban and sprawling development patterns of specific areas and forest types. For example, smaller patches of deciduous forest are more highly valued in the urban and sprawling areas of Greensboro, North Carolina, whereas larger patches of deciduous forest are more highly valued in the urban and sprawling areas of Greenville, South Carolina. Within the Greenville and Greensboro areas, visible landscape complexity is highly valued for deciduous and evergreen forest patches, whereas lower visible landscape complexity, i.e., smoothly trimmed forest patch boundaries, is highly valued for mixed forest patches.     

Application of recycled paper sludge and biomass materials in manufacture of green composite pallet

Rice straw, rice husk and paper sludge are by-products and industrial waste, and are beneficial resources as raw biomass materials used for manufacturing value-added composite products. We investigated the effect on selected mechanical properties of adding rice straw, rice husk and paper sludge to wood composites to replace wood particles for manufacturing green pallets. Results showed that increasing the contents of rice straw and rice husk dramatically decreased the mechanical strength of the composites. This is because the wax and silicate coating of these materials obstructed the strong bonding with UF resin. When 10 wt.% of wood particle was replaced with 10 wt.% of paper sludge, the wood–paper sludge composites showed similar mechanical properties to those of wood particle. Wood particle can be replaced by 10 wt.% of dried paper sludge in accordance with the minimum requirement recommended by standards in green pallet manufacturing.     

Application of TRIZ creativity intensification approach to chemical process safety

This study develops a modified method of TRIZ to improve safety in chemical process design. This method is modified by the theory of TRIZ, which is inventive problem solving theory, for retrofit design of chemical process considering safety.The original TRIZ is difficult to access to chemical process safety due to inapplicability and ambiguity of terminology in classification of these parameters. It is necessary to be modified TRIZ for chemical process safety. This study reorganized thirty-nine parameters of the TRIZ into six categories such as mechanic, operator, process upset, design, natural hazard and material. The modified TRIZ is tested to jacketed reactor and polyethylene reactor.     

Methane production potential of leachate generated from Korean food waste recycling facilities: a lab-scale study

This paper examines the applicability of food waste leachate (FWL) in bioreactor landfills or anaerobic digesters to produce methane as a sustainable solution to the persisting leachate management problem in Korea. Taking into account the climatic conditions in Korea and FWL characteristics, the effect of key parameters, viz., temperature, alkalinity and salinity on methane yield was investigated. The monthly average moisture content and the ratio of volatile solids to total solids of the FWL were found to be 84% and 91%, respectively. The biochemical methane potential experiment under standard digestion conditions showed the methane yield of FWL to be 358 and 478 ml/g VS after 10 and 28 days of digestion, respectively, with an average methane content of 70%. Elemental analysis showed the chemical composition of FWL to be C(13.02)H(23.01)O(5.93)N(1). The highest methane yield of 403 ml/g VS was obtained at 35 degrees C due to the adaptation of seed microorganisms to mesophilic atmosphere, while methane yields at 25, 45 and 55 degrees C were 370, 351 and 275 ml/g VS, respectively, at the end of 20 days. Addition of alkalinity had a favorable effect on the methane yield. Dilution of FWL with salinity of 2g/l NaCl resulted in 561 ml CH(4)/g VS at the end of 30 days. Considering its high biodegradability (82.6%) and methane production potential, anaerobic digestion of FWL in bioreactor landfills or anaerobic digesters with a preferred control of alkalinity and salinity can be considered as a sustainable solution to the present emergent problem.     

Behavior of PAHs from sewage sludge incinerators in Korea

Although production of sewage sludge increases every year, its proper treatment has only been recently raised as a new issue, as current landfill and ocean dumping arrangements are expected to become increasingly difficult to manage in the future. The Korean Ministry of Environment plans to diversify its processing facilities and expand its processing systems by 2011, with the purpose of processing all sludge produced in Korea. According to this plan, incineration (including incineration of municipal wastes) will process 30% of the entire sewage sludge throughout the country in 2011. This study reviews the characteristics of PAH, which is one of the organic substances found in sewage sludge during the incinerating process. The total amount of PAH produced from sewage sludge incineration was found to be 6.103 mg/kg on average, and investigation performed on 16 PAHs of inlets and outlets of the air control devices at five full-scale incineration facilities showed that concentrations of the PAHs on the inlet and on the outlet ranged from 3.926 to 925.748 microg/m(3) and from 1.153 to 189.449 microg/m(3), respectively. In the case of the incineration facility fed with municipal waste (95%) and sewage sludge (5%), the total of the PAH emissions concentration was higher than that found at the incineration facilities used exclusively to treat sewage. The combustion of waste vinyl and plastics contained in municipal waste fed into the facility might contribute to the high levels of PAHs in the stack gas. However more investigation is needed on the production mechanism of PAHs at different operating conditions of the incineration facilities, such as the types of waste, and other relevant factors.     

Efficiency analysis of reduction and stabilization of biodegradable waste using an aerobic stabilization system

The reduction and stabilization of biodegradable waste were studied using three operational stages in an aerobic stabilization system. The system used for mechanical/biological treatment utilized two-shaft screws in multiple box reactors. In the first operational stage, 50-kg batches of biodegradable waste were charged in each of the three reactors, with peat moss used as a bulking agent. Analysis revealed that peat moss can be used at this initial stage, based on the observed increase in temperature and carbon dioxide levels. The second stage of operation involved adding 100 kg/day of biodegradable waste to the first reactor. It was confirmed that a continuous reaction is possible by the addition of more waste. In the third stage of operation, 20 kg/day of the 100 kg/day of biodegradable waste feed was replaced with material fed back from the third reactor. At this stage, final product was also removed from the third reactor. The temperature was not controlled, and up to 8%–9% carbon dioxide was formed, enabling normal activation of decomposition. This three-stage operational test confirmed the expected decomposition of organic matter and biodegradable materials. The rate of mass reduction calculated for the final product compared with the input amount was 94.3%, which confirmed that this system would be a useful means for the reduction and stabilization of biodegradable waste. This study also measured the water content of the material in the reactors: the water content decreased as the reaction progressed. This indicated that the activation of microorganisms did not occur sufficiently in the second and third reactors. Future studies of methods to control the internal water content of each reactor should improve the decomposition efficiency.     

South Korean managerial reactions to voicing discontent: The effects of employee attitude and employee communication styles

Using a scenario‐based experiment, this study examined how employee attitude and employee communication styles affected managers' reactions to employees' objections to a company policy. In the experiment, employee attitude (cynical versus trusting) and employee communication styles (aggressive versus diplomatic) were manipulated, and managers' reactions to voicing discontent were assessed through a questionnaire. Based on a sample of 185 middle managers working in various organizations in South Korea, the results showed that managers were more likely to engage in social undermining and were less likely to provide social support when cynical (rather than trusting) employees objected to a company policy. Also, attributed motives (i.e., personal attack and health concern) fully mediated the relationship between employee attitude and social support and social undermining. In addition, managers more likely attributed the objection to moral concerns when trusting (rather than cynical) employees communicated in an aggressive manner. Copyright © 2009 John Wiley & Sons, Ltd.     

Enhancement of arsenic mobility by indigenous bacteria from mine tailings as response to organic supply

Arsenic leaching by indigenous bacteria in abandoned Au-Ag mine tailings which contained approximately 3200 mg/kg of As was investigated after supply of various organic substrates. Sequential extraction analysis designed to determine the mode of As occurrence in the tailings revealed that most As (90%) was closely associated with the Fe fraction. When glucose was supplied as a C source, indigenous bacteria significantly enhanced the extent of As release from the tailings into solution under both aerobic and anaerobic conditions. Anaerobic indigenous bacteria leached more amount of As from the tailings than aerobes. Highly positive correlation between the extracted amounts of As and Fe implied that microbial dissolution of Fe(III)-oxides, whether it was ligand- and proton-promoted dissolution or reductive dissolution, might be dominantly responsible for the As release. Bacterial strains which were resistant to up to 100 mM As(V) was aerobically isolated from the tailings. One of the isolates appeared to reduce some aqueous As(V) to likely As(III) in a batch type experiment, which indicated that indigenous bacteria can mediate the electrochemical speciation and thus the mobility of As in the tailings. The results suggest that indigenous bacteria in As-contaminated tailings can increase As mobility from the solid media when microbially available organic substrates are supplied, and thus enhance the risk of As dispersion to nearby soil, sediment and groundwater.     

Characteristics of atmospheric speciated mercury concentrations (TGM,Hg(II) and Hg(p)) in Seoul,Korea

Ambient speciated mercury concentrations including total gaseous mercury (TGM), gaseous divalent mercury (Hg(II)), and particulate mercury (Hg(p)) were measured on the roof of the Graduate School of Public Health building in Seoul, Korea from February 2005 to February 2006. The average concentrations were 3.22 ± 2.10 ng m^?3, 27.2 ± 19.3 pg m^?3, and 23.9 ± 19.6 pg m^?3 for TGM, Hg(II), and Hg(p), respectively. Hg(II) and Hg(p) concentrations were higher during the daytime than during the nighttime, probably because of high photochemical activity. Hg⁰ concentrations were not significantly correlated with ozone however a positive correlation between ozone and Hg(II) was found during periods of high humidity. Eighteen days were characterized as pollution events with 24 h average PM_2.5 concentrations >65 μg m^?3. The average concentrations of TGM and Hg(p) during these events were 1.4–2 times higher than those during non-pollution events. In order to identify the contribution of long-range transported mercury to the enhanced mercury concentrations in Korea, an episode was defined as a period with hourly average TGM and CO concentrations higher than the monthly average TGM and CO concentrations and with significant enhancement of both TGM and CO concentrations for at least 10 h. A total of 70 episodes were identified during the sampling period: 36 local episodes and 34 long-range transport episodes. The mean ΔTGM/ΔCO slope for all episodes was 0.0063 ng m^?3 ppbv^?1 which agreed well with the slope (0.0036–0.0074 ng m^?3 ppbv^?1) found in previous studies that identified long-range transport of TGM from China. The mean slope during non-events was 0.0011 ng m^?3 ppbv^?1. Back-trajectory analysis showed that during episodes, air parcels arrived mostly from the major industrial areas in China (n = 25, 73%), followed by Japan (n = 4, 12%), Yellow Sea (n = 3, 9%), and Russia (n = 2, 6%).